• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.11
• /
• pp.2023-2026
• /
• 2008

Cooling technologies using natural and forced convection are limited and operated in very low efficiency. The corona discharge is utilized as the driving mechanism for an ionic pump, which allows for air flow control and generation with low noise and no moving parts. These ideal characteristics of ionic pump give rise to variety applications. However, all of these applications would benefit from maximizing the flow velocities and efficiencies of the pumps. In this study a needle-mesh type ionic pump, with a ring type third electrode installed just near the needle point, has been investigated by focusing on elevating the ionic wind velocity and efficiency. As a result, the enhanced ionic wind velocity and increased power yield can be obtained with the proposed ionic pump with the third electrode.

• Journal of Powder Materials
• /
• v.9 no.6
• /
• pp.433-440
• /
• 2002

Synthesis and compaction of Al-base nano powders by pulsed discharge method were investigated. The aluminum based powders with 50 to 200 nm of diameter were produced by pulsed wire evaporation method. The powders were covered with very thin oxide layer. The perspective process for the compaction and sintering of nanostructured metal-based materials stable in a wide temperature range can be seen in the densification of nano-sized metal powders with uniformly distributed hard ceramic particles. The promising approach lies in utilization of natural uniform mixtures of metal and ceramic phases, e.g. partially oxidized metal powders as fabricated in our synthesis method. Their particles consist of metal grains coated with oxide films. To construct a metal-matrix material from such powder, it is necessary to destroy the hard oxide coatings of particles during the compaction process. This goal was realized in our experiments with intensive magnetic pulsed compaction of aluminum nanopowders passivated in air.

• Proceedings of the SAREK Conference
• /
• 2005.11a
• /
• pp.564-569
• /
• 2005

Recently, from the viewpoint of global wanning, natural gas CO2 is considered as a main refrigerant for hot water system. The characteristics of CO2 is not toxic, not flammable, high pressure, and high refrigerating capacity. Also it is widely available as a byproduct of industrial processes. This paper describes the performance analysis program of the swash plate type compressor using CO2 refrigerant. Estimates of the refrigerant flow rate, compression work, discharge temperature and volumetric, compressor efficiencies of the CO2 swash plate type compressor are obtained from the various design parameter such as the inclination angle of the swash plate, discharge hole area and suction hole area.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.196-196
• /
• 2016

Landslide dam failure presents as a severe natural disaster due to its adverse impact to people and property. If the landslide dams failed, the discharge of a huge volume of both water and sediment could result in a catastrophic flood in the downstream area. In most of previous studies, breaching process used to be considered as a constructed dam, rather than as a landslide dam. Their erosion rate was assumed to relate to discharge by a sediment transport equation. However, during surface erosion of landslide dam, the sediment transportation regime is greatly dependent on the slope surface and the sediment concentration in the flow. This study aims to accurately simulate the outflow hydrograph caused by landslide dam by overtopping through a 2D surface flow erosion/deposition model. The lateral erosion velocity in this model was presented as a function of the shear stress on the side wall. The simulated results were then compared and it was coherent with the results obtained from the experiments.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05a
• /
• pp.52-57
• /
• 1996

The coolant void reactivity is positive for CANDU reactor loaded with DUPIC fuel which has more fissile content compared to natural uranium. A parametric study was done to reduce the void reactivity of the fuel bundle and loss in discharge burnup was estimated. It is observed that the burnable absorbers like gadolinium, boron, europium are not able to keep the reduction in void reactivity uniform throughout fuel burnup. Dysprosium and erbium can keep the void reactivity reduction uniform throughout. fuel burnup but toss in discharge burnup for erbium case is more compared to that of dysprosium case.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.327-327
• /
• 2020

Increase in Earth's surface temperature, higher rainfall intensity rate, and rapid changes in land cover are just some of the most evident effects of climate change. Flooding, and river sedimentation are two inevitable natural processes in our environment, and both issues poses great risks in the dam industry when not addressed properly. River sedimentation is a significant issue that causes reservoir deposition, and thus causes the dam to gradually lose its ability to store water. In this study, the long-term effects of climate change on the sediment discharge in Yongdam Dam watershed is analyzed through the utilization of SWAT, a semi-distributed watershed model. Based from the results of this study, an abrupt increase on the annual sediment inflow trend in Yongdam Dam watershed was observed; which may suggests that due to the effects of climate change, higher rainfall intensity, land use and land cover changes, the sedimentation rate also increased. An efficient sedimentation management should consider the increasing trend in sedimentation rate due to the effects of climate change.

• Journal of Korea Water Resources Association
• /
• v.46 no.12
• /
• pp.1169-1180
• /
• 2013

The objectives of this study are to construct the natural streamflow in the Bokhacheon middle-upper watershed using the SWAT-K model and to assess the impacts of groundwater withdrawals, water intake, treated sewage water release on streamflow. The simulated natural streamflow from 2006 to 2013 showed the minimum discharge of $1.7m^3/s$, the annual average discharge of $26.2m^3/s$, the drought flow of $2.0m^3/s$ at the outlet of the study area. The simulated results indicated that the groundwater pumping has induced the decrease of 34% in drought flow against the natural condition and the net water release has caused the increase of 15%, while the combined effects of the groundwater pumping and the net water release have induced the decrease of 19%. It was found out from the simulated natural streamflow data that the specific discharges of the abundant flow, normal flow, low flow, drought flow in the upper-middle channels of the Bokha-cheon watershed have a tendency to increase as the drainage area increases, but the specific discharges showed almost constant values at any downstream point with drainage area more than about 180 $km^2$.

