• Transactions of the Korean hydrogen and new energy society
• /
• v.28 no.2
• /
• pp.220-224
• /
• 2017

Nitrogen dioxide ($NO_2$) is an important urban pollutant in Korea. Expecially, diesel vehicles are responsible for the most traffic rated nitrogen oxide ($NO_X$) emission, including nitric oxide (NO) and nitrogen dioxide ($NO_2$). Though nitrogen oxide ($NO_X$) emission from vehicle was applied a strict enforcement of emission standard, the specific $NO_2$ fraction in $NO_X$ ($NO_2/NO_X$) from various types of diesel vehicles was not understood. In order to investigate the fraction of $NO_2/NO_X$, the vehicle emission study was carried out at the facility of Transport Pollution Research Center (TPRC), National Institute of Environmental Research (NIER), Korea. Three different types of diesel vehicles(VAN, SUV, passenger) were tested on the NIER driving mode. The result of $NO_2/NO_X$ ratio was over 0.1 for all test vehicles and the highest $NO_2$ emission was observed at the van vehicle. The observation was showed that the emission trend of $NO_2/NO_X$ for passenger and SUV vehicles were inversely proportional. Also, as the emission standard has been strengthen, the emission rate of $NO_2$ has been decrease.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.5
• /
• pp.615-623
• /
• 2004

This study was conducted for developing the emission factors of nitrogen oxide(NOx) and carbon monoxide (CO) from the combustion boilers burning liquefied natural gas (LNG). These emission factors were compared with those of U.S. EPA and European Environment Agency (EEA). NOx and CO concentration in the flow gas were measured using Kane-May, KM9106 and Thermo Environmental Instruments Inc., 42C-HL. Measurement were conducted at thirty industrial and commercial LNG boilers. Emission factors were calculated on the basis of fuel consumption (kg-pollutant/㎥-fuel burned). NOx concentration at industrial boiler was 14~125 ppm and it was measured as 35~125 ppm at commercial boiler. NOx emission factors of industrial boiler and commercial boiler were 1.84kg/$m^3$ and 2.09kg/$m^3$, respectively. NOx emission factor of commercial boiler was higher than that of industrial boiler. The NOx emission factors estimated in this study were lower than those of U.S. EPA and higher than those of EEA. Average CO emission factor of industrial boiler was 0.65 kg/$m^3$ and at commercial boiler it was 0.70kg/$m^3$, CO emission factor at industrial boiler was lower than that at commercial boiler.

• Journal of Korean Society for Atmospheric Environment
• /
• v.11 no.E
• /
• pp.31-43
• /
• 1995

Natural emissions of NOx from soils were measured at an agricultural corn field during 3 weeks of growing season in summer (from May to June) 1995. This experiment was conducted in an effort to characterize the role of soil NOx on tropospheric ozone formation in rural atmosphere, and understand the natural NOx emission mechanism with respect to soil parameters. NO fluxes were ranged from 3.1 ng Nm$^{-2}s^{-1}$ to 259.0 ng Nm$^{-2}s^{-1}$, and average NO flux during experimental period was found to be 47.6 $\pm$ 50.6 ng Nm$^{-2}s^{-1}$ with 732 number of data. Diurnal variation of NO flux was shown clearly with daytime maximum and nighttime minimum. NO fluxes were correlated with soil temperature. Exponential soil temperature dependency of NO fluxes was found with 0.0160$^{circ}C^{-1} of k and r^2=0.508$, which agrees well to the value estimated at corn fields in eastern United States. The significant increases of NO fluxes from agricultural soil were detected after applying N fertilizers to soil. THe mechanisms attributed to this are enhanced biological nitrification and denitrification. In the view of rural ozone formation, the roles of natural NO emissions are very essential, especially in NOx - limited region such as southern United States.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.50 no.1
• /
• pp.50-57
• /
• 2014

The performance of five kind adsorbents, which can reduce nitrogen oxide (NOx) from the diesel engine occupying 85% of the fishing boat, was carried out and the emission reduction filter was manufactured and evaluated in the adsorption efficiency of the emission gas for 240 KW diesel portable generator. As a NOx emission filter made of mordenite which has an excellent cation exchange capacity was manufactured by ball type adsorbents having excellent specific surface area. The adsorption efficiency of mordenite material applying the emission reduction filter began to show up at the operating time 10 minutes in comparison with the activated carbon and zeolite materials, and it was exposed to continue until 100% capability with passing by 20 minutes. So the adsorption efficiency of the NOx reduction filter consistently maintained at the averaged 80%.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05b
• /
• pp.35-41
• /
• 2003

