• Korean Journal of Environmental Agriculture
• /
• v.27 no.2
• /
• pp.145-149
• /
• 2008

Anaerobic co-digestion of swine manure and food waste for biogas production was performed in serum bottles at various volatile solids(VS) contents and mixing ratios of two substrates(swine manure:food waste=$100:0{\sim}0:100$). Through kinetic mode of surface methodology, the methane production was fitted to a Gompertz equation. The ultimate methane production potential of swine manure alone was lower than that of food waste regardless of VS contents. However, it was appeared that maximum methane production potentials in 80 : 20 of the mixing rate at VS 3% was enhanced at 144.7%, compared to its only swine manure. The potential increased up to 815.71 ml/g VS fed as VS concentration and food composition increased up to 3.0% and 20%, respectively. The ultimate amount of methane produced had significantly a positive relationship with that of methane yield rate. Overall, it would be strongly recommended that feeding stocks use 20% of mixing ratio of food waste based on VS 3% contents when operating the anaerobic reactor on site at $35^{\circ}C$ if not have treatment of its anaerobic waste water.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.2
• /
• pp.205-213
• /
• 2002

This paper deals with the implementation of three-phase VSI systems which can control the power regenerated from DC bus line to AC supply. The overall system consists of the line-to-line voltage and line current sensors, an actual power calculator using d-q transformation method, a complex power controller with PI control scheme, a gating signal generator for modified ｑ-conduction mode, a DPLL for frequency followup, and Power circuits. Control board is constructed by using a 32-bit DSP TMS32C32, two EFLDs , six ADCs, and a DAC. To verify the performance of the proposed system, we designed and constructed the propotype with the power rating of 5kVA at AC 220V. Experimental results show that the regenerated active power is well controlled to its command vague and the regenerated reactive power still remained at nearly zero through all operating modes.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.7
• /
• pp.4692-4697
• /
• 2014

A micro-grid including photovoltaic source and Li battery has been installed and operated for several years at the campus of USF and been used as a test bed. Photovoltaic power source has been strongly influenced by the location, weather and climate of the installed area. To compensate for the uncertainty of photovoltaic source's power output, a Li battery is connected directly to the photovoltaic source and supplies electric power to the grid. The Li battery is operated to supply power output to the grid according to the charging or discharging mode of the battery based on the average power output of the photovoltaic source, which is calculated from the monitored data for several years. The grid of the photovoltaic and Li battery system is operated as a severe loading condition and the operating characteristics of PV source and Li battery cells are analyzed in detail.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.22 no.5
• /
• pp.879-885
• /
• 2013

Satellites provide a lot of information and essay roles in the areas of defense and space observations. The precise distances to the satellites are measured by emitting and retro-reflecting a laser. For such surveys, satellite laser ranging (SLR) systems have been developed in different forms and for different areas. The structural integrity of the tracking mount is essential for it to be able to track a high-speed satellite precisely, overcoming the various external and internal disturbances and operating conditions. In this study, the analysis of a tracking mount was performed for weight, wind loads, and inertia loads in order to verify its soundness. The results of the comparison between aluminum and steel were analyzed in order to select the optimal material for the fork and main housing part. In addition, the natural frequency and mode shape were predicted. Optimal material selection and structural integrity will also be verified using static analysis.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.1
• /
• pp.119-126
• /
• 2012

H.264/AVC can use three transforms depending on types of residual data which are to be coded. H.264/AVC always executes $4{\times}4$ DCT transform. In $16{\times}16$ intra mode only, $4{\times}4$ Hadamard transform for luma DC coefficients and $2{\times}2$ Hadamard transform for chroma DC coefficients are performed additionally. Quantization is carried out to achieve further data compression after transform coding is completed. In this paper, the hardware implementation for DCT transform, Hadamard transform and quantization is studied. Especially, the proposed architecture adopting the pipeline technique can output a quantized result per clock cycle after 33-clock cycle latency. The proposed architecture is coded in Verilog-HDL and synthesized using Xilinx 7.1i ISE tool. The operating frequency is 106MHz at SPARTAN3S-1000. The designed IP can process maximum 33-frame at $1920{\times}1080$ HD resolution.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.12
• /
• pp.93-101
• /
• 2007

