• International Journal of Automotive Technology
• /
• v.7 no.3
• /
• pp.277-282
• /
• 2006

With the aim of achieving half the regulated value of EURO-3 Emission Regulations, an ultra low emission motorcycle has been developed based on a motorcycle with an 1800 $cm^3$, horizontal opposed 6-cylinder engine. For the fuel supply system, an electronically controlled fuel injection system was applied. For the emission purification system, three-way catalysts, a feedback control system with a LAF(Linear Air-Fuel ratio) sensor, and a secondary air induction system were applied. To reduce CO and HC emissions during cold starting, an early catalyst activation method combining RACV(Rotary Air Control Valve) and retarded ignition timing was applied. After the catalyst activation, air-fuel ratio was controlled to maximize the purification ratio of the catalyst according to vehicle speed. For the air-fuel ratio control system, the LAF sensor was used. Furthermore, fine adjustment by the LAF feedback control reduced torque fluctuation due to the air-fuel ratio change. As a result, smooth ride feeling was maintained. Owing to these technologies, half the regulated value of EURO-3 has been achieved without any negative impact to the large-scaled motorcycles' drivability. This paper presents the developed ultra low emission technologies including the control method using an LAF sensor.

• Journal of Korean Society for Atmospheric Environment
• /
• v.3 no.1
• /
• pp.55-64
• /
• 1987

Actual driving pattern of each motor vehicle type was measured and analyzed in Seoul area and vehicle emission rate was measured and traffic data were used to estimate vehicular emission factor and motor vehicle-related air pollutant emission. The analysis of contribution ratio of each vehicle type showed that LPG taxi's took 38.1% of total vehicular CO, gasoline passenger cars 37.5%, therefore, these cars are major sources of CO, gasoline passenger cars took 45.4% of total vehicular HC, motorcycles 25.3%, LPG taxi's 16.2%, so motorcycles can be said to play an important role in HC emission. For NOx, buses and trucks were thought to be major sources as buses took 36.8% and truck 26.4%. Diesel vehicles, on the other hand, took most $SO_2$ and particulate matter emission. Total emission from motor vehicles in Seoul was estimated to be 547 t/day of CO, 68t/day of HC, 163t/day of NOx, 18t/day of $SO_2$ and 19t/day of paticulate matter.

• Journal of Environmental Science International
• /
• v.5 no.2
• /
• pp.229-241
• /
• 1996

This study was performed to find the most desirable emission reduction for each mobile source pollutant and the optimal control strategy at a given level of expenditures in Pusan City in 2000 by using the interactive s-constraint method developed by Chang-Hyo Lee and Hyung-Wook Kim, which isone of the mathematical programming models. The most desirable emission reduction is 7093 ton/year for particulate (TSP), 4871 ton/year for NOx, 5148 ton/year for HC and 36779 ton/year for CO. The optimal control strategy is as follows; 1. As to passenger car and taxi, limiting VKT (vehicle kilometers travelled) in congested areas will be necessary. In addition to this, improving vehicie inspection Program should be enforced. 2. As to small-gasoline bus, traffic adaptive control system will be necessary. 3. As to small-diesel bus, non-adjustable engine parameters will have to be applied. .4. As to heal bus and heart truck, catalytic trap oxidizer and limiting VKT in congested areas will do necessary. 5. As to motorcycle, 2-cycle motorcycles should be converted to 4-cycle motorcycles.

• Journal of Auto-vehicle Safety Association
• /
• v.10 no.1
• /
• pp.6-11
• /
• 2018

Recently, many drivers of two-wheeled motorcycles in leisure and express delivery industries etc. brought increasing issues for the motorcycle safety. This paper has studied the structural safety of two-wheeled motorcycles considering the regulations for stand, rear registration plate and anti-tampering measures. The authors have investigated and compared a variety of international and domestic regulations and specifications for structural safety of those components. Detailed experimental procedures of stand, mounting for rear registration plate and anti-tampering measures are proposed to secure the two-wheeled motorcycle safety and the outcomes of this study can be used to confirm the Korean motor vehicle safety standards.

• Journal of Korean Society of Transportation
• /
• v.29 no.4
• /
• pp.7-15
• /
• 2011

Emerged in early 1990s, so called 'Quick service' industry that provides faster delivery of small parcels than regular mail service accelerated use of motorcycles. As the economic grows, use of large bicycles (more than 250CC displacement) for leisure purpose has also rapidly increased. Traffic crash data clearly shows the increasing trend in motorcycle crashes. The ratio of motorcycle involved crashes out of total has increased from 5.7% in 2005 to 8.3% in 2008, and similar trend can be found in fatalities ratio as well. In this study, we assess the level of risk when motorcycles operate on motorways by analyzing traffic rule violation ratio, lane change behaviour, driving speed behaviors of motorcycles in Uninterrupted Traffic Flow Facilities and using PC-CRASH simulation we also calculate car shock impulses occurred when an accident happens. Analysis result shows that the motorcycle is different from the car in terms of lane change timing and average speed, and also shows motorcycle drivers tends to conduct more improper driving behavior particularly when traffic is congested. The results from this study could be usefully applied when the law enforcement agent decides whether bicycles shall be allowed to use motorways. The result could be also utilized as fundamental information for further study of bicycles' driving behavior.

