• Transactions on Electrical and Electronic Materials
• /
• v.7 no.3
• /
• pp.149-153
• /
• 2006

An attempting to produce a p-type diluted magnetic semiconductor (DMS) using $Ti_{1-x}Co_xO_{2-\delta}-based$ thin films was made by suitable control of the deposition parameters including deposition temperature, deposition pressure, and doping level using a pulsed laser deposition method. T$Ti_{0.97}Co_{0.03}O_{2-\delta}-based$ (TCO) films deposited at $500^{\circ}C$ at a pressure of $5\times10^{-6}$ Torr showed an anomalous Hall effect with p-type characteristics. On the other hand, films deposited at $700^{\circ}C$ at $5\times10^{-6}$ Torr showed n-type behaviors by a decreased solubility of cobalt. The charge carrier concentration in the p-type TCO films was approximately $7.9\times10^{22}/cm^3$ at 300 K and the anomalous Hall effect in the p-type TCO films was controlled by a side-jump scattering mechanism. The magnetoresistance (MR), measured at 5 K in p-type TCO films showed a positive behavior in an applied magnetic field and the MR ratio was approximately 3.5 %. The successful preparation of p-type DMS using the TCO films has the potential for use in magnetic tunneling junction devices.

• Progress in Superconductivity
• /
• v.14 no.1
• /
• pp.1-10
• /
• 2012

We fabricated a closed coils by using resistive-joint method and the joint resistance of the coils were estimated by field decay technique in liquid nitrogen. We used the Runge-kutta method for the numerical analysis to calculate the decay properties. The closed coil was wound by $(Bi,Pb)_2Sr_2Ca_2Cu_3O_x$/Ag tape. Both ends the tape were overlapped and soldered to each other. The current was induced in a closed coils by external magnetic flux density. Its decay characteristic was observed by means of measuring the magnetic flux density generated by induced current at the center of the closed coil with hall sensor. The joint resistance was calculated as the ratio of the inductance of the loop to the time constants. The joint resistances were evaluated as a function of critical current of loop, contact length, sweep time, and external magnetic flux density in a contact length of 7 cm. It was observed that joint resistance was dependent on contact length of a closed coil, but independent of critical current, sweep time, and external magnetic flux density. The joint resistance was measured to be higher for a standard four-probe method, compared with that for the field decay technique. This implies that noise of measurement in a standard four-probe method is larger than that of field decay technique. It was estimated that joint resistance was $8.0{\times}10^{-9}{\Omega}$ to $11.4{\times}10^{-9}{\Omega}$ for coils of contact length for 7 cm. It was found that 40Pb/60Sn solder are unsuitable for persistent mode.

• Korean Journal of Materials Research
• /
• v.34 no.5
• /
• pp.254-260
• /
• 2024

This study is to manufacture a titanium dioxide (TiO₂) photocatalyst by recycling sludge generated using titanium tetrachloride (TiCl₄) as a coagulant. Compared to general sewage, a TiCl₄ coagulant was applied to dyeing wastewater containing a large amount of non-degradable organic compounds to evaluate its performance. Then the generated sludge was dried and fired to prepare a photocatalyst (TFS). Scanning electron microscope-energy dispersive X-ray spectroscopy (SEM-EDX), X-ray diffraction (XRD), and nitrogen oxide reduction experiments were conducted to analyze the surface properties and evaluate the photoactive ability of the prepared TFS. After using titanium tetrachloride (TiCl₄) as a coagulant in the dyeing wastewater, the water quality characteristics were measured at 84 mg/L of chemical oxygen demand (COD), 10 mg/L of T-N, and 0.9 mg/L of T-P to satisfy the discharge water quality standards. The surface properties of the TFS were investigated and the anatase crystal structure was observed. It was confirmed that the ratio of Ti and O, the main components of TiO₂, accounted for more than 90 %. As a result of the nitric oxide (NO) reduction experiment, 1.56 uMol of NO was reduced to confirm a removal rate of 20.60 %. This is judged to be a photocatalytic performance similar to that of the existing P-25. Therefore, by applying TiCl₄ to the dyeing wastewater, it is possible to solve the problems of the existing coagulant and to reduce the amount of carbon dioxide generated, using an eco-friendly sludge treatment method. In addition, it is believed that environmental and economic advantages can be obtained by manufacturing TiO₂ at an eco-friendly and lower cost than before.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.12
• /
• pp.851-857
• /
• 2014

