• Korean Journal of Construction Engineering and Management
• /
• v.10 no.6
• /
• pp.40-47
• /
• 2009

The lightweight bubble mixture soil is used for soft ground rear-filling material by applying reduced weight on structure. However, comparing with the general soil, it is not applied in domestic because of initial phase cost of construction. General soil, which has lower initial phase cost is usually used for rear-filling, but the use of overlay method of general soil is reduced as the number of layers increases. Especially box structure placed in soft ground or the overlay method when gap near pier rear-filling can be replaced with temporary alternative method, however, it can't be a solution to gap by generation of extra weight of thickness of overlaying. Therefore, execute LCC analysis of two alternative-the general and the lightweight bubble mixture soils, which are rear-filling material of box structure- and present economical analysis in order to make resonable decision from the economics. As a result, although the lightweight bubble mixture soil takes higher initial phase cost than the general soil, it has been analyzed to procure economical efficiency by having less cost of maintenance.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.2
• /
• pp.67-74
• /
• 2008

Many industrialized countries of the world have many problems about the reuse of waste landfill area because of the increase of terminated waste disposal landfill. Especially, the effective use of the terminated waste disposal landfill nearby the urban area has been demanded, because of the lack of the usable land. However, in case of the construction of the building on such a landfill, ground settlement and reduced bearing capacity would be occurred without ground stabilization and proper reinforcement. This study is to evaluate the applicability of geosynthetics for the increment of bearing capacity of solid waste landfill ground. A numerical simulation has been undertaken to model a layer of weathered soil overlaying a layer of geosynthetic reinforcement and waste disposal ground. The proposed analytical model can be used to obtain surface settlement characteristic in the two-dimensional deformation related reinforcement.

• Journal of the Korean Society of Safety
• /
• v.27 no.6
• /
• pp.172-177
• /
• 2012

In areas around Deoksan Li and Deokjeon Li, Inje Eup, Inje Gun, located between $38^{\circ}2^{\prime}55^{{\prime}{\prime}}N$ and $38^{\circ}5^{\prime}50^{{\prime}{\prime}}N$ in latitude and $128^{\circ}11^{\prime}20^{{\prime}{\prime}}E$ and $128^{\circ}18^{\prime}20^{{\prime}{\prime}}E$ in longitude, large-sized avalanche disasters occurred due to Typhoon Ewiniar in 2006. As a result, 29 people were dead or missing, along with a total of 37.25 billion won of financial loss(Gangwon Province, 2006). To evaluate such landslide and debris flow risk areas and their vulnerability, this study applied a technique called 'Weight of Evidence' based on GIS. Especially based on the overlay analysis of aerial images before the occurrence of landslides and debris flows in 2005 and after 2006, this study extracted 475 damage-occurrence areas in a shape of point, and established a DB by using such factors as topography, hydrologic, soil and forest physiognomy through GIS. For the prediction diagram of debris flow and landslide risk areas, this study calculated W+ and W-, the weighted values of each factor of Weight Evidence, while overlaying the weighted values of factors. Besides, the diagram showed about 76% in prediction accuracy, and it was also found to have a relatively high correlationship with the areas where such natural disasters actually occurred.

• Journal of the Korean association of regional geographers
• /
• v.4 no.2
• /
• pp.139-150
• /
• 1998

Recently in connection with the development of network technology, GIS researches shift their focuses to openGIS which enables to share heterogeneous geodata and geoprocessing resource under the environment of LAN and WAN. This study proposes an easy method to develope GUIs which enables openGIS in the intranet environment. In the developing stage of GUI, the most important thing is to develop effective windows programming technique and apply a internet linking technique to developed GUIs. This study shows an internet linking technique and a GUI developing method using OLE automation and ActiveX/COM standards. Using a case study of Taegu City Library, the study constructs a GIS database and develops its GUI which performs map overlaying, referencing attribute tables, drawing up of thematic map, buffer analysis, and statistical calculations. This study remains same further research areas of developing a new advanced technique for openGIS and its GUI using distributed object model of CORBA, Java language, and JDBC data accessing technique.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.15 no.3
• /
• pp.25-34
• /
• 2001

In this paper, discharge lamp ozonizer(DLO) of a new discharge type using superposition of gaseous electrical discharge for environment improvement was designed and manufactured. DLO is equipped with 3 electrodes(central ground electrode of discharge lamp type internal high voltage electrode of mesh type and external high voltage electrode of spiral type), and it is composed of double gap(gap between discharge lamp and internal electrode, gap between discharge lamp and external electrode). Internal and external electrodes are respectively applied AC high voltage which has 180[$^{\circ}$] phase difference. Ozone is generated by overlaying of each silent discharge which is respectively came from two gaps. At the moment discharge characteristics and ozone generation characteristics of DLO were investigated in accordance with quantity of supplied gas, discharge power and the number of DLO. When ozone generated by DLO was in contact with NO gas, removal characteristics was excellent, so it confirmed that DLO could be used as air environment improvement facility.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.450-450
• /
• 2006

