• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.7
• /
• pp.999-1008
• /
• 1993

동기추적 루프는 수신된 확산 부호의 동적 파형에 대한 추적을 수행함에 있어 AWGN 존재 하에서 낮은 동기추적 지터를 목적으로 설계되며, 전송지연에 대한 효율적인 추적을 위한 루프의 대역폭이 요구된다. 본 논문에서는 지연동기루프의 최적 설계를 위한 대역통과필터의 대역폭에 대하여 고찰하였다. NRZ 데이타의 경우 단극, 쌍극 및 이상적 Butterworth 대역통과 필터를 채용한 비코히어런트 BLL의 재곱손실을 구하였으며, 이를 통해 루프의 동기추적 지터를 최소화하는 대역통과필터의 최적의 대역폭을 주어진 데이타율과 수신비트에너지대 잡음밀도비에 대해 구하였다. 결과로서 NRZ 데이타의 경우 합리적인 대역통과필터의 최적대역폭이 존재함을 알 수 있으며, 아울러 DLL의 동기추적 지터에 대한 성능은 사용된 필터의 종류에 대해서는 비교적 민감하지 않음을 알 수 있다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.5
• /
• pp.369-378
• /
• 1988

In this paper, the performance of the timing jitter which has great effects on the echo canceller that can be used for full-duplex digital transmission on two-wire subscriber loops is analyzed. The power spectrum of timing jitter is about 8.9dB lower in the AMI input format than in the Polar-NRZ-L input format. The performance of the echo canceller also has been shown improved by 4dB when the input signal is in the AMI format.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.8
• /
• pp.1421-1432
• /
• 1994

The optimum design and performance of noncoherent TDL considering the effect of distortions due to the IF bandpasss filters are described. NRZ data and ideal filter is presumed in the simulation. The optimum filter bandwidth is calculated in the sense of minimizing the loop's squaring loss, which is equivalent to minimizing the loop's tracking jitter for a given data rate and data signal-to-noise ratio. As a result, the optimum filter bandwidth depends on the signal-to-noise ratio, and is obtained in the range of about 1-2 times of the data rate.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.6B
• /
• pp.848-855
• /
• 2001

본 논문에서는 GHz 대역의 고속 클럭 신호를 필요로 하는 데이터 통신 시스템 분야에 응용될 수 있는 새로운 구조의 클럭 및 데이터 복원회로를 제안하였다. 제안된 회로는 고속의 데이터 전송시 주로 사용되는 NRZ 형태의 데이터 복원에 적합한 구조로서 NRZ 데이터가 주입될 경우에 위상동기 회로에 발생하는 주요 잡음원인인 high frequency jitter를 방지하기 위한 새로운 위상 검출구조를 갖추고 있어서 보다 안정적인 클럭을 제공할 수 있다. 또 가변적인 지연시간을 갖는 delay cell을 이용한 위상검출기를 제안하여 위상 검출기가 갖는 dead zone 문제를 없애고, 항상 최적의 동작을 수행하여 빠른 동기 시간을 갖도록 하였다. Gbps급 대용량의 데이터를 복원하기 위한 클럭 생성을 목표로 하여 CMOS 0.25$\mu\textrm{m}$ 공정을 사용하여 설계한 후 그 동작을 HSPICE post-layout simulation을 통해 검증하였다.

• Journal of Sensor Science and Technology
• /
• v.29 no.3
• /
• pp.180-186
• /
• 2020

In this study, we applied edge-pulse modulation to prevent the flicker of light-emitting diode (LED) light in a visible light identification system. In the visible light transmitter, positive pulses were transmitted at the edges of the low-to-high transition points, and negative pulses were transmitted at the edges of the high-to-low transition points of the non-return-to-zero (NRZ) data waveforms. In the visible light receiver, the NRZ waveforms were regenerated by making low-to-high and high-to-low transitions at the point of the positive and negative pulses, respectively. This method has two advantages. First, it ensures that the LED light is flicker-free because the average optical power of the LED was kept constant during data transmission in the transmitter. Second, the 120 Hz optical noise from the adjacent lighting lamps was easily cut off using a simple RC-high pass filter in the receiver.