Treatability of heavy metals in marine sediments contaminated with mainly organic matter was investigated on the basis of washing technology using oxidizers and surfactants. Sediment samples were collected at N area which expected for remediation project of contaminated marine sediment. For additives, hydrogen peroxide ($H_2O_2$) and Tween-80 were used at oxidizer and nonionic surfactant, respectively. In experiments, sediments was mixed with sea water at the ratio of 1 : 3 than $H_2O_2$ (1 M, 3 M, 4 M, 5 M) and Tween-80 (0.05%) were added. Samples were gathered at following reaction time (10, 20, 30, 40, 50, 60, 70, 80 min and 24 h). Total Organic Carbon (TOC) was 55.2% at the conditions of 5 M $H_2O_2+0.05%$ Tween-80 24 h. Hence total heavy metals were Cu 29.5%, Zn 42.3%, Cd 73.0% and bioavailable heavy metals were Cu 60.0%, Zn 77.7%, Cd 90.2% at the conditions of 5 M $H_2O_2+0.05%$ Tween-80 10 min. The correlations for between bioavailable metals (Cu, Zn, Cd) and TOC were significant (Cu, Zn, Cd; $r^2=0.94$, 0.85, 0.69, respectively).

• Korean Journal of Materials Research
• /
• v.22 no.4
• /
• pp.202-206
• /
• 2012

$CoSi_2$ was formed through annealing of atomic layer deposition Co thin films. Co ALD was carried out using bis(N,N'-diisopropylacetamidinato) cobalt ($Co(iPr-AMD)_2$) as a precursor and $NH_3$ as a reactant; this reaction produced a highly conformal Co film with low resistivity ($50\;{\mu}{\Omega}cm$). To prevent oxygen contamination, $ex-situ$ sputtered Ti and $in-situ$ ALD Ru were used as capping layers, and the silicide formation prepared by rapid thermal annealing (RTA) was used for comparison. Ru ALD was carried out with (Dimethylcyclopendienyl)(Ethylcyclopentadienyl) Ruthenium ((DMPD)(EtCp)Ru) and $O_2$ as a precursor and reactant, respectively; the resulting material has good conformality of as much as 90% in structure of high aspect ratio. X-ray diffraction showed that $CoSi_2$ was in a poly-crystalline state and formed at over $800^{\circ}C$ of annealing temperature for both cases. To investigate the as-deposited and annealed sample with each capping layer, high resolution scanning transmission electron microscopy (STEM) was employed with electron energy loss spectroscopy (EELS). After annealing, in the case of the Ti capping layer, $CoSi_2$ about 40 nm thick was formed while the $SiO_x$ interlayer, which is the native oxide, became thinner due to oxygen scavenging property of Ti. Although Si diffusion toward the outside occurred in the Ru capping layer case, and the Ru layer was not as good as the sputtered Ti layer, in terms of the lack of scavenging oxygen, the Ru layer prepared by the ALD process, with high conformality, acted as a capping layer, resulting in the prevention of oxidation and the formation of $CoSi_2$.

• Textile Coloration and Finishing
• /
• v.20 no.3
• /
• pp.31-38
• /
• 2008

Regenerated composite fibers were prepared from solution of styela clava tunics(SC) and poly vinyl alchol(PVA) using N-methylmorpholine-N-oxide(NMMO)/water(87/13)(wt%/wt%) as a solvent by dry jet-wet spinning. Structure and physical properties of regenerated composite fibers were investigated through birefrngence, x-ray diffratograms, tenacity, fibrillation and SEM. Optimal blend ratio of SC/PVA for mechanical properties of composite fibers was 70/30 and total weight was 4wt% concentrations in NMMO/$H_2O$ solvent system. Crystallinity index of composite fibers were decreased as the PVA contents increased. Fibrillation of $10{\sim}20wt%$ PVA blended fibers were occurred less than pure SC fiber. Shape of composite fibers were a circle cross section within 10wt% PVA content. But the cross section of fibers were changed as crushed flat with the PVA contents increased.

