• KSBB Journal
• /
• v.10 no.2
• /
• pp.126-130
• /
• 1995

A membrane gas sensor was developed for the measurement of ethanol concentration during acetic acid fermentation. The fermentation broth including ethanol was permeated through the silicone membrane by synthetic air as a carrier gas and was detected by a semiconductor gas sensor. The optimum conditions of membrane gas sensor were 20m1/min of flow rate and 0.5mm of membrane thickness. In acetic acid fermentation, an on-line measurement of ethanol concentration was conducted by the proposed membrane gas sensor and then the on-line sensor signal, was compared with the result of off-line analysis by gas chromatography. As a result, a correlated response over the range of $0∼70g/\ell$ was shown between membrane gas sensor and gas chromatography and this use of membrane gas sensor was experimentally ascertained for the monitoring and control of bioprocess like acetic acid fermentation.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.5
• /
• pp.843-850
• /
• 2016

In this paper, we propose a digital controller design process for the interleaved type of a boost PFC (Power Factor Correction) converter which can disperse the heat of the switching devices due to the interleaved topology. We establish a mathematical model of a boost PFC converter and propose a controller design method based on the root locus. The performance of the designed controller is verified by simulations. The measurement of the input voltage, inductor currents, and the converter output link voltage are needed for the control of the converter system which consists of a power unit and a control unit where a high-performance 32-bit microcontroller is used. The adjustment of A/D conversion timing is also needed to avoid high frequency noise generated when the switches on/off. It is illustrated by the real experiments that the designed control system with the properly adjusted ADC timing satisfies the given performance specifications of the interleaved boost PFC converter in the on-board slow battery charger.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2022.10a
• /
• pp.459-461
• /
• 2022

One of the big differences between Network-on-Chip (NoC) and the existing parallel processing system based on an off-chip network is that data packet routing is performed using a centralized control scheme. In such an environment, the best-effort packet routing problem becomes a real-time assignment problem in which data packet arriving time and processing time is the cost. In this paper, the Hungarian algorithm, a representative computational complexity reduction algorithm for the linear algebraic equation of the allocation problem, is implemented in the form of a hardware accelerator. As a result of logic synthesis using the TSMC 0.18um standard cell library, the area of the circuit designed through case analysis for the cost distribution is reduced by about 16% and the propagation delay of it is reduced by about 52%, compared to the circuit implementing the original operation sequence of the Hungarian algorithm.

• Science of Emotion and Sensibility
• /
• v.7 no.4
• /
• pp.35-41
• /
• 2004

This study addressed the development of an automobile aroma blast device to reduce fatigue of drivers. We also analyzed the adaptation character of the aroma blast device, The aroma blast device was designed in a way that volatilized aroma is mixed with oxygen (air) and blasted to the outside, It was devised to possibly change on/off time of 2-Port Solenoid Valve using the 8051 micro processor, through which the amount of aroma can be controlled, We conducted an experiment to examine time for occurrence/elimination of adaptation to aroma in 20 college students using 4 types of natural fragrances, The subjects had an average age of 22$\pm$2 years and included both men and women. The results showed that the occurrence and elimination times for adaptation to aroma were 1 minute 28 seconds and 3 minutes and 15 seconds for Jasmine 30%, 2 minutes and 41 seconds and 4 minutes and 3 seconds for Jasmine 50%, 1 minute and 47 seconds and 2 minutes and 59 seconds for Peppermint 30%, and 1 minute 59 seconds and 4 minutes and 11 seconds for Peppermint 50%, respectively.