• Journal of Korea Water Resources Association
• /
• v.51 no.8
• /
• pp.687-701
• /
• 2018

A multi-function weir is representative control structure in the stream flow. Estimation of accurate flood discharge according to gate operations and prediction of floodwave travel times at the downstream are very important in terms of water use and river management. This study analyzed the limitation and improvement through the current gate operation data on the Young-san river. in addition, flood discharge was calculated considering lower and upper water level condition and gate operating using the modified slope-area method in the Seoung-chon weir. As a result, the current state was required improvement because exceed the theoretical range and rapidly fluctuation of discharge coefficient, can not be considered difference between the upper and lower water level and the estimation by the regression equation. As a result of applying the proposed method in this study, the above mentioned limitations can be compensated, compared with the current discharge data. Also it was analyzed as more physically valid because using the evaluated hydraulic equation and estimate the slope and friction loss of natural stream by iteration and to reduce the error. In conclusion, the process carried out serves as a representative flow control point of the water system through reliable discharge estimation, it is expected that it will be possible to properly river management.

• ALGAE
• /
• v.17 no.2
• /
• pp.105-115
• /
• 2002

Influences of vrious environmental factors on the eutrophication of Nakdong River were analyzed statistically using water samples collected from 1 January, 1999, to 30 September, 2001 at Namji area. The relationships between the concentration of chlorophyll α (eutrophication index) and environmental factors and were analyzed to develop a statistical model which can predict the status of eutrophication. The concentation of chlorophyll α ranged from 66.2 mg · $m^{-3}$ to 70.8 mg · $m^{-3}$ during dry winter season and the average concentration during this study period was 35.5 mg · $m^{-3}$ Namji area of Nakdong River was in the hypereutrohic stage in terms of water quality. Stephanodiscus sp. and Aulacoseria granulata var. angustissima were dominant species during the witnter to spring time and summer to autumn period, respectively. Based on the correlation analysis and the analysis of variance between chlorophyll α concentration and environmental factors, significantly high positive relationships were found in the order of BOD> pH> COD > KMnO₄ consumption > DO > conductivity > alkalinity. In contrast to these factors, significantly negrative relationships were found as in the order of $PO₄^{3-}-P$ >water level>the rate of Namgang-dam discharge > NH₃-N> the rate of Andong-dam discharge> the rate of Hapchoen-dam discharge. Based on the factors analysis of environmental factors on the concentration of chlorophyll α, we obtained five factors as follows. The first factor included water level, pH, turbiditiy, conductivity, alkalinity and the rate of Namgang-dam discharge. The second factor included water temperature DO, NH₄+-N, NO₃- -N. The third factor included KMnO₄ consumption COD and BOD. The fourth factor included the rate of Andong-dam discharge, the rate of Hapcheon-dam discharge, and the rate of Imha-dam discharge. The final factor included T-N T-P and $PO₄^{3-}-P$ > concentration. We derived two statistica models that can predict the occurrence of eutrophication based on the factors by factor analysis, using regression analysis. The first model is the stepwise regression model whose independent variables are the factors produced by factor analysis : chl α (mg · $m^{-3}$ = 42.923+(18.637 factor 3) + (-17.147 factor 1) + (-12.095 factor 5) + (-4.828 factor 4). The second model is the alternative stepwise regression model whose independent variables are the sums of the standardized main component variables:chl α (mg · $m^{-3}$ = 37.295+(7.326 Zfactor 3) + (-2.704 Zfactor 1)+(-2.341 Zfactor 5).

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.13 no.5
• /
• pp.173-181
• /
• 1993

Under natural conditions, rivers do not in general take straight courses but instead take winding courses. This is known as meandering of rivers. Meandering of rivers are so complicated because of the mutual interactions between flow and movable boundaries. In quantitative information, it is important to predict the future location of a river channel(channel migration) because in selecting a bridge site or a location of a road. It may be valuable to know the future impact of a nearby river on those structures. When the prediction model of the migration of channel is used in domestic rivers with high coefficient of river regime, it is rational to use the periodical dominant discharge (PDD), which is named firstly by the author, instead of the average discharge. According to the analysis of the erosion coefficient, the mean deviation on the channel migration, and the bed scour factor, it can bring shedding light on the fact that the discharge is one of the dominant components in channel migration. In project area, the discharge that can shift the channel is slightly greater than 6,000CMS. The prediction model of the migration of channel estimated the erosion coefficient, $E_0$ by the data from the South Han River. This estimated value from the South Han River was also used to predict the migration of the South Han River in year 2000.