Organic light-emitting diodes (OLED) as pixels for flat panel displays are being actively pursued because of their relatively simple structure, high brightness, and self-emitting nature [1, 2]. The top-emitting diode structure is preferred because of their geometrical advantage allowing high pixel resolution [3]. To enhance the performance of TOLEDs, it is important to deposit transparent top cathode films, such as transparent conducting oxides (TCOs), which have high transparency as well as low resistance. In this work, we report on investigation of the characteristics of an indium tin oxide (ITO) cathode electrode, which was deposited on organic films by using a radio-frequency magnetron sputtering method, for use in top-emitting organic light emitting diodes (TOLED). The cathode electrode composed of a very thin layer of Mg-Ag and an overlaying ITO film. The Mg-Ag reduces the contact resistivity and plasma damage to the underlying organic layer during the ITO sputtering process. Transfer length method (TLM) patterns were defined by the standard shadow mask for measuring specific contact resistances. The spacing between the TLM pads varied from 30 to $75\;{\mu}m$. The electrical properties of ITO as a function of the deposition and annealing conditions were investigated. The surface roughness as a function of the plasma conditions was determined by Atomic Force Microscopes (AFM).

• Journal of Wetlands Research
• /
• v.12 no.1
• /
• pp.83-94
• /
• 2010

Purpose of this study is to define the wise use of Nakdong River estuary based on the expert's survey aiming to identify the core conservation area, the buffering area and the transition area of the estuary. The boundary of the each area is determined by overlaying the expert's opinion of the conservation area, the Biotop conservation value evaluation carried out by Busan Metropolitan city and the designated legal boundary of conservation such as Cultural Reserve area and Wetland Reserve area. Then the concept for wise use of the core preservation area, the buffering area and the transition area is set by the discussion, brainstorming and several workshops. We believe this research leads the sustainable development in the area of the Nakdong River estuary and helps to minimize the conflict among the stakeholders.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.17 no.3
• /
• pp.233-243
• /
• 1999

In this study, sample sites are chosen where digitalized cadastral maps are available, and boundaries of forestry, farming lands, and residence are clearly distinguishable. Digital orthophotos, produced from aerial photographs, are overlaid with digitalized cadastral maps to grope for applications of digital orthophoto in cadastre. The conclusions and applicable fields of this study are as follows. The first. digital orthophoto is applicable to solve problems such as discordance and duplication of boundary produced in the process of digitizing cadastral maps. The second, using digital orthophoto, it is possible to extract regions where a trouble of ownership would exist and so the necessity of cadastral resurveying can be brought. The third, by overlaying digital orthophoto and cadastral map, it can be used effectively for the present situation maintenance of buildings. The fourth, because it is possible to examine current land use of each lot, digital orthophoto may contribute to decide the validity of land category on cadastral map.

• Journal of Korean Society of Forest Science
• /
• v.78 no.2
• /
• pp.168-176
• /
• 1989

Recent development of geographic information systems(GIS) provides a great deal of potential in handling a variety of spatial data required by forest resource managers. This study is designed to identify a possible GIS application in forest pest management. Several mountain pine beetle risk assessment parameters(stand characteristics, weather conditions, and topographic factor) were spatially analyzed through computer map overlaying operations in order to estimate the hazard level of the pest damage. In addition, the expected infestation route from an initially infected forest stand was located through further may analysis operations(distance measurement and connectivity analysis). Although current GIS technology may have a few limitations in operational situations, the computer based GIS has been proven as an invaluable tool to resource managers by providing flexible spatial data handing capabilities.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.38 no.4
• /
• pp.337-342
• /
• 2018

This study was conducted to perform the suitability analysis of whole-crop rye (Secale cereale L.) based on the climatic information in the Republic of Korea to present useful information for producers and policy makers to determine the site-selection for the cultivation of the whole-crop rye. The criteria to analyze the climatic suitability of whole-crop rye was developed firstly. Then, the climatic suitability map for spatial analysis was developed through weighted overlaying the raster layers of climatic items in the evaluation criteria. Meanwhile, 16 geographically representative weather stations were selected to show examples of the calculation process of the climatic suitability score of a specific cultivation area. The results of the climatic suitability mapping indicated that the climatic conditions in most arable lands of the Republic of Korea such as the coastal, southern, western areas in the southern region of the Korean Peninsula and central areas in Jeju Island are suitable for the cultivation of whole-crop rye. The climatic suitability scores of the 16 weather stations were all in line with the results of the climatic suitability map.