• 소음진동
• /
• 제11권2호
• /
• pp.249-256
• /
• 2001

In this paper the characteristics of vibration induced by subway trains running on track is discussed. The quantitative prediction of the vibration level and the countermeasure for reduction of necessary, is of importance for the better environment. It was made the constructed Bundang line as first step with the modified Young-Dan type to basis on the Japanese Young-Dan type. In this paper it was measured and analyzed to two region ($ \circled1$Susuh-Bokjung. $ \circled2$Chorim-Suhyun region) of this. at present, operational Bundang line when averaging velocity of train is 60 (km/h). As the response characteristics of frequency Induced by subway operation, it was confirmed that frequency band of neighborhood of 30~80 Hz in generally dominant. Also to assess the quantitative nitration as response level to be measured for each point of two region in subway operation, the vibrational response level was measured at the state to be not subway operation. And the level was approximately $\fraction one-fifth~\fraction one-ten$ level comparing to subway operation.

• 한국물환경학회지
• /
• 제24권1호
• /
• pp.1-6
• /
• 2008

Biological and chemical sensors are the two most frequently used sensors to monitor the water resource. Chemical sensor is very accurate to pick up the types and to measure the concentration of the chemical substance. Drawback is that it works for just one type of chemical substance. Therefore a lot of expensive monitoring system needs to be installed to determine the safeness of the water, which costs too much expense. Biological sensor, on the contrary, can judge the degree of pollution of the water with just one monitoring system. However, it is not easy to figure out the type of contaminant with a biological sensor. In this study, an endeavor is made to identify the toxicant in the water using the shape of the chlorophyll fluorescence induction curve (FIC) from a biological monitoring system. Wem-tox values are calculated from the amount of flourescence of contaminated and reference water. Curve fitting is executed to find the representative curve of the raw data of Wem-tox values. Then the curves are digitalized at the same interval to train the neural network model. Taguchi method is used to optimize the neural network model parameters. The optimized model shows a good capacity to figure out the toxicant from FIC.

• 복식
• /
• 제52권2호
• /
• pp.59-70
• /
• 2002

For the purpose of providing basic data for the development of size specifications for middle-aged women in Busan, one dimensional measurements were made with the subjects. ranging 45 to 59 in age. The following are the conclusions : 1) According to ages, the middle and elder groups of the middle-aged women shared similar body types, having shorter height, more lowered bust. and increased upper-body depth and girth factors, compared with the earlier middle-aged women group. But the thigh girth of the elder middle-aged group (age: 55∼59) was the lowest, maybe owing to the aged lower-body muscles. 2) In the comparison with national averages. armhole girth, elbow girth, wrist girth. back waist length, side neck point-B.P.-waist line, and sleeve length showed great differences. This is problematic in that the national size standards fail to reflect each legion\`s peculiar body type characteristics. 3) Even though body types were classified according to drop value criteria suggested by KS specifications, 23.05% did not belong to the criteria. They were thus classified as A, N, and H body types, following the distribution of the present experiment. 4) In consideration of the economy factor of the production and sales of the clothes industry, the combinations of height and chest garth for the middle-aged Busan women were as follows: 155cm-85cm (Body Type A) 150cm-88cm (Body Type N), and 155cm-94cm (Body Type H).

• 대한용접접합학회:학술대회논문집
• /
• 대한용접접합학회 2000년도 특별강연 및 추계학술발표대회 개요집
• /
• pp.40-42
• /
• 2000

This paper presents a new method of segmenting a one-dimensional signal into a set of features of type(line, Vee-groove, Lap-joint and etc.), A set of requirements for the segmentation process result from the application area, which in this case are laser welding, GMAW(Gas Metal Arc Welding), SAW(Submerged Arc Welding) and high speed tack welding. The algorithm is able to detect an exact welding position in the presence of noise and missing data, yet is reasonably economical to implement

• 천문학회보
• /
• 제39권1호
• /
• pp.47.2-47.2
• /
• 2014

Several studies have reported the presence of sodium excess objects having neutral atomic absorption lines at $5895{\AA}$ (NaD) and $8190{\AA}$ that are deeper than expected based on stellar population models that match the stellar continuum. The origin of these lines is therefore hotly debated. van Dokkum & Conroy proposed that low-mass stars (0.3M) are more prevalent in massive early-type galaxies, which may lead to a strong NaI 8190 line strength. It is necessary to test this prediction, however, against other prominent optical line indices such as NaD, Mgb, and Fe5270, which can be measured with a significantly higher signal-to-noise ratio than NaI 8190. We identified a new sample of roughly one thousand NaD excess objects (NEOs; ~8% of galaxies in the sample) based on NaD line strength in the redshift range 0.00$H{\beta}$ line strengths and significant emission lines, which are indicative of the presence of young stellar populations. This result implies that the presence of the interstellar medium and/or dust contributes to the increase in NaD line strengths observed for these galaxies.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집A
• /
• pp.38-43
• /
• 2001