산업의 고도화 및 도시의 집중화로 오염물질의 종류가 다양화 되었으며 여러 가지 오염물질 중에서도 비산 분진, 황산화물(SOx) 등은 연료 중의 특정성분을 제거하거나 연료를 대체하여 그 배출량을 줄일 수 있다. 그러나 질소산화물(NOx)의 경우에는 연료의 문제가 아니라 연소과정에서 반드시 발생되는 특징을 가진 오염물질이다. 이와 같이 환경오염물질의 제거기술에 있어 가장 중요하게 고려되어야 할 사항은 오염가스 제거의 효율성과 경제성이다. 따라서 본 연구에서는 사무실, 가정 등 주로 실내공기정화를 위하여 NOx 제거를 위한 선 대 평판형 플라즈마 반응기에 자석의 개수에 의한 자계세기 및 자속밀도 시뮬레이션과 도출된 시뮬레이션 결과를 바탕으로 제작된 반응기에 자석을 부가한 NOx 제거에 대한 실험을 하였다. 그 결과 자석을 부가한 경우가 NOx 제거효과에 있어 효율이 좋음을 알 수 있었다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.2
• /
• pp.121-127
• /
• 2011

NOx (Nitrogen Oxide) reduction system periodically needs a rich or stoichiometric operating condition to reduce NOx. A new method that optimizes the control of external HC injection into a diesel exhaust pipe for HC-type LNT (Lean NOx Trap) catalyst system has been developed. In this paper, these catalysts are called HC-LNT catalysts. The concentration and amount of HC can be controlled by controlling the external injection. In this study, we investigated the relationship between the spray behavior of hydrocarbons injected into the transparent exhaust pipe and NOx reduction characteristics. From the results of this experiment, we obtained useful information about the optimum injection and position of HC injector to the exhaust pipe. Further, we obtained useful information about the optimal injection condition for an HC-LNT catalyst system with a gasoline PFI (port fuel injection) typeinjector.

• Applied Chemistry for Engineering
• /
• v.33 no.6
• /
• pp.600-605
• /
• 2022

In this study, nitrogen oxide (NO_x) removal experiments were performed using a graphene based ceramic filter coated with a V₂O₅-WO₃-TiO₂ catalyst. Graphene oxide (GO) was prepared by Hummer's method using graphite, and the reduced graphene oxide was produced by reducing with hydrazine (N₂H₄). Vanadium (V), Tungsten (W), and Titanium (Ti) were coated by the sol-gel method, and then a metal oxide-supported filter was prepared through a calcination process at 350 ℃. A NO_x removal efficiency test was performed for the catalytic ceramic filters with UV light in a humid condition. When graphene oxide (GO) and reduced graphene oxide (rGO) were present on the filter, the NOx removal efficiency was superior to that of the conventional ceramic filter. Most likely, this is due to an improvement in the adsorption properties of NOx molecules on graphene coated surfaces. As the concentration of graphene increased, higher NO_x removal efficiency was confirmed.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.9 no.3
• /
• pp.68-75
• /
• 2001

In this paper, a number of supported metal oxides and perovskite type catalysts were investigated for the NOx reduction from the diesel engine exhaust gas. All catalysts were made into pellets type with diameter of 3-4 mm alumina(Al$_2$O$_3$) as a supporter. These samples were tested by real diesel exhaust gas which contains CO, hydrocarbons and soot in the temperature range of 150~55$0^{\circ}C$ with the $3300h^{-1}$ space velocity (SV). Among the results, several promising catalysts showed NOx conversion above 50% in the temperature range of 150-35$0^{\circ}C$. From these results supported metal oxides catalysts and perovskite type could be recommended for the practical application to the automobile exhaust treatments.

• Clean Technology
• /
• v.17 no.3
• /
• pp.225-230
• /
• 2011

Characteristics of hydrocarbon selective catalytic reduction of NOx using various noble metal catalysts were investigated. The best active metal is Pt, supports are $CeO_2$ and $TiO_2$ by strong interactions between active metals, and 55% of conversion rate of NOx is shown. Pd, Rh and Ag catalysts presented a conversion of less than 20% as active metals, and supports also showed the poor activity compared to $SiO_2$ and $ZrO_2$. Experiments were performed with different types of reducing agents, amount, concentration of oxygen and space velocity in order to investigate the performance of catalysts according to operating conditions. The results confirm that the methane is better than propane as a reducing agent, and as the ratio of methane/nitrogen oxide increases, the catalytic activity increased, as the concentration of oxygen increases and space velocity decreases, the performance of catalysts increased.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.23 no.6
• /
• pp.608-614
• /
• 2015

Nitrogen oxide(NOx) emission reductions are required to meet the strict emission regulations for environmental protection. Most of the Exhaust Gas Recirculation(EGR) system applied to a diesel engine can relatively decrease the NOx at a low cost, but it has a disadvantage in that the PM generation is promoted due to the hot intake air temperature. Thus, high heat exchange efficiency of the EGR cooler is required for an effective removal of NOx. In this study, heat exchange efficiency for various types of heat exchangers used in EGR cooler was measured under same conditions, and determined best heat exchange performance shape depending on type of heat exchanger.