• Journal of Korean Society on Water Environment
• /
• v.24 no.5
• /
• pp.523-532
• /
• 2008

A phase II site investigation and feasibility study was conducted at a military mortar shooting range near the demilitarized zone (Kyunggi, South Korea) to assess the extent of contaminants migration to the nearby Imjin river in which a flood control dam is under construction. The results showed that silty-clay soils around target areas were co-contaminated with heavy metals (Cd, Cu, and Pb) and explosives (HMX, RDX, and TNT). The total amount of contaminant was estimated to be 497.1 kg-RDX, 20.6 kg-HMX, 1.4 kg-TNT, 35.2 kg-Cd, 4,331 kg-Cu, and 5,115 kg-Pb, respectively. Both heavy metals and explosives were almost equally distributed on each soil particle size fraction. Neither subsurface soil samples nor ground water samples showed signs of contamination above the environmental criteria. The major migration route of contaminants was soil particles in surface run-off during rain at which a mass discharge rate of 30.0 mg-RDX/hour was observed.

• Journal of the Korean Society of Industry Convergence
• /
• v.24 no.6_2
• /
• pp.883-890
• /
• 2021

In this study, joint analysis was conducted on the rock slope by aerial surveying using UAV. Aerial photos were taken using UAV to measure the directionality of the rock slope exposed to the site, and the directionality of the joint was analyzed using the photographed photos. UAV photography was taken under conditions of 90% overlap and an altitude of 50m. The photographing path was measured in the horizontal, vertical, and oblique directions based on the slope, and the joint characteristics were analyzed. Aerial surveying research on the joint directionality analysis of rock slopes is still incomplete, and the method for accurate joint directionality analysis is not presented strategically, so it is difficult to apply it in design. Through the results of this study, we would like to propose an flight photographing technique for the investigation of rock joints. As a result of the study, in the case of the joint investigation of the rock slope using UAV, it was necessary to change conditions such as altitude, aerial photography route, and overlap according to the size of the joint according to the site conditions.

• Journal of Conservation Science
• /
• v.10 no.1 s.13
• /
• pp.31-37
• /
• 2001

The metallurgical investigation of four lumps of bronze from the third building site of the northern workshop site at the Neungsan-ri temple site in Buyeo was performed. The microstructures of a section of sample was observed by SEM and qualitative and quantitative analysis of the sample was performed by EDS. The results are as follows: Sample 1 of the lump of bronze from northern workshop site in the third building site at Neungsan-ri temple site and sample 2 are speculated to be low-quality bronze resulting from refinery of matte which formed on the process of bronze refinery. Sample 3 is speculated as a lump of bronze which is one of Cu-Sn system and the one made by alloy only with pure bronze and tin on the process of bronze refinery. Sample 4 is confirmed as a lump of bronze which is one of Cu-Sn-Pb system from alloy of tin and lead into pure bronze. It is believed that the third building site at Neungsan-ri temple site in Buyeo produced bronze matte by refinery of copper ore or produced low-quality bronze by melting matte imported from outside.

• Journal of the Korea Institute of Building Construction
• /
• v.3 no.3
• /
• pp.107-112
• /
• 2003

This study is to investigate the properties of concrete with crushed sand on site and to propose a quality guideline for its use as artificial sand and concrete. From our experimental result in laboratory and site, we found that demand water of concrete with crushed sand for target slump increased by 18kg/m3 compared to mixed sand and l8kg/m3 compared to sea sand respectively. The compressive strength increased by around 3∼6% when compared to concrete with sea sand. Accordingly, our study showed that the combined sand mixed with sea sand would be desirable to obtain workability and strength of concrete including dry shrinkage and bleeding test. Furthermore, the optimal replacement percentage of crushed sand was 50% with sea sand. As such, crushed sand would be sufficient as fine aggregate for concrete in terms of economic efficiency and quality. Crushed sand, on the other hand can only be used as fine aggregate when VFS(Very Fine Sand) is below 3.5 percentage of weight of sand and particle shape is above 55 percentage. Also, the particle shape and microsand passing NO.200 sieve should continually be improved to increase workability of concrete on site.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.2 s.48
• /
• pp.51-62
• /
• 2006

