• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제50권4호
• /
• pp.161-168
• /
• 2001

Organic thin film transitors(TFTs) are of interest for use in broad area electronic applications. For example, in active matrix liquid crystal displays(AMLCDs), organic TFTs would allow the use of inexpensive, light-weight, flexible, and mechanically rugged plastic substrates as an alternative to the glass substrates needed for commonly used hydrogenated amorphous silicon(a-Si:H). Recently pentacene TFTs with carrier field effect, mobility as large as 2 $cm^2V^{-1}s^{-1}$ have been reported for TFTs fabricated on silicon substrates, and it is higher than that of a-Si:H. But these TFTs are fabricated on silicon wafer and $SiO_2$ was used as a gate insulator. $SiO_2$ deposition process requires a high insulator which is polyimide and photo acryl. We investigated trasfer and output characteristics of the thin film transistors having active layer of pentacene. We calculated field effect mobility and on/off ratio from transfer characteristics of pentacene thin film transistor, and measured IR absorption spectrum of polymide used as the gate dielectric layer. It was found that using the photo acryl as a gate insulator, threshold voltage decreased from -12.5 V to -7 V, field effect mobility increased from 0.012 $cm^2V^{-1}s^{-1}$ to 0.039 $cm^2V^{-1}s^{-1}$ , and on/off current ratio increased from $10^5\;to\;10^6$. It seems that TFTs using photo acryl gate insulator is apt to form channel than TFTs using polyimide gate insulator.

• Macromolecular Research
• /
• 제10권2호
• /
• pp.75-79
• /
• 2002

Organic materials have considerable attention as active semiconductors for device applications such as thin-film transistors (TFTs) and diodes. Pentacene is a p-type organic semiconducting material investigated for TFTs. In this paper, we reported the morphological and electrical characteristics of pentacene TFT films. The pentacene transistors showed the mobility of 0.8 $\textrm{cm}^2$/Vs and the grains larger than 1 ${\mu}{\textrm}{m}$. Deep-level transient spectroscopy (DLTS) measurements were carried out on metal/insulator/organic semiconductor structure devices that had a depletion region at the insulator/organic-semiconductor interface. The duration of the capacitance transient in DLTS signals was several ten of seconds in the pentacene, which was longer than that of inorganic semiconductors such as Si. Based on the DLTS characteristics, the energy levels of hole and electron traps for the pentacene films were approximately 0.24, 1.08, and 0.31 eV above Ev, and 0.69 eV below Ec.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2005년도 International Meeting on Information Displayvol.II
• /
• pp.1313-1316
• /
• 2005

In the present paper, it was investigated that adhesion layer on gate insulator could affect the electrical characteristics for the organic thin film transistors (OTFTs). The polyimide (PI) as organic adhesion layer was fabricated by using the vapor deposition polymerization (VDP) processing . It was found that electrical characteristics improved comparing OTFTs using adhesion layer to another. We researched adhesion layer as a function of thickness. For inverted-staggered top contact structure, field effect mobility, threshold voltage, and on-off current ratio of OTFTs using adhesion layer of PI 15 nm thickness on the gate insulator with a thickness of 0.2 ${\mu}m$ were about 0.5 $cm^2/Vs$, -0.8 V, and $10^6$, respectively.

• Journal of Information Display
• /
• 제4권2호
• /
• pp.1-6
• /
• 2003

In this paper, we demonstrate that the organic electrophosphorescent device is driven by the organic thin film transistor with spin-coated photoacryl gate insulator. It was found that electrical output characteristics in our organic thin film transistors using the staggered-inverted top-contact structure showed the non-saturated slope in the saturation region and the sub-threshold nonlinearity in the triode region, where we obtained the maximum power luminance that was about 90 $cd/m^2$. Field effect mobility, threshold voltage, and on-off current ratio in 0.45 ${\mu}m$ thick gate dielectric layer were 0.17 $cm^2/Vs$, -7 V, and $10^6$ , respectively. In order to form polyimide as a gate insulator, vapor deposition polymerization process was also introduced instead of spin-coating process, where polyimide film was co-deposited by high-vacuum thermal evaporation from 4,4'-oxydiphthalic anhydride (ODPA) and 4,4'-oxydianiline (ODA) and cured at 150${\sqsubset}$for 1hr. It was also found that field effect mobility, threshold voltage, on-off current ratio, and sub-threshold slope with 0.45 ${\mu}m$ thick gate dielectric films were 0.134 $cm^2/Vs$, -7 V, and $10^6$ A/A, and 1 V/decade, respectively.

