• Proceedings of the KSR Conference
• /
• 2004.06a
• /
• pp.987-993
• /
• 2004

The status of mud-pumping in the existing railroad lines were investigated and real-scale tests simulating mud-pumping phenomena were carried out to analyze its mechanism. The penetration of ballast material into the subgrade and the cause of mud-pumping are explored. The results of the investigation and tests will be used to develop the new method and materials for the prevention of mud-pumping.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1999.03a
• /
• pp.463-470
• /
• 1999

The railroad transportation system has more advantages over other transportation systems in terms of low cost, safety and mass transportation The development in economy and social environments lead to the increase of the transportation between cities. As a result, the increased capacity of transportation system is required and maintenance of transportation facilities becomes more important, In the railroad system mud-pumping is one of the troubles to cause distortion of rails and progressive disrupture of subgrade. h this study, SASW measurements were performed to investigate stiffness structures at the sites with mud-pumping and without mud-pumping, Comparison of the stiffness structures revealed the mechanism of mud-pumping and provided information to choose measures for the mud-pumping.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1999.03a
• /
• pp.415-422
• /
• 1999

A series of crosshole tests was conducted to evaluate the mechanical characteristics of railway subgrade materials which has been experiencing mud-pumping. The shear wave velocity profiles of mud-pumped sites were compared with those of adjacent intact sites. The shear wave velocities of mud-pumped layers are less than 150 m/sec.

• Geomechanics and Engineering
• /
• v.30 no.2
• /
• pp.201-210
• /
• 2022

This paper presents a study regarding the influence of various water levels on the characteristics of subgrade mud pumping through a self-developed test instrument. The characteristics of mud pumping are primarily reflected by axial strain, excess pore water pressure, and fine particle migration. The results show that the axial strain increases nonlinearly with an increase in cycles number; however, the increasing rate gradually decreases, thus, an empirical model for calculating the axial strain of the samples is presented. The excess pore water pressure increases rapidly first and then decreases slowly with an increase in cycles number. Furthermore, the dynamic stress within the soil first rapidly decreases and then eventually slows. The results indicate that the axial strain, excess pore water pressure, and the height and weight of the migrated fine particles decrease significantly with a low water level. In this study, when the water level is 50 mm lower than the subgrade soil surface, the issue of subgrade mud pumping no longer exist.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.1546-1553
• /
• 2005

In this study, geotextiles was applied on the selected track-bed, which is relatively economical and efficient way to prevent the problem of mud-pumping and settlement. Field testing sections from Mock-haeng to Dong-ryang in the Chung-buk lines in Korea were selected to investigate the state of track and roadbed. And three places were chosen among 1,700 spots where mud-pumping was frequently occurred and maintenance required. At the curved section with radius of 500m between Mock-haeng and Dong-ryang, we divided this testing site into 5 section and 4 different types of geotextile were installed and left the last section with no reinforcement. Total length of the test site was 200m and individual length of each site was 40 m. In order to understand the state and the strength of prepared roadbed, stiffness and physical properties of the roadbed soil were evaluated and analyzed. Also, after the installation, mud-pumping, settlement of elastic or plastic sleeper, failure of track, wheel-loads, lateral force and earth pressures were investigated.

• Proceedings of the KSR Conference
• /
• 2005.05a
• /
• pp.734-743
• /
• 2005

In this study, geotextiles was applied on the selected track-bed, which is relatively economical and efficient way to prevent the problem of mud-pumping and settlement. Field testing sections from Mock-haeng to Dong-ryang in the Chung-La lines in Korea were selected to investigate the state of track and roadbed. And three places were chosen among 1,700 spots where mud-pumping was frequently occurred and maintenance required. At the curved section with radius of 500m between Mock-haeng and Dong-ryang, we divided this testing site into 5 section and 4 different types of geotextile were installed and left the last section with no reinforcement. Total length of the test site was 200m and individual length of each site was 40 m. In order to understand the state and the strength of prepared roadbed, stiffness and physical properties of the roadbed soil were evaluated and analyzed. Also, after the installation, mud-pumping, settlement of elastic or plastic sleeper, failure of track, wheel-loads, lateral force and earth pressures were investigated.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03b
• /
• pp.191-198
• /
• 2000

Dynamic fatigue test is carried out using soil model box for the evaluation of performance of three different roadbed materials. Bearing capacity, settlement and mud pumping phenomenon of each roadbed materials as well as penetration of model ballast into the roadbeds are investigated. It was found that settlement of slag and crushed stone roadbed is smaller than the soil roadbed during dynamic fatigue test with same initial conditions.

• The KSFM Journal of Fluid Machinery
• /
• v.17 no.6
• /
• pp.29-37
• /
• 2014

Non-Newtonian fluid mechanics takes charge of an important role in the oil industries. Especially in the oil well drilling process, the drilling fluid such as mud keeps the drill bit cool and clean during drilling, with suspending drill cuttings and lubricating a drill bit. The purpose of this study is to examine the effect of fluid mud rheological properties to predict different characteristics of non-Newtonian fluid in the mud mixing tank on offshore drilling platforms. In this paper, ANSYS fluent package was used for the simulation to solve the hydrodynamic force and to evaluate mud mixing time. Prediction of the power consumption and the pumping effectiveness has been presented with different operating fluid models as Newtonian and non-Newtonian fluid. The comparison between Newtonain mud model and non-Newtonian mud model is confirmed by the CFD simulation method of drilling mud mixing tank. The results present useful information for the design of the drilling mud mixing tanks and provide some guidance on the use of CFD tool for such non-Newtonian fluid flow.

• Journal of the Korean Geosynthetics Society
• /
• v.6 no.4
• /
• pp.21-28
• /
• 2007

3 years visual inspection has been performed on the railway lines where ballast replacement or geosynthetics-reinforcement had been used to restrain the mud pumping. The result indicates that geosynthetics-reinforcement is more effective than ballast replacement for the long-term mud pumping. In addition, the non-woven geotextile to be used for mud pumping restraint is effective when its weight is $330N/m^2$ or above. Furthermore, the lateral tensile strain under ballast on which wheel load applies ranges from 0.016 to 0.1211% and it's 10 times larger than the lateral tensile strain which ranges from 0.0078 to 0.0385%.

• Journal of the Korean Society for Railway
• /
• v.9 no.1 s.32
• /
• pp.69-75
• /
• 2006

In this study, Several types of geotextile was used on the selected track-bed. The use of geotextile prove a economical and efficientmean to prevent the problem of mud-pumping and settlement. Field testing sections from Mock-haeng to Dong-ryang in the Chungbuk lines in Korea were selected to investigate in current condition the of track and roadbed. This testing site was divided into 5 sections. In the four sections, different types of geotextiles were installed. In order to estimate for performance of the reinforced section with geotextiles on the soft ground, four different geotextiles were installed and compared with no reinforced section. Also, after the installation, mud-pumping, settlement of elastic or plastic sleeper, failure of track, wheel-loads, and earth pressures were investigated. The following is the summaries from the field tests. As a conclusion, According to naked eyes investigation, mud pumping didn't happen at reinforced sections, but no reinforced section was happen to a top of track for 6 months. And Elastic displacements at the reinforced and no reinforced section were about $30.7\%\;and\;73.8\%,$ respectively. Also, It was found that plastic displacement in reinforced section was retrained about $50\%$ more than that in no reinforced section.