• Computers and Concrete
• /
• 제15권1호
• /
• pp.73-88
• /
• 2015

Following previous studies, the current paper describes the results of an experimental program concerning the repair of reinforced concrete columns by thixotropic pseudo plastic mortar, preformed to analyze and quantify the influence of initial construction damage to the behavior of the repaired element. Five columns (section scale 1:2) were designed according to the minimum requirements of reinforcement of ductility orientated codes' design with variables the percentages of initial construction damages. All were tested in axial compression with repeated cycles up to failure. For comparison reasons, another one of the same characteristics, yet healthy, was constructed and tested as a reference specimen. A numerical study (Finite Element Analysis) was conducted for further investigation of the behavior of the thixotropic mortar as repair material. The results indicate that: a) surpassing a specific amount of damage, columns even suitably repaired present lower strain capacity, b) finite element analysis present the same way of deboning of the repaired material taking into consideration the buckling of the reinforcement bars.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 봄 학술논문 발표대회
• /
• pp.265-266
• /
• 2023

In this study, a mortar was prepared using Rhodobacter capsulatus which is forming glycocalyx and immersed in a simulated sewage environment. As a result of the experiment, it was observed that bacteria continued to grow in the mortar immersed in the simulated sewage environment, and it was confirmed that glycocalyx was formed by bacteria on the surface of mortar specimen.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2010년도 춘계 학술대회 제22권1호
• /
• pp.27-28
• /
• 2010

본 연구는 변형경화형 시멘트 복합체를 사용한 접합부의 거동에 관한 논문으로, 주요 변수는 시멘트 복합체의 종류( 무수축 몰탈, 하이브리드 SHCC) 및 보강근의 유무이다. 실험결과, 동일한 배근상세에서 SHCC 실험체가 무수축 몰탈 실험체에 비해 전체적으로 성능이 향상된 것으로 나타났다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2000년도 봄 학술발표회 논문집
• /
• pp.78-81
• /
• 2000

The test specimen proposed in this study, named the bimaterial eccentric compression specimen, is a rectangular prism of two dissimilar materials with a notch at their interface. Normalized energy release rates and phase angles were calibrated with the finite element method. The normalized energy release rate increases with notch ratio but decreases with E2/E2, loading point, and phase angle, Bimaterial specimens consisting of mortar and ploymer as well as mortar and rock were prepared and tested to simulate fracture behavior ar the interface. Test results have confirmed that initial notch has significant effect on the apparent interfacial toughness.

• 한국세라믹학회지
• /
• 제28권11호
• /
• pp.917-925
• /
• 1991

For the present experiment five Portland cement mortars are in order: mortars with two different water/ cement ratios (W/C=0.45 and 0.50, each having no chemical additive), and those with an additive such as superplasticizer, air-entraining agent or water-repelling agent. We fix the W/C ratio of mortars having additive so that their pastes can yield the same workability as that of the cement mortar of W/C=0.50 with no additive. It is shown that the freeze-thaw resistivity depends heavily on the characteristic of wide pores. Despite a good deal of wide pores, the air-entrained specimen shows a good freeze-thaw resistivity due to appropriate air-pores. And also the specimen with water-repelling agent, which proves to cause the microstructure to become hydrophobic, make good resistance to freeze-thaw cycles in spite of its high wide-porosity. Our suggestion is that the freeze-thaw durability of Portland cement mortar/concrete can be more effectively enhanced by using air-entraining agent or water-repelling agent, and simutaneously by taking proper measures against foaming and/or the increased tendency of wide-pore building due to additive.

• 한국세라믹학회지
• /
• 제26권6호
• /
• pp.729-736
• /
• 1989

This study aims to reinforce concrete structure by impregnation of molten sulfur. The improved properties of sulfur impregnated concerete were confirmed by compressive strength test and water proof effect. Following variables were adopted to evaluate impregnation parameters ; 1) the effect of water content in concrete structure (0-8%) 2) impregnation time of molten sulfur(0-22hr) 3) impregnation temprature of molten sulfur(13$0^{\circ}C$, 14$0^{\circ}C$). In partial ponding experiments, the concrete specimen of sulfur impregnated by 2wt% yields 1.5 times higher value of compressive strength than that of control one(non-impregnated concerte). In complete ponding experiments, the mortar specimen of slufur impregnated by 12-14wt% yields 2-3 times higher value of compressive strength than that of control one (non-impregnated mortar). From the examination of X-ray diffractions, $\alpha$-sulfur was found in concrete pores. Homogeneous impregation of molten sulfur into concrete pores was also identified with poresize analysis and micrographs of SEM.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1997년도 봄 학술발표회 논문집
• /
• pp.136-145
• /
• 1997

