• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.11
• /
• pp.1380-1386
• /
• 2016

In this paper, we propose and evaluate OFDM(Orthogonal Frequency Division Multiplexing)-SSB(Singe Side Band) for improving spectral efficiency. The proposed system is based on OFDM system using DCT(Discrete Cosine Transform) and DHT(Discrete Hilbert Transform) for SSB modulation, this proposed system transmit a BPSK modulation signal through a single sideband and BPSK modulation signal through the other single sideband. In other words, we design and evaluate the proposed system which transmit two BPSK signal through each other single sideband. Also each BPSK BER performance is similar with theoretical BPSK BER performance. the proposed system transmits BPSK signal using half of spectrum of conventional OFDM system or transmit two BPSK signal in same time.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.9
• /
• pp.1000-1009
• /
• 2008

The purpose of this paper is to analyze the performance of MB-OFDM UWB system when the interference signal that can be WIMAX signal or 4 G system signal is received by detection limit of -80 dBm/MHz proposed in Korea for DAA(Detect And Avoid) to permit UWB in $3.1{\sim}4.8$ GHz. MB-OFDM UWB system supports two transmission modes; one is TFI(Time frequency Interleaving) mode that transmits OFDM symbols using different carrier frequency from symbol to symbol according to Time Frequency(TF) codes, the other is FFI(Fixed Frequency Interleaving) mode that transmits OFDM symbols using a specific carrier frequency. In this paper, we considered the TX average power and the synchronization structure to reflect the effect of frequency hopping according to TFC. Interference analysis results show that the WiMAX system is fenced thoroughly from UWB interference in domestic DAA regulation, but the performance of MB-OFDM UWB system is degraded seriously by an interference signal with the DAA detection limit even in frequency Hopping mode that can get frequency diversity effect.

• ETRI Journal
• /
• v.38 no.6
• /
• pp.1124-1134
• /
• 2016

The tone reservation method is one of the most effective pre-distortion methods for peak-to-average power ratio reduction in orthogonal frequency division multiplexing (OFDM) systems. Its direct application to OFDM systems with offset quadrature amplitude modulation (OQAM) is, however, not effective. In this paper, two novel TR-based methods are proposed, specifically designed for OFDM/OQAM systems by taking into consideration the overlapping nature of OQAM signals. These two methods have different approaches to the generation of the peak-cancelling signal. The first one (overlapped scaling tone reservation) generates the peak-cancelling signal using a least squares approximation algorithm with possible adjacent symbol overlap; the second one (multi-kernel tone reservation) generates the peak-cancelling signal by using multiple impulse-like time domain kernels. It is shown by simulation that, when used in OFDM/OQAM systems, the proposed methods can provide better performance than the direct application of the existing controlled clipping tone reservation method, and even outperform the multi-block tone reservation method.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.4
• /
• pp.89-95
• /
• 2008

In the maritime communication, Orthogonal Frequency Division Multiplexing (OFDM) communication terminal should be operated with low power consumption, because the communication should be accomplished in the circumstance of disaster. Therefore, Low power FFT processor is required to be designed with current mode signal processing technique than digital signal processing. Current- to-Voltage Converter (IVC) is a device that converts the output current signal of FFT processor into the voltage signal. In order to lessen the power consumption of OFDM terminal, IVC should be designed with low power design technique and IVC should have wide linear region for avoiding distortion of signal voltage. To design of one-chip of the FFT LSI and IVC, IVC should have a small chip size. In this paper, we proposed the new IVC with wide linear region. We confirmed that the proposed IVC operates linearly within 0.85V to 1.4V as a function of current-mode FFT output range of -100~100[uA]. Designed IVC will contribute to realization of low-power maritime data communication using OFDM system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.6C
• /
• pp.498-504
• /
• 2008

In this paper, an efficient hardware platform for the digital signal processing for OFDM Communication systems is presented. The hardware platform consists of a single FPGA, two DSPs with 8000 MIPS of maximum at 1 GHz clock, 2-channel ADC and DAC supporting maximum 125 MHz sampling rate, and flexible data bus architecture, so that a wide variety of baseband signal processing algorithms for practical OFDM communication systems may be implemented and tested. The IEEE 802.16 software modem is also presented in order to verify the effectiveness and usefulness of the designed platform.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3A
• /
• pp.214-220
• /
• 2006

In this paper, we propose the transmit power controlled adaptive modulated OFDM with frequency symbol spreading and equalization(TPC-AMS/FSS-OFDM) system. In the transmitter of the TPC-AMS/FSS-OFDM, each SP transformed signal is spread by orthogonal spreading codes and combined, so the detected signals obtain the same SINR(signal interference to noise ration) for each frequency symbol spreading block. In this case, we can assign the same modulation level and transmit power for each frequency symbol spreading block. Thus, the proposed system provides the increased throughput performance with reducing the total transmit power, FBI and MLI.

• ETRI Journal
• /
• v.37 no.4
• /
• pp.677-684
• /
• 2015

Recently, orthogonal frequency-division multiplexing (OFDM) was applied to VLC systems owing to its high rate capability. On the other hand, a real-valued unipolar OFDM signal for VLC significantly reduces bandwidth efficiency. For practical implementation, channel estimation is required for data demodulation, which causes a further decrease in spectral efficiency. In addition, the large fluctuation of an OFDM signal results in poor illumination quality, such as chromaticity changes. This paper proposes a spectrally efficient method based on a hidden-pilot-aided precoding technology for VLC with less flickering than a conventional OFDM-based method. This approach can obtain channel information without any loss of bandwidth efficiency while ensuring illumination quality by reducing the flickering effect of an OFDM-based VLC. The simulation results show that the proposed method provides a 6.4% gain in bandwidth efficiency with a 4% reduction in flicker compared to a conventional OFDM-based method.

• The Journal of the Acoustical Society of Korea
• /
• v.28 no.2
• /
• pp.107-111
• /
• 2009

Acoustic OFDM is used for audible frequency band acoustic communication which employs loudspeaker as transmitter and microphone as the receiver antenna. Since acoustic OFDM can transmit about 1 kbps using 1600 Hz band. acoustic OFDM signal is inserted into the audio signal like music or speech, However. audio quality deteriorates definitely during the inserting process. This paper introduces a reason for audio quality deterioration and discuss how to reduce this phenomenon.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.3C
• /
• pp.331-337
• /
• 2007

In this paper, we propose a novel Walsh coded training signal design and Walsh decoding method to estimate the channel response in MIMO-OFDM systems. The Walsh coded training signals are designed to have orthogonal property in time domain. Using the orthogonal property, the Walsh decoding process makes it possible to separate the desired training signal from the received signal and to estimate the channel response. The computer simulation results show that the proposed method exhibits almost the same performance as Li's original method using the optimal training sequence, even though the proposed method has much lower complexity.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.574-577
• /
• 2002

In this paper, we propose a new symbol time synchronization scheme suitable for the OFDM system with an interpolator. The proposed performs the following three steps. In the first step, the coarse symbol time synchronization is achieved by continuously measuring the average power of the received envelope signal. Based on this average power, the detection possibility for the symbol time synchronization is determined. If the signal is sufficient for synchronization, we next perform a relatively accurate symbol time synchronization by measuring the correlation a short training signal and the received envelope signal. Finally, an additional frequency synchronization is performed with a long training signal to correct symbol synchronization errors caused by the phase rotation. From the simulation results, one can see that the proposed synchronization scheme provides a good synchronization performance over frequency selective channels.