• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2014.11a
• /
• pp.174-175
• /
• 2014

We fabricated a Ni/C composite thick film on ${\alpha}-Al_2O_3$ substrate. A number of precipitations were observed on the film surface. Structural characterization was performed on the observed precipitations using transmission electron microscopy (TEM) with help of the elemental mapping, electron diffraction (ED) and ED simulation. The structural characterization revealed that the precipitation is ${\theta}-Al_2O_3$ having the space group of C2/m (Monoclinic).

• Journal of the Korean Ceramic Society
• /
• v.26 no.6
• /
• pp.789-794
• /
• 1989

The high-temperature strength of Ce-TZP was measured at 200, 650 and 100$0^{\circ}C$ by 4-point bending test. And its fracture behavior was observed by SEM. Below $650^{\circ}C$ of the temperature, where monoclinic fraction was almost zero, the decreasing rate of bending strength was relatively slow, but above this temperature, high temperature strength was largely decreased as a result of the decrease of stress-induced transformation of zirconia. The observation of fracture surface bended at 100$0^{\circ}C$ indicated that the fracture mode changed from intergranular-into transgranular-form with regardless of ceria contents.

• Journal of the Korean Ceramic Society
• /
• v.36 no.11
• /
• pp.1198-1204
• /
• 1999

The effect of sintering atmosphere on the grain sizes and phase distributions in 3Y-ZrO2 and 8Y-ZrO2 was investigated O2 and N2 were used as sintering atmospheres. In the case of 3Y-ZrO2 the sintered density was higher in N2 than in O2 while in the case of 8Y-ZrO2 contrary results were obtained. The observation can be explained by the nitrogen solubility into the zirconia lattice. That is nitrogen gas can behave as a diffusive gas contrary to the behavior in other oxides depending on the amount of Y2O3. In 3Y-ZrO2 tetragonal phase was retained at room temperature irrespective of sintering atmospheres. Grain sizes of two specimens were below 2㎛ and larger in O2 thin in N2 Under a given stress the transformability of tetragonal phase into monoclinic phase was higher in O2 than N2. The results are discussed on the basis of an effect of the grain size and non-transformable ttragonal(t') phase.

• Journal of the Korean Ceramic Society
• /
• v.42 no.11 s.282
• /
• pp.718-721
• /
• 2005

The high temperature tetragonal phase of zirconia containing $1.40{\~}1.60\;mol\%$ of yttria can be fully retained at room temperature by rapid cooling. The metastable tetragonal phase transforms into the monoclinic phase athermally upon subzero cooling. The transformation exhibited an athermal burst transformation. The effects of yttria content and grain size on the athermal martensitic transformation were studied in detail. The burst temperature linearly decreased with increasing yttria content or decreasing grain size. To consider the distribution of martensite nuclei, the Weibull modulus of the athermal martensitic transformation was evaluated from the distribution of the burst transformation temperature. From the Weibull analysis, the distribution of embryos appears to be more homogeneous than that of the defects responsible for the fracture of similar material.

• Journal of the Korean Ceramic Society
• /
• v.33 no.1
• /
• pp.25-34
• /
• 1996

Yttria stabilized zirconia (YSZ) thin films were prepared by the electrochemical vapor deposition (EVD) method on the porous Al2O3 substrates which were fabricated by different substrate thickness and porosity. Film growth rates decreased with increase on the substrate thickness and porosity and obeyed a parabolic rate law. Activa-tion energy calculated from the parabolic rate onstants was 69.9 kcal/mol. With increase on the deposition time, monoclinic phase was appeared and then disappeared. YSZ penetrated deeply into substrates when the EVD temperature decreased. Electrical conductivity of the films was 0.09 S/cm at 100$0^{\circ}C$ similar to the value of YSZ single crystal.

• Journal of Applied Reliability
• /
• v.15 no.3
• /
• pp.216-221
• /
• 2015

Sintering behavior of 3%yttria-stabilized zirconia was comparatively studied using a spray-dried powder produced by a domestic and global company. Quality of the sintered block was analysed in terms of relative density, shrinkage rate, grain growth, hardness, and fracture toughness. Relative density, shrinkage rate, and hardness value of the finally sintered block was similar between domestic and global zirconia powder, respectively. But, flexural strength of the domestic powder specimen was about 70% of the sintered block produced by using a global powder. The poor sintering quality of the domestic powder was discussed in relation with compressibility of the spray-dried granule-type powder and the amount of monoclinic phase in the as-received powder.

• Korean Journal of Crystallography
• /
• v.11 no.3
• /
• pp.147-150
• /
• 2000

The complex [CuL}Cl₂·3H₂O(1)(L=2,13-bis(2-hydroxyethyl)-5,16-dimethyl-2,6,13,17-tetraazatricyclo[14,4,0/sup 1.18/,0/sup 7.12/] docosane) has been synthesized and characterized by X-ray crystallography. 1. crystallized in the monoclinic, space group C2/c, with a=21.647(6)Å, b=8.549(1)Å, c=18.132(5)Å, β=118.58(2)°, V=2946.8(12)ų, Z=4, R₁(wR₂) for 2374observed reflections of [I>2σ(I)] was 0.052(0.187). The centrosymmetric complex 1 has an axially elongated octahedral geometry with four secondary and tertially amines of the macrocycle and tow oxygen atoms of the pendant hydroxyethyl groups.

• Korean Journal of Crystallography
• /
• v.11 no.2
• /
• pp.80-83
• /
• 2000

Compound [Ni(P(OEt)3)4] (1) reacted with bis(diphenylphosphino)ethane (Ph2PCH2CH2Ph2, dppe) to give bis(bis(diphenylphosphine)ethane)nickel(0), [Ni(dppe)2] (2). Compound 2 was characterized by spectroscopy (1H-and 31P{1H}-NMR) and X-ray crystallography. Crystallographic data for 2: monoclinic space group P21/n, a=9.826(1)Å, b=21.167(2)Å, c=21.425(2)Å, β=91.957(9)°, Z=4, R(wR2)=0.0377(0.0882).

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2002.11a
• /
• pp.31-31
• /
• 2002

The hydrothermal reaction of Zn(NO₃)₂6H₂O with benzene-1,3-dicarboxylic acid (or isophthalic acid, 1,3-BDