• Membrane and Water Treatment
• /
• v.1 no.2
• /
• pp.93-101
• /
• 2010

This study examined the effects of feed water chemistry and membrane fouling on the rejection of trace organics by a loose nanofiltration membrane. One ionisable and one non-ionisable trace organics were selected for investigation. Results reported here indicate that the solution pH and ionic strength can markedly influence the removal of the ionisable trace organic compound sulfamethoxazole. These observations were explained by electrostatic interactions between the solutes and the membrane surface and by the speciation of the ionisable compound. On the other hand, no appreciable effects of solution pH and ionic strength on the rejection of the neutral compound carbamazepine were observed in this study. In addition, membrane fouling has also been shown to exert some considerable impact on the rejection of trace organics. However, the underlying mechanisms remain somewhat unclear and are subject to on-going investigation.

• Membrane and Water Treatment
• /
• v.5 no.4
• /
• pp.251-263
• /
• 2014

The study contributes in the treatment of waste generated by the textile complex cotton of Draa Ben Khedda, Algeria. The azo dye "Direct Red Solophenyle 4GE" represents the base particle of the discharges and electrocoagulation with nanofiltration are used as a means of treatment. The solar photovoltaic is suitable for electrochemical process to reduce the energy cost. Several study parameters are considered in this work. The electrocoagulation batch gives the best reduction 37% for a dye concentration of 7.21 mg/L ($[NaCl]_{added}$=1g/L; $j=25.2mA/cm^2$). Coupling methods (electrocoagulation-nonofiltration) gives a complete discoloration rejecting concentration 52.4 mg/L (pHi = 7.6, $[NaCl]_{added}$=3g/L, $j=2.13mA/cm^2$). The result shows the coupling efficiency with a reduced amount of resulting slurry at the end of treatment.

• Membrane and Water Treatment
• /
• v.3 no.4
• /
• pp.231-242
• /
• 2012

The performance of a nanofiltration membrane for treatment of a low-level radioactive liquid waste was investigated through static and dynamic tests. The liquid waste ("carbonated water") was obtained during conversion of $UF_6$ to $UO_2$. In the static tests membrane samples were immersed in the waste for 24, 48 or 72 h. The transport properties of the samples (hydraulic permeability, permeate flow, selectivity) were evaluated before and after immersion in the waste. In the dynamic tests the waste was permeated in a permeation flow front system under 0.5 MPa, to determine the selectivity of NF membranes to uranium. The surface layer of the membrane was characterized by zeta potential, field emission microscopy, atomic force spectroscopy and infrared spectroscopy. The static test showed that the pore size distribution of the selective layer was altered, but the membrane surface charge was not significantly changed. 99% of uranium was rejected after the dynamic tests.

• Membrane and Water Treatment
• /
• v.12 no.2
• /
• pp.59-64
• /
• 2021

The rejection of sodium chloride (NaCl) and calcium chloride (CaCl2) single salt solutions were carried out for commercial nanofiltration NFDK membrane. Results showed that the NFDK membrane had a negative surface charge and had a higher observed rejection of 93.65% for calcium (Ca2+) ion and 78.27% for sodium (Na+) ions. Prediction of rejection for aqueous solutions of both salts was made using Donnan Steric Pore Model based on Extended Nernst-Planck Equation in addition to concentration polarization film theory. A MATLAB program was developed to execute the model calculations. Absolute Average Relative Error (% AARE) was found below 5% for real rejection of the NFDK membrane. This research could be used successfully to assess the membrane characterization parameter using a proposed procedure which can reduce the number of experiments.

• Membrane and Water Treatment
• /
• v.10 no.4
• /
• pp.299-305
• /
• 2019

Managed aquifer recharge (MAR) systems are gaining interest as an alternative to conventional water resources. However, when the water recovered in MAR systems, dissolved iron and manganese species may easily oxidize and they cause well screen clogging or require abandonment of extraction wells. In this study, both oxic and anoxic conditions were analyzed to verify the feasibility of the membrane filtration performance under various solution chemistries. The fouling mechanisms of the metal ions under anoxic conditions were also investigated by employing synthetic wastewater. The fouled membranes were then further analyzed to verify the major causes of inorganic fouling through SEM and XPS. The newly suggested anoxic process refining existing membrane process is expected to provide more precious information about nanofiltration (NF) membrane fouling, especially for demonstrating the potential advantages to chemical-free drinking water production for indirect potable reuse.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1995.06a
• /
• pp.27-38
• /
• 1995

Based on innovative membrane module concepts reverse osmosis and nanofiltration are going to become important instruments in environmental engineering. One example is the Disc-Tube-module and its application for the purification of landfill leachate. Currently over 45 different landfills are using this ROCHEM DT-module, in some cases combined with the high pressure reverse osmosis versions of this module, operating at up to 120 bar and 200 bar. This state of the art membrane technology and the DTF-module for nanofiltration, developed by ROCHEM on the basis of the DT-module and RO-systems for the purification of landfill leachate, make possible in hybrid processes permeate recovery rates of more than 97 % with concentration factors up to 40.

• Journal of Adhesion and Interface
• /
• v.24 no.1
• /
• pp.17-25
• /
• 2023

In this study, waste polyethylene terephthalate (PET) was recycled to produce a support and then polyetherimide (PEI) was used for environmentally friendly organic solvent nanofiltration. The prepared composite membrane was first prepared by electrospinning a PET support, then casted on the support using PEI having excellent solvent resistance, and organic solvent nanoparticles using a Non-solvent Induced Phase Separation (NIPS) method. A filtration membrane was prepared. First, the fiber diameter and tensile strength of the PET scaffold prepared prior to membrane fabrication were identified through morphology analysis, and the optimal scaffold for the organic solvent nanofiltration membrane was identified. Afterward, the PET/PEI composite membrane prepared was checked for the DEA removal rate of Congo red having a molecular weight of 697 g/mol in ethanol to understand the performance as an organic solvent nanofiltration membrane according to the concentration of PEI. Finally, the removal rate of Congo red was 90% or more.

• Proceedings of the KSCN Conference
• /
• 2005.10a
• /
• pp.81-81
• /
• 2005

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.8
• /
• pp.579-587
• /
• 2014

Various kinds of micro organic pollutants have frequently been detected from a water system. Therefore, it is considered to be very important part in the drinking water treatment system. And the research about removal process and processing efficiency have been being conducted briskly. In this study, the removal efficiency was evaluated using advanced water treatment process and nanofiltration process. The removal efficiency of nanofiltration process was very different according to physical and chemical characteristics of materials. The molecular weight of cutoff was the most influential factor in the removal efficiency. And when pKa value was higher than pH of raw water or Log Kow value was below 2, the removal efficiency of material was decreased. In case of oxidation reaction, the bigger the molecular weight of material was and the more hydrophobic a material was, the less oxidation reaction occurred. And the removal efficiency was decreased. Most unoxidized materials were removed by absorption. And the more actively oxidation reaction occurred by $H_2O_2$, the more absorption reaction increased.

• Clean Technology
• /
• v.10 no.1
• /
• pp.37-45
• /
• 2004

This study examined the separation characteristics of some of the most commonly used disperse, reactive and acid dyes by nanofiltration membrane. The chemical characteristics of three major dye solutions such as chemical oxygen demand, total nitrogen, total organic carbon, color, suspended solids, total dissolved solids, conductivity were investigated in this work. Experiments showed that the types of dye had a significant effect on both permeate flux and rejection efficiencies mainly due to the differences among their chemical structures and natures. Especially, the nanofiltration of reactive dye solutions showed higher permeate flux, lower total dissolved solid rejection efficiency and higher organics rejection efficiency than those of disperse dye solutions.