• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.634-637
• /
• 1999

The amorphous vanadium oxide as a cathode material is very preferable for fabricating high performance micro-battery. The amorphous vanadium oxide cathode is preferred over the crystalline form because three times more lithium ions can be inserted into the amorphous cathode, thus making a battery that has a higher capacity. The electrochemical properties of sputtered films are strongly dependent on the oxygen partial pressure in the sputtering gas. The effect of different oxygen partial pressure on the electrochemical properties of vanadium oxide thin films formed by r.f. reactive sputtering deposition were investigated. The stoichiometry of the as-deposited films were investigated by Auger electro spectroscopy. X-ray diffraction and atomic force microscopy measurements were carried out to investigate structural properties and surface morphology, respectively. For high oxygen partial pressure(>30% ), the films were polycrystalline V$_2$O$_{5}$ while an amorphous vanadium oxide was obtained at the lower oxygen partial pressure(< 15%). Half-cell tests were conducted to investigate the electrochemical properties of the vanadium oxide film cathode. The cell capacity was about 60 $\mu$ Ah/$\textrm{cm}^2$ m after 200 cycle when oxygen partial pressure was 20%. These results suggested that the capacity of the thin film battery based on vanadium oxide cathode was strongly depends on crystallinity.y.

• 한국세라믹학회지
• /
• 제50권4호
• /
• pp.288-293
• /
• 2013

Zn-In-Sn-O films were prepared at room temperature by combinatorial RF-magnetron co-sputtering system. The cationic contents of the films were varied using a compositionally combinatorial technique. The effects of the oxygen partial pressure and film compositionon the structural and electrical properties were investigated. The Zn-In-Sn-O films deposited at Ar gas atmosphere showed an amorphous phaseirrespective of the film composition. However, the amorphous Zn-In-Sn-O films with a Zn content below 30.0 at% were converted into a bixbyite type-ITO polycrystalline phase with an increase in the oxygen partial pressure. The resistivity, carrier concentration, and Hall mobility were strongly affected by the oxygen partial pressure and chemical composition of the film. At sufficiently high carrier densities above $5{\times}10^{18}cm^{-3}$, the conduction behavior of amorphous Zn-In-Sn-O film changes from thermally activated to degenerate band conduction accompanied with high mobility.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2008년도 추계학술대회 초록집
• /
• pp.101-101
• /
• 2008

The effect of oxygen partial pressure on the surface tension data of liquid alloys was investigated by means of comparing the calculated data and the measured one. Two binary alloy systems were chosen to observe the dependence of oxygen adsorption behavior on different oxygen partial pressures. It was found that the difference between the computed values and the experimental of the surface tension was within the range of maximum 10%.

• 한국세라믹학회지
• /
• 제34권6호
• /
• pp.561-568
• /
• 1997

The effects of sintering temperature and oxygen partial pressure on the electromagnetic properties of Mn-Zn ferrites were investigated. The grain increased with increasing temperature. The power loss at 100 kHz was decreased, while the power loss at 500 kHz was increased as the grain size increased with sintering temperature. Sintering with low oxygen partial pressure at 115$0^{\circ}C$ resulted in high density and initial permeability, and decreased the power loss at 100 kHz and 500 kHz. The oxygen partial pressure lower than 10-2 atm. during heating, significantly suppressed the hysteresis loss. However, the oxygen activity did not affect the grain size of sintered cores.

• 한국결정성장학회지
• /
• 제6권3호
• /
• pp.406-414
• /
• 1996

본 연구에서는 금속타겟을 이용한 반응성 스퍼터링법을 이용하여 PZT 박막 증착후 냉각시 산소분압에 따른 박막의 상형성 거동 및 전기적 특성에 미치는 영향을 고찰하였다. 냉각시 산소분압의 감소에 따라 박막 표면의 휘발에 기인하여 표면거칠기는 증가하였고 입성장은 거의 일어나지 않았다. 산소분압이 증가할수록 각형비가 보다 우수한 hysteresis 특성을 얻을 수 있었고 산소분압이 감소함에 따라 remanent polarization과 retained polarization이 감소하였으며, 항전계의 감소가 관찰되었다. 산소분압에 따른 유전율-전압 특성 측정에서 산소분입이 감소함에 따라 internal bias field의 증가가 관찰되었으며, 유전율도 조금씩 감소하였다. Field accelerated retention 시험결과 냉각시 산소분압이 감소함에 따라 nonswitched polarization의 증가가 관찰되었고 bias time이 증가함에 따라 nonswitched polarization이 감소하였다.

• 한국진공학회지
• /
• 제17권3호
• /
• pp.204-210
• /
• 2008

산소분압비에 따른 ZnO 박막의 성장특성을 알아보기 위해 RF 스퍼터링 시스템을 이용하여 $0%{\sim}30%$의 산소분압비로 박막을 제작하였다. 위상변조방식의 분광타원계를 이용하여 $1.5{\sim}3.8eV$ 범위에 걸쳐 타원상수를 측정하였고, TL 분산관계식을 이용하여 최적맞춤한 결과 박막과 표면기칠기층의 두께, void 비율을 알 수 있었고, ZnO 알갱이의 크기는 산소분압비의 증가에 따라 그 크기가 작아짐을 알 수 있었다. 산소분압비에 따른 ZnO 박막의 밴드 갭은 산소유입량의 증가에 따라 증가하여 ZnO 박막의 광흡수 특성이 산소분압비에 크게 의존함을 알았고, 산소분압비의 증가는 결정의 불완전성을 증가시키는 것으로 나타났다.

• Transactions on Electrical and Electronic Materials
• /
• 제3권2호
• /
• pp.24-27
• /
• 2002

The NdBaCuO superconductor samples were zone-melted in low oxygen partial pressure (1%O$_2$+99%Ar). The zone-melting temperature was decreased about 12$0^{\circ}C$ film 1,06$0^{\circ}C$, the zone-melting temperature in air. Thus the loss of liquid phase (BaCuO$_2$ and CuO) was reduced during: the zone-melting process. The content of non-superconducting phase Nd422 in zone-melted NdBaCuO samples was clearly decreased and, therefore, the substitution of Nd for Ba was occurred. The superconductivity of zone-melted Nd$_{1+x}$Ba$_{2-x}$Cu$_3$O$_{y}$ prepared under low oxygen partial pressure was distinctively improved.d.d.d.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.85-88
• /
• 2001

The NdBaCuO superconductor samples were Zone-melted in low oxygen partial pressure (1% $O_{2}+ 99% Ar$ ). The Zone-melting temperature was decreased about $120^{\circ}C$ from $1060^{\circ}C$ the zone-melting temperature in air. Thus the loss of liquid phase ($BaCuO_{2}$ and CuO) was reduced during the zone-melting process. The content of non-superconducting phase Nd422 in zone-melted NdBaCuO samples was clearly decreased, so was the substitution of Nd for Ba. The superconductivity of zone-melted $Nd_{1+x}Ba_{2-x}Cu_{3}O_{y}$ prepared under low oxygen partial pressure was distinctively improved.

• 한국세라믹학회지
• /
• 제36권12호
• /
• pp.1335-1341
• /
• 1999

The electrical conductivity ($\sigma$) of TiO2 doped with 0.05-4.0mol% Nb2O5 was measured in the oxygen partial pressure range of 10-17 to 100 atm and temperature range of 1100 to 130$0^{\circ}C$ to investigate the electrical properties and defect types. The oxygen partial pressure dependence of the electrical conductivity (log$\sigma$/logPo2) above 110$0^{\circ}C$ was divided into the four regions. From these experimental results the following defect regions were proposed ; 1) Magneli phase(extended defect) 2) reduced rutile region where intrinsic defect predominates 3) nearly stoichiometric region which is independent on the oxygen partical pressure and 4) overstoichiometric region which is not observed in pure TiO2 The electrical conductivity of Nb-doped TiO2 depended on the doping content the oxygen partial pressure and the measuring tem-perature.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.85-88
• /
• 2001

The NdBaCuO superconductor samples were Zone-melted in low oxygen partial pressure (1% O$_2$+99% Ar). The Zone-melting temperature was decreased about 120$^{\circ}C$ from 1060$^{\circ}C$ the zone-melting temperature in air. Thus the loss of liquid phase (BaCuO$_2$ and CuO) was reduced during the zone-melting process. The content of non-superconducting phase Nd422 in zone-melted NdBaCuO samples was clearly decreased, so was the substitution of Nd for Ba. The superconductivity of zone-melted Nd$\sub$1+x/Ba$\sub$2-x/Cu$_3$O$\sub$y/ prepared under low oxygen partial pressure was distinctively improved.