• Journal of Astronomy and Space Sciences
• /
• v.28 no.4
• /
• pp.299-304
• /
• 2011

As more satellites are designed to downlink their observed image data through the X-band frequency band, it is inevitable that the occupied bandwidth of a target satellite will overlap with that of other X-band downlink satellites. For sun-synchronized low earth orbit satellites, in particular, it can be expected that two or more satellites be placed within the looking angle of a ground station antenna at the same time. Due to the overlapping in the frequency band, signals transmitted from the adjacent satellites act as interferers, leading to degraded link performance between target satellite and ground station. In this paper, link analysis was initiated by modeling the radiation pattern of ground station antenna through a validated Jet Propulsion Laboratory peak envelope model. From the relative antenna gain depending on the offset angle from center axis of maximum antenna directivity, the ratio of received interference signal level to the target signal level was calculated. As a result, it was found that the degradation increased when the offset angle was within the first point of radiation pattern. For a 7.3 m antenna, serious link degradation began at an offset angle of 0.4 degrees. From this analysis, the link performance of the coming satellite passes can be recognized, which is helpful to establish an operating procedure that will prevent the ground station from receiving corrupted image data in the event of a degraded link.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.11
• /
• pp.10-22
• /
• 1998

In this paper, as a way of improving the availability and spectral efficiency of radio relay system, a co-channel radio relay system based upon the synchronous digital hierarchy is developed and its performance measured by 64-QAM with a never-seen multi-purpose ASIC chip is illustrated. This system provides a couple of transmission capacity compared with alternative channel arrangement. By adopting a powerful complex 13-tap adaptive time domain equalizer and cross-pol interference canceller, improvement of more than 1.5 ~ 2.0 dB in signature is obtained in comparison to 9 or 11-tap adaptive time domain equalizer, and about 22.5 dB in improvement factor of cross-pol interference canceller is achieved at C/N of 24.5 dB. In addition, digital filter makes it possible to optimize the occupied bandwidth by selecting an appropriate roll-off factor externally. It is expected that co-channel radio relay system with the powerful multi-purpose ASIC chip plays a key role in creating a value-added product, reliability, and reducing the outage time.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.43-51
• /
• 2013

This paper presents a design and implementation of a low power switched-capacitor 3rd-order delta-sigma modulator for a digital hearing-aid application. The power consumption is reduced by minimizing the output swing of integrators through optimizing the coefficients of modulator architecture and using class-AB output operational amplifiers. The modulator was implemented in a 130nm CMOS technology, and measured to have 79dB of SNR(Signal-to-Noise Ratio) in the signal bandwidth between 100Hz and 10kHz with an oversampling ratio of 160. The power consumption was $60{\mu}W$ from 1.2V power supply and the modulator core occupied $0.53mm{\times}0.53mm$.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.292-299
• /
• 2013

In this paper, we developed a data transmission system over coaxial cable based on the IEEE 802.15.3 MAC and Ultra-Wideband(UWB) Physical Layer. This system is capable of operation in both wireless and wired medias. When operating on coax cable it is capable of Gigabit bi-directional data rate operation on in-home coax wiring and over Hybrid-Fiber-Coax(HFC) cable infrastructure. The developed system transceives command, control and data over a 75 ohm coax system in a home or office. This system operates at a center frequency of 4GHz with a total occupied bandwidth of 1.33Ghz centered on 4GHz. The system uses BPSK modulation and sends symbols at a maximum power level of +15dBm. It has been tested and works through up to three CATV RF splitters in a home environment.

• Journal of the Korean Magnetics Society
• /
• v.3 no.1
• /
• pp.48-55
• /
• 1993

We report the photoemission (PES) studies for the Co/Pd multilayter. The Co 3d PES spectrum of Co/Pd exhibits two interesting features, one near the Fermi energy, $E_{F}$, and another at ~2.5 eV below $E_{F}$. The Co 3d peak near $E_{F}$ of Co/Pd is much narrower than that of the bulk Co, consistent with the enhanced Co magnetic moment in Co/Pd compared to that in the bulk Co. The Co 3d feature at ~-2.5 eV resembles the Pd valence band structures, which suggests a substantial hybridization between the Co and Pd sublayers. The Co 3d PES spectrum of Co/Pd is compared with the existing band structures, obtained using the local spin density functional calculations. A reasonable agreement is found concerning the bandwidth of the occupied part of the Co 3d band, whereas a narrow Co 3d peak near $E_{F}$ seems not to be described by the band structure calculations.