• Journal of Environmental Health Sciences
• /
• v.20 no.3
• /
• pp.13-18
• /
• 1994

Information on the heating values of municipal solid wastes is very important in evaluating the feasibility of incineration and RDF (Refuse Derived Fuel) manufacture. This paper describes the forecasting methods about the lower heating values of municipal solid wastes. The lower heating values are forecast by the heating values of physical components. The municipal solid wastes consist of paper, food wastes, textiles, plastics, wood and rubber (contained leather). These are the physical components of municipal solid wastes.

• Journal of Environmental Health Sciences
• /
• v.29 no.4
• /
• pp.35-41
• /
• 2003

The objective of this study was investigate the generation rates, composition, proportion and calorific values each of material in the municipal solid wastes as well as the effect of incineration residual leachate on the environment in Yangsan sanitary landfill site. The results were as follows ; The annual average generation rate of municipal solid wastes in Yang-san is approximately 2.0 kg/cㆍd. The weight percent of combustible matters is on average 78∼87% and the lower heating values of municipal solid wastes is measured to be more than 2,151 kcal/kg after removing the briquette component. The food waste was major source of solid wastes in Yang-san city as 35% and its variation by seasons was negligible. Combustible part was larger than incombustible part of the domestic solid wastes in spring and summer. It is recommended that municipal solid wastes be treated by multiple methods such as the sanitary landfill, resources and recovery, composting and incineration.

• KIEAE Journal
• /
• v.1 no.1
• /
• pp.45-52
• /
• 2001

This study aims to make a fundamental data for a policy-making decision in treatment and disposal of municipal solid wastes and presents a research data on the discharge properties of municipal solid wastes and making a unit of them in the Taegu metropolitan city. The results can be summarized as follows; survey the discharge properties of municipal solid wastes, calorific values and to present a research-data in supplying incineration-heat of wastes with the area of Sung-seo in Taegu. So, using fundamental data for planning and running wastes-incineration plants as well as trying to make better Urban Environmental Infra-structure. The results are obtained from the study. 1) The proportion of combustible wastes in Taegu increased from 89.6% to 94.47% during 1993~2000. However, the proportion of incombustibles decreased from 10.4% to 5.53% during 1993~2000. 2) The value of representative properties is about 1500~2000kcal/kg. So we can expect that it should be made use of energy-resources positively. 3) The heat from Sung-seo wastes-incineration plants is used to produce electronic-energy for wastes-incineration plants in summer season. The heat from Sung-sea wastes-incineration plants is in charge of 27% which of supplying the area of Sung-seo with district heating energy in winter season.

• Korean Journal of Soil Science and Fertilizer
• /
• v.45 no.3
• /
• pp.421-427
• /
• 2012

Nepal is one of the least urbanized countries in the world where more than 80% of the total population live in rural areas. In recent years, the rate of urbanization became rampant which ultimately accelerated immense pressure on municipal services, especially on managing the ever increasing amount of wastes. Due to lack of technology, infrastructure and financial capacity management of increasing amount of solid waste has become a major challenge in municipalities of Nepal. The indiscriminate dumping of solid wastes already affected the urban environment by creating a serious occupational health and environmental hazard to the vicinity of the dumping sites. However, there is great possibility of recovering methane from the landfill sites since the typical Nepalese municipal solid waste contains more than 65% of organic wastes. Despite having enormous potential of generating electricity from hydropower, Nepal is facing acute shortage of energy. Therefore, comprehensive scientific research and development is necessary for making solid waste to environmentally friendly by converting waste to the energy.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.9 no.4
• /
• pp.105-110
• /
• 2001

To provide successful treatment policy and to apply sources for establishing plan, municipal solid wastes quantity was investigated as physical and chemical characteristics from Sunchon city. Results are like following after checking out characteristics by seasons, type. The average specific weight of municipal solid wastes is $219kg/m^3$ for combustible wastes, $391kg/m^3$ for non-combustible. Food wastes of combustible wastes contained moisture of 38.1% as standard of moisture weight per real weight, 49.6% moisture is contained in non-combustible wastes except food wastes moisture. Moisture, volatile and ash are contented by 16.9%, 68.1% and 15.0% in combustible wastes except food wastes. That means combustible wastes are available a refuse incineration. The low calorific value of only combustible waste is 2,962kca1/kg that is good for refuse incineration.

• Environmental Engineering Research
• /
• v.24 no.4
• /
• pp.529-542
• /
• 2019

Nowadays, drying methods for municipal solid waste quality improvement have been adopted in the developed and developing countries to valorize wastes for a renewable energy source, reduce dependency on fossil fuel and keep safer disposal at landfills. Among them, biodrying, biostabilization, thermal drying and solar drying are the most common. Drying of municipal solid waste could offer several environmental and economic benefits. Therefore, this review highlighted the drying methods for municipal solid waste quality improvement around the world and compared them based on the reduction of moisture, weight and volume of municipal solid wastes against drying temperature and time by using statistical analysis. It was observed that the drying temperature of different drying methods accounted for 115 ± 40℃ for thermal drying, 59 ± 37℃ for solar drying, 55 ± 15℃ for biodrying and 58 ± 11℃ for biostabilization. Among the drying methods, thermal drying provided the shortest drying time. The moisture reduction, weight reduction, volume reduction and heating value increase of municipal solid waste could vary with drying temperature and time. Finally, the benefits and drawbacks of different drying methods were specified, and recommendations were made for the future efficient drying.