• Journal of ILASS-Korea
• /
• v.20 no.1
• /
• pp.28-34
• /
• 2015

Recently, some researchers have been carried out risk assessment of vehicles exhaust on human health. Especially, some of VOCs which is non-controlled, was classified to hazardous pollutant, such as 1,3-Butadiene and BTEX(Benzene, Toluene, Ethylbenzene and Xylene). Therefore, the profile on non-controlled pollutant may be needed in the future, because it would be critical data or information to control them. Additionally, with increasing amount of motorcycle, the source profiling is essential for estimating emission factor and amount on motorcycle exhaust. For these, in this study, imported motorcycles (8 vehicles) were selected as a test model while considering the increasing ratio on sales volume between 2013 and 2014; it was also compared with domestic motorcycles on those. The experiment was conducted by driving mode, UDC and ECE+EUDC that made from EURO III. In addition, it was performed at cold start driving mode without effect by displacement, for evaluating only correlation of BTEX with HC. In order to apply the ratio (m,p-Xylene/o-Xylene) as a marker, the ratio was compared with those of tunnel, road side and residential area. As a result, it showed best correlation ($R^2=0.98$) among those. In the future, it has to be considered as a marker for effect evaluation to atmospheric environment by exhaust emission.

• Journal of Climate Change Research
• /
• v.1 no.1
• /
• pp.51-57
• /
• 2010

Recently the number of motorcycles has increased in urban area, and it is believed that motorcycle is one of the air pollution and greenhouse gas emission sources. But the greenhouse gas emission from motorcycle has been high uncertainty due investigation of a lack of activity data and emission factors in Korea. So in this study, the greenhouse gas emission from motorcycle is estimated by considering the population of moped and VKT(vehicle kilometers travelled) of motorcycle by recent other studies. And the emissions by IPCC Tier 2 and Tier 3 methodology are calculated and compared. As the results, the nationwide $CO_2$ equivalent emissions from motorcycles by Tier 2 and Tier 3 method are calculated as 2,758 kton/yr and 2,739 kton/yr in 2008. The contribution ratio of this emission is estimated as 2.7% in on-road transport sector.

• International journal of advanced smart convergence
• /
• v.11 no.1
• /
• pp.87-93
• /
• 2022

In each country, efforts are being made to replace engine-driven cars and motorcycles using fossil fuels with electric drive. Electrically driven vehicles have the advantage of no harmful gas or environmental pollution and low noise. In the motorcycle market, China accounts for more than 95% of the world, and the electric motorcycle market is being revitalized due to the strengthening of regulations. Japan is actively preparing to include electric motorcycles in ISO 26262, forming a TF team centered on electric motorcycle producers. Therefore, it is necessary to respond to standardization targeting China and Japan in Korea. In this study, we propose a proprietary transmission model that can be applied to small electric vehicles that can be operated in hilly domestic terrain. The proposed continuously variable transmission model is a continuously variable transmission system which moves the pin between the basic disk and the rotary disk using a spline to perform shifting. The proposed continuously variable transmission model is used in the pulley configuration by connecting the linear type spline and the inclined spline with the central axis of the basic disk and the rotational disk, respectively. In addition, it can be divided into two types according to the application of the auxiliary disk, and the production drawing is completed for the practical use of the model.

• Journal of Korea Foundry Society
• /
• v.44 no.3
• /
• pp.79-85
• /
• 2024

• Journal of Korean Society of Transportation
• /
• v.35 no.1
• /
• pp.25-36
• /
• 2017

The purpose of this study is to analyze traffic accident reduction effect of the introduction of motorcycle safety inspection. To analyze the effect of motorcycle inspection, we first estimate the number of defective motorcycles, and calculate the probability of accident occurrences caused by the defect using four year traffic accident data. Finally, we estimate the number of reduced accidents due to the introduction of the inspection and the total reduced accident cost. In this study, we analyzed three scenarios. It is analyzed that when the safety inspection system is applied to all motorcycles, 642 cases of traffic accidents and 325 million won per year of traffic accident costs are reduced. It is approximately 0.1% of 2014 total traffic accident cost of 26.5725 trillion won per year. It suggests that the cost of traffic accidents and traffic accidents due to vehicle factors are reduced when the safety inspection system is introduced.