• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.9
• /
• pp.70-77
• /
• 2006

We have fabricated an integrated three-phase flux-lock type SFCL, which consists of an YBCO($YB_a2Cu_3O_7$) thin film and a flux-lock reactor wound around an iron core of each phase. In order to apply the SFCL in a real power system, fault analyses for the three-phase system are essential. The short-circuit currents were effectively limited by adjusting the numbers of winding of each secondary coil and their winding directions. The flux flow generated in the iron core cancelled out under the normal operation due to the parallel connection between primary and secondary windings. However, the flux-lock type SFCL with same iron core was operated just after the fault due to the flux generating in the iron core. To analyze the current limiting characteristics, the additive polarity winding was compared with the subtractive one in the flux lock reactor. Whenever a single line-to-ground fault occurred in any phase, the peak value of the line current of the fault phase in the additive polarity winding increased up to about 12.87 times during the first-half cycle. On the other hand, the peak value in the subtractive polarity winding increased up to about 34.07 times under the same conditions. This is because the current flow between the primary and the secondary windings changed to additive or subtractive status according to the winding direction. We confirmed that the current limiting behavior in the additive polarity winding was more effective for a single-line-to-ground fault

• Geomechanics and Engineering
• /
• v.7 no.3
• /
• pp.233-246
• /
• 2014

Estimation of fracture initiation pressure is one of the most difficult technical challenges in hydraulic fracturing treatment of vertical or horizontal oil wells. In this study, the influence of in-situ stresses and pore pressure values on fracture initiation pressure and its profile in vertical and horizontal oil wells in a normal stress regime have been investigated. Cohesive elements with traction-separation law (XFEM-based cohesive law) are used for simulating the fracturing process in a fluid-solid coupling finite element model. The maximum nominal stress criterion is selected for initiation of damage in the cohesive elements. The stress intensity factors are verified for both XFEM-based cohesive law and analytical solution to show the validation of the cohesive law in fracture modeling where the compared results are in a very good agreement with less than 1% error. The results showed that, generally by increasing the difference between the maximum and minimum horizontal stress, the fracture pressure and its profile has been strongly changed in the vertical wells. Also, it's been clearly observed that in a horizontal well drilled in the direction of minimum horizontal stress, the values of fracture pressure have been significantly affected by the difference between overburden pressure and maximum horizontal stress. Additionally, increasing pore pressure from under-pressure regime to over-pressure state has made a considerable fall on fracture pressure in both vertical and horizontal oil wells.

• Wind and Structures
• /
• v.30 no.5
• /
• pp.465-474
• /
• 2020

Vortex-induced vibrations of a yawed flexible cylinder near a plane boundary are numerically investigated at a Reynolds number Re_n= 500 based on normal component of freestream velocity. Free to oscillate in the in-line and cross-flow directions, the cylinder with an aspect ratio of 25 is pinned-pinned at both ends at a fixed wall-cylinder gap ratio G/D = 0.8, where D is the cylinder diameter. The cylinder yaw angle (α) is varied from 0° to 60° with an increment of 15°. The main focus is given on the influence of α on structural vibrations, flow patterns, hydrodynamic forces, and IP (Independence Principle) validity. The vortex shedding pattern, contingent on α, is parallel at α=0°, negatively-yawed at α ≤ 15° and positively-yawed at α ≥ 30°. In the negatively- and positively-yawed vortex shedding patterns, the inclination direction of the spanwise vortex rows is in the opposite and same directions of α, respectively. Both in-line and cross-flow vibration amplitudes are symmetric to the midspan, regardless of α. The RMS lift coefficient C_L,rms exhibits asymmetry along the span when α ≠ 0°, maximum C_L,rms occurring on the lower and upper halves of the cylinder for negatively- and positively-yawed vortex shedding patterns, respectively. The IP is well followed in predicting the vibration amplitudes and drag forces for α ≤ 45° while invalid in predicting lift forces for α ≥ 30°. The vortex-shedding frequency and the vibration frequency are well predicted for α = 0° - 60° examined.

