• 한국환경보건학회지
• /
• 제19권4호
• /
• pp.38-43
• /
• 1993

The characteristics of food wastewater treatment in an anaerobic packed bed reactor (APBR) with polyurethane as a packing material and sludge bed reactor (ASBR) was studied. The reactor of 9cm-ID, 150cm-height was fed in a continuous mode from bottom of reactor. For the purpose of constant temperature of reactor, water jacket was installed. The used packing materials was polyurethane sponge foam. Methane which was produced by decomposed organics collected at the top of the reactor for using as a fuel. The substrates used were synthetic, mixed and food wastewater. For the acclimatization of microorganisms, mixed wastewater was used. The major analyses were gas production, COD, pH and volatile acids. Based upon the completed works, the results are as follows: When food wastewater was fed the quantity of produced gas was less than that of synthetic wastewater, but food process saw higher methane content than synthetic process. As well as COD removal efficiency of food process reached at about 85%. In aspect of effluent volatile acid, food process showed low concentration of below 500 mg/l, therefore anaerobic reaction stabled. Conclusively food wastewater used can be digested by anaerobic treatment, especially anaerobic packed bed reactor showed 82% of COD removal, 75% of methane content, 10 l of gas production, and anaerobic sludge bed reactor did 79% of COD removal, 75% of methane content, 81 of gas production at 4 kgCOD/m$^3$day, 36$\circ$C.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 하계학술대회 논문집
• /
• pp.171-171
• /
• 2009

We have investigated the impact of coffee ring effect on the inkjet-printed $Al_2O_3$ thick films. In a single solvent system such as Dimethylformamide, the coffee-ring-pattern has appeared on the edge of sessile drop after evaporation. The peak-to-valley height difference in $Al_2O_3$ coffee ring is over 2um. This non-uniform deposition of $Al_2O_3$ over the surface leads to sever surface roughness of the inkjet-printed films. However, we have manipulated our printing parameters to improve the surface roughness and the packing density of the printed $Al_2O_3$ films. Our inkjet-printed $Al_2O_3$ films show 10 times smoother surface than the initially printed sample's surface. Also the packing density of the printed Ah03 film becomes 70% of high packed $Al_2O_3$. In this presentation, we would like to present the key process parameters of the inkjet printing process to overcome the genetic coffee ring problem.

• Journal of Trauma and Injury
• /
• 제30권4호
• /
• pp.238-241
• /
• 2017

A 52-year-old man experienced blunt trauma upon falling from a height of 40 m while trying to repair the elevator. The patient's systolic blood pressure and hemoglobin levels were 60 mmHg and 7.0 g/dL, respectively, upon admission. A large volume of bloody discharge was observed in the open wound of the perianal area and sacrum. A computed tomography scan revealed an open comminuted sacral fracture with multiple contrast blushes. He underwent emergency laparotomy. Both internal iliac artery ligations were performed to control bleeding from the pelvis. Protective sigmoid loop colostomy was performed because of massive injury to the anal sphincters and pelvis. Pad packing was performed for a sacral open wound and perineal wound at the prone position. After resuscitation of massive transfusion, he underwent the second operation 2 days after the first operation. The pad was removed and the perineal and sacral open wounds were closed. After the damage-control surgery, he recovered safely. In this case, the hemodynamically unstable, open comminuted sacral fracture was treated safely by internal iliac artery ligation with pad packing.

• 대한환경공학회지
• /
• 제29권1호
• /
• pp.62-67
• /
• 2007

본 연구의 목적은 액상 균일질 촉매를 이용하여 연소가스 중에 포함되어 있는 $SO_2/NO$의 동시제거 기술 개발에 있다. 연구는 bench scale/소규모 pilot scale에서 이루어졌으며 연구 결과는 다음과 같다. 1) $SO_2$는 실험조건에 상관없이 높은 제거효율을 가지는 것으로 확인되었다. 그러나 NO의 경우 충진층 높이가 증가할수록, 농도가 낮을수록, 촉매 분사량이 증가할수록 제거효율이 증가하는 것으로 나타났다. 2) Fe(II)-EDTA를 이용한 $SO_2/NO$ 동시처리 기술 개발을 위한 최적의 설계 인자는 충진 높이 =0.5 m, 액체-기체비 = 20 $L/m^3$, 반응기 단수=3단, 반응기 단면적 = 0.025 $m^2$로 결정하였다. 3) 연구 결과를 기초로 $SO_2/NO$의 동시처리 효율을 실험한 결과 각각 95%, 81% 이상 제거가 가능했다. 4) 높은 HTU는 NO의 제거에 있어 유리하지만 과도한 HTU는 스크러버의 운전효율을 감소시키므로 최적의 HTU를 결정하는 것이 필요하다.

• 대한환경공학회지
• /
• 제27권7호
• /
• pp.686-689
• /
• 2005

회분식 및 연속식 충전 복극전해조 사용시 인가전압, 전해시간 및 활성탄 충진고 등이 암모니아성 및 질산성 질소 제거에 미치는 영향을 검토할 목적으로 실험하였다. 회분식 충전복극 전해조에 $4{\times}8$ mesh GAC를 충전한 후 20 V의 전위에서 30분간 전해한 결과 활성탄 충진고가 80 mm인 경우 암모니아성 질소 제거효율은 전해시간 30분에서 99.9%, 질산성 질소 제거효율은 전해시간 60분에서는 97.6%이었다. 그리고 암모니아성 및 질산성 질소를 연속식으로 처리시 활성탄을 280 mm 충전한 충전복극전해조에 총 질소 농도가 30 mg/L가 되도록 조제한 질산암모늄 시료를 6.7 mL/min 속도로 주입하면서 72시간 연속전해 결과 총 질소 제거효율은 약 80% 이상이었다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2001년도 봄 학술발표회 논문집
• /
• pp.763-768
• /
• 2001

The purpose of this study is to research a specific material characteristics of top down concrete at column joint and to reduce column joint opening. Based on the established top down study, the experiment to apply an real construction case is performed. When the concrete placed into joint of top down column, raised air bubble is left as opening. This study is examined the incomplete packing reason in the top down column and found to air deflation method. The result of study is below (1) As the method to minimize column opening caused from confined air, it is required that an air exhaust port installation in joint column. (2) From air exhaust port installation, most of air bubble in column part is exhausted. As the concrete placing height is going up, air bubble size is going smaller.