• The Korean Journal of Nuclear Medicine
• /
• v.26 no.1
• /
• pp.140-146
• /
• 1992

$^{99m}Tc-Methionine$ complexes from enantiomeric and racemic methionines were prepared controlling reaction parameters such as pH and the concentration of stannous chloride. Some radiochromato-graphic systems were also examined to determine the labelling yields of $^{99m}Tc$ complexes. The best resolutions of $^{99m}Tc$ complexes were obtained at ITLC-SA developed with acetone and paper chromatography with n-butanol saturated with 0.3N HCI. In the former system, $HR-{99m}Tc$ and $^{99m}Tc-methionine$ complex remained at origin, while $^{99m}TcO_4^-$ moved with Rf value of 1.0. In latter process, $HR-^{99m}Tc$ stayed at the origin, while $^{99m}TcO_4^-\;and\;^{99m}Tc-methionine$ complexes moved with Rf value of 0.5. By combining of two chromatographic systems, the contents of three $^{99m}Tc$ species were calculated easily. $^{99m}Tc$ Labelling from enantiomeric and racemic methionines had little differences and the optimal condition was found at pH 9.00 and the molar ratio of methionine to stannous chloride of 24:1. The yields of $^{99m}Tc$ complexes from D-, L-, and DL-methionines were 87.6%, 94.1%, and 97.9%, respectively. The results indicated that methionine containing relatively hydrophobic methylthio group $(-SCH_3)$ would be labelled with $^{99m}Tc$ by stannous chloride method.

• Journal of Astronomy and Space Sciences
• /
• v.21 no.4
• /
• pp.343-350
• /
• 2004

The charge exchange (or transfer) due to collision with hydrogen has important effects on the physical characteristics of astrophysical plasma. In this paper, collisional ionization equilibrium in the temperature range of ${\sim}1,000--80,000K$ are investigated for C, N, and O ions including the effects of charge exchange. The calculated ionic abundance fractions are compared with those of previous works. The ionic abundance fractions calculated in the paper can be used in understanding the spectroscopic properties of warm interstellar medium. It is also found that the ratio between the degree of ionization of oxygen and that of hydrogen shows big difference with the previously well-known result for the environment where the collisional ionization is not important. This implies that investigations on the collisional ionization in the warm interstellar medium are required.

• Korean Chemical Engineering Research
• /
• v.44 no.5
• /
• pp.540-546
• /
• 2006

Effects of organic and inorganic additives on the SNCR reaction of NOx were investigated in a pilot scale flow reactor with a variation of operating parameters. NOx reduction efficiency increased with the increase of a residence time and an initial NOx concentration. NOx reduction reaction by urea solution started to appear about 850 and then reached to maximum value around $970^{\circ}C$. NOx reduction efficiency also increased with the increase of NSR (Normalized Stoichiometric Ratio) up to 2.0. Addition of ethanol and phenol as an organic additives shifted the optimum temperature window to lower region with decreasing the maximum NOx reduction efficiency. This might be due to the side reaction of hydrocarbon in ethanol structure. NaOH addition widened the temperature window and enhanced the NOx reduction efficiency about 10％ due to the chain reaction of NaOH and the reduction of $N_2O$.

• Korean Journal of Ecology and Environment
• /
• v.38 no.3 s.113
• /
• pp.382-392
• /
• 2005

Data were collected in Lake Daecheong from March 1997 to October 2002 and used to understand an annual change of water environmental factors and trophic states. The surface water temperature was ranged from $3.2^{\circ}C$ to $33.1^{\circ}C$ In the middle of February, water temperature was the lowest. Turbidity was ranged from 0.1 to 203.5 NTU, but the values of above 30 NTU were only measured at site 1. The total mean values of COD and Chl a were $3.6{\pm}1.4\;mg\;O_2\;L^{-1}$, $9.3{\pm}12.8\;{\mu}g\;L^{-1}$respectively. The concentrations of TP and TN were ranged from 0.14 to 5.09 mg N $L^{-1}$, 1 to $247\;{\mu}g\;P\;L^{-1}$ respectively. The total mean value of TN/TP ratio was $98.7{\pm}56.2$. The trophic states were ranged from mesotrophic to eutrophic in Lake Daecheong.