The purpose of this study is to develope of alternative adimixture for manufacture of PHC pile(compressive strength above 800kg/$\textrm{cm}^2$). For the investigation, properties of alternative admixture admixed with II-anhydrite and pozollanic fine powders(e.q., Fly-ash, Silica-Fume), the fluidity and viscosity in the cement pastes, the fluidity and compressive strength in mortars at steam curing condition, were respectively examined. Also, properties of compressive strength of concretes with exiting admixture(specimen name SM) and alterantive admixture(specimen name AP) for PHC pile, at steam and standard curing condition, were compared each other. As a result of this experimental study, it was found that specimens admixed with II-anhydrite and pozollanic fine powders had an increase on the fluidity of cement paste and mortar, and compressive strength of mortar and concrete was as good as concrete with SM.

• 한국해양공학회지
• /
• 제14권4호
• /
• pp.23-29
• /
• 2000

When the concrete structures were being made with sand containing chloride ion it was knows that corrosion rate of reinforced steel embedded in concrete with chloride ion was higher than that of concrete with on chloride ion. In this study, the operation of Friedel salts affecting the corrosion behavior of reinforced steel embedded in cement mortar was investigated with electrochemical view. Corrosion potential of reinforced steel embedded in cement mortar with sand containing chloride ion was shifted noble direction than that of cement mortar with no chloride ion after immersed 5 month in natural sea water and also corrosion current density decreased with shifting corrosion potential to noble direction. However Friedel salts appeared from surface to 2.5cm of inside direction of mortar specimen, which is located at 11.5$\circ$(2$\theta$) in XRD analysis and the amount of Ca(OH)2 by SEM photograph in cement mortar with chloride ion was larger than that of cement mortar with mo chloride ion. Eventually it is suggested that Friedel salts was resulted from chloride ion and it acted as the corrosion inhibitor.

• 한국건설순환자원학회논문집
• /
• 제9권3호
• /
• pp.330-337
• /
• 2021

3D 프린팅의 기술발전으로 대형물 제작이 가능하게 되면서 이를 건축물에 적용하기 위한 연구가 활발하게 진행되고 있다. 건축물에서는 구조재와 비구조재로 구분되고 비구조재는 비정형 구조물 및 내·외장패널에 적용하기 유리하다. 3D 프린팅 재료는 기본적으로 시멘트 모르타르의 압출과 적층이 가능해야하므로 시멘트 혼화용 폴리머 와 경량재료의 사용이 필수적이다. 본 연구는 3D 프린팅 적용을 위해 시멘트 모르타르에 EVA 재유화형 분말수지를 사용하였다. 경량재료 혼입 폴리머 시멘트 모르타르의 난연특성을 평가하기 위해 골재로는 규사8호와 경량재료로 경량골재, 중공글라스를 사용하여 난연 및 불연성능을 평가하였다. 연구결과, 규사8호 및 경량골재를 사용한 시험체가 충분한 난연 및 불연성능을 보였다. EVA 재유화형 분말수지를 혼입할 경우 5% 이하로 적용하여 사용하는 것이 유리하다.

• 한국건설순환자원학회논문집
• /
• 제10권2호
• /
• pp.176-183
• /
• 2022

저전력 사용이 가능한 발열콘크리트를 제작하기 위하여 시멘트 모르타르에 고순도 폐CNT를 혼입하였으며, 모르타르의 전도율을 향상시키기 위하여 압축강도를 제어하는 수준에서 탄소섬유와 폐음극재를 활용하고자 하였다. 사용된 폐CNT는 다중벽 CNT의 함유량이 많은 것으로 분석되었고, 모르타르 배합시 분산성을 높이기 위하여 액상형으로 치환하여 사용하였다. 모르타르 발열시 태양광 등에 의한 소형 자가발전 설비를 활용하고 전자파를 최소화하기 위하여 DC 24 V이하의 전력 사용시의 모르타르의 온도 변화를 평가하였다. 액상형 폐CNT를 적용하고, DC 24 V의 전압을 도입한 경우 200 × 100 × 50 mm 블럭 시험편에서 60 ℃까지 상승하였으며, 액상형 폐CNT와 탄소섬유, 폐음극재를 모두 사용한 경우에는 DC 12 V에서도 55 ℃이상까지 온도가 상승하여 현장 적용성이 충분한 것으로 판단되었다. 특히 발열에너지 변화량에 있어서도 다른 변수들과 비교하여 효과적인 것으로 나타났다.