• 한국환경과학회지
• /
• 제8권2호
• /
• pp.177-182
• /
• 1999

Nitrifier consortium entrapped in Ca-alginate bead were packed into aerated packed bed bioreactor and non aerated packed bed bioreactor and the performances of two bioreactors were evaluated for the removal of ammonia nitrogen from synthetic aquaculture water. Total ammonia nitrogen(TAN) removal rate was decrease in aerated packed bed bioreactor below 0.3hr of hydraulic residence time(HRT), but increased in non aerated packed bed bioreactor until 0.5hr of HRT. At HRT of 0.05hr, TAN removal rate of non aerated packed bed bioreactor was about 335g TAN/㎥/day and the optimum ratio of packing height and inside diameter of reactor (H/D) was 4. The performance of two bioreactors indicated that non aerated packed bed bioreactor was better than aerated packed bed bioreactor in ammonia removal from synthetic aquaculture water.

• 한국환경보건학회지
• /
• 제19권2호
• /
• pp.23-33
• /
• 1993

The anaerobic digestion of organic synthetic wastewater in anaerobic fluidized bed bioreactor (AFBBR) and anaerobic fluidized packed bed bioreactor (AFPBBR) was studied. This study was conducted to evaluate efficiency and reliability of two reactor. Experiment was performed to find the effect of upflow rate with AFBBR and the height of packed bed with AFPBBR. As a result, this program obtained several conclusion. These are given as follows: As applied the upflow rate increased in AFBBR the produced volume of biogas increased, while the gas production and COD removal decreased at above 0.3 m$^3$/h. When a upflow rate is 0.4 m$^3$/h in AFBBR the volatile suspended solid (VSS) became significantly increased. At an organic loading rate from 0.1 to 0.4 of upflow rate in AFBBR, the methane yield was 1.5584 m$^3$CH$_4$/kgCOD removed, and the observed cell yield coefficient was 0.0933 gVSS/gCOD. In case of AFPBBR, the results showed also that 20 cm of height of packed bed was superior to other in the aspect ot biogas production, the content of methane and COD removal. At 20 cm of height, the profile of microorganisms was stable, while at 30 cm the VSS of effluent became higher than AFBBR. Though COD removal of AFPBBR increased with packed bed, COD removal deteriorate with over packing because the loss of pressure became higher in the reactor. At an organic loading rate from 20 to 40 cm of packed bed in-AFPBBR, the methane yield was 2.5649 m$^3$CH$_4$/kgCOD removed, and the observed cell yield coefficient was 0.0506 gVSS/gCOD. Based upon the results obtained, it is suggested that AFBBR and AFPBBR is the most effective conditions at 0.3 m3/h of upflow rate, the 20cm of packed bed, respectively. The rate constant are summarized as follow:

• 상하수도학회지
• /
• 제14권1호
• /
• pp.37-44
• /
• 2000

Laboratory experiments were conducted to investigate the performances of anaerobic filters packed with ceramic tube and pall-ring media treating a dairy waste. The media packing volume was 65% of effective volume of anaerobic filter. Organics removals of anaerobic filters were maintained above 80% even at an organics loading rate of $10kgCOD/m^3/d$, and this was comparable to aerobic treatment of organic wastes. Organics removals of the ceramic tube anaerobic filters were always lower than those of the pall-ring anaerobic filters due to intrinsic physical property of ceramic tube, especially lower void space which caused to clogging and entrapment of biogas, substrate transfer limitation, and irregular evolution of biogas leading to loss of solids and biomass. This was clearly observed in higher concentration of TSS in the effluent from the ceramic tube anaerobic filter despite of higher retention capacity of TSS compared with pall-ring media. Vertical distribution of organics and solids in the filters showed above 90% of organics and solids in influent were removed below 20% of reactor height, and 50% of remaining organics and solids were removed though media packing zone. Effluent quality from the anaerobic filter was heavily depended on media itself as well as suspended biomass formed below media. It is therefore concluded that the type of media played an important role in biomass accumulation arid gas-liquid-solid separation efficiency. Type of media did not affect the start-up behaviors of the anaerobic filter, and supernatant from anaerobic digested sludge showed a good performance as a seeding materials.

• 한국화재소방학회논문지
• /
• 제30권2호
• /
• pp.98-105
• /
• 2016

물류창고 화재위험성은 보관물품, 포장재 및 파렛 등의 가연성과 화재하중 그리고 창고 내부 천장높이, 랙크 등의 저장높이와 배치, 통로 폭 등에 따라 결정된다. 물류창고의 소화 또는 진압대책은 이러한 주요 인자를 고려한 가연물 등급 분류기준을 마련하고 스프링클러설비 설계기준을 적용해야 한다. 본 연구는 국내 물류창고의 자동식스프링클러 적용을 위한 첫 단계로서 경기도 소재 5개 물류단지 내 28개 창고 동을 대상으로 수용물품의 분포 및 창고 공간특성을 현장 조사하였다. 아울러 미국 유럽 및 일본의 물품 분류기준을 분석하였으며 이를 통하여 물류창고 수용물품의 등급분류기준 마련을 위한 기초자료를 제시하고자 한다.