• Analytical Science and Technology
• /
• v.21 no.3
• /
• pp.183-190
• /
• 2008

PFOS (Perfluorooctane sulfonate) and PFOA (Perfluorooctanoic acid) are environmental hormones which belong to potential future persistent organic pollutants (POPs), and it is easy to exposure to human because they are used in a wide variety of consumer products. We studied exposure route and the relativity through determining and monitoring of PFOS and PFOA in Korean plasma of metropolis, small town, rural area and industrial area. And we monitored the concentration of PFOS and PFOA regarding the gender and age. The older age is, the higher concentration of PFOS is. The mean concentration of PFOS and PFOA in men (4.74 ng/mL, 2.20 ng/mL) was higher than that in women (3.53 ng/mL, 1.17 ng/mL). In the comparison of residential areas, the mean concentration of PFOS and PFOA was the lowest in metropolitan plasma (2.47 ng/mL, 0.79 ng/mL) whereas it was the highest in the industrial area (6.57 ng/mL, 2.19 ng/mL).

• Carbon letters
• /
• v.19
• /
• pp.72-78
• /
• 2016

Spinnable pitches and carbon fibers were successfully prepared from petroleum or coal pyrolysis residues. After pyrolysis fuel oil (PFO), slurry oil, and coal tar were simply filtered to eliminate the solid impurities, the characteristics of the raw materials were evaluated by elemental analysis, ¹³C nuclear magnetic resonance spectrometer, matrix-assisted laser desorption/ionization time-of-flight mass spectrometer (MALDI-TOF-MS), and so on. Spinnable pitches were prepared for melt-spinning carbon fiber through a simple distillation under strong nitrogen flow, and further vacuum distillation to obtain a high softening point. Carbon fibers were produced from the above pitches by single-hole melt spinning and additional heat treatment, for oxidization and carbonization. Even though spinnable pitches and carbon fibers were processed under the same conditions, the melt-spinning and properties of the carbon fiber were different depending on the raw materials. A fine carbon fiber could not be prepared from slurry oil, and the different diameter carbon fibers were produced from the PFO and coal tar pitch. These results seem to be closely correlated with the initial characteristics of the raw materials, under this simple processing condition.

• Journal of the Korean Applied Science and Technology
• /
• v.14 no.1
• /
• pp.77-87
• /
• 1997

PFO(pyrolized fuel oil) and $C_{10}^{+}$ oil, which are the residual heavy oils form a NCC(naphtha cracking center), were heat-treated to produce the precursor-pitch for carbon materials. After PFO was initially distilled near $300^{\circ}C$ to separate the volatile matters recovering as high-quality fuel oil, the residuum of nonvolatile precursor-pitch was then thermally pyrolized in the temperature ranges from $350^{\circ}C$ to $450^{\circ}C$. Spinnable isotropic pitch with the softening point of $200^{\circ}C$ and the toluene insolubles of 36wt% was obtained at $365^{\circ}C$, and then was successfully spun through a spinneret(0.5mm diameter). After spinning, an isotropic carbon fiber of $25{\mu}m$ diameter was obtained via oxidation and craboniation procedures. Mesophase spherules began to be observed from the product pitch pyrolized at $400^{\circ}C$, and bulk mesophase with a flow texture was observed above $420^{\circ}C$. In the case of $C_{10}^{+}$ was the feed was polymerized in the presence $H_2SO_4$ at room temperature to increase the molecular weight and then heat-treated gradually up to $200{\sim}250^{\circ}C$. The products obtained with the softening point of $80{\sim}190^{\circ}C$ were carbonized at 500 and $1000^{\circ}C$ to examine the morphology.

• Korean Journal of Food Science and Technology
• /
• v.48 no.6
• /
• pp.555-559
• /
• 2016

Perfluorinated compounds (PFCs) are linked to adverse effect on human healths, therefore, the aim of this study was to determine the levels of PFCs in prepared food. One hundred and fifty-one samples of six prepared food groups were purchased from retail food establishments in Korea. Twelve PFCs were detected in the sample, the accuracy ranged between 80.8-119.4% and precision ranged between 2.2-2.89% high and low concentrations in PFCs spiked samples. The detection frequency of perfluoro-pentanoic acid (PFPeA) was and perfluorooctanoic acid (PFOA) above the limit of detection, which was 84.1 and 82.8%, respectively, but positive detection frequency of perfluorooctanesulphonic acid (PFOS) was as shown as low as 29.1%. Residual PFOA levels in most of the samples were higher than the PFOS levels. The average concentration of total PFCs in the samples was $1.68{\pm}1.79ng/g$, and PFPeA and PFOA were the predominant PFCs.

