• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.4
• /
• pp.299-312
• /
• 2006

This paper presents the results of a novel test structure for process control monitor for uncooled IR detector technology of microbolometer arrays. The proposed test structure is based on resistive network configuration. The theoretical model for resistance of this network has been developed using 'Compensation' and 'Superposition' network theorems. The theoretical results of proposed resistive network have been verified by wired hardware testing as well as using an actual 16x16 networked bolometer array. The proposed structure uses simple two-level metal process and is easy to integrate with standard CMOS process line. The proposed structure can imitate the performance of actual fabricated version of area array closely and it uses only 32 pins instead of 512 using conventional method for a $16{\times}16$ array. Further, it has been demonstrated that the defective or faulty elements can be identified vividly using extraction matrix, whose values are quite similar(within the error of 0.1%), which verifies the algorithm in small variation case(${\sim}1%$ variation). For example, an element, intentionally damaged electrically, has been shown to have the difference magnitude much higher than rest of the elements(1.45 a.u. as compared to ${\sim}$ 0.25 a.u. of others), confirming that it is defective. Further, for the devices having non-uniformity ${\leq}$ 10%, both the actual non-uniformity and faults are predicted well. Finally, using our analysis, we have been able to grade(pass or fail) 60 actual devices based on quantitative estimation of non-uniformity ranging from ＜ 5% to ＞ 20%. Additionally, we have been able to identify the number of bad elements ranging from 0 to ＞ 15 in above devices.

• Journal of Sensor Science and Technology
• /
• v.30 no.5
• /
• pp.331-336
• /
• 2021

The Non-dispersive Infrared (NDIR) gas sensor has high selectivity, measurement reliability, and long lifespan. Thus, even though the NDIR gas sensor is expensive, it is still widely used for carbon dioxide (CO₂) detection. In this study, to reduce the cost of the NDIR CO₂ gas sensor, we proposed the new optical waveguide structure design based on ready-made gas pipes that can improve the sensitivity by increasing the initial light intensity. The new optical waveguide design is a structure in which a part of the optical waveguide filter is inclined to increase the transmittance of the filter, and a parabolic mirror is installed at the rear end of the filter to focus the infrared rays passing through the filter to the detector. In order to examine the output characteristics of the new optical waveguide structure design, optical simulation was performed for two types of IR-source. As a result, the new optical waveguide structure can improve the sensitivity of the NDIR CO₂ gas sensor by making the infrared rays perpendicular to the filter, increasing the filter transmittance.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.1
• /
• pp.93.2-93.2
• /
• 2012

Point Spread Function (PSF) is one of the most important optical characteristics for describing the performance of a telescope. And a concept of subpixelization is inevitable in evaluating the undersampled PSF (Shin and Sakurai 2009). Then, the internal structure of Yohkoh SXT CCD pixel is not uniform: For the top half of pixel area, the X-ray should pass a so-called gate structure where the charges are transferred to an output amplifier. This gate structure shows energy-dependent sensitivity (Tsuneta et al. 1991). For example, for Al-K (8.34 A) X-ray emission, the transmission of the polysilicon gate is about 0.9. Also, for the peak coronal response of the SXT thin filters, around 17 angstrom (0.729 keV), the transmission of the gate is about 0.6, falling off sharply towards longer wavelengths. It should be noted that this spectrally dependent non-uniform response of each CCD pixel will certainly have a noticeable effect on the properties of the PSF at longer wavelengths. Therefore, especially for analyzing the undersampled PSF of low energy source, a careful consideration of non-uniform internal pixel structure is required in determining the shape of the PSF core. The details on the effect of gate structure will be introduced in our presentation.

• Journal of the Korean Ceramic Society
• /
• v.34 no.7
• /
• pp.758-766
• /
• 1997

Non-brittle fracture behaviour of the two composite structures made of two different brittle materials was investigated using 3-point bending test. First, the layered and fibrous macro-composites were fabricated using the material easily formed, yet showing a brittle fracture behaviour similar to ceramics. The layered and fibrous Al2O3 /Al2O3 composites with weak interface were also fabricated using plate of 2 mm thickness and rod of 3 mm diameter respectively. Comparison of the mechanical properties between these two structures was performed in the lights of flexural strength and work of fracture for the composites consisting of Al2O3 and simulated materials respectively. The strength ratio of layered structure to the monolith of same volume was 0.6 and the ratio of fibrous one was about 0.2 for the composites made of simulated brittle material. The ratio of the work of fracture of the fibrous to the layered was 0.47. For Al2O3/Al2O3 composites, the strength ratio of layered and fibrous structures to the monolith with same volume were about 0.6 and 0.2 respectively. The ratio of work of fracture of the fibrous to the layered was 0.6. These confirmed that the layered structure was superior to the fibrous one in terms of flexural strength and work of fracture.

