• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.5
• /
• pp.273-278
• /
• 2004

This paper analyzed the phase noise characteristics of frequency-shifting module by figuring out the relationship between the phase noise components of 1st and 2nd local oscillator composing the frequency-shifting module and those of RF output signals shifted in frequency. Also, frequency-shifting module with the improvement of the phase noise performance was designed and implemented by means that the phase noise components of 1st local oscillator were cancelled in the output signal. Output signal has been affected by only phase noise of 2nd local oscillator, which had excellent phase noise performance than that of the 1st local oscillator.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.30 no.1
• /
• pp.25-32
• /
• 1994

An underwater speaker was made of a moving coil driver unite of usual speaker, acryl-boards, polyester resin, rubber and castor oil and it's frequency characteristics was measured in range of 250~600Hz in air water tank and sea. The results of measurements are follows: 1. Transmitting and receiving frequency of measurement frequency were similar in air, water tank and sea. 2. The input and output wave forms of a manufactured speaker which is not water-proof in air were similar to each other in 300~450Hz, but other frequencies showed distorted wave forms. 3. The input and output wave forms of an underwater speaker in water thank and sea were similar to each other in 250~600Hz. But output wave forms showed combination waves with very low frequency. 4. Transmitting and receiving frequency wave forms and resisting pressure of an underwater speaker at 80m in the depth of water were in good condition. Therefore it can be possible to use it as an underwater speaker.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.58 no.4
• /
• pp.588-591
• /
• 2009

We had experimental studies of microwave output generator. We experimented with a corrugate-shped K-band slow wave guide in the backward wave oscillator. It generated output 표 interaction between electron beam's generation and magnetic field. We estimated oscillation frequency at 24GHz by changing propagation velocity and group velocity. We identified movement by second harmonic of Cherencov interaction and slow cyclotron mode. In our study we achieved oscillation stabilization, generation of long pulse, improvement of oscillation efficiency and output.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.15 no.6
• /
• pp.87-90
• /
• 1978

In previous VFC type A/D converter high linearity charateristics knave been achieved to several hundred kHz, and in the converter with maximum output frequency of several MHz, the conversion linearity is poor in upper frequency range. In this paper the problem of the extension of the output frequency to MHz range is studied in the following two view points: First, a tunnel diode VCO is used to increase the output frequency range to several MHz. Second, the linearity between the input voltage and the frequency of the output pulse is accomplished by using negative pulse feedback circuit. From the experimental results, it was followed that the linearity of the proposed converter was about 0.209 percent at the frequency of 3.7MHz.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.38 no.1
• /
• pp.53-60
• /
• 2001

In many applications of power electronics, high frequency resonant inverters are used, and the PAM(Pulse Amplitude Modulation), PFM(Pulse Frequency Modulation) or PWM(Pulse Width Modulation) techniques are used to control the output power of resonant inverters. And the resonant inverters have to control the output frequency for the reliable operation under the variable load conditions. In this paper, a new switching scheme is proposed as a PWM control of resonant inverters. With the proposed method, it can be obtained that optimum resonant frequency and unity output displacement factor under the variable resonant frequency adaptively. The detail algorithm or the proposed PWM switching scheme and its output characteristics are discussed. And the veridity of the proposed method is confirmed with the experimental results.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.6
• /
• pp.949-954
• /
• 2017

Multiple input, multiple output orthogonal frequency division multiplexing (MIMO OFDM) systems are the candidate for the future wireless communications. However, the main drawback of MIMO OFDM systems is their sensitivity to carrier frequency offset (CFO) similar to the single input, single output OFDM (SISO OFDM) systems. The demodulation of a signal with CFO causes large bit error rate and degrade the performance of a symbol synchronizer. It is important to estimate the frequency offset and minimize or eliminate its impact. In this paper, we propose a technique based on observation training symbols for estimating CFO by employing block-by-block estimation for SISO OFDM systems. The technique of SISO OFDM is extended to the MIMO OFDM systems. Simulation results show that the proposed techniques have a superior performance and better accuracy compared to the conventional techniques in the sense of mean square error.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.841-844
• /
• 2005

Multi-output VC-TCXO (Voltage Controlled-Temperature Compensated Crystal Oscillator) for WCDMA has integrated the additional CMOS inverter, so it can be normal clipped sinewave output and additional CMOS output and it can be satisfied the VC-TCXO Characteristics that WCDMA system required. In this paper, however 26MHz is used for reference frequency, similarly and practically, it is usable from 10MHz to 40MHz, Most important factor to integrate CMOS inverter internally is the isolation between normal output and additional output. For this, it is separated in package design, due to this, when it isn't used additional output, it shows the same electrical performance, when it is used additional output, it has minimum-rized the interference. and then the important characteristics in reference oscillator are met to WCDMA system's requirements, like phase noise and frequency short term stability.

• Journal of Power Electronics
• /
• v.9 no.2
• /
• pp.320-333
• /
• 2009

A Photovoltaic (PV) system's power output varies with the change of climate. Frequency deviations, tie line voltage swings are caused by the varying PV power when large PV power from several PV systems is fed in the utility. In this paper, to overcome these problems, a simple coordinated control method for smoothing the variations of combined PV power from multiple PV systems is proposed. Here, output power command is formed in two steps: central and local. Fuzzy control is used to produce the central smoothing output power command considering insolation, variance of insolation and absolute average of frequency deviation. In local step, a simple coordination is kept between the central power command and the local power commands by producing a common tuning factor. Power converters are used to achieve the same output power as local command power employing PI control law for each of the PV generation systems. The proposed method is compared with the method where conventional Maximum Power Point Tracking (MPPT) control is used for each of the PV systems. Simulation results show that the proposed method is effective for smoothing the output power variations and feasible to reduce the frequency deviations of the power utility.

• Journal of the Korean Magnetics Society
• /
• v.19 no.1
• /
• pp.17-21
• /
• 2009

In this study, we have investigated that the excitation current and operation frequency dependences of the output properties of the orthogonal fluxgate sensor which was fabricated with a Co base amorphous wire and a pick-up coil. The output signal increased linearly with increase of the excitation current below 0.3 A, and decreased with increase of the excitation current over 0.6 A. It was also found that the output increased sensitively with increase of operation frequency below 1.3MHz. The output was 3.8 V at the frequency of 1.3MHz while 1.32 V at 1MHz.

• Journal of information and communication convergence engineering
• /
• v.8 no.2
• /
• pp.197-200
• /
• 2010

The FLL(frequency locked loop) circuit is used to generate an output signal that tracks an input reference signal. The locking time of FLL is short compared to PLL(phase locked loop) circuit because the output signal of FLL is synchronized only in frequency. Also the FLL is designed to allow the circuit to be fully integrated. In this paper, the temperature stable FLL circuit is designed by using full CMOS transistors. When the temperature is varied from $-20^{\circ}C$ to $70^{\circ}C$, the variation of output frequency is about from -2% to 1.6% from HSPICE simulation results.