In the companion paper (I-Problem Statements of the Current Seismic Design Code), the current Korean seismic design code is required to be modified considering site characteristics in Korea for the reliable estimation of site amplification. In this paper, three site classification methods based on the mean shear wave velocity of the top 30m $V_{S30}$, fundamental site periods $(T_G)$ and bedrock depth were investigated and compared with each other to determine the best classification system. Not enough of a difference in the standard deviation of site coefficients $(F_a\;and\;F_v)$ to determine the best system, and neither is the difference between the average spectral accelerations and the design response spectrum of each system. However, the amplification range of RRS values based on $T_G$ were definitely concentrated on a narrow band than other classification system. It means that sites which have a similar behavior during earthquake will be classified as the same site category at the site classification system based on $T_G$. The regression curves between site coefficients and $T_G$ described the effect of soil non linearity well as the rock shaking intensity increases than the current method based on $V_{S30}$. Furthermore, it is unambiguous to determine sue category based on $T_G$ when the site investigation is performed to shallower depth less than 30m, whereas the current $V_{S30}$ is usually calculated fallaciously by extrapolating the $V_s$ of bedrock to 30m. From the results of this study, new site classification system based on $T_G$ was recommended for legions of shallow bedrock depth in Korea.

• Journal of Soil and Groundwater Environment
• /
• v.13 no.6
• /
• pp.31-39
• /
• 2008

The purpose of this research is to evaluate the efficiency of soil pollution investigation conducted at South Korea and Gyeonggi-do, and to drive the way to improve its efficiency. The average pollution discovery rates in the soil pollution investigation were 2,7% in South Korea and 1.9% in Gyeonggi-do respectively during the last six years (2002${\sim}$2007), which the discovery rates were lower than those of Japan and United States of America. The exceeding rate of the Korea soil pollution standard of the heavy metal and petroleum compounds in the soil pollution investigation were 89.8% and 8.9%, respectively in the whole country. The investigation rate of topsoil for heavy metal and deepsoil analysis for petroleum compounds analysis were 38% and 62% respectively. This show contradictory result which is demanded the improvement of investigation method on the deep soil. The main steps affecting the discovery rate of soil pollution were site selection step, sampling step and analysis step. We suggested the the guideline of priority on the site selection step which was the most important step. Also, the certificate need to be provided to the companies which have lower soil pollution degree after conducting the soil pollution investigation.

• Tunnel and Underground Space
• /
• v.18 no.1
• /
• pp.80-89
• /
• 2008

The influence of in-situ rock stress on the stability of an underground rock structure increases as the construction depth become deeper and the scale of a rock structure become larger. In general, hydraulic fracturing stress measurement has been performed in the surface boreholes of the target area at the design stage of an underground structure. However, for some areas where the high horizontal stresses were observed or where the overstressed conditions caused by topographical and geological factors are expected, it is desirable to conduct additional in-situ stress measurement in the underground construction site to obtain more detailed stress information for ensuring the stability of a rock structure and the propriety of current design. The study area was a construction site for the additional underground oil storage facility located in the south-east part of OO city, Jeollanam-do. Previous detailed site investigation prior to the design of underground structures revealed that the excessive horizontal stress field with the horizontal stress ratio(K) greater than 3.0 was observed in the construction area. In this study, a total of 13 hydraulic fracturing stress measurements was conducted in two boreholes drill from the two water tunnel sites in the study area. The investigation zone was from 180 m to 300 m in depth from the surface and all of the fracture tracing works were carried out by acoustic televiewer scanning. For some testing intervals at more than 200 m ind depth from surface, the high horizontal stress components the horizontal stress ratio(K) greater than 2.50 were observed. And the overall investigation results showed a good agreement with the previously performed test.

