• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2009년도 춘계학술발표대회
• /
• pp.35.1-35.1
• /
• 2009

Vertically aligned zinc oxide (ZnO) nanorods (NRs) with different surface morphology were grown by metal organic chemical vapor deposition (MOCVD) on sapphire substrate. The films thus prepared were characterized by measuring X-ray diffraction (XRD), Scanning electron microscopy (SEM) and Transmission electron microscopy (TEM) studies. To study the effect of surface morphology on wettability, the contact angle (CA) of water was measured. It was demonstrated that the CA of the deposited ZnO NRs varied between $104^{\circ}$ and $135^{\circ}$ depending upon the surface morphology. Variable temperature photoluminescence (PL) have employed to probe the exciton recombination in high density and vertically aligned ZnO Nanorod arrays. The low-temperature PL characterizes the dominant near-band-edge excitonic emissions from such nanorod arrays.

• 대한금속재료학회지
• /
• 제49권5호
• /
• pp.406-410
• /
• 2011

ZnO nanorods were prepared by the electrodeposition route on conductive Au/Si substrates. The effects of deposition time on the microstructural evolution and optical properties of ZnO nanorods were investigated. With increasing deposition time from 1 h to 20 h, the diameter and length of the ZnO nanorods increased gradually to about 328 nm and 6.55${\mu}m$, respectively. The ZnO nanorods were dense and vertically well-aligned. The photoluminescence (PL) peaks corresponding to the near band edge of ZnO were observed. With increasing deposition time, the intensity of PL peaks increased with nanorod growth up to 4 h and then decreased. This might be due to the degradation of crystal quality caused by merging of nanorods.

• 한국전기전자재료학회논문지
• /
• 제23권11호
• /
• pp.848-853
• /
• 2010

We have grown GaN nanowires by the low pressure MOCVD method on Ni deposited oxidized Si surface and have established optimum conditions by observing surface microstructure and its photoluminescence. Optimum growth temperature of $880^{\circ}C$, growth time of 30 min, TMG source flow rate of 10 sccm have resulted in dense nanowires on the surface, however further increase of growth time or TMG flow rate has not increased the length of nanowire but has formed nanocrystals. On the contrary, the increase of ammonia flow has increased the length of nanowires and the coverage of nanowire over the surface. The shape of nanowire is needle-like with a Ni droplet at its tip; the length is tens of micron with more than 40 nm in diameter. Low temperature photoluminescence obtained from the sample at optimum growth condition has revealed several peaks related to exciton decay near band-edge, but does not show any characteristic originated from one dimensional quantum confinement. Strong and broad luminescence at 2.2 eV is observed from dense nanowire samples and this suggests that the broad band is related to e-h recombination at the surface state in a nanowire. The current result is implemented to the nanowire device fabrication by nanowire bridging between micro-patterned neighboring Ni catalysis islands.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제40회 동계학술대회 초록집
• /
• pp.146-146
• /
• 2011

The blue light emitting diode (LED) structure based on non-polar a-plane (11-20) GaN which was coated TiO2 nanoparticles using spin coating method was grown on r-plane (1-102) sapphire substrates to improve light extraction efficiency. We report on the emission and structural properties with temperature dependence of photoluminescence (PL) and x-ray rocking curves (XRC). From PL results at 13 K of undoped GaN samples, basal plane stacking fault (BSF) and near band edge (NBE) emission peak were observed at 3.434 eV and 3.484 eV, respectively. We also found the temperature-induced band-gap shrinkage, which was fitted well with empirical Varshini's equation. The PL intensity of TiO2 nanoparticles ?coated multiple quantum well (MQW) sample is decayed slower than that of no coating sample with increasing temperature. The anisotrophic strain and azimuth angle dependence in the films were shown from XRC results. The full width at half maximum (FWHM) along the GaN [11-20] and [1-100] directions were 564.9 arcsec and 490.8 arcsec, respectively. A small deviation of FWHM values at in-plane direction is attributed to uniform in-plane strain.

• 한국재료학회지
• /
• 제19권5호
• /
• pp.281-287
• /
• 2009

ZnO thin film was grown on a sapphire single crystal substrate by plasma assisted molecular beam epitaxy. In addition to near band edge (NBE) emissions, both blue and green luminescences are also observed together. The PL intensity of the blue luminescence (BL) range from 2.7 to 2.9 eV increased as the amount of activated oxygen increased, but green luminescence (GL) was weakly observed at about 2.4 eV without much change in intensity. This result is quite unlike previous studies in which BL and GL were regarded as the transition between shallow donor levels such as oxygen vacancy and interstitial zinc. Based on the transition level and formation energy of the ZnO intrinsic defects predicted through the first principle calculation, which employs density functional approximation (DFA) revised by local density approximation (LDA) and the LDA+U approach, the green and blue luminescence are nearly coincident with the transition from the conduction band to zinc vacancies of $V^{2-}_{Zn}$ and $V^-_{Zn}$, respectively.

• Bulletin of the Korean Chemical Society
• /
• 제34권4호
• /
• pp.1205-1211
• /
• 2013

The structural and optical properties of the ZnO, Al-doped ZnO, Ga-doped ZnO, and In-doped ZnO nanorods were investigated using field-emission scanning electron microscopy, X-ray diffraction, photoluminescence (PL) and ultraviolet-visible spectroscopy. All the nanorods grew with good alignment on the ZnO seed layers and the ZnO nanorod dimensions could be controlled by the addition of the various dopants. For instance, the diameter of the nanorods decreased with increasing atomic number of the dopants. The ratio between the near-band-edge emission (NBE) and the deep-level emission (DLE) intensities ($I_{NBE}/I_{DLE}$) obtained by PL gradually decreased because the DLE intensity from the nanorods gradually increased with increase in the atomic number of the dopants. We found that the dopants affected the structural and optical properties of the ZnO nanorods including their dimensions, lattice constants, residual stresses, bond lengths, PL properties, transmittance values, optical band gaps, and Urbach energies.