• Journal of Sensor Science and Technology
• /
• v.30 no.2
• /
• pp.99-104
• /
• 2021

In this study, we utilized the duty factor of the transition frequency modulation (TFM) for the illumination control of the light emitting diode (LED) light in visible light communication (VLC). The average optical power is linearly proportional to the duty factor in TFM waveforms. We used the transition frequencies of Na=5 and Nb=1 for the high and the low bits, respectively, of the non-return-to-zero (NRZ) data in the VLC transmitter. A resistor and capacitor high-pass filter (HPF) was used in the VLC receiver to eliminate the 120 Hz optical noise from adjacent lighting lamps and the spikes at the HPF output were used to recover NRZ data from the TFM waveform. In experiments, the illumination of the LED light was controlled in the range of 25-90% of the constant-wave optical power by changing the duty factor of the TFM waveforms.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.4
• /
• pp.127-134
• /
• 2015

VLC(Visible Light Communication) is the technology to send and receive data by using visible light that LED emits. The basic principle of VLC is the communication by using flashing(ON/OFF) of the light from the LED that changes electricity to light in short time. As the recent advances in LED technology, VLC is also received a lot of attention and the research about it is in progress actively. Especially, the interest about indoor VLC system is increasing because the visible light can't pass through the wall. In this paper, we compose the indoor SISO VLC system with NRZ-OOK and VPPM modulation schemes. Also, we apply SR-ARQ, a kind of re-transmission error control schemes, to the VLC system. And then, we compare and analyze the performance of communication according to the location of receiver and the type of modulation by using BER, the number of transmission and throughput.

• Korean Journal of Optics and Photonics
• /
• v.13 no.4
• /
• pp.295-300
• /
• 2002

We developed an optical transmitter and receiver for an electrical time division multiplexed (ETDM) 20 Gb/s optical transmission system, and experimentally investigated their characteristics. Especially, the clock extraction circuit, which is a key component in realizing broadband optical transmission receivers, was realized by using an NRZ-to-PRZ converter implemented with a half-period delay line and an EX-OR, a high-Q bandpass filter using a cylindrical dielectric resonator, and a microstrip coupled-line bandpass filter. Finally, the bit-error-rate of demultiplexed 10 Gb/s electrical signal after back to-back transmission was measured, and a high receiver sensitivity [-26.2 dBm for NRZ ($2^{7}-1$) pseudorandom binary sequence (PRBS)] was obtained

• Korean Journal of Optics and Photonics
• /
• v.20 no.3
• /
• pp.143-147
• /
• 2009

We propose an asymmetrical 2.5 Gbps / 622 Mbps bidirectional optical subscriber network with Manchester coded downstream and NRZ (Non-Return-to-Zero) upstream remodulation. The proposed system has important characteristics in the optical network unit (ONU): it does not require a light source or the usual control circuits such as wavelength control and output power control, and it is possible to use a synchronization scheme between upstream and downstream data. We theoretically analyze BER(Bit Error Rate) performance of upstream data remodulated with Manchester coded downstream according to the types of NRZ downstream data and perform simulations with MATLAB. The BER performance and the receiver sensitivity have been improved by 3 dB by adjusting threshold levels compared to the conventional receiver. The results have shown the remodulation scheme with Manchester coded downstream could be a useful technology for asynchronous and asymmetric optical subscriber networks with low cost and simple structures.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.3
• /
• pp.154-161
• /
• 2006

This paper describes the new types of ngative differential resistance (NDR) IC applications which use a monolithic quantum-effect device technology based on the RTD/HBT heterostructure design. As a digital IC, a low-power/high-speed MOBILE (MOnostable-BIstable transition Logic Element)-based D-flip flop IC operating in a non-return-to-zero (NRZ) mode is proposed and developed. The fabricated NRZ MOBILE D-flip flop shows high speed operation up to 34 Gb/s which is the highest speed to our knowledge as a MOBILE NRZ D-flip flop, implemented by the RTD/HBT technology. As an analog IC, a 14.75 GHz RTD/HBT differential-mode voltage-controlled oscillator (VCO) with extremely low power consumption and good phase noise characteristics is designed and fabricated. The VCO shows the low dc power consumption of 0.62 mW and good F.O.M of -185 dBc/Hz. Moreover, a high-speed CML-type multi-functional logic, which operates different logic function such as inverter, NAND, NOR, AND and OR in a circuit, is proposed and designed. The operation of the proposed CML-type multi-functional logic gate is simulated up to 30 Gb/s. These results indicate the potential of the RTD based ICs for high speed digital/analog applications.