• Proceedings of the KIEE Conference
• /
• 2007.11c
• /
• pp.165-169
• /
• 2007

Organic EL has been expected to adopt to a new styles of technology that make flat display after Tang & Vanslyke made food electric luminescence device in late 1980s. Their studies based on multi layer structure that consists of emitting layer and carrier transporting layer using proper organic material. In this study we made multi layer device using $Eu(TTA)_3(phen)$ as a luminescence material by PVD and investigate luminous properties of each device. But oxidization of organic layer by ITO, energy walls in both pole interface, contaminations of ITO surface, importance of protecting membrane, diffusive dimming of light to cathode organic layer, these causes of degradations are common facts of a macromolecule and micromolecule. We think these degradation caused by the impact of heat and electro-chemical factor, bulk effect and interface phenomenon, and raise a question.

• Journal of information and communication convergence engineering
• /
• v.9 no.2
• /
• pp.193-196
• /
• 2011

Transmit antenna selection techniques are prominent since they exploit the spatial selectivity at the transmitter side. In the literature, antenna selection techniques assume full knowledge of the channel state information (CSI). In this paper, we consider that the CSI is not perfectly known at the transmitter; however, a quantized version of the channel coefficients is fed back by the users. We employ the non-uniform Lloyd-Max quantization algorithm which takes into consideration the distribution of the channel coefficients. Simulation results show that the degradation in the BER of the system with imperfect CSI at the transmitter is tolerable, especially when the transmit diversity order is high.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2001.04a
• /
• pp.323-328
• /
• 2001

The behavior of bridge column under multi-directional loading as well as uni-directional loading need to be studied because bridge columns will be subjected to the multi-directional cyclic loading during a strong earthquake. To evaluate the capacity of columns, uni-axial cyclic loading tests and bi-axial alternate cyclic loading tests were carried out. The number of cycles of alternate bi-axial loading were determined considering the ratio of natural frequencies in two orthogonal directions. From the test results, strength degradation and ductility reduction were observed in biaxial loading conditions. Their rates were found to be more rapid in the loading pattern that was determined considering the different natural frequencies.

• Proceedings of the KIEE Conference
• /
• 2005.10b
• /
• pp.619-621
• /
• 2005

This paper proposes apractical design method for ship-to-ship missiles' autopilot. When the pre-designed analogue autopilot is implemented in digital way, theygenerally suffer from severe performance degradation and instability problem even for a sufficiently small sampling time. Also, aerodynamic uncertainties can affect the overall stability and this happens more severely when the nonlinear autopilot is digitally implemented. In order to realize a practical autopilot, two main issues, digital implementation problem and compensation for the aerodynamic uncertainties, are considered in this paper. MIMO (multi-input multi-output) nonlinear autopilot is presented first and the input and output of the missile are discretized for implementation. In this step, the discretization effect is compensated by designing an additional control input. Finally, we design a parameter adaptation law to compensate the control performance. Stability analysis and 6-DOF (degree-of-freedom) simulations are presented to verify the proposed adaptive autopilot.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.1
• /
• pp.112-117
• /
• 2016

This paper presents a half-rate current-integrating DFE receiver with sub-unit interval (sub-UI) inter-symbol interference (ISI) cancellation. By having a single additional DFE tap in each data path, the proposed DFE receiver can minimize BER degradation due to input pattern dependency and feedback tap latency problems in conventional current-integrating DFE receivers. The proposed DFE receiver was designed and fabricated in a 45 nm CMOS process, whose measurement results indicated that the BER bathtub width is increased from 0.235 UI to 0.315 UI (34% improvement) at $10^{-12}$ BER level.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.775-779
• /
• 1999

This paper presents design of AGC(Automatic Gain Control) and DC offset remover suitable for cable modem which makes use of QAM(Quadrature Amplitude Modulation) scheme. Since QAM has multi-level signal characteristic, for high-order QAM, the constellation is dense and the distance of decision boundary between adjacent symbols is short. So AGC and DC offset remover must be designed optionally for preventing performance degradation. AGC is designed into feedback type and is related to the STR(Symbol Timing Recovery)and Paff interpolation algorithm. Whereas AGC need to perform average power detection during many symbols by comparison with the reference power, DC offset remover uses only the instant polarity decision such that simple implementation can be achieved with good performance. Though the AGC and DC offset remover are simulated here only for 256 QAM scheme for convenience'sake, it can be applied to other multi-level QAM or PSK modulation scheme.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.4
• /
• pp.47-55
• /
• 1994

This paper presents the CDMA system using the RAKE receiver over a multipath fading channel and in multi-user environments. The interference between the propagation paths in a multipath fading causes a serious degradation in the mobile communication environment. In order to derive the path inteference and reduce the fading effect, the RAKE receiver is used. In a computer simulation, the path number of a fading channel and the branch number of the RAKE receiver are modified. As a result, the CDMA system using the RAKE receiver gives a better performance than the conventional CDMA system over a multipath fading channel and in multi-user environments.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.594-598
• /
• 2003

In this paper, we analyze the performance of UWB(Ultra-WideBand) communication system employing Bi-phase modulation and RAKE Receiver under the MAI(Multiple Access Interference) and the OSI(Other System Interference) environment. Using the multi-path channel model recommended by IEEE P802.15.TG3a, the performance degradation Is described with the number of users, the number of RAKE fingers and training sequences. To meet BER 10e-4 for 20 users at the same time, the number of RAKE fingers are proposed from 3 to 32. And the number of training sequences are limited less than 8 to keep the channel estimation error within 3dB

• Journal of Korea Multimedia Society
• /
• v.20 no.9
• /
• pp.1481-1490
• /
• 2017

This paper presents an image quality enhancement algorithm for dark image acquired under poor lighting condition. Various retinex algorithms which are human perception-based image processing methods were proposed to solve this problem. Although MSR(Multi-Scale Retinex) among these algorithm works well under most lighting condition, it shows color degradation because their separate nonlinear processing of RGB color channels. To compensate for the loss of the color, MSRCR(Multi-Scale Retinex with Color Restoration) was proposed. However, it requires high computational load and has additional parameters that need to be adjusted according to input image. In order to overcome this problem, a new retinex algorithm based on MSR is proposed in this paper. The proposed method consists of V channel MSR, saturation correction, and separate contrast enhancement process. Experimental results show that the subjective and objective image quality of the proposed method better than those of the conventional methods.

• Journal of information and communication convergence engineering
• /
• v.8 no.6
• /
• pp.687-689
• /
• 2010

In this paper, the equalization for frequency slope of path loss in Multi-Band(MB) OFDM UWB is proposed. The path loss of a signal is proportionate to the square of the signal's frequency. So, the received signal amplitudes of OFDM subcarrier can be different up to 3dB when MB-OFDM occupies bandwidth over 1.5GHz. The differences of subcarrier-amplitudes make an effective of 0.3 bit reduction of soft decision bits of viterbi decoder, and when the effective of 0.3 bit reduction can cause 0.5dB SNR degradation. This paper proposes two modem architectures which compensate for the degraded subcarrier by multiplying the reciprocal of degraded values in analog or digital domain. It is shown that, for the proposed architecture applied to MB-OFDM UWB, the performance improvements up to 0.5dB can be obtained over the conventional uncompensated receiver architecture.