• Korean Journal of Animal Reproduction
• /
• v.13 no.1
• /
• pp.40-48
• /
• 1989

Guppy fry were treated for the first 40 days of life with 0, 20, 40, 60 & 100$\mu\textrm{g}$ of estradiol per gram of food in order to change the sex of normal males to functional females(genetic male). The present investigation deals with the effects of steroid hormones, such as $\beta$-estradiol and testosterone, on the sex differentiation in guppy and tilapia. The results obtained were summarized as follows. 1. In B (20$\mu\textrm{g}$/g diet) group 17$\beta$-estradiol-treated, 67.8% of male offsprings were produced. 2. In D (60$\mu\textrm{g}$/g diet) group 17$\beta$-treated, 67% of female offsprings were produced. 3. B, D groups of genetic male brooders had significantly different effects (P<0.01) upon sex ratios of their progeny. 4. This strongly indicates that sex direction has been achieved and that the male is the heterogametic sex. 5. The group that produced the highest percentage of male offspring(male percentage of observed number to expected number was 91%) contained only full-sibling male brooders to the sex-reversed female brooders. 6. After 7 months following treatment, the sex-reversed males had ovarian portion in the anterior region and a testicular portion in the posterior region of the same intersexual gonad, respectively. 7. At 7 months after treatment, the ovareis revealed a complete arrest of the ovarian formation, and appearances of spermatogenetic cell cysts among surviving auxocytes. 8. In most of sex-reversed fish, anterior portion of test is was devoid of sperm ducts including the seminal vesicle and vas deferens. 9. The male transferrin showed two strong bands, while the female transferrin showed a single weak band. 10. One of the two bands of male transferrin showed the same mobility with band of female transferrin.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.9
• /
• pp.1-8
• /
• 2003

Velocity data were acquired at a series of stations in the chordwise direction above a delta wing with leading edge extension, using a triple axis hot film anemometry. Surveys normal to planform yield velocity field data at incidence angle of 24$^{\circ}$and 32$^{\circ}$at a centerline chord Reynolds number of $1.76{\times}10^6$. Experimental results of velocity measurements of mean velocity of three components gave a confidence to quantitative investigate the vortical flow field over a LEX-delta wing with this probe. The present experiments indicated the existence of both wing and LEX vortex where the local mean axial velocity is maximum. It also shown the development of secondary vortex of opposite sign of rotating above the wing surface near the leading edge. The insertion of probe across the flow field was found to have little influence on the position of the vortex core.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.6
• /
• pp.17-22
• /
• 2003

An airship is statically unstable, because it has no wing, relatively small tails and a large hull. Hence, an accurate prediction of dynamic stability is critical. In this study, dynamic stability data of the 50m Length Airship were acquired through forced oscillation wind tunnel tests. The tests were done in Birhle Applied Research Inc's Lange Amplitude Multi-Purpose(BAR LAMP) Facility located in Germany. The tests were composed with 16 static runs and 26 dynamic runs. As results, it is obtained that dynamic characteristics of the airship depend on the sideslip angle, the angular rate and its direction as well as the angle of attack. Generally, three directional moments have damping, but the normal force, the side force, and the cross-derivatives are unstable. The dynamic derivatives are not sensitive to the control surfaces, but nonlinear to the sideslip angle.

• Journal of KIISE:Computing Practices and Letters
• /
• v.16 no.5
• /
• pp.621-625
• /
• 2010

This paper presents a hand motion tracking method for hand gesture interface using a camera in mobile devices such as a smart phone and PDA. When a camera moves according to the hand gesture of the user, global optical flows are generated. Therefore, robust hand movement estimation is possible by considering dominant optical flow based on histogram analysis of the motion direction. A continuous hand gesture is segmented into unit gestures by motion state estimation using motion phase, which is determined by velocity and acceleration of the estimated hand motion. Feature vectors are extracted during movement states and hand gestures are recognized at the end state of each gesture. Support vector machine (SVM), k-nearest neighborhood classifier, and normal Bayes classifier are used for classification. SVM shows 82% recognition rate for 14 hand gestures.