• Journal of Food Hygiene and Safety
• /
• v.36 no.4
• /
• pp.310-315
• /
• 2021

This study was carried out to monitor the level of 17 perfluorinated compounds (PFCs) present in liquid milk products sold on the Korean market. The liquid milk samples were extracted via liquid-liquid extraction and analyzed by LC-MS/MS. Excellent linearity over the calibration range (r²>0.99), and the limit of quantification of perfluorooctane sulfonate (PFOS) was 0.021 ng/g, and perfluorotetradecanoic acid (PFOA) was 0.057 ng/g. The accuracy was in the range of 72.5-115.3%, and the precision was under 20%. The preprocessing method for this experiment is considered appropriate for analysis of milk samples. The proposed analytical method was applied for the determination of PFCs in 98 liquid milk product samples, and the average content of total PFCs was 0.6576 ng/mL. PFOA and PFOS were detected in most samples, and their levels were less than 0.1 ng/mL, which was lower than those in other studies.

• Applied Chemistry for Engineering
• /
• v.32 no.1
• /
• pp.42-48
• /
• 2021

In this study, a sensor for detection of nitric oxide (NO) gas was developed using petroleum pitch-based activated carbon which was synthesized from pyrolysis fuel oil (PFO). Polyethylene terephthalate (PET) was added to increase molecular weight by stimulating a polymerization of components in PFO during the pitch synthesis process. The increase in the molecular weight of pitch contributed to the improvement of textural properties of activated carbon, such as the specific surface area and micropore volume. It also enhanced the sensitivity of NO gas sensor based on the activated carbon. In addition, the effect of PET addition during the pitch synthesis on the surface oxygen content and conductivity of activated carbon was investigated. Finally, the correlation of the sensitivity with physical properties of activated carbon was analyzed.

• Korean Chemical Engineering Research
• /
• v.60 no.3
• /
• pp.439-445
• /
• 2022

In this study, Silicon and petroleum pitch were coated on the surface of Si/C fiber manufactured using electrospinning to improve the electrochemical performances. SiO₂/PAN fiber was prepared by electrospinning with TEOS and PAN at various ratios dissolved in DMF. The characteristics of carbonization, reduction, and pitch coating processes were investigated for the optimal process of the pitch coated Si/C fiber anode composite. Anode composite prepared with TEOS/PAN = 4/6 (CR-46) after carbonization and reduction process has a capacity of 657 mAh/g. To improve capacity and stability, Si powder and PFO pitch were coated at the surface of CR-46. When the pitch composition was fixed at 10 wt%, it was found that the capacity increased as the weight ratio of silicon increased, but the stability decreased. The pitch coated Si/C fiber composite with 10 wt% silicon has high capacity of 982.4 mAh/g and capacity retention of 86.1%. In the test to evaluate rate performance, the rate capability was 80.2% (5C/0.1C).

• Bulletin of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.1312-1316
• /
• 2014

Metal-carbon nanoreactors (MCNRs) were prepared from a pristine carbon cage (CC) using a simple and efficient template method with nano silica ball (NSB), pyrolysis fuel oil (PFO) and transition metals, such as palladium and gold. Metal nanoparticles were embedded in approximately 25 and 170 nm sized, highly ordered carbon cages. The newly developed Pd, Au and Au-Pd doped carbon nanoreactors were characterized by microanalysis, $N_2$ adsorption-desorption isotherm, powder X-ray diffraction (XRD), thermo-gravimetric analysis (TGA), scanning electron microscopy coupled with energy dispersive spectroscopy (SEM-EDS), transmission electron microscopy and inductively coupled plasma (ICP) analysis. The ordered MCNRs have exhibited dynamic hydrogen adsorption capability compared to the carbon cage.

• Korean Journal of Materials Research
• /
• v.28 no.3
• /
• pp.189-194
• /
• 2018

Porous graphites were synthesized by removing the template in HF after cabothermal conversion for 3 h at $900^{\circ}C$, accompanied by intercalations of pyrolyzed fuel oil (PFO) in the interlayer of Co or Ni loaded magadiite. The X-ray powder diffraction pattern of the porous graphites exhibited 00l reflections corresponding to a basal spacing of 0.7 nm. The particle morphology of the porous graphites was composed of carbon plates intergrown to form spherical nodules resembling rosettes like a magadiite template. TEM shows that the cross section of the porous graphites is composed of layers with very regular spaces. In particular, crystallization of the porous graphite was dependent on the content of Co or Ni loaded in the interlayer. The porous graphite had a surface area of $328-477m^2/g$. This indicates that metals such as Co and Ni act as catalysts that accelerate graphite formation.

• Journal of Chest Surgery
• /
• v.18 no.2
• /
• pp.283-287
• /
• 1985

Seven patients had undergone repair of endocardial cushion defect from Jan. 1977 to Dec. 1984 at National Medical Center. Most patients had no associated anomalies except one who had PFO, and mortality case was absent. Five patients had partial ECD and two had complete ECD [Rastelli type A]. In P-ECD patients, the atrial septal defect was closed with patch in all cases and mitral cleft was approximated with 2-3 direct stitches. In two cases of C-ECD, atrial and ventricular septal defect was closed with single patch in one case and atrial septal defect was closed with patch but ventricular septal defect was closed with patch but ventricular septal defect was closed it direct suture in the other case. Atrioventricular cleft was approximated with 2-3 direct sutures. Postop. transient A-V block was noted in 2 cases but returned to regular sinus rhythm after 2 to 6 months.