• 정보통신설비학회논문지
• /
• 제4권1호
• /
• pp.31-36
• /
• 2005

In this paper, a planar type bandpass filter in multilayered PCB is presented. The multilayered PCB structure has some advantages on fabricating microwave devices such as the size reduction and ability of tight coupling by folding or embedding. The proposed BPF has two transmission zeros at the both sides of the center frequency by using independent electric and magnetic coupling structure. The designed BPF with four layer teflon PCBs of dielectric constant 2.94 has dimensions of 24x20x1.524 in mm, center frequency of 2.47GHz and bandwidth of about l00MHz. A good agrement is achieved between the measured result and the simulated one. The influences of air gaps between the layers are also analyzed and presented.

• 센서학회지
• /
• 제20권2호
• /
• pp.77-81
• /
• 2011

This paper presents a single-pole eight-throw(SP8T) switch based on proposed a radio-frequency(RF) microelectromechanical systems (MEMS) switches. The proposed switch was driven by a double stop(DS) comb drive, with a lateral resistive contact. Additionally, the proposed switch was designed to have tapered signal line and bi-directionally actuated. A forward actuation connects between signal lines and contact part, and the output becomes on-state. A reverse actuation connects between ground lines and contact part, and the output becomes off-state. The SP8T switch of 3-stage tree topology was developed based on an arrangement of the proposed RF MEMS switches. The developed SP8T switch had an actuation voltage of 12 V, an insertion loss of 1.3 dB, a return loss of 15.1 dB, and an isolation of 31.4 dB at 6 GHz.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.265-266
• /
• 2015

A multiple output dc-dc resonant converter topology for an independent voltage control technique is proposed, using a narrow frequency selection band-pass filters. The multi-output converter is supplied by a single source inverter with the superposed sinusoidal signals reserved for each output. A series-series parallel resonant topology is utilized to implement the narrow frequency selection channels for minimum interference. Finally the experimental setup for four output dc-dc converter is verified with the narrow channel frequencies of 26 kHz, 32 kHz, 38 kHz and 46 kHz.

• Journal of electromagnetic engineering and science
• /
• 제9권3호
• /
• pp.159-163
• /
• 2009

This paper presents the design and implementation of Q-band MMIC phase shifters using InGaAs PIN diodes. The topology using a thin-film microstrip line(TFMS) has been proposed to achieve the desired phase-shift as well as good loss characteristics. Five single-bit MMIC phase shifters have been implemented by using a developed BCB(benzocyclobutene)-based multi-layer fabrication technology. The developed phase shifters have less than 3.4 dB of insertion loss and better than 11 dB of input and output return loss in the frequency range of 43 to 47 GHz. To the authors' knowledge, this is the first demonstration of high-performance InGaAs PIN diode-based MMIC phase shifters operating at Q-band frequencies.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2003년도 종합학술발표회 논문집 Vol.13 No.1
• /
• pp.256-259
• /
• 2003

In this paper, a design of multi-layered BPF(bandpass filter) using LTCC(Low Temperature Co-fired Ceramic) process by a lumped-elements is proposed for SOP(system-on-a-chip) of wireless communication systems. The proposed BPF improved a characteristic of rejection band to build an attenuation pole caused by structurally adjacent co-inductance and coupling. The simulation data shows a bandwidth of 90MHz from a center frequency of 2.4GHz, a return loss of 27dB, an insertion loss of 3.2dB, and an attenuation of at least 20dBc at $f_0{\pm}250MHz$. Simulations have used serenade circuit simulation and HFSS EM simulation.

• Transactions on Electrical and Electronic Materials
• /
• 제16권4호
• /
• pp.173-178
• /
• 2015

In lieu of the excellent radio frequency (RF) performance of microelectromechanical system ( MEMS) switches, these micro switches need higher actuation voltage for their operation. This requirement is secondary to concerns over the swtiches’ reliability. This paper reports high reliability operation of RF MEMS switches with low voltage requirements. The proposed switch is optimised to perform in the Q-band, which results in actuation voltage of just 16.4 V. The mechanical stress gradient in the thin micro membrane is computed by simulating von Mises stress in a multi-physics environment that results in 90.4 MPa stress. The computed spring constant for the membrane is 3.02 N/m. The switch results in excellent RF performance with simulated isolation of above 38 dB, insertion loss of less than 0.35 dB and return loss of above 30 dB in the Q-band.

