• Asian Journal of Atmospheric Environment
• /
• v.10 no.1
• /
• pp.32-41
• /
• 2016

Particle-phase concentrations were measured at 10, 80, and 200 m from the roadside of a national highway near Seoul in January and May 2008. The highway has two lanes each way, with an average hourly traffic volume of 1,070 vehicles. In January 2008, $PM_{10}$ concentrations decreased from 10 to 80 m but increased at 200 m. Black carbon (BC) decreased only slightly with distance due to the influence of biomass burning and open burning from the surrounding areas. In May 2008, the effect of secondary formation on both $PM_{10}$ and $PM_{2.5}$ was significant due to high temperatures compared with January. Because on-road emissions had little effect on secondary formation for a short time, variations in $PM_{10}$ concentrations became smaller, and $PM_{2.5}$ concentrations increased with distance. The effects of fugitive dust on PM concentrations were greater in May than in January when the mean temperature was below freezing. In the composition variations, the amounts of primary ions, organic carbon (OC), and BC were larger in January, while those of secondary ions and others were larger in $PM_{10}$, as well as $PM_{2.5}$ in May.

• Journal of Korean Society for Atmospheric Environment
• /
• v.26 no.3
• /
• pp.265-275
• /
• 2010

Mass and ion concentrations of $PM_{10}$ and $PM_{2.5}$ were measured in Yongin, downwind of the Seoul metropolitan area. Twenty-four hour average samples were collected daily for a month or so in spring and fall of both 2007 and 2008. Asian dust occurred twice in each period except in the fall of 2007. During the Asian dust period, nitrate in fine particles decreased since large amount of cations in coarse particles of Asian dust absorbed it. In spring 2008, sulfate as well as ammonium also increased in coarse particles. In spite of occasional Asian dust events, the influence of secondary formation was dominant over the period. Excessive ammonium over sulfate was enough to neutralize nitrate as well. High correlation coefficients between $K^+$ and sulfate, nitrate, and ammonium indicate a close relationship between secondary formation and biomass burning. Biomass burning and open burning are considered to be important sources of chloride.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.05a
• /
• pp.159-162
• /
• 2008

In this study, various cycles of liquid rocket engines were surveyed and specifically gas generator after burning cycle was investigated for upper stage motors. The engines for the upper stage can be categorized into three group based on the cycles and propellants at the diagram. Kerosene engines which adapt the gas generator after burning cycle and are located in the region II, are characterized for high combustion pressure and complexity. This cycle usually needs more than two pumps to use the turbine power efficiently. The fuel line can be divided into the gas generator line and the combustor line, and only the gas generator line is need to be pressured more because the combustion pressure in the gas generator is much higher than that of the combustor. Basically, all the oxidizer goes into the gas generator and than to the combustor, thus the auxiliary LOx pump is not critically necessary. However, for the various reasons, the LOx line requires a booster pump. A gas generator after burning cycle engines produces relatively high specific impuls than that of the open cycle engines. Thus it is suitable for upper stages of launch vehicles.

• Journal of Korean Society for Atmospheric Environment
• /
• v.21 no.4
• /
• pp.459-469
• /
• 2005

In recent years, concerns have been growing globally regarding greenhouse gases. Open burning of biomass causes emission of a number of greenhouse and other gases and substances. This paper studied an analysis on the characteristics of four types of biomass using duel type cone calorimeter. Cone calorimeter is widely used for assessing combustibility of materials in Europe. As a result, we evaluated several characteristics of biomass, such as heat released rate, smoke production rate, CO, $CO_2$ production and mass loss rate, and so on. $CO_2$ is currently responsible for over $60\%$ of the enhanced greenhouse effect, and may be the most important contributor to future. $CO_2$ production for biomass in the range of $1.74\~1.99kg/kg$ is similar to previous research conducted by Bhattacharya et al. (2002a).

• Journal of Environmental Health Sciences
• /
• v.33 no.1 s.94
• /
• pp.30-35
• /
• 2007

Waste policies with waste metering system and recycling in 1995 have contributed to the reduction of solid waste generation. Now rural areas as well as urban areas produce less amount of solid wastes in terms of per capita. However most policies in relation to waste issue have been concentrated in urban areas. Large portion of agricultural waste in rural region are being illegally treated such as open incineration or burned out on the road. In this study, we assessed the atmospheric air quality and health risk by illegal open incineration in rural region. In case of benzene level, worst concentration during illegal open incineration was 0.23 ppm and cancer risk by exposure was estimated to $2.29{\times}10^{-3}$.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.2
• /
• pp.336-341
• /
• 2010

The burning interruption between the initiator and the delay column in a Zr-Ni K1 delay system used for a K510 fuze occurs with long-time storage. About 10 % failure probability of 15-years stored delay systems shows the failure mode in open literature. This paper shows storage lifetime improvement results for the delay system through changing the single-base delay column into double-base ones and controlling the manufacturing processes especially the initial inclusion of humidity. The double-base delay columns was implemented by inserting one delay column of fast burning rates between the initiator and the previous delay column of slow burning rates. Accelerated aging tests of the delay systems with double-base columns, and then the firing tests were performed to evaluate the improved lifetime. The double-base delay columns shows improved storage lifetime of the delay system through preventing the failure mode.

