• Journal of the Korea Organic Resources Recycling Association
• /
• v.7 no.2
• /
• pp.83-92
• /
• 1999

Chitosan was prepared from chitin which was abstracted from wasted crab shells. Then itaconic acid was graft-copolymerized onto chitosan using ceric ammonium nitrate as a reaction initiator. To investigate the optimal grafting conditions, the influences of several factors on the grafting were studied, i. e., the concentrations of CAN and itaconic acid, the reaction temperature and time. And to find out its flocculation ability. the flocculation test was carried out with a metal plating factory waste water. The state of graft-copolymer was identified through IR spectra analysis. The optimal grafting conditions and flocculation results were shown to be : concentration of ceric ammonium nitrate is $3.5{\times}10^3M$, reaction temperature is $40^{\circ}C$ and reaction time is 4hrs with 0.25M of the monomer(itaconic acid). Though flocculation tests using chitosan, grafted chitosan and cation, CODcr. metal ions removal rates were measured. The order of superiority is Itaconic acid grafted chitosan>Chitosan>Cationic polymer.

• Environmental Analysis Health and Toxicology
• /
• v.5 no.3_4
• /
• pp.19-28
• /
• 1990

Nitroarenes are ubiquitous environmental pollutants displaying potent mutagenicity in bacteria and carcinogenicity in mammal. In this study, the concentration of nitroarenes in coarse and fine particles and mutagenicity of POC$\_$N/ fraction was investigated in suspended particulates at the Shinchon and Bulkwang area of Seoul. The suspended particulates were collected bimonthly by a high volume cascade impactor air sampler from July 1987 to May 1988. Extractable organic matter was obtained by ultrasonic extraction on diethly ether/cyclohexane (8/2, v/v). Neutral fraction was obtained by liquid-liquid extraction. Polar neutral organic compounds (POC$\_$N/) was fractionated by thin-layer chromatography. Finally, the concentrations of nitroarenes in POC$\_$N/ fraction were measured and determined by capillary gas chromatography. Direct and indirect mutagenicity of POC$\_$N/ fraction were measured using Salmonella typhimurium TA 98. The result were as follows: 1) Major nitroarenes at the Shinchon area was 1-nitropyrene and at the Bulkwang area it was 2,7-dinitro-9-fluorenone during the year. 2) Average concentration of total nitroarenes measured was 67.26 ng/m$^3$in fine particles which was 1,3 folds higher that in coarse particle (52.30 ng/m$^3$). 3) Annual pattern of nitroarenes concentrations revealed that concentration during heating season (Feb., Jan., Mar.) was 2.2 folds higher than that in non heating season (May, Jul., Sep.). Concentration of each season has 157.68 ng/m$^3$and 80.39 ng/m$^3$. 4) The mutagenic activity of POC$\_$N/ fraction from fine particles was higher compared to that of coarse particles and was increased when metabolically activated, with 59 mixture. Mutagenicities, Metabolically activated, were significantly different between Shinchon and Bulkwang area, 322.8 rev/250 $\mu\textrm{g}$/plate and 286.8 rev/250 $\mu\textrm{g}$/plate, respectively. 5) Annual pattern of mutagenicity of POC$\_$N/ fraction revealed that mutagenicity during the heating season was 1.7 folds higher at Shinchon area and 1.2 folds higher at Bulkwang than during the non heating season. The variable contents and levels of nitroarenes in suspended particulates may affect human health significantly. Further studies such as risk assessment should be conducted on the basis of these kind of studies.

• Analytical Science and Technology
• /
• v.23 no.2
• /
• pp.128-137
• /
• 2010

The purpose of this study is to set up the analytical method of new persistent organic pollutants (POPs) such as chlordecone, endosulfan, ${\alpha}$-HCH, ${\beta}$-HCH, ${\gamma}$-HCH. The analytical methods for these compounds listed as new POPs by the Stockholm Convention need to be newly established. Therefore, we proposed the analytical method for 5 organic chlorinated pesticides (OCPs) and then applied the analytical method to environmental samples. To do this, the pre-treatment such as florisil and activated carbon cleanup process in the Korean official method for classic POPs had been reviewed. All of compounds except chlordecone were pre-treated simultaneously with reviewed cleanup process and detected by GC/MS and HRGC/HRMS respectively. There is a problem that chlordecone could not get a high sensitivity by GC analysis, but in this study GC/MS method was proposed.

