• Journal of the Korea Organic Resources Recycling Association
• /
• v.23 no.4
• /
• pp.52-62
• /
• 2015

This study estimated the contribution rates of inlet air flow, moisture content, air-filled porosity and particle size on the total pressure drop for the sawdust used as the bulking agent in the composting. The statistical model for pressure drop including the affecting factors was proposed.($R^2=0.998{\sim}0.950$) While the laminar air flow(v) and particle size(SIZE*v) had the positive relations to the total pressure drop, the turbulent air flow($v^2$), moisture content(MC*v) and air-filled porosity(AFP*v) had the negative relations. Total pressure drop sharply increased with increasing of the inlet air flow. And the most significant factors affecting to total pressure drop were the particle size(SIZE*v) as positive factor and air-filled porosity(AFP*v) as negative factor. The contribution rate to total pressure drop by the particle size(SIZE*v) was continuously increased with increasing of the inlet air flow, but the contribution rate by air-filled porosity(AFP*v) was decreased. And total pressure drop was little changed even though the increasing of moisture content above the range of dry moisture content 0.25. The contribution rates of affecting factors had the different tendencies with increasing of the moisture content, especially in the negative factors as air-filled porosity(AFP*v) and moisture content(MC*v). For effective composting process, it is preferable to select the sawdust with higher air-filled porosity as bulking agent to enhance the air permeability.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.16 no.3
• /
• pp.43-60
• /
• 1998

The photosensitive properties and spectroscopic characteristics in the organic photoconductor(OPC) with carrier generation layer(CGL) of poly(vinylbutyral)(PVB) and polycarbonate(PC) doped with titanyl phthalocyanine(TiOPc) were investigated. The change of crystal structure of TiOPc dispersed with PVB and PC was shown by UV-visible reflective spectrum and FT-IR spectrum and mainly caused by the difference of solubility of solvent and the interaction between TiOPc and binder. The particle size of TiOPc dispersed with PVB measured by SEM was smaller than in PC. The crystal structure of TiOPc dispersed with PVB was amorphous type and in PC was $\alpha$type. It was found that the photosensitive properties of OPC were dependent on the change of absorbance and ionization potential of TiOPc occurred from the difference of crystal structure. In this work, the photosensitivity of OPC of TiOPc dispersed with PVB was better than PC due to the crystal type and the smaller particle size.

• Journal of Energy Engineering
• /
• v.24 no.2
• /
• pp.51-54
• /
• 2015

The mesoporous metal organic framework structure of Ni-BTC was successfully synthesized in a low temperature and short operation time via hydrothermal synthesis process. Such operational route virtuously consumed less electrical and thermal energy. It proved time saving along with acceptable product yield (38%). The product was characterized through FESEM, FT-IR, XRD and $N_2$ gas adsorption measurement. Hightemperature stability of synthesized MOF was gauged by diffraction indexing of XRD patterns of as synthesized and heat treated samples of MOFs. The mathematically calculated particle size of Ni-BTC was found to be 42nm.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.11
• /
• pp.2669-2674
• /
• 2009

Controlled reduction of silver alkylcarbamate complexes with hydrogen gas was investigated as a facile synthetic method for high concentrations of silver nanocolloids in organic solvent. Polyvinylpyrrolidone (PVP) was used to stabilize the silver colloids obtained from the chemical reduction. To determine optimum conditions for preparation of the stable and controlled silver colloids with the narrowest particle size and distribution, a large number of experiments were carried out involving variations in the concentrations of the silver 2-ethylhexylcarbamate (Ag-EHCB) complex, PVP, and 2-propanol. The initial colloid had a mean particle diameter between 5$\sim$50 nm, as measured by transmission electron microscopy, and exhibited a sharp absorption band in the UV region with a maximum size near 420 nm. After treatment with a reducing agent, the colloids were characterized by ultraviolet-visible spectroscopy, X-ray diffraction, and high-resolution transmission electron microscopy.

• Textile Coloration and Finishing
• /
• v.19 no.5
• /
• pp.30-36
• /
• 2007

Cypermethrin-containing polyurea microcapsules were prepared by interfacial polymerization using aromatic 2,4-toluene diisocyanate(TDI) and Ethylene diamine(EDA) as wall forming materials. The effects of the protective colloids of polyvinylalcohol(PVA) and gelatin were investigated through experimentation. The mean size of the polyurea microcapsules was smaller and the surface morphology of the PVA was much smoother than gelatin. In addition the release behavior was much more controlled and better sustained. As the concentration of protective colloid increased, the wall membrane of the polyurea microcapsules became more stable, the thermal stability of the wall membrane increased, the mean particle size became smaller, and the particle distribution was more uniform. The release behavior of the core material changed according to the concentration. As the gelatin concentration was increased, a more controlled and sustained release behavior was observed. However, in the case of PVA, the increase of PVA concentration lead to a more rapid release rate.