• Earthquakes and Structures
• /
• v.20 no.1
• /
• pp.87-96
• /
• 2021

Ground motions recorded in near-fault sites, where the rupture propagates toward the site, are significantly different from those observed in far-fault regions. In this research, finite element modeling is used to investigate the effect of pile cap stiffness on the seismic response of soil-pile-structure systems under near-fault ground motions. The Von Wolffersdorff hypoplastic model with the intergranular strain concept is applied for modeling of granular soil (sand) and the behavior of structure is considered to be non-linear. Eight fault-normal near-field ground motion records, recorded on rock, are applied to the model. The numerical method developed is verified by comparing the results with an experimental test (shaking table test) for a soil-pile-structure system. The results, obtained from finite element modeling under near-fault ground motions, show that when the value of cap stiffness increases, the drift ratio of the structure decreases, whereas the pile relative displacement increases. Also, the residual deformations in the piles are due to the non-linear behavior of soil around the piles.

• Management & Information Systems Review
• /
• v.28 no.1
• /
• pp.99-124
• /
• 2009

This study has observed the influence of green advertisemen on the attitude of consumers in relation to its message effect. The analysis has been conducted in the perpective of awareness-emotion -behavior targeting housewives based on the message structure of the advertisement(conclusion omission type/ conclusion offer type). Results of the analysis are as follows : 1) Green advertisement was more effective for the attitude toward advertisement and products than non-green advertisement and in the case of high involvement the conclusion omission message was more effective than the conclusion offer message. 2) Green advertisement was more effective also for the emotion side than non-green advertisement and the conclusion omission message was found more effective than the conclusion offer message. 3) Green advertisement was found more effective for purchasing activities than non-green advertisement and the conclusion omission message was found more effective than the conclusion offer message in the case of high involvement. 4) In case of the conclusion offer type structure of green advertisement the awareness side influenced purchasing activities and in case of the conclusion omission type structure of green advertisement the emotion side influenced purchasing activities. Besides that in case of the conclusion offer type structure of non-green advertisement both the awareness and emotion sides were found to influence purchasing activities. No difference was found in the conclusion omission type structure of non-green advertisement.

• Honam Mathematical Journal
• /
• v.28 no.4
• /
• pp.573-589
• /
• 2006

Let M be a real hypersurface with almost contact metric structure $({\phi},{\xi},{\eta},g)$ in a non flat complex space form $M_n(c)$. In this paper, we prove that if the structure Jacobi operator $R_{\xi}$ is ${\xi}$-parallel and the Ricci tensor S commutes with the structure operator $\phi$, then a real hypersurface in $M_n(c)$ is a Hopf hypersurface. Further, we characterize such Hopf hypersurface in $M_n(c)$.

• Proceedings of the KAIS Fall Conference
• /
• 2010.11b
• /
• pp.611-613
• /
• 2010

Constant Structure는 Non-Functional Harmony로써 현대 재즈에 적극적으로 사용되고 있다. 본 논문에서는 McCoy Tyner의 'Passion Dance'에서 Constant Structure Voicing이 어떻게 사용되었는지 분석하고, 이를 토대로 Constant Structure Voicing의 기초적 활용 방법을 연구한다.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.1504-1508
• /
• 1996

In this paper, we derive dynamic equation of helicopter and design controller based on variable structure system. It is difficult to control helicopter because it has non-linear coupling between input and output of system and is MIMO system. The design of control law is considered here using variable structure methodology giving the robustness to parameter variations and invariance to some subsets of external disturbance. However we derive dynamic equations of helicopter and design stabilizing variable structure controller. Also, simulation results are given in this paper.

• Composites Research
• /
• v.31 no.4
• /
• pp.161-170
• /
• 2018

Cylindrical composite lattice structures are manufactured by filament winding process. The fiber volume fraction non-uniformity and resin rich layers that can occur in the manufacturing process affect the stiffness and strength of the structure. Through the cross-section examination of the hoop and helical ribs, which are major elements of the composite lattice structure, we observed the fiber volume fraction non-uniformity and resin rich layers. Based on the results of the cross-section examination, the stiffness of the ribs was analyzed through the experimental and theoretical approaches. The results show that the fiber volume fraction non-uniformity and resin rich layers have an obvious influence on the rib stiffness of composite lattice structure.