• 대한금속재료학회지
• /
• 제50권8호
• /
• pp.605-611
• /
• 2012

ZnO nanostructures were grown on R-plane sapphire substrates with seed layers annealed at different temperatures ranging from 600 to $800^{\circ}C$. The properties of the ZnO nanostructures were investigated by scanning electron microscopy, high-resolution X-ray diffraction, UV-visible spectrophotometer, and photoluminescence. For the as-prepared seed layers, ZnO nanorods and ZnO nanosheets were observed. However, only ZnO nanorods were grown when the annealing temperature was above $700^{\circ}C$. The crystal qualities of the ZnO nanostructures were enhanced when the seed layers were annealed at $700^{\circ}C$. In addition, the full width at half maximum (FWHM) of near-band-edge emission (NBE) peak was decreased from 139 to 129 meV by increasing the annealing temperature to $700^{\circ}C$. However, the FWHM was slightly increased again by a further increase in the annealing temperature. Optical transmittance in the UV region was almost zero, while that in the visible region was gradually increased as the annealing temperature increased to $700^{\circ}C$. The optical band gap of the ZnO nanostructures was increased as the annealing temperature increased to $700^{\circ}C$. It is found that the optical properties as well as the structural properties of the rod-shaped ZnO nanostructures grown on R-plane sapphire substrates by hydrothermal method are improved when the seed layers are annealed at $700^{\circ}C$.

• Advances in materials Research
• /
• 제12권3호
• /
• pp.179-192
• /
• 2023

We have studied the structural and optical properties of the non-doped and Co 0.08 at.%, Co 0.02 at.%, and Co 0.11 at.% doped ZnO nanorods (NRs) synthesized using the simple low-temperature chemical bath deposition (CBD) method at 95℃ for 2 hours. The scanning electron microscope (SEM) images confirmed the morphology of the ZnO NRs are affected by Co incorporation. As observed, the Co 0.08 at.% doped ZnO NRs have a larger dimension with an average diameter of 153.4 nm. According to the International Centre for Diffraction Data (ICDD) number #00-036-1451, the x-ray diffraction (XRD) pattern of non-doped and Co-doped ZnO NRs with the preferred orientation of ZnO NRs in the (002) plane possess polycrystalline hexagonal wurtzite structure with the space group P63mc. Optical absorbance indicates the Co 0.08 at.% doped ZnO NRs have stronger and blueshift bandgap energy (3.104 ev). The room temperature photoluminescence (PL) spectra of ZnO NRs exhibited excitonicrelates ultraviolet (UV) and defect-related green band (GB) emissions. By calculating the UV/GB intensity, the Co 0.08 at.% is the proper atomic percentage to have fewer intrinsic defects. We predict that Co-doped ZnO NRs induce a blueshift of near band edge (NBE) emission due to the Burstein-Moss effect. Meanwhile, the redshift of NBE emission is attributed to the modification of the lattice dimensions and exchange energy.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 추계학술대회 논문집
• /
• pp.172-172
• /
• 2009

In this study, we presented comparative discrimination methods to identify various line and planar defects observed in nonpolar a-GaN epilayers on r-sapphire substrates. Unlike the case of conventional c-GaN, which is dominated by perfect threading dislocations, systematic identification of undistinguishable defects using transmission electron microscopy (TEM) is necessary to suppress the propagation of defects in nonpolar GaN epilayers. Cross-sectional TEM images near the [0001] zone axis revealed that perfect mixed and pure screw type dislocations are visible, while pure edge, partial dislocations, and basal stacking faults (BSFs) are not discernible. In tilted cross-sectional TEM images along the [$1\bar{2}10$] zone axis, the dominant defects were BSFs and partial dislocations for the $g=10\bar{1}0$ and 0002 two-beam images, respectively. From plan view TEM images taken along the [$11\bar{2}0$] axis, it was found that the dominantpartial and perfect dislocations were Frank-Shockley with b=${\pm}1/6$<$20\bar{2}3$> and mixed type without an 1 component including b=${\pm}1/3$<$1\bar{2}10$> and ${\pm}1/3$<$\bar{2}110$>, respectively. Prismatic stacking faults were observed as inclined line contrast near the [0001] zone axis and were visible as band contrast in the two-beam images along the [$1\bar{2}10$] and [$11\bar{2}0$] zone axes.

• 한국안광학회지
• /
• 제13권3호
• /
• pp.73-77
• /
• 2008

목적: 본 논문은 저온열처리로 비결정 또는 결정 ZnO 박막의 UV emission 가능하다는 것이다. 방법: 화학적 용액법을 이용하여 소다-라임-실리카 유리 위에 100, 150, 200, 250 및 $300^{\circ}C$로 열처리하여 비정질 및 나노 결정질 ZnO 박막을 제조하였으며, 박막의 성장 특성 및 광학적 특성을 X-선 회절 분석법, 자외선-가시광선-근적외선 분광법 및 발광분석법을 통하여 분석하였다. 결과: $100^{\circ}C{\sim}200^{\circ}C$에서 60분간 열처리된 박막은 비정질 특성을 나타내고 있었으며, $250^{\circ}C$ 및 $300^{\circ}C$로 열처리된 박막에서는 ZnO 결정상이 나타났다. 비정질 ZnO 박막의 PL분석에 의하면 매우 강한 Near-band-edge emission이 나타났으며, Green emission은 거의 검출되지 않았다. 결론: 앞으로는 저온에서 ZnO 광전자소자를 쉽게 제조할 수 있을 것이다.