• Journal of environmental and Sanitary engineering
• /
• v.16 no.3
• /
• pp.96-103
• /
• 2001

This study was carried out to investigate the major factors for the removal of NOMs (Natural Organic Matters) by alum ferric chloride and blended coagulants that consisted of alum and ferric chloride. Investigated factors were pH, the dosage of coagulant, alkalinity, hardness and bloc strength. The particle size contained in the test water came from the Han River was also measured. DOC(Dissolved Organic Carbon) removal at pH 6 was two to three times higher than at pH 8.5. The blended coagulant showed 9 to 10 percent higher DOC removal efficiency and 2 to 4 percent higher turbidity under the same condition. Alkalinity consumption of alum, ferric chloride and blended coagulant was 81%, 90% and 86% of theoretical value, respectively. The limit concentration of alkalinity to avoid pin floe was 10 mg $CaCO_3/L$ when alum was used. Hardness had no apparent effect on coagulation. The residual turbidity and $UV_{254}$ showed a tendency of increasing with floc strength($sec^{-1}$) increase. The order of floe strength was the following; alum >blended coagulant > ferric chloride. The particle counter test showed 89 percent of the small particle size(SPS, $1~5{\;}{\mu}textrm{m}$) and 11 percent of the medium to large particle size(M.LPS, $5~125{\;}{\mu}textrm{m}$). At PH7.85, the particle removal efficiencies of SPS($1~5{\;}{\mu}textrm{m}$) and M.LPS($5~125{\;}{\mu}textrm{m}$) in the coagulation process were 81% and 95%, respectively.

• Journal of environmental and Sanitary engineering
• /
• v.15 no.4
• /
• pp.52-58
• /
• 2000

This study was carried out to investigate the contents of heavy metals with respect to the depth, particle size and Tessier et al. method in surface sediment of the Nakdong river. The contents of Cd, Cu & Pb were high or similar with increasing depth, but Mn & Zn were high to middle depth. Generally, the contents of heavy metals were found to be high as the particle size become more small and more deep. Because the more particle size was small, the specific surface area was large, the contents of heavy metals was high for increasing affinity. It was estimated that the types of heavy metals contained in surface sediment by Tessier et al. method was dissimilar with anaerobic condition, pH and degradation of organic matter, etc.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.E2
• /
• pp.53-59
• /
• 2004

The roadway tunnels in urban areas give rise to problems such as a localized air pollution. Here, we report the results of a case study of an urban roadway tunnel measurement. The size-resolved particle sampling was carried out with a two 2-stage filter pack samplers and an Andersen impactor sampler at the center of Buk-Ak tunnel in November 2001. Particle Induced X-ray Emission (PIXE) was applied to determine the elemental composition of size-resolved particles divided into soluble and insoluble fractions. The Thermal/Optical Reflectance (TOR$^{(R)}$) method was also employed in analyzing of elemental carbon (EC) and organic carbon (OC). Mass concentrations of fine (< 1.2 ${\mu}{\textrm}{m}$) and coarse (> 1.2 ${\mu}{\textrm}{m}$) particles are 165 and 48 $\mu\textrm{g}$ m$^{-3}$ , respectively. Total elemental mass concentration (the sum of insoluble coarse, soluble coarse, insoluble fine, and soluble fine) is found to be 24$\mu\textrm{g}$ m$^{-3}$ and comprises only 11 % of total particle mass concentration. The concentrations of EC, OC, and mass show the clear dependency on particle size with the maximum between 0.1 and 0.43 ${\mu}{\textrm}{m}$ aerodynamic diameters. Total carbon (sum of EC and OC) accounts for approximately 70% of mass concentration.n.

• Journal of Korean Society on Water Environment
• /
• v.29 no.2
• /
• pp.170-175
• /
• 2013

Achieving very low phosphorus levels in treated wastewater will require the installation of additional treatment. Phosphorus removal experiments by chemical coagulation were carried out for the effluent of wastewater treatment plant in this study. TP (total phosphorus) or phosphate were highly related to the addition of PAC (poly aluminium chloride) which is one of the inorganic coagulants. But, organic polymer did not significantly affect the phosphorus removal efficiency. Polymer affected the flocculation of particle especially particle matter less than 10 micrometer so, the number of micro particles was decreased by polymer dose. Chlorination would not affect on chemical coagulation process and TP and turbidity could be effectively removed by the co-addition of PAC and polymer.

• Membrane and Water Treatment
• /
• v.13 no.1
• /
• pp.29-37
• /
• 2022

To verify the fate and transport of engineered nanoparticles (ENP), it is essential to understand its interactions with organic matter. Previous research has shown that dissolved organic matter (DOM) can increase particle stability through steric repulsion. However, the majority of the research has been focused on model organic matter such as humic or fulvic acids, lacking the understanding of organic matter found in field conditions. In the current study, organic matter was sampled from wastewater treatment plants to verify the stability of engineered nanoparticles (ENP) under field conditions. To understand how different types of organic matter may affect the fate of ENP, wastewater was sampled and separated based on their size; as small organic particular matter (SOPM) and large organic particular matter (LOPM), and dissolved organic matter (DOM). Each size fraction of organic matter was tested to verify their effects on nano-zinc oxide (nZnO) and nano-titanium oxide (nTiO₂) stability. For DOM, critical coagulation concentration (CCC) experiments were conducted, while sorption experiments were conducted for organic particulates. Results showed that under field conditions, the surface charge of the particles did not influence the stability. On the contrary, surface charge of the particles influenced the amount of sorption onto particulate forms of organic matter. Results of the current research show how the size of organic matter influences the fate and transport of different ENPs under field conditions.