• Applied Chemistry for Engineering
• /
• v.16 no.4
• /
• pp.474-484
• /
• 2005

Biological treatment is a promising alternative to conventional air pollution control methods. Bioreactors for air pollution control have found most of their success in the treatment of dilute and high flow waste air streams containing volatile organic compounds and odor compounds. They offer several advantages over traditional technologies such as incineration or adsorption. These include lower treatment costs, absence of formation of secondary pollutants, no spent chemicals, low energy demand and low temperature treatment. The most widely used bioreactor for air pollution control is biofilter, but it has several limitations. In the past years major progress has been accomplished in the development of vapor phase bioreactor, in particular biotrickling filters. Biotrickling filters are more complex than biofilters, but are usually more effective, especially for the treatment of compounds which are difficult to degrade or compounds that generate acidic by-products. While the level of understanding of biotrickling filtration process for VOCs still remains limited, the evident success of biotreatment of VOC in air stimulated the pursue of acitve research. This paper presents fundamental and theoretical/practical aspect of air pollution control in biotrickling filter. Special emphasis is given to the operating parameters and the factors influencing performance for air pollution control in biotrickling filter.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.12 no.2
• /
• pp.68-74
• /
• 2009

Polycyclic aromatic hydrocarbons (PAHs), one of ubiquitous organic pollutants in marine environments, are major toxic components of petroleum and are produced during the incomplete combustion of organic materials. As shipyards are located inside of natural or artificial semi-enclosed bay, even a relatively weak environmental disturbance by ship-building activity can cause severe damage to marine ecosystem in the bay. Many studies of pollution in shipyard area have been focused on the antifouling agent, like tributyltin. This study aimed to investigate the effect of ship-building activity on PAH contamination. Total PAHs concentration was higher nearby and inside shipyard area than outside, implying that shipyard could be one of major source area of PAH contamination to pose harmful effects to surrounding environments. Through PAH profile and source recognition index, the source of PAHs inputs in this area was estimated to originate from both petrogenic and pyrogenic origin. PAH levels showed a significant correlation with total butyltins, indicating that ship-building activity influenced PAH concentration and distribution. Vertical distribution of PAHs historically confirmed the correlation between shipbuilding activity and PAHs contamination.

• Applied Chemistry for Engineering
• /
• v.28 no.5
• /
• pp.501-505
• /
• 2017

Due to the rapid urbanization and increased population, there is an increase in airtight nature of buildings which causes serious indoor air pollution. Among several indoor air pollutants, volatile organic compounds (VOCs) emitted from paint are of major concern. Therefore, there is an urge for the development of environmental friendly paint products. In this wok, a natural wall paint (NWP) was prepared by utilizing a natural clay material "sericite" as a main component. A small chamber test was carried out to identify the toxic substances release from NWP and the results were compared with two eco-friendly commercial paints. The total VOCs were detected in trace level inside the test chamber and their concentrations were below the recommended indoor air quality standards. Toluene was not detected for NWP, whereas formaldehyde was observed in trace level. The toxicity index results were compared with two commercial paints and found that NWP exhibited less harmful gas emission. Based on certification rating of building materials, NWP can be classified as the first grade of building materials. Due to the above advantages, the use of sericite as a major component in NWP will be a useful technique to maintain the indoor air quality.