• 마이크로전자및패키징학회지
• /
• 제12권4호통권37호
• /
• pp.359-363
• /
• 2005

유기 박막트랜지스터 (OTFT)를 제작하기 위하여 게이트 절연막으로서 PVP 계통의 유기막을 갖는 MIM(metal-insulator-metal)구조의 유기 절연층 소자를 제작하였다. 유기 절연층의 형은 ITO/Glass 기판위에 polyvinyl 계열의 PVP(poly-4-vinylphenol)를 용질로, PGMEA (propylene glycol monomethyl ether acetate)를 용매로 사용하여 co-polymer PVP를 제조하였다. 또한 열경화성 수지인 poly(melamine-co-formaldehyde)를 경화제로 사용하여 cross-linked PVP 절연막을 합성하였다. 유기 절연층의 전기적 특성은 co-polymer PVP 소자에 비해 cross-link 방식으로 제조된 소자에서 약 300 pA의 낮은 누설전류와 상대적으로 낮은 잡음전류의 특성을 나타내었다. 또한 cross-linked PVP 절연막에서 보다 양호한 표면형상 (거칠기)이 관찰되었으며 정전용량 값은 약 0.11${\~}$0.18 nF의 값을 나타내었다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1315-1318
• /
• 2007

Hafnium dioxide nano film as gate insulator for organic thin film transistors is prepared by atomic layer deposition. Mostly crystalline of $HfO_2$ films can be obtained with oxygen plasma and with water at relatively low temperature of $150^{\circ}C$. $HfO_2$ was deposited as a uniform rate $1.2A^{\circ}/cycle$. The morphology and performances of OTFT will be discussed.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2004년도 Asia Display / IMID 04
• /
• pp.661-664
• /
• 2004

In this paper, it was demonstrated that the organic thin film transistors with the organic gate insulators were fabricated by vapor deposition polymerization (VDP) processing. The configuration of OTFTs was a staggered-inverted top-contact structure and gate dielectric layer was deposited with 0.45 ${\mu}m$ thickness. In order to form polyimide as a gate insulator, VDP process was also introduced instead of spin-coating process. Polyimide film was respectively co-deposited with different materials. One was from a 4,4'-oxydiphthalic anhydride (ODPA) and 4, 4'-oxydianiline (ODA) and the other was from 2,2-bis(3,4-dicarboxyphenyl) hexafluoropropane dianhydride (6FDA) and ODA. And it was also cured at 150 $^{\circ}C$ for 1 hour followed by 200 $^{\circ}C$ for 1 hour. Electrical characteristics of the organic thin-film transistors were detailed comparisons between the ODPA-ODA and the 6FDA-ODA which were used as gate insulator.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1220-1224
• /
• 2007

The effects of plasma damages to the organic thin film transistor (OTFT) during the fabrication process are investigated; metal deposition process on the organic gate insulator by plasma sputtering mainly generates the process induced damages of bottom contact structured OTFTs. For this study, various deposition methods (thermal evaporation, plasma sputtering, and neutral beam based sputtering) and metals (gold and Indium-Tin Oxide) have been tested for their damage effects onto the Poly 4-vinylphenol(PVP) layer surface as an organic gate insulator. The surface damages are estimated by measuring surface energies and grain shapes of organic semiconductor on the gate insulator. Unlike thermal evaporation and neutral beam based sputtering, conventional plasma sputtering process induces serious damages onto the organic surface as increasing surface energy, decreasing grain sizes, and degrading TFT performance.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2009년도 9th International Meeting on Information Display
• /
• pp.566-567
• /
• 2009

We have examined the silicon nitride ($SiN_x$) as gate insulator with the ammonia ($NH_3$) plamsa treatment for the soluble derivatives of polythiophene as p-type channel materials of organic thin film transistors (OTFTs). Fabrications of the jetting-processed OTFTs with $SiN_x$ as gate insulator by $NH_3$ plasma treatment can be similar to performance of OTFTs with silicon dioxide ($SiO_2$) insulator.

• 한국진공학회지
• /
• 제13권3호
• /
• pp.99-102
• /
• 2004

유기 절연층을 사용한 유기 박막 트랜지스터의 특성 향상을 위해 절연층 표면에 Ar플라즈마 처리를 하였다. 플라즈마 처리는 절연체 표면의 화학적, 물리적 특성 변화를 통해 그 후에 이어지는 활성층 성막시 분자들의 결정성을 향상시키기 위한 방법이다. 활성층으로 사용된 물질은 pentacene이며, 절연층으로 사용된 물질은 PVP(poly-vinyl-phenol)이다. Pentacene는 약 $10^{-6}$ Torr에서 0.5 $\AA$/sec의 속도로, PVP는 spin coating법에 의해 각각 성막되었다. 형성된 절연층을 일정 시간동안 H플라즈마 처리 한 후 각 소자의 전기적 특성을 측정하여 표면처리에 의한 특성 변화를 살펴보았다.