• 한국물환경학회지
• /
• 제22권3호
• /
• pp.534-539
• /
• 2006

The supply of oxygen for aeration is the largest energy consumer at activated sludge wastewater treatment plants. Replacement of less efficient aeration systems with fine pore aeration devices can save up to 50 percent of aeration energy costs. The purpose of this study was the diagnosis and evaluation of a domestic wastewater aeration system by the off-gas method which had been studied by US EPA and ASCE. For this study, an off-gas analyzer and its hood were made to collect off-gas. Also, a vacuum pump was connected to the analyzer to make suction of off-gas. Experiments were conducted at a domestic activated sludge wastewater treatment plant which had a single spiral roll aeration system installed with P.E tube diffuser. Data on OTE(f), SOTE(pw), OUR, and air flow rate were obtained from these experiments. In case of replacing an aeration system, it is recommended that it should be replaced with perforated membrane disc or ceramic disc fine bubble diffusers installed in a full floor coverage or grid pattern.

• International Journal of Automotive Technology
• /
• 제7권4호
• /
• pp.385-390
• /
• 2006

A fast response $CO_2$ analyzer has been developed to study transient characteristics on an SI engine. The analyzer has the delay time of 4.5 ms and time constant of 2.8 ms, which is fast enough to measure $CO_2$ concentration on a transient condition. Wide range of A/F(Air/Fuel) ratio can be estimated using the analyzer with an additional switch type oxygen sensor. The results of measurement of $CO_2$ concentration and A/F ratio on a transient condition including rapid acceleration/deceleration and EGR(Ehxaust Gas Recirculation) on/off are presented and compared with a commercial exhaust gas analyzer and UEGO(Universial Exhaust Gas Oxyzen) sensor.

• 전기학회논문지
• /
• 제59권8호
• /
• pp.1423-1428
• /
• 2010

The results of off-line and on-line diagnostic tests performed on the stator winding of an air-cooled gas turbine(G/T) generator are reported in this paper. Off-line diagnostic tests included measurements of the ac current, dissipation factor(tan${\delta}$), and partial discharge(PD). Six epoxy-mica capacitors were installed in the three phases of G/T generator for performing on-line diagnostic testing with the turbine generator analyzer(TGA). The TGA showed that the normalized quantity number(NQN) and the PD magnitude($Q_m$) were high in phase A of the stator winding. Internal discharges were generated in phases B and C, and slot discharge occurred in phase A. According to the trend analyses of the NQN and $Q_m$ values available for insulation condition assessment for G/T generator stator windings, it was concluded that phases B and C were in good condition, whereas phase A has been significantly deteriorated.

• 한국연소학회지
• /
• 제21권4호
• /
• pp.1-5
• /
• 2016

The aim of this study is to compare the effectiveness of turbo chargers on engines for off-road use when combined with WGT and VGT technologies. The effectiveness of turbo chargers was measured and performance was compared using a functional model. Exhaust characteristics were compared using WGT and VGT technologies through a gas analyzer. Results showed VGT technology was more effective at high RPM compared to WGT technology. When it came to maximising turbo performance, VGT was more effective than WGT in every test. WGT and VGT produced similar exhaust NOx levels, whereas the VGT was more effective on the PM.

• 한국진공학회지
• /
• 제17권1호
• /
• pp.1-8
• /
• 2008

포항가속기연구소 저장링에 설치된 방사광 차단용 진공부품에서 냉각수가 누설되었을 때의 진공도 분포, 압력 변화, 잔류 기체의 변화 등을 측정하여 그 특성을 분석하였다. 냉각수 누설 시에 압력 상승은 국부적으로 나타났으며 잔류 기체의 변화 양상은 누설 위치로부터 잔류기체 분석기까지 거리와 이온펌프 및 전자빔의 On/Off에 따라서 크게 달랐으며 특정 기체의 선택적 상승도 나타났다. 냉각수 누설의 발견은 전압변화 측정으로 가능하였으며 잔류기체 분석기로는 물분자를 직접 측정하기보다는 $CH_4$, CO, NO 등 특성 기체의 증가를 분석함으로 누설 여부를 판단할 수 있었다.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 전기학술대회논문집
• /
• pp.1166-1169
• /
• 2005

This paper describes a new transient voltage suppressor(TVS) with a low insertion loss and a high cut-off frequency to protect antenna circuit from transient voltages. Conventional protection devices have some problems such as a low frequency bandwidth and a high insertion loss. In order to improve these limitations, a coaxal type TVS, which consists of a gas tube is developed. The performance of the proposed transient voltage suppressor is tested by using a combination surge generator specified in IEC 61000-4-5 standard and by using a network analyzer of 40 MHz ${\sim}$ 5 GHz bandwidth. From the experimental results, it is confirmed that the proposed TVS has an enough protection performance in a low insertion loss and a high cut-off frequency.

• 전기학회논문지P
• /
• 제60권3호
• /
• pp.114-119
• /
• 2011

Large Power transformer is a complex and critical component of power plant and consists of cellulosic paper, insulation oil, core, coil etc. Insulation materials of transformer and related equipment break down to liberate dissolved gas due to corona, partial discharge, pyrolysis or thermal decomposition. The dissolved gas kinds can be related to the type of electrical faults, and the rate of gas generation can indicate the severity of the fault. The identities of gases being generated are using very useful to decide the condition of transformation status. Therefore dissolved gas analysis is one of the best condition monitoring methods for power transformer. Also, on-line multi-gas analyzer has been developed and installed to monitor the condition of critical transformers. Rogers method, IEC method, key gas method and Duval Triangle method are used to failure diagnosis typically, and those methods are using the ratio or kinds of dissolved gas to evaluate the condition of transformer. This paper analyzes the reliability of transformer diagnostic methods considering actual dissolved gas concentration. Fault diagnosis is performed based on the dissolved gas of five transformers which experienced various fault respectively in the field, and the diagnosis result is compared with the actual off-line fault analysis. In this comparison result, Diagnostic methods using dissolved gas ratio like Rogers method, IEC method are sometimes fall outside the ratio code and no diagnosis but Duval triangle method and Key gas method is correct comparatively.

• 대한환경공학회지
• /
• 제27권8호
• /
• pp.859-869
• /
• 2005

소각장 off gas에 장기간 노출이 되어 활성이 저하된 상용 $V_2O_5-WO_3/TiO_2$ aged 촉매를 물리화학적 방법으로 재생 처리를 수행한 후, 재생 처리에 따른 촉매의 물성 변화를 확인하고 이에 따른 촉매 활성변화를 고찰하였다. 촉매의 특성분석은 XRD(x-ray diffractometer), BET, POROSIMETER, EDX(energy dispersive x-ray spectrometer), ICP(inductively coupled plasma), TGA(thermogravimetric Analyze,), SEM(scanning electron microscopy)등을 이용하여 수행하였고 NOx 전환반응실험은 소각장 off gas를 모사하여 $NH_3$에 의한 SCR 반응을 통해 수행하였다. 본 연구에서 수행된 재생처리 방법 중, 열처리 방법으로 재생처리를 수행 할 경우 fresh 촉매환성의 95% 이상을 회복하였으며, 화학적 재생 처리 방법으로는 산성용액의 경우는 pH가 5인 용액으로 재생 처리된 촉매가, 염기성 용액의 경우는 pH가 12인 용액으로 재생 처리된 촉매가 fresh 촉매활성의 90% 이상의 촉매 활성을 회복 하였다. 촉매 특성 분석 결과, 상기와 같은 방법으로 재생 처리된 촉매의 경우 비표면적은 fresh 촉매의 $85{\sim}95%$ 수준으로 회복 되었으며, aged 촉매 표면에 축적되어 있던 촉매 비활성 물질로 잘 알려진 황(S)이나 칼슘(Ca)등은 최대 99%이상 제거 되었다. Aged 촉매 표면상의 인(P), 크롬(Cr), 아연(Zn) 등과 같은 중금속의 경우는 최대 95% 이상 제거 되었으나 납(Pb)의 경우는 제거율이 $10{\sim}30%$ 수준으로 매우 미흡한 것으로 나타났다.

• 멤브레인
• /
• 제29권1호
• /
• pp.51-60
• /
• 2019

분리막 소재의 투과도와 선택도 사이의 trade-off 관계로 인해 여전히 많은 연구가 필요하다. 특히 고분자 분리막에 무기물 나노입자가 들어가 있을 때, 기체투과 거동의 학문적 이해는 여전히 부족하다. 따라서 본 연구에서는 분리막 소재로 가장 많이 사용되는 PDMS에 2~5 nm의 기공을 가지고 있으며 직경이 약 5 nm 크기의 aluminosilicate hollow nanoparticles인 allophane을 이용하여 복합매질 분리막을 제조하여 기체투과특성을 연구하였다. 대표적인 분리막 소재인 PDMS에 친수성 allophane, 그리고 나노입자에 undecylenic acid로 표면을 개질한 allophane을 막 내부에 고르게 분산시켜 함량 별로 복합매질 분리막을 제조하였다. 나노입자가 분산된 혼합매질 분리막 내에서 기체의 투과 특성을 파악하고, 이에 따른 기체투과 거동과 나노입자가 가지고 있는 기공의 역할을 평가하고자 하였다. 표면개질된 allophane을 첨가함에 따라 기체 투과도와 산소/질소 그리고 이산화탄소/메탄의 선택도가 동시에 점진적으로 향상되는 결과를 얻었다.

• 한국분무공학회지
• /
• 제18권1호
• /
• pp.16-20
• /
• 2013

The investigation was conducted to analyze the exhaust emission characteristics in diesel engine according to intake air mass flow. In this study, the test diesel engine with a 5,899 cubic centimeter displacement and power of the 260 ps was used to analyze the emission characteristics according to the intake air mass flow. In addition, the test modes were applied by the ND-13 and ETC mode. In order to analyze the emission characteristics, the engine dynamometer with 440 kW and emission gas analyzer (AMA-4000) were utilized. From the experimental results, it is revealed that the NOx and HC emissions in the intake air mass flow of large amount have high levels compared to those in the intake air mass flow of small amount in the ND-13 mode. However, the PM emission was shown the opposite trend in the NOx and HC emission due to the trade-off relation between the NOx and PM.