• Journal of Environmental Science International
• /
• v.17 no.2
• /
• pp.177-183
• /
• 2008

Characteristic of wastes in a unsanitary landfill at the residential development site in H city, Kyunggi-do was investigated for the disposal of huge amount of wastes. The total amount of wastes was estimated at 117,000 ton and construction solid wastes and municipal solid wastes were detected together. The portion of combustibles was very low and soils, concrete wastes, and pebbles were the major components in landfilled wastes. Because the site was the residential development site, the landfilled wastes should be removed immediately for the construction. Therefore the way that the unsanitary landfill was excavated and the wastes were sorted into three categories such as soils, noncombustibles and combustibles was selected as the best method. Soils and noncombustibles could be recycled and sorted combustibles could be re-landfilled in a smaller area or incinerated.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.1377-1383
• /
• 2005

Mechanical properties of Municipal Solid Wastes(MSW) and their influencing parameters were studied by using a series of triaxial compression tests and resonant column tests. The shear strength of MSW can be modeled by a bilinear failure criterion. As the unit weight increasing, cohesion and internal friction were increased linearly on semi-log scale. As the proportion of waste to soil increases, maximum shear moduli tend to decrease whereas minimum damping ratios increase. Shear moduli and damping of degradable waste are higher than those of non-degradable MSW.

• Journal of environmental and Sanitary engineering
• /
• v.20 no.1 s.55
• /
• pp.1-11
• /
• 2005

This research was performed to investigate the generation and physico-chemical characteristics of municipal solid wastes in the east coast of gangwon. The results were as follows: i) The generation rate of G city and Y gun were 0.187-0.384 $\cal{kg/cap/d}$ and 0.136-0.259 $\cal{kg/cap/d}$. Apparent density of G city and Y gun were 137.9-191.9 g/L and 157.3-238.3 g/L, respectively. ii) The wastes consisted of $76.1-97.5\%$ of combustibles and $2.5-23.9\%$ of incombustibles in G city. And the wastes consisted of $73.7-98.6\%$ of combustibles and $1.4-26.3\%$ of incombustibles in Y gun. Most of municipal solid wastes are composed of food, paper, and vinyl-plastics waste. Water content of commercial area, agricultural resident, detached resident, apartment area, school zone were 42.5-45.9, 37.6-43.4, 32.4-38.4, 29.3-32.3, $6.8-26.9\%$, respectively. iii) The low heating value of G city and Y gun were 1,125.5-2,540.7 $\cal{kcal/kg}$, 1,104.4-2,062.3 $\cal{kcal/kg}$, and school and apartment area were higher than commercial area.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.9 no.4
• /
• pp.125-134
• /
• 2001

The purpose of this study is to provide basic information for a future countermeasure municipal and to establish several wastes policy after investigating solid wastes from Sunchon City. In addition, this research can be supported to manage of recycling plant and to reuse plant of each wastes. Results are as bellows after checking up and analysis type of waste in Sunchon city Unit solid waste generation rate from single family is $0.50kg/person{\cdot}day$, and total solid wastes are 41.9ton/day. Unit solid waste generation rate from apartments is $0.45kg/person{\cdot}day$, and solid wastes generation is 55.5ton/day. Unit solid waste generation rate from agricultural is $0.22kg/person{\cdot}day$ and total solid wastes are 13.5ton/day. That show total amount of municipal solid wastes from residential are 110.9ton/day. Unit solid waste generation rate from traditional markets is $1.85kg/person{\cdot}day$, and solid waste total volume is 5,400kg/day. Unit solid waste generation rate from small store is $2.03kg/person{\cdot}day$, and solid waste total are 25,101kg/day. Therefore, this show that total wastes are 30.50kg from downtown and commercial area. Solid waste quantity from Industrial area (Factory region) is 8.5ton and in case of school and hospitals are 7.2kg/day and 3.0kg/day. Solid waste amount from Institutional is 6.6kg/day. Food wastes were eliminated from municipal solid wastes as standard 63.4ton/day, and combustible wastes were 126.9ton/day. If it schedule about 5 years (by 2006) as durable year for food wastes treatment plant, it is expected 42.5ton/day for treatment capacity. We can judge that it is effective to be set 2 lines equipment ${\times}25ton/day$ as treatment ability under considering unexpected working condition such as any repair, trouble and an electrical load. If it schedule about 10 years (by 2011) as durable year for food wastes treatment plant, it is expected 150 ton/day for treatment capacity. We can conclude that it is effective to be set 2 lines equipment ${\times}80ton/day$ as treatment ability under considering working condition such as low loaded operating and the repair for incineration.