• Nuclear Engineering and Technology
• /
• v.53 no.6
• /
• pp.1955-1963
• /
• 2021

As the IAEA has applied integrated safeguards and a state level approach to member states, the importance of national inspection has increased. However, the requirements for national inspection for some member states are different from the IAEA safeguards. In particular, the national inspection for the ROK requires on-site U concentration analysis due to a domestic notification. This research proposes an on-site U concentration analysis (OUCA) method for UO₂ pellets using gamma spectroscopy to satisfy the domestic notification requirement. The OUCA method calculates the U concentration of UO₂ pellets using the measured net X-ray counts and declared ²³⁵U enrichment. This research demonstrates the feasibility of the OUCA method using both MCNP simulation and experiment. It simulated and measured the net X-ray counts of different UO₂ pellets with different U concentrations and ²³⁵U enrichments. The simulated and measured net X-ray counts were fitted to polynomials as a function of U concentration and ²³⁵U enrichment. The goodness-of-fit results of both simulation and experiment demonstrated the feasibility of the OUCA method.

• Economic and Environmental Geology
• /
• v.36 no.3
• /
• pp.191-200
• /
• 2003

Investigations on the contaminated lands due to heavy metals from mining activities or hydrocarbons from oil spillage for example, should be planned based on specific fitness-for-purpose criteria(FFP criteria). A FFP criterion is site specific or varies with situation, based on which not only the data quality but also the decision quality can be determined. The limiting factors on the qualities can be, for example, the total budget for the investigation, regulatory guidance or expert's subjective fitness-for-purpose criterion. This paper deals with planning of investigation methods that can satisfy each suggested FFP criterion based on economic factors and the data quality. To this aim, a probabilistic loss function was applied to derive the cost effective investigation method that balances the measurement uncertainty, which estimates the degree of the data quality, with the decision quality. In addition, investigation planning methods when the objectives of investigations do not lie in the classification of the land but simply in producing the estimation of the mean concentration of the contaminant at the site(e.g. for the use in risk assessment), were also suggested. Furthermore, the efficient allocation of resources between sampling and analysis was also devised. These methods were applied to the two contaminated sites in the UK to test the validity of each method.

• Proceedings of the Plant Resources Society of Korea Conference
• /
• 2018.10a
• /
• pp.24-24
• /
• 2018

Degraded plantation forests are increasing because of unfavorable forestry conditions prevailing in Japan, including falling timber prices, increasing operational costs, and aging and declining forestry workforce. To remedy this situation, appropriate management strategy is required. This study introduces the challenges of Odai Town, Mie Prefecture that employed a new management strategy by evaluating site suitability for conifer forests and that proposes a new forest management regime of planting deciduous trees in unsuitable sites. The site suitability for conifer forests was evaluated from two aspects: the natural site conditions and the relationship among site conditions, growth, and damage by Anaglyptus subfasciatus Pic. in Cryptomeria japonica D. Don and Chamaecyparis obtusa Sieb. Et Zucc. forests. By analyzing the relationship among site conditions, growth, and insect damage based on field data obtained in plantation forests, growth evaluation and insect damage evaluation maps were developed. Based on the natural forest investigation, natural site condition maps for C. japonica and C. obtusa were established. Furthermore, by integrating these evaluation maps with the forest road maps showing the accessibility to the forest, the forest management regime for the whole plantation area of Odai Town was established. The forest management regime map indicates the sites suitable for forestry: suitable for long-rotation, short-rotation, and potential sites for short-rotation. The sites unsuitable for forestry were considered to be more suitable for broadleaved forests. Clear-cutting was conducted in a small area and different seral stage saplings (approximately 20 deciduous tree species) suitable to the site conditions were planted in an area of $80-120m^2$ protected by deer-fences. This might establish a forest composed of many species with a multilayer vertical forest structure in a short period. The planted saplings were distributed neither randomly nor uniformly to reflect the natural distribution of trees in the forest. A challenge to develop new products using the deciduous trees has started, such as wood chips for preparing smoked food, essential oil, and deodorizer. As these challenges have just begun, their effects on enhancing sustainable resource management are still being monitored. Even with the challenges, this regime can be of high value as a management strategy to remedy the situation of expansion of degraded forests in Japan.