Small area and low power implementation are important requirements for various multimedia processing hardware, especially for mobile environment. This paper presents a hardware architecture of H.264/AVC Intra Prediction module aiming on small area and low power. A single arithmetic unit was shared and processed sequentially for all mode decisions and computations to predict an image frame. As a result, we could get smaller area and smaller memory size compared to other existing implementations. The proposed architecture was verified using the Altera Excalibur device, and the implemented hardware has been described in Verilog-HDL and synthesized on Samsung STD130 0.18um CMOS Standard Cell Library using Synopsys Design Compiler. The synthesis result was about 11.9K logic gates and 1078 byte internal SRAM and the maximum operating frequency was 107Mhz. It consumes 879,617 clocks to process one QCIF frame, which means it can process 121.5 QCIF$(176\times144)$ frames per second, therefore it shows that it can be used for real time H.264/AVC encoding of various multimedia applications.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.1
• /
• pp.9-17
• /
• 2005

We studied the characteristics of impedance and electromechanical coupling coefficient in ZnO and AIN thin films by using resonance frequency spectrum method. The response peak of impedance decreased with the decrease of thickness of piezoelectrics, the number of mode of response peak decreased with the decrease of substrate thickness. An error of Kt² estimated from input Kt² increased as the thickness of piezoelectrics decreased and the thickness of substrate increased. Also, the error was increased in case of a large acoustic impedance of substrate. It was found that the composite resonator operating in optimized condition could be designed through the resonance frequency spectrum analysis of composited resonator consisted of piezoelectric thin film and substrate.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.28 no.3
• /
• pp.591-603
• /
• 2018

Windows Event Log is a format that records system log in Windows operating system and methodically manages information about system operation. An event can be caused by system itself or by user's specific actions, and some event logs can be used for corporate security audits, malware detection and so on. In this paper, we choose actions related to corporate security audit and malware detection (External storage connection, Application install, Shared folder usage, Printer usage, Remote connection/disconnection, File/Registry manipulation, Process creation, DNS query, Windows service, PC startup/shutdown, Log on/off, Power saving mode, Network connection/disconnection, Event log deletion and System time change), which can be detected through event log analysis and classify event IDs that occur in each situation. Also, the existing event log tools only include functions related to the EVTX file parse and it is difficult to track user's behavior when used in a forensic investigation. So we implemented new analysis tool in this study which parses EVTX files and user behaviors.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.9
• /
• pp.1633-1640
• /
• 2016

In this paper, we propose a open-ended rectangular microstirp patch antenna with fork-shaped feeding structure. This antenna extends the effective bandwidth by transforming single or multi resonant frequency and is designed planar monopole structure with microstrip line to satisfy the WLAN bands (2.4 - 2.484, 5.15 - 5.35, 5.25-5.825 GHz). The substrate is printed in 0.8 mm thickness on an FR-4 board. A commercial 3D simulation tool was used to analyze surface current and electromagnetic field distribution in order to analyze the operation mode and reconfiguration principle of antenna. According to the lengths of individual patches, simulated reflection loss was compared to obtain optimized values. When it was designed with the optimized values, it satisfied WLAN bands (2.380 - 2.710, 4.900 - 5.950 GHz), if the switch is off, and 2.4 WLAN band (2.380 - 2.710 GHz). From the fabricated and measured results, measured results of return loss, gain and radiation patterns characteristics displayed for operating bands.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.25 no.6
• /
• pp.1361-1376
• /
• 2015

Recently, the size of the mobile game market and the number of mobile game users are growing. Also, as the mobile game's life cycle is increasing at the same time, auto program issue reappears which has been appeared in PC online games. Gamers usually tend to ignore warning messages from antivirus programs and even worse they delete antivirus program to execute auto programs. Therefore, mobile game users are easily compromised if the auto program performs malicious behaviors not only for the original features. In this paper, we analyze whether seven auto programs of "clash of clans" which has a lot more users for a long time perform malicious behaviors or not. We forecast the possible security threats in near future and proposed countermeasures based on this analysis. By analyzing auto programs of highly popular mobile game of today, we can acquire the knowledge on auto program's recent trend such as their development platform, operating mode, etc. This analysis will help security analysts predict auto program's evolving trends and block potential threats in advance.