• Journal of the Korean Institute of Gas
• /
• v.16 no.4
• /
• pp.52-58
• /
• 2012

Recently, waste gas incineration is increasing due to strong environmental regulatory system in Korea. These incinerating facilities are usually connected with the top of the storage tank through pipeline and incinerate off gas with the flame. Therefore, the flame originated from these facilities is likely to move back into pipeline and might cause an explosion of the storage tank. Accordingly, the purpose of this study is to suggest the preventive measures and the way to improve the safety of these incineration systems through the cause analysis of a major industrial accident occurred in a acrylic acid manufacturing process in Korea. As a result of the study, the preventive measures are suggested as follows. (1) Air or inert gas inflow facilities should be well designed to dilute flammable gases into air or inert gas sufficiently before the blower is restarted in order to prevent the explosion (2) It is needed for the detonation-type flame arresters to be installed on the top of the storage tanks. (3) In case of using the deflagration-type flame arresters, it is necessary to install a rupture disk before the arresters, or blow off the flame outside tanks by connecting the tank top and the incinerator with hood-type pipe. (4) TDR should be installed to be restarted automatically after the momentary power failure.

• Journal of Bio-Environment Control
• /
• v.10 no.4
• /
• pp.207-212
• /
• 2001

The environmental characteristics, absorption rate of NO$_2$, physiological response, and quality of lettuces were examined in a semi-closed plant production system consisted of human and plant modules. Leaf lettuces were transplanted to 10-cm diameter pots at 4-to 5-leaf stage, and grown in a gas-fumigated plant module. Air containing NO$_2$was circulated 10 min-ON/ 20 min-OFF between the human and plant modules by a diaphragm. At 0.13, 0.30, and 0.45 $\mu$mol.mol$^{-1}$ NO$_2$, NO$_2$ decrements in the chamber during the 10 min were 0.040, 0.109, and 0.149 $\mu$mol.mol$^{-1}$ , respectively. The NO$_2$absorption rate of the plants was estimated to be 0.078 $\mu$mol.mol$^{-1}$ .m$^{-2}$ .min$^{-1}$ at 0.45 $\mu$mol.mol$^{-1}$ NO$_2$ was less than that of the control plant at 4th and 5th days, whereas the respiration rate was the same. The lettuce grown at 0.45 $\mu$mol.mol$^{-1}$ NO$_2$ had similar leaf length, leaf area, dry and fresh weights, and quality to that grown without NO$_2$.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.274-274
• /
• 2014

금속칼코게나이드 화합물중 하나인 $MoS_2$는 초저 마찰계수의 금속성 윤활제로 널리 사용되고 있으며 흑연과 비슷한 판상 구조를 지니고 있어 기계적 박리법을 통한 그래핀의 발견 이후 2차원 박막 합성법에 대한 활발한 연구가 진행되고 있다. 최근 다양한 응용이 진행 중인 그래핀의 경우 높은 전자이동도, 기계적 강도, 유연성, 열전도도 등 뛰어난 물리적 특성을 지니고 있으나 zero-bandgap으로 인한 낮은 on/off ratio는 thin film transistor (TFT), 논리회로(logic circuit) 등 반도체 소자 응용에 한계가 있다. 하지만 $MoS_2$는 벌크상태에서 약 1.2 eV의 indirect band-gap을 지닌 반면 단일층의 경우 1.8 eV의 direct-bandgap을 나타내고 있다. 또한 단일층 $MoS_2$를 이용하여 $HfO_2/MoS_2/SiO_2$ 구조의 트랜지스터를 제작하였을 때 $200cm^2/v^{-1}s^{-1}$의 높은 mobility와 $10^8$ 이상의 on/off ratio 나타낸다는 연구가 보고되어 있어 박막형 트랜지스터 응용을 위한 신소재로 주목을 받고 있다. 한편 2차원 $MoS_2$ 박막을 합성하기 위한 대표적인 방법인 기계적 박리법의 경우 고품질의 단일층 $MoS_2$ 성장이 가능하지만 대면적 합성에 한계를 지니고 있으며 화학기상증착법(CVD)의 경우 공정 gas의 분해를 위한 높은 온도가 요구되므로 박막형 투명 트랜지스터 응용을 위한 플라스틱 기판으로의 in-situ 성장이 어렵기 때문에 이를 보완할 수 있는 $MoS_2$ 박막 합성 공정 개발이 필요하다. 특히 Plasma enhanced chemical vapor deposition (PECVD) 방법은 공정 gas가 전기적 에너지로 분해되어 chamber 내부에서 cold-plasma 형태로 존 재하기 때문에 박막의 저온성장 및 대면적 합성이 가능하며 고진공을 바탕으로 합성 중 발생하는 오염 요소를 효과적으로 제어할 수 있다. 본 연구에서는PECVD를 이용하여 plasma power, 공정압력, 공정 gas의 유량 등 다양한 공정 변수를 조절함으로써 저온, 저압 조건하에서의 $MoS_2$ 박막 성장 가능성을 확인하였으며 전구체로는 Mo 금속과 $H_2S$ gas를 사용하였다. 또한 향후 flexible 소자 응용을 위한 플라스틱 기판의 녹는점을 고려하여 공정 온도는 $300^{\circ}C$ 이하로 설정하였으며 합성된 $MoS_2$ 박막의 두께 및 화학적 구성은 Raman spectroscopy를 이용하여 확인 하였다. 공정온도 $200^{\circ}C$와 $150^{\circ}C$에서 성장한 $MoS_2$ 박막의 Raman peak의 경우 상대적으로 낮은 공정온도로 인하여 Mo와 H2S의 화학적 결합이 감소된 것을 관찰할 수 있었고 $300^{\circ}C$의 경우 약 $26{\sim}27cm^{-1}$의 Raman peak 간격을 통해 5~6층의 $MoS_2$ 박막이 형성 된 것을 확인할 수 있었다.

