• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.2
• /
• pp.393-400
• /
• 2015

As the development and distribution of the intelligent transport system is spreading recently and some of the services are commercialized through a pilot project, interest in DSRC with high utilization is increasing and antennas for roadside and on board equipment are being studied. A single patch was used for a vehicle antenna due to the requests of miniaturization of size, but there was performance degradation in most cases due to miniaturization. In addition, some methods to improve performance have been used in the antennas that were previously researched using the arrays, but they have the disadvantages of bulkiness in size of the antennas when using the arrays. Therefore, in this paper, the CPW fed microstrip patch antenna with the simple structure of being compact and easy to produce, which can be used in the OBU of DSRC, was designed.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.3 no.1 s.4
• /
• pp.21-30
• /
• 2004

This paper describes the design of RF link between RSE and OBU of ETCS and the analysis of the antenna beam pattern to get a proper communication area in the cross direction and traveling direction of lanes. This stage should be performed prior to determination of system requirements of ITS service based on active DSRC. This study is important and fundamental technical analysis to design and implement base station of ETCS.

• 한국ITS학회:학술대회논문집
• /
• 2003.11a
• /
• pp.182-187
• /
• 2003

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.3 no.1 s.4
• /
• pp.75-83
• /
• 2004

This paper describes the design, fabrication, and measurement of a low side lobe antenna for RSE base station of the ETCS which is one of the ITS services. The antenna is installed on the gantry of road side and provides the wireless communication lint between vehicles and RSE. The required characteristics of ETCS base station antenna are low sidelobe and specific beam pattern by the road and install environment and installed place of OBU. To minimize the affects of multipath signal by reflection, Circular polarization is required. To get low sidelobe of antenna, array configuration and weighting factor by Taylor distribution in radiator elements are applied. The measured results of fabricated antenna are as follows; return loss of 130MHz by -10dB, an axial ratio of 2.6dB, and a gain of 17dBi. It is found that the measured beam patterns are similar to design results.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.11a
• /
• pp.101-105
• /
• 1999

Electronic Toll Collection(ETC) System makes the telecommunication possible between the Beacon and the On Board Unit(OBU) in vehicle at the highway. In this paper, the propagation path of microwave is modelled and the induced voltage of receiving antenna is analyzed numerically according to multi-path fading effort. In this modelling, we consider the weather condition, polarization and antenna radiation pattern. Also, we suggest the diversity technique in order to re duce the fading effect. In the result, the lading effort is reduced significantly in case of the vertical polarization at the rain condition. The circular polarization is the most desirable in this application. The antenna which has the high directivity, is also desirable. Using the space diversity technique at the Beaten, the fading effect is reduced as the distance increases between the Beacon and OBU. These results are presented at the graphs whose axes are related to the magnitude of received voltage(dB) and the distance of the beacon and a vehicle.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.1
• /
• pp.176-185
• /
• 2017

This paper describes a design of the WAVE antenna system in V2X wireless communication systems for Intelligent Transport Systems. The WAVE standard protocols defined 5.825~5.9GHz frequency range for wireless communications with V2X. In a recent, A study of WAVE communication system it has been studied mainly the base station and the OBU technology in order to improve the communication performance of the communication distance. In this paper, the proposed vehicular WAVE antenna using the EBG structure is to improve performance. The proposed WAVE antenna with EBG shows improvement of return loss and radiation beam pattern. The performance of WAVE communication systems for intelligent transport systems is dependent on the performance of antenna. The proposed vehicular antenna for WAVE communication systems shows improvement of return loss for performance.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.3 no.2 s.5
• /
• pp.95-104
• /
• 2004

This paper describes the design, fabrication, and measurement of a omni-directional beam pattern antenna for base station of the BIS which is one of the ITS services. The antenna is installed on the signal lamp of important crossroad and provides the wireless communication link between vehicles and RSE(Road Side Equipment). The required characteristics of BIS base station antenna are omni-directional beam pattern and specific beam pattern by the road and install environment and installed place of OBU. To get omni-directional beam pattern of antenna, Array configuration and OMA are applied. The measured results of fabricated antenna are as follows; return loss of 640MHz by -10 dB, and a gain of 10.3dBi. It is found that the measured beam patterns are similar to design results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.5A
• /
• pp.696-701
• /
• 2000

Electronic Toll Collection (ETC) System makes the telecommunication possible between the Beacon and the On Board Unit(OBU) for automatic toll collection. In this paper, the propagation path of microwave is modelled and the induced voltage of receiving antenna is analyzed numerically according to multi-path fading effect. In our modelling, we consider frequency, weather condition, polarization and antenna radiation pattern. Also, we suggest the diversity technique in order to reduce the fading effect. In the resuts, the fading effect is reduced significantly in case of the vertical polarization at the rain condition. In general the circular polarization is the most desirable in this application. The antenna which has the high directivity, is also desirable. Using the space and frequency diversity technique at the Beacon, the fading effect is reduced effectively. These results are compared with our experimental data.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.4
• /
• pp.30-37
• /
• 2014

The Electronic Toll Collection System based on Free-Flow Multi-Lane is needed to solve some yearly problems such as traffic congestion, safety accident, maintenance by hold-up of one way hi-pass system. The hi-pass communication system is first-in, first-out method in one way environment so, it can't handle various running patterns such as vehicle platoon, switching lane and passing in multi-lane environment. In this thesis we compared and analyzed the communication system of foreign countries ETCS operating system and domestic hi-pass communication system, then studied communication system which can run in multiple-way accepting existing hi-pass OBU. And we formed the communication system of Free-Flow Multi-Lane environment as a plan using incoherent of IR antenna and coherent of RF antenna. The communication system in Free-Flow Multi-Lane environment can be used not alone in parking garages but in expressways of ETCS and toll roads from now on.