• Journal of the korean Society of Automotive Engineers
• /
• v.1 no.1
• /
• pp.28-41
• /
• 1979

Propane-Air premixed combustible gas was ignited by the conventional current break system inside the open combustion chamber under the atmospheric pressure and the room temperature to measure the flame propagating speed and the burning speed, also to elucidate the history of the propagating flame behavior and wall effects to flame shape by using Ion Gap Method and High Speed Schlieren Photography. The results obtained show that the maximum flame propagating speed and maximum burning speed are approximately 292 cm/sec and 36 cm/sec at the mixture ratio 4.6%, respectively. The cellular flame structures can be observable in the rich mixture region, moreover, the cellular structures become finer, with increasing the mixture strength.

• Journal of People, Plants, and Environment
• /
• v.24 no.6
• /
• pp.585-593
• /
• 2021

Background and objective: Illegal open-air incineration, which is criticized as a leading source of air pollutants among agricultural activities, currently requires constant effort and attention. Countries around the world have been undertaking studies on the emission of heavy metal substances in fine dust discharged during the incineration process. A precise analytical method is required to examine the harmful effects of particulate pollutants on the human body. Methods: In order to simulate open-air incineration, the infrastructure needed for incineration tests complying with the United States Environmental Protection Agency (EPA) Method 5G was built, and a large-area analysis was conducted on particulate pollutants through automated scanning electron microscopy (SEM)-energy-dispersive X-ray spectroscopy (EDS). For the test specimen, high-density polyethylene (HDPE) waste collected by the DangJin Office located in Choongcheongnam-do was used. To increase the identifiability of the analyzed particles, the incineration experiment was conducted in an incinerator three times after dividing the film waste into 200 g specimens. Results: Among the metal particulate matters detected in the HDPE waste incineration test, transition metals included C (20.8-37.1 wt%) and O (33.7-37.9 wt%). As for other chemical matters, the analysis showed that metal particulate matters such as metalloids, alkali metals, alkaline earth metals, and transition metals reacted to C and C-O. Si, a representative metalloid, was detected at 14.8-20.8 wt%, showing the highest weight ratio except for C and O. Conclusion: In this study, the detection of metal chemicals in incinerated particulate matters was effectively confirmed through SEM-EDS. The results of this study verified that HDPE waste adsorbs metal chemicals originating from soil due to its own properties and deterioration, and that when incinerated, it emits particulate matters containing transition metals and other metals that contribute to the excessive production and reduction of reactive oxygen species.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.12 no.4
• /
• pp.1-11
• /
• 2004

Combustion and fuel distribution characteristics of heavy duty engine with the liquid phase LPG injection(LPLI) were studied in a single cylinder engine, Swirl ratio were varied between 1.2, 2.3, and 3.4 following Ricardo swirl number(Rs) definition, Rs=2.3 showed the best results with lower cycle-by-cycle variation and shorter burning duration in the lean region while strong swirl(Rs=3.4) made these worse for combustion enhancement. Excessive swirl resulted in reverse effects due to high heat transfer and initial flame kernel quenching. Fuel injection timings were categorized with open valve injection(OVI) and closed valve injection(CVI). Open valve injection showed shorter combustion duration and extended lean limit. The formation of rich mixture in the spark plug vicinity was achieved by open valve injection. With higher swirl strength(Rs=3.4) and open valve injection, the cloud of fuel followed the flow direction and the radial air/fuel mixing was limited by strong swirl flow. It was expected that axial stratification was maintained with open-valve injection if the radial component of the swirling motion was stronger than the axial components. The axial fuel stratification and concentration were sensitive to fuel injection timing in case of Rs=3.4 while those were relatively independent of the injection timing in case of Rs=2.3.

• Journal of Korean Society for Atmospheric Environment
• /
• v.22 no.3
• /
• pp.287-295
• /
• 2006

PAHs (Polycyclic Aromatic Hydrocarbons), one of the carcinogenic materials in environment, were investigated in this study. The standardized analysis conditions were tested, and then various factors which affect to the ambient PAHs concentration in Seoul were estimated. Moreover, the emissions of PAHs from major stationary sources were investigated to determine the quantitative relationships between ambient PAHs concentrations and emission sources. From the factor analysis, three factors relevant to the ambient PAHs in Seoul were found. Factor 1 was related to the concentrations of chrysene, pyrene, indeno (1, 2, 3-cd)pyrene, benzo[b]fluoranthene, benzo[k]fluoranthene, and benzo prerylene which were mainly emitted from gasoline and diesel fueled cars. Factor 2 showed higher loadings in phenanthrene and anthracene which were due to LNG and BC oil combustion in industry and home. And factor 3 included dibenz(a, h)anthracene and acenaphthene which were emitted from open burning and municipal solid waste incineration. Conclusively, all of three factors were consisted in 82% of total variance. The contribution of mobile sources in ambient air in Seoul was estimated at 64%, that of industrial and home sources at 17%, and that of open burning and municipal incineration at 1%.