• Journal of Korean Medical classics
• /
• v.30 no.3
• /
• pp.77-93
• /
• 2017

Objectives : Clear and detailed analysis on Pulse-taking on both Carotid and Wrist Pulses is an absolute prerequisite if it is to be applied in real practice or its practical value proven. Methods : The original notes found in Suwen and Lingshu, their translations, and conventional studies regarding Suwen LiuJieCangXiangLun's Pulse-taking are compared and analyzed to find cases within medical texts where this method was used and to get an idea of the direction taken by the conventional study. Results : The ilsung, esung, samsung, and sasung of Carotid (or wrist pulses) refers that the pulse is one-, two-, three-, four-fold in differences. Refrainment should be practiced while comparing carotid and wrist pulses. Rather, they need to be compared with their normal states. Used by Luo Tianyi in Ming Dunasty, this method of pulse-taking was used for (radial artery) when diagnosing and treating the degree of seriousness of food injury. The measurement of maximum blood flow velocity using TCD done recently proved the validity of this pulse-taking, and it's been used for alleviating hypertension or tinnitus through acupuncture, or abating intractable diseases (around carotid). Conclusions : The obscurity of the measuring method of this pulse-taking can be resolved, and the problem which occurs while comparing carotid and wrist pulses can be solved. Even though there are differences in opinion regarding the positions when comparing the two pulses, their practical values are acknowledged since their usages in diagnosis, treatments, experiments, and researches have yielded positive results to a degree. They may not be used that often, but they are nonetheless under utilization.

• Journal of Korean Neurosurgical Society
• /
• v.55 no.5
• /
• pp.284-288
• /
• 2014

A rare case of atlantoaxial rotatory subluxation occurred after pediatric cervical spine surgery performed to remove a dumbbell-shaped meningioma at the level of the C1/C2 vertebrae. This case is classified as a post-surgical atlantoaxial rotatory subluxation, but has a very rare morphology that has not previously been reported. Although there are several reports about post-surgical atlantoaxial rotatory subluxation, an important point of this case is that it might be directly related to the spinal cord surgery in C1/C2 level. On day 6 after surgery, the patient presented with the Cock Robin position, and a computed tomography scan revealed a normal type of atlantoaxial rotatory subluxation. Manual reduction was performed followed by external fixation with a neck collar. About 7 months after the first surgery, the subluxation became severe, irreducible, and assumed an atypical form where the anterior tubercle of C1 migrated to a cranial position, and the posterior tubercle of C1 and the occipital bone leaned in a caudal direction. The pathogenic process suggested deformity of the occipital condyle and bilateral C2 superior facets with atlantooccipital subluxation. A second operation for reduction and fixation was performed, and the subluxation was stabilized by posterior fixation. We encountered an unusual case of a refractory subluxation that was associated with an atypical deformity of the upper spine. The case was successfully managed by posterior fixation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.12
• /
• pp.2387-2393
• /
• 2017

The Moon government, launched in May 2017, regards telecommunication service as part of people's welfare and is trying to save telecommunication costs. However, the direction of policy presented is assessed as symptomatic approach. This is largely attributable to the a partial improvement approach from the framework of the present mobile telecommunication industry. However if we restart from an essential point of view, the result is likely to be much better. The nation's mobile communication costs are not adequate because the government's role was not sufficient. There is a problem with the mobile phone supply chain, the subsidy payment mechanism, and the billing system. Addressing these complex issues requires the establishment of an independent system of handset distribution from telecommunication companies, ban on discriminative subsidies payment, and adoption of volume rate system. Telecommunications Business Act that defines the service charges to normalize the market might be somewhat useful, but the normal application of the Fair Trade Act is more important.