• Clean Technology
• /
• v.13 no.1 s.36
• /
• pp.1-15
• /
• 2007

Biological treatment is a relatively recent air pollution control technology in which off-gases containing biodegradable odors and volatile organic compounds(VOCs) are vented through microbes. It is a promising alternative to conventional air pollution control methods. Bioreactors for air pollution control have found most of their success in the treatment of dilute and high flow waste air streams containing VOCs and odor compounds. They offer several advantages over traditional technologies such as incineration or adsorption. These include lower treatment costs, absence of formation of secondary pollutants, no spent chemicals, low energy demand and low temperature treatment. The three most widely used technologies are described, namely biofiltration, biotrickling filtration, bioscrubbing. The most widely used bioreactor for air pollution control is biofilter, but it has several limitations. In the past years major progress has been accomplished in the development of vapor phase bioreaction systems, for solving problems of biofilter. Biotrickling filters are more complex than biofilters, but are usually more effective, especially for the treatment of compounds which are difficult to degrade or compounds that generate acidic by-products. This, paper reviews fundamental and theoretical/practical aspect of air pollution control in biofilter, biotrickling filter and bioscrubber, focusing more extensively on biotrickling filtration. Special emphasis is given to the operating parameters and the factors influencing performance for air pollution control, and cost estimation in biotreatment technologies.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.10
• /
• pp.927-932
• /
• 2009

Toxic and recalcitrant organic pollutants in wastewaters can be effectively treated when advanced oxidation and biodegradation are combined, ideally with intimate coupling, in which both processes occur simultaneously in the same system. One means to achieve intimate coupling is to coat nanoscale $TiO_2$ on the outside of macroporous biofilm carriers. This study investigated the kinetics of photocatalysis with $TiO_2$-coated porous carriers. The carriers were made of polyvinyl alcohol (PVA) and coated with $TiO_2$ using a low-temperature sol-gel process. The $TiO_2$-coated carriers catalyzed the oxidation of methylene blue (MB) effectively under irradiation of UV light. The overall reaction rate with adsorption and photolysis saturated at high MB concentration, and approached the adsorption rate, which was first order for all MB concent rations. This result indicates that adsorbed MB may have slowed photocatalysis by blocking active sites for photocatalysis. The overall kinetics could be described by a quasi-Langmuir model. The estimated maximum specific (per unit mass of $TiO_2$) transformation rate of MB by the $TiO_2$-coated carriers was four times larger than that obtained from slurry-$TiO_2$ reactors. This observation demonstrated that the $TiO_2$ present as a coating on the carriers maintained high efficiency for transforming recalcitrant organic matter via photocatalysis. These findings serve as a foundation for advancement of an intimate coupling of photocatalysis to biodegradation.

• Resources Recycling
• /
• v.18 no.2
• /
• pp.16-29
• /
• 2009

This paper describes characteristics of pollutants in wastewater from the pulp and paper industry and biological technologies for the wastewater treatment. The wastewater from the pulp and paper industry contains high concentrations of biochemical oxygen demand (BOD) and chemical oxygen demand (COD) and shows high toxicity and strong black-brown color. In particular, organic chlorinated compounds such as dioxins and furans may be formed by the chlorination of lignin in wood chips. Thus the pulp and paper industry is recently trending toward total chlorine-free (TCF) bleaching processes. All biological technologies for pulp and paper wastewater treatment are based on the contact between wastewater and bacteria, which feed on organic materials in the wastewater, thus they reduce BOD concentration in it. Both aerobic and anaerobic treatments were found to be effective for the wastewater treatment. Furthermore, advanced technologies such as fungal application and combined biological-filtration process have been also introduced to the wastewater treatment field. These technologies would be useful for water recycling to reduce water consumption throughout pulp and paper making process.

• Membrane Journal
• /
• v.31 no.1
• /
• pp.35-51
• /
• 2021

Advancements in thin-film nanocomposite (TFN) membrane technology for nanofiltration is crucial for removing pollutants from natural resources. In recent years, various metal-organic framework (MOF) modifications have been tested to overcome the drawbacks that are inevitable with conventional thin-film composite (TFC) and TFN membranes. In general, MIL-101(Cr), UiO-66, ZIF-8, and HKUST-1 [Cu3(BCT2)] are MOFs that were proven to exhibit excellent membrane performance in terms of solvent permeability and solute rejection; their respective studies are reviewed in this article. Other novelties, such as the simultaneous use of different MOFs and unique MOF layering techniques (e.g., dip-coating, spray pre-disposition, Langmuir-Schaefer film, etc.) are also discussed as they present alternate solutions for membrane enhancement and/or preparation convenience. Not only are these MOF-modified TFN membranes frequently shown to improve separation performance from their respective TFC and TFN membranes, but many reports also explain their potential for a cost-effective and environmentally friendly process. In this review the thin film nanocomposite nanofiltration membrane is discussed.