• 분석과학
• /
• 제10권6호
• /
• pp.439-444
• /
• 1997

압전 세라믹스 [$Pb(ZrTi)O_3$] 소재에 대하여 신속하고 정확하게 분석할 수 있는 X-선 형광분석용 표준물질 12종을 제작하였다. 특히 매질효과의 제거, 보관성, 균질성 등을 고려하여 융제($Li_2B_4O_7/LiBO_2=4/1$)로 시료를 16배 희석하여 제작하였다. 네 곳의 분석기관에서 X-선 형광분광기로 12개의 표준물질에 포함된 11 원소에 대하여 검정곡선을 작성해 본 결과 PbO, $ZrO_2$, $TiO_2$, SrO, $WO_3$, $La_2O_3$, $Cr_2O_3$, MgO, $Nb_2O_5$, $MnO_2$들은 correlation factor가 0.998을 넘는 대단히 좋은 직선을 얻었다. 그러나 ZnO의 correlation factor는 0.977로 비교적 낮았으며, 이는 표준시료 중 ZnO의 함량이 10ppm 정도로 낮았기 때문이다. 본 연구에서 제작한 XRF 분석용 표준물질을 이용하면 PZT 중의 주 부성분 원소의 함량을 간편하고 신속 정확하게 분석결과를 얻을 수 있다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1022-1024
• /
• 1995

In this study, $Pb(Zr_xTi_{1-x})O_3$(x=0.65, 0.52, 0.35) thin films were fabricated by Sol-Gel method. A stock solution with excess Pb 10[mol.%] of $Pb(Zr_xTi_{1-x})O_3$ was made and spin-coated on the Pt/$SiO_2$/Si substrate at 4000[rpm] for 30[sec.]. Coated specimens were dried on the hot-plate at $400[^{\circ}C]$ for 10[min.]. Sintering temperature and time were $500{\sim}800[^{\circ}C]$ and $1{\sim}60$[min.]. To investigate crystallization condition, PZT thin films were analyzed with sintering temperature, time and composition by the XRD. The microstructure of thin films were investigated by SEM. The ferroelectric perovskite phases precipitated under the sintering of $700[^{\circ}C]$ for 1 hour. In the PZT(52/48) composition, dielectric constant and dielectric loss were 2133, 2.2[%] at room temperature, respectively.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.609-612
• /
• 1998

Pyroelectric properties of rhombohedral $Pb(ZrxTi_1-x)O_3ceramics$ with various Zr/Ti ratios of 84/16, 87/13, 90/10, and 93/7 are investigated using dynamic method. The response characteristics of PZT samples are examined by considering frequency dispersion. Since the reorientation of the grain does not the influence on the increase of frequency at low frequency (2~200Hz), the maximum pyroelectric response can be obtained with the change of spontaneous polarization. However, the pyroelectric response of PZT samples could be reduced as the spontaneous polarization decreases due to the restrain of the reorientation of the grain with the increasing of requency at high frequency (200~2000Hz). We have obtained the good pyroelectric response in the PZT sample having 84/16 Zr/Ti ratio, then the pyroelectric coefficient (${\gamma}$) and the figure of merit (FV) were $17.3nC/\textrm{cm}^2K$ and 2.28$\times$10-11Ccm/J, respectively. The noise equivalent power (NEP), the detectivity (D*) were 1.21$\times$10-7W/Hz$\frac{1}{2}$ and 8.26$\times$106cmHz$\frac{1}{2}$/W, respectively.

• 한국전기전자재료학회논문지
• /
• 제11권5호
• /
• pp.394-399
• /
• 1998

High power characteristics with vibration velocity were studied in $Pb(Y_{2/3}W_{1/3})O_3-Pb(Zr,Ti)O_3$(PYW-PZT) ceramics by using the constant current method. Young s modulus $Y_0^E$ and mechanical quality factor $Q_m$ are a function of the square of effective vibration velocity \upsilon_0$. The nonlinear proportional constants of the above functions indicate the degree of stability under the vibration level change. The stability of PYW-PZT ceramics estimated by these constants coincides with the results obtained through the heat generation. It was found that $Q_m$ was markedly decreased with increasing the vibration velocity, accompanying a lot of heat generation. The vibration hysteresis and dielectric loss according to the vibration velocity was reduced by doping $Fe_2O_3$to the ceramics. On the contrary, these losses was increased by doping $Nb_2O_5$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 추계학술대회 논문집 Vol.15
• /
• pp.317-321
• /
• 2002

Piezoelectric properties of $(Pb_{1-x}Y_x)[(Ni_{1/3}Nb_{2/3})_{0.15}(Zr_{1/2}Ti_{1/2)})_{0.85}]O_{3}$ (x=0~0.05) ceramics were investigated, The stoichiometric PNN-PZT ceramics required the sintering temperature above $1100^{\circ}C$, but the addition of $Y_{2}O_{3}$ in the PNN-PZT ceramic lowered the sintering temperature down to $1000^{\circ}C$. In case of x=0.005, the electro-mechanical coupling $factor(K_p)$, the piezoelectric $constant(d_{33})$, and the maximum strain ratio of PNN-PZT ceramics sintered at $1000^{\circ}C$ were 53.1%, 395pC/N, and $2200{\times}10^{-6}$ respectively, A 30-layer piezoelectric actuator$(10{\times}10{\times}1.7mm)$ fabricated with the above material showed the maximum strain of $2.09{\mu}m$ under 100V DC bias.