• Journal of Electrical Engineering and Technology
• /
• 제12권3호
• /
• pp.1250-1256
• /
• 2017

This paper proposes the design of microstrip patch antennas for dual-band polarization adjustment. The antenna has a multi-layer structure for dual-band operation, and each layer contains a resonating patch with surrounding strips separated into two parts. The antenna polarization is adjusted by varying the separated positions of the strips, while fixing other design parameters. To demonstrate the feasibility, an antenna sample with right-hand circular polarization is fabricated, and its antenna characteristics are measured in a full anechoic chamber. The operating principle of polarization adjustment in the dual frequency bands is also verified by observing near electromagnetic fields and the magnetic surface current density around the antenna.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2006년도 춘계종합학술대회
• /
• pp.970-973
• /
• 2006

본 논문은 RFID(Radio frequency IDentification)와 무선 단말기를 이용하여 무선으로 물류를 관리하는 시스템을 구현한다. RFID Reader는 소프트웨어를 이용해 UHF 대역에서의 Class를 지정하고, 하드웨어를 제어함으로서 UHF 대역 Tag들을 인식할 수 있다. 이렇게 구현된 시스템을 이용해 보다 효율적인 물류 관리를 가능하게 하고자 한다.

• 전자공학회논문지
• /
• 제52권11호
• /
• pp.156-163
• /
• 2015

국내에서 개발된 단일모드 균일한 단주기형 광섬유 격자소자(FBG: Fiber Bragg Grating)를 이용하여, 수중에서 음파를 검출할 수 있는 FBG 일체형 Transducer를 설계 및 제작하였다. 이를 통하여 신호검출 시스템구성 시, 최근 제작된 Hopper WDM(특허번호 제10-1502954)을 이용하여 수중에서 다중점신호검출과 지향성 연구를 한 결과, 기존의 광섬유 센서가 지니고 있는 우수한 장점들을 모두 지니고 있을 뿐만 아니라, Sensor Arm 구성이 간단하여 실용화에 큰 장점을 지니고 있다. 제작된 FBG 일체형 트랜스듀서는 30 Hz~2.5KHz 범위에서 주파수 검출이 가능하고, 최적의 공진조건 주파수는 1.2KHz로 나타났다. 또한, 이를 이용한 수중에서 넓은 영역에 대한 다중점 신호 검출을 구현하기 위하여, WDM(Wavelength Division Multiplexing) 방법과 Passive band-pass filter system을 이용하여 FBG Hydrophone Arrays System을 구축하고, 2개의 FBG 일체형 Transducers에서 주파수 200Hz~1.3 KHz대까지 다중점 수중 음파 신호 검출을 성공 하였다. 아울러, 음원의 방향과 각도에 따라 검출된 신호의 세기가 변화되므로 음원의 물체에 대한 방향성 검출이 가능함으로서, 향후 FBG Hydrophone의 실용화 연구에 새로운 기틀을 마련하였다.

• 천문학회보
• /
• 제39권2호
• /
• pp.114-114
• /
• 2014

We present our activities linking to planning of possible forms of large program to study on circumstellar H2O and SiO maser sources with KaVA. A great advantage of KaVA for the stellar maser observations is the combination of the unique capability of the multi-frequency phase referencing technique of KVN and the dual-beam astrometry of VERA with the KaVA's relative dense antenna configuration. We have demonstrated this advantage through the test observations conducted by the KaVA Evolved Stars Sub-working Group since 2012 March. Snapshot KaVA imaging is confirmed to be possible in integration time of 0.5 hour at the 22 GHz band and 1.0 hour at the 43 GHz band in typical cases. This implies that large snapshot imaging surveys towards many H2O and SiO stellar masers are possible within a reasonable machine time (e.g., scans on ~100 maser sources within 200 hours). This possibility enables us to select the maser sources, which are suitable for future long-term (10 years) intensive (biweekly-monthly) monitoring observations, from 1000 potential target candidates selected from dual-frequency band (K/Q-bands) KVN single-dish observations. The output of the survey programs will be used for statistical analysis of the structures of individual stellar maser clumps and the spatio-kinematical structures of circumstellar envelopes with accelerating outflows. The combination of astrometry in milliarcsecond(mas) level and the multi-phase referencing technique yields not only trigonometric parallax distances to the masers but also precise position reference for registration of different maser lines. The accuracy of the map registration affects interpretation of the excitation mechanism of the SiO maser lines and the origin of the variety of the maser actions, which are expected to reflect periodic behaviors of the circumstellar envelope with stellar pulsation. Currently we are checking the technical feasibility of KaVA operations for this combination. After this feasibility test, the long-term monitoring campaign program will run as one of KaVA's legacy projects.