The interfacial adhesive joining characteristics of the foams are very important for the structural integrity of sandwich structures. Peel strength is one of the best criteria for the interfacial characteristics of the sandwich structures and peel energy is most commonly used for the interfacial characteristics. The peel strength is the first peak force per unit width of bond line required to produce progressive separation by the wedge or other crack opening type action of two adherends where one or both undergo significant bending and the peel energy is the surface active energy per unit width of bond line. In this work, to investigate the strengthening effect of resin treatment on the interfacial surface of foam material, peel strength and peel energy of epoxy resin treated polyurethane foam core sandwich structures were obtained by the cleavage peel tests and compared with those of non surface treated polyurethane foam core sandwich structures.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 추계학술대회 논문집 학회본부 B
• /
• pp.300-302
• /
• 2000

There are two kinds of the synchronous motor, one is an induction type motor started without a driving system, the other is the one started with an external driving system. but, both are complicated. Nowadays, in order to devoid for the synchronous motor being complicated in design, line start permanent magnet(LSPM) motors are being developed. The LSPM motor is composed of the rotor that has interior permanent magnet and aluminum bar instead of general rotor. In this paper, we analyzed the characteristics of the LSPM motor which has both characteristics of an induction motor and a synchronous motor, and we compared the the LSPM motor characteristics with the induction motor.

• 유통과학연구
• /
• 제15권10호
• /
• pp.81-92
• /
• 2017

Purpose - One of the main objectives of this paper is to identify the most effective type of social media and to analyze the priority of blogs by their informational attributes in the aspect of their impacts on word-of-mouth intention(WOM) in on-line markets. Research design, data, and methodology - We set 'attitude' variable in the middle to see if there is mediating effects between blog information and word-of-mouth intention. We conducted a survey by questionnaire and received 206 answers. Employing the OLS statistical methods through the SPSS package, we tested our hypotheses. Results - Some of the main results are the followings. First, blog, micro-blog, and profile-based services showed significant effects on WOM, while Internet community and mini-homepages are not significant. Second, blog has positive impacts on WOM. Third, attitude has perfect mediating effects between blog and WOM. Fourth, in terms of effects on WOM, interactivity shows the first priority and reliability and usability follows. Finally, attitude has a more significant effect for users of 3 types of blog compared with those of 2 types. Conclusions - In this paper, we analyzed the effects of social network services by type and identified the priority among various attributes of information contained in blogs. It would provide businesses with viable strategic options to establish public relations in their sales promotion.

• 천문학회보
• /
• 제35권2호
• /
• pp.40.2-40.2
• /
• 2010

Polycyclic aromatic hydrocarbon (PAH) features have emerged as one of the most important infrared (IR) features since these PAH features dominate mid-IR spectra of galaxies and are ubiquitous within galactic and extragalactic objects. These PAH features have the potentials to become reliable star formation rate (SFR) proxies and diagnostics of physical conditions of interstellar medium, such as ionization states of dust grains and grain sizes. While constructing an unbiased library of 44 sample galaxies selected from 5MUSES sample, AKARI mJY Unbiased Survey of Extragalactic Sources in 5MUSES (AMUSES) intends to measure and to calibrate the PAH 3.3 mm emission feature which has not been studied extensively due to its weak strength and dearth of capable instruments. Out of 20 target galaxies, we detected the 3.3mm feature from eight galaxies and measured their line strengths, line widths and line ratios with other PAH emission features. Sample galaxies whose spectral energy distributions (SEDs) are classified as starburst-type have clearly stronger 3.3mm emission features than ones with AGN-type SEDs. We also found that there is a correlation between the PAH 3.3mm luminosity and total IR luminosity within our sample galaxies, albeit a large scatter. We further discuss implications of our results.

• 대한한의학회지
• /
• 제18권1호
• /
• pp.157-168
• /
• 1997

The purpose of this study is the separation of biologically active ingredients from Coptidis Rhizoma which has been widely used as one of oriental herbal medicine for body fever. In this study, berberine-type alkaloids were tested on their biological activities in the aspect of antibacterial, antitumor, anti-herpetic and anti-HIV activity. Contents of five major alkaloids for the various origin of Coptidis Rhizoma were assayed by HPLC. As the results, the content of berberine from Coptis chinensis and Coptis japonica were 6.78% and 7.09%, respectively. The contents of coptisine, jatrorrhizine, berberastine from Coptis chinensis were higher than those of Coptis japonica. The amount of palmatine from both species were almost the same. Surprisingly for antitumor experiment, all compounds have been shown remarkable activity, especially against SNU-l(human stomach cancer) cell line. Among the compounds purified through column chromatography, palmatine, coptisine, and jatrorrhizine inhibited the growth of K-562(human chronic myelogenous leukemia) cell line whereas jatrorrhizine has been shown the effective inhibition of A-549 (human lung) cell line at the same time.