• Korean Journal of Optics and Photonics
• /
• v.24 no.5
• /
• pp.231-236
• /
• 2013

We investigated the optical design of a smart headlamp capable of producing various beam patterns through only on/off modulation of light sources. This was implemented by forming a continuous matrix of beams from discontinuous beam patterns by means of a multi-array LED optical system. As one such optical system, the multi-array LED system is a convenient and economical device for implementing beam patterns with the simple on/off modulation of the light sources. A single optical assembly module can be made by combining a multiple-LED array, optical system module, and electronic control with no need for any additional mechanical components. The present optical system was designed to include a secondary lens and a projection lens mounted at the front of each LED in the array to realize accurate lighting patterns as well as the required luminosity at a distance of 25 m in the forward direction. Finally, we identified and analyzed the patterns implemented by the designed optical system that produced satisfactory performance of high beams and adaptive driving beams (ADB).

• Journal of Korea Water Resources Association
• /
• v.51 no.spc
• /
• pp.1135-1148
• /
• 2018

Previous studies on reservoir operation have been assumed that the climate in the future would be similar to that in the past. However, in the presence of climate non-stationarity, Robust Optimization (RO) which finds the feasible solutions under broader uncertainty is necessary. RO improves the existing optimization method by adding a robust term to the objective function that controls the uncertainty inherent due to input data instability. This study proposed Robust-SDP that combines Stochastic Dynamic Programming (SDP) and RO to estimate dam operation rules while coping with climate non-stationarity. The future inflow series that reflect climate non-stationarity were synthetically generated. We then evaluated the capacity of the dam operation rules obtained from the past inflow series based on six evaluation indicators and two decision support schemes. Although Robust-SDP was successful in reducing the incidence of extreme water scarcity events under climate non-stationarity, there was a trade-off between the number of extreme water scarcity events and the water scarcity ratio. Thus, it is proposed that decision-makers choose their optimal rules in reference to the evaluation results and decision support illustrations.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.22 no.1
• /
• pp.461-467
• /
• 2021

Among the defect factors that can occur when a wafer-level lens is molded using a thermosetting material, the mold sticking problem of a molded lens during the release process can damage the molded substrate and deform the substrate at the wafer level. An experiment was conducted to examine the factors affecting the demolding force in the lens forming process. The demolding force was examined according to the coating material of the molds. The mold was surface-treated with ITO and Ti, followed by plasma treatment in an O2 atmosphere. A DLC coating was then performed, and the curing and releasability were examined. A coating method for the pull-off experiment was selected based on the results. To measure the demolding force according to the curing process conditions, a method of curing at a constant pressure and a method of curing at a constant position were applied. As a result, the TiO2 surface treatment reduced the release force. When cured by controlling the location, curing shrinkage can reduce the adhesion energy of the interface during curing, resulting in better demolding.