• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.4
• /
• pp.651-658
• /
• 2001

A novel multi-section power divider configuration is proposed to obtain wide-band frequency performance up to microwave frequency region. Design procedures for the proposed microwave broadband power divider are composed of a planar multi-section three-ports hybrid and a waveguide transformer design procedures. The multi-section power divider is based on design theory of the optimum quarter-wave transformer. Furthermore, in order to obtain the broadband isolation performance between the two adjacent output ports, the odd mode equivalent circuit should be matched by using the lossy element such as resistor. The derived design formula for calculating these odd mode matching elements is based on the singly terminated filter design theory. The waveguide transformer section is designed to suppress the propagation of the higher order modes such as waveguide modes due to employing the metallic electric wall. Thus, each section of the designed waveguide transformer should be operated with evanescent mode over the whole design frequency band of the proposed microwave broadband power divider. This paper presents several simulations and experimental results of multi-section power divider to show validity of the proposed microwave broadband power divider configuration. Simulation and experiment show excellent performance of multi section power divider.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.7
• /
• pp.10-16
• /
• 1999

This paper describes a low voltage swing bus driver using FCSR(Feedback Control Swing voltage Reduction) which can control bus swing voltage within a few hundred of mV. It is proposed to reduce power consumption in On-chip interface, especially for MDL(Merged DRAM Logic) architecture wihich has wide and large capacitance bus. FCSR operates on differential signal dual-line bus and on precharged bus with block controlling fuction. We modeled driver and bus to scale driver size automatically when bus environment is variant. We also modeled coupling capacitance noise(crosstalk) of neighborhood lines which operate on odd mode with parallel current source to analysis crosstalk effect in the victim-line according as voltage transition in the aggressor-line and environment in the victim-line. We built a test chip which was designed to swing 600mV in bus, shows 70Mhz operation at 3.3V, using Hyundai 0.8um CMOS technology. FCSR operate with 250Mhz at 3.3V by Hspice simulation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.907-915
• /
• 2002

In this paper, a compact digital phase shifter to be used an active phased array antenna system for satellite communications was proposed. The even and odd mode analysis for a given reflection-type phase shifter, which uses a folded hybrid coupler as a base element, was performed and the design parameters were derived. Also, to verify experimentally the electrical performances of the proposed structure, X-band 4-bit digital phase shifter was designed and fabricated using Teflon soft substrate $({\varepsilon}_r; =\;2.17)$. Its circuit size was less than 3.5 cm $\times$ 3.0 cm, and it exhibited at least 50 % size reduction as compared with the conventional unfolded configuration. The experimental results of the fabricated phase shifter showed that the average insertion loss and insertion loss variation were less than 3.5 dB, $\pm$ 0.6 dB within the operating band, 7.9 ~ 8.4 GHz, respectively. And, input and output return loss were more than 10 dB, respectively. Also, the phase response of the phase shifter showed 4-bit operation with $\pm$3$^{\circ}$ rms phase error.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.12
• /
• pp.35-41
• /
• 2011

In this paper, an analysis for a new substrate shielding symmetric coupled MIS structure consisting of grounded crossbar at the interface between Si and SiO2 layer using the Finite-Difference Time-Domain(FDTD) method is presented. In order to reduce the substrate effects on the transmission line characteristics, a shielding structure consisting of grounded crossbar lines over time-domain signal has been examined. Parameters of symmetric coupled MIS transmission line with various gaps between crossbars for even- and odd-mode are investigated as the functions of frequency, and the extracted distributed frequency-dependent transmission line parameters and corresponding equivalent circuit parameters as well as quality factor for the new MIS crossbar embedded structure are also presented. It is shown that the quality factor of the symmetric coupled transmission line can be improved without significant change in the characteristic impedance and effective dielectric constant.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.4
• /
• pp.7-14
• /
• 1975

A significant new technique in the dsvelopment of micro-wave circuits is the process of untilization of coupled lines in the transverse electro-magnetic field. The bases for this technique are the application of even-and odd-mode characteristic impedances of the transmission line. This article describes the properties of directional couplers and explains a prccfdure usrd to design micro-strip directional couplers with the aid of the computer. The article also describes the experimental results obtained from seven microstrip couplers, which were built to verify the computer program and the approximate solutions. It can be seen that in cases at X-band where couplings of 10 to 20dB are required, the computer program and approximate solutions will produce good results.

• Journal of the Optical Society of Korea
• /
• v.1 no.2
• /
• pp.81-89
• /
• 1997

The formation of phase singularities in optical fibers is theoretically and experimentally investigated. In particular, their structural characteristics and properties are discussed in relation to guided mode patterns. It is found that except for the fundamental linearly polarized(LP) modes, all the mixed modes displayed phase singularities in the transverse plane. The results in the few mode fiber show that superposition of the LP even and odd modes produces isolated dark points and phase singularities. Phase singularities are found to be of the screw type and of first order. The number of phase singularities linearly increases with the number of guided modes.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.664-669
• /
• 2003

This paper proposes a swing-arm type dual-stage actuator, which consists of a PZT actuator for fine motion and a VCM(Voice Coil Motor) for coarse motion, for SFF ODD(Small Form Factor Optical Disk Drive), in order to achieve fast access speed and precise track following control. We focus our attention on the design and control of the PZT actuator, because there have been a lot of previous researches related to the VCM and dual-stage actuators. Due to the dual cantilever structure, the PZT actuator can generate precise translational tracking motion at its tip where optical pickup is attached at, and the effect of hysteric behavior of the PZT element is reduced. The dynamic model of the PZT actuator is derived by using the Hamilton's principle, and verified by comparing with the experimental frequency response. The sliding mode control is designed in order to be robust against modeling uncertainties. Simulations and experimental results confirm the effectiveness of the suggested control scheme.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.6
• /
• pp.1-5
• /
• 1983

A new equation, which enables us to calculate the characteristics of coupled slot-lines on a dielectric substrate, is derived. Their calculations are based on the single slot-line analysis of S.B. Cohn, but each equation of total admittance in the even mode and the odd mode is derived by a different approach. The results agree with Knorr and Kuchler's data.

• Proceedings of the IEEK Conference
• /
• 2000.07a
• /
• pp.167-170
• /
• 2000

This paper describes a novel multi-operand radix-2 signed-digit(SD) adder. The novel multi-operand addition algorithm can eliminate carry propagation chain by dividing the input operands into even place part and odd place part, and adding them each. The multi-operand adder with this algorithm can add six operands in parallel, and is faster than the ordinary method of SD adder binary tree. A hardware model for proposed adder is shown which is implemented by the current-mode MOSFET circuit technology. Simulations have been made by SPICE in order to verify the function of the proposed circuit.

• Transactions of the Society of Information Storage Systems
• /
• v.7 no.1
• /
• pp.13-18
• /
• 2011

As a standard of optical disk drive (ODD) was determined to Blu-ray diks (BD), researches for securing slim drive thickness, high data transfer rate and high capacity have been progressed. The actuator for applying BD is also required to have high performances, such as compatibility, slim thickness and 3-axis motion. In this paper, an asymmetric dual lens actuator is proposed to satisfy abovementioned performances. To design the actuator in a limited space, stress analysis and design of experiment (DOE) are performed to reduce weight of moving part and increase driving force and flexible mode frequency. Consequently, the final model, which is satisfied with specifications, is secured.