• 한국세라믹학회지
• /
• 제42권10호
• /
• pp.685-690
• /
• 2005

Pb(Zr,Ti)$O_{3}$Pb($Mn_{1/3}$$Nb_{2/3}$)$O_{3}$ powder was successfully synthesised by high-energy milling method, and the behavior of low­temperature sintering and piezoelectrical properties of Pb(Zr,Ti)$O_{3}$-Pb($Mn_{1/3}$$Nb_{2/3}$)$O_{3}$ ceramics were investigated as a function of mechanical alloying time. In order to confirm whether the Perovskite phase in this composition was formed by mechanical activation technique or not, we performed X-Ray Diffraction pattern analysis (XRD). The microstructure for the sintered samples were characterized using a Scanning Electronic Microscope (SEM). And the piezoelectrical properties ($k_{p}$ and $Q_{m}$) of the sintered samples was measured using HP 4194A impedance analyzer.

• 대한화학회지
• /
• 제36권1호
• /
• pp.51-56
• /
• 1992

페로브스카이트구조를 갖는 $Pb(Zr_{1-y}Ti_y)O_3$ (PZT)계의 $Pb^{2+}$ 위치에 $Nd^{3+}$ 이온을 치환시키면서 그 결정구조와 결합특성을 X-선 회절분석법 및 적외선 분광광도법으로 알아보았으며, 이런 구조변화가 (Pb1-xNdx)(Zr1-yTiy)O3 (PNZT)계의 전기적 및 광학적 특성에 미치는 영향에 대하여 조사하였다. $Pb^{2+}$ 이온이 $Nd^{3+}$ 이온으로 치환될수록 정방성이 감소하며, 8${\sim}$12 mol% 치환되었을 때 입방정계의 구조이다. 결정내의 결합강도는 입방정게의 구조일 때 가장 강하고 높은 투광도를 나타냈으며, PNZT계 화합물이 투광도를 나타내는 것은 전자의 전하-이동 전이에 의한 것으로 생각된다.

• 한국세라믹학회지
• /
• 제42권5호
• /
• pp.314-318
• /
• 2005

The effect of reaction parameters in the characteristic of $Pb(Zr_{0.52}Ti_{0.48})O_3$ (below nominal PZT) powders by SHS was investigated in this study. In the preparation of PZT, the effect of starting material contents, pressure, additive on phase fraction and morphology was investigated respectively. The optimum condition of PZT powders were prepared by SHS is $0.37Pb_3O_4+0.52ZrO_2+0.48TiO_2+0.35KClO_3+0.5C,\;(P_{Ar}= 50 atm)$. The PZT powder synthesized in this condition had an spherical shape and the particle size of 0.8$\mu$m.

• Transactions on Electrical and Electronic Materials
• /
• 제7권6호
• /
• pp.279-282
• /
• 2006

[ $Pb(Zr_{0.4}Ti_{0.6}O_{3}\;and\;Pb(Zr_{0.6}Ti_{0.4})O_{3}$ ] paste were made and alternately screen-printed on the $Al_{2}O_{3}$ substrates. We have introduced a press-treatment to obtain a good densification of screen printed films. The porosity of the thick films was decreased with increasing the applied pressure and the thick films pressed at 60 MPa showed the dense microstructure and thickness of about $76\;{\mu}m$. The remanent polarization and coercive field increased with increasing applied pressure and the values for the PZT thick films pressed at 60 MPa were $17.04{\mu}C/cm^{2}$ and 78.09 kV/cm, respectively.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.307-307
• /
• 2007

압전액츄에이터 및 초음파진동자는 전자제품의 소형화 및 경량화, 의료기기, 모바일기기 및 소형로붓의 발전에 힘입어 그 활용범위가 넓게 확장되고 있다. 1960년 Smolenski등에 의해 $A(B_1,B_2)O_3$형 복합 페로브스카이트 구조를 갖는 강유전성 세라믹스에 대한 연구가 시작된 이래 $Pb(Co,Nb)O_3-Pb(Zr,Ti)O_3$, $Pb(Zn,Nb)O_3-Pb(Zr,Ti)O_3$, $Pb(Mg,Nb)O_3-Pb(Zr,Ti)O_3$ 등 3성분계 세라믹스의 유전, 압전 및 강유전 특성에 대한 많은 연구가 진행되어 왔다. 그러나 압전성이 우수한 세라믹스들은 Pb가 포함되어 있기 때문에 $1000^{\circ}C$ 이상에서 PbO가 급격하게 휘발되는 성질에 따라서 조성의 변동이 생겨 재현성이 어려우며 이를 방지하기 위하여 과잉 PbO를 첨가시키기 때문에 환경오염뿐만 아니라, 경제적인 측면에서도 많은 문제점을 가지고 있다. 소결조제를 이용한 산화물 첨가법은 PbO의 휘발을 억제하는 저온소결 방법중 가장 효과적인 방법으로 알려져 있다. 따라서, 본 연구에서는 적층형 압전액츄에이터로 사용하기위한 저온소결 압전세라믹스를 개발하기 위하여 PZN-PZT세라믹스에 $Li_2CO_3$, $Bi_2O_3$, CuO 를 소결조제로 사용하여 $Li_2CO_3$의 첨가량 변화에 따른 압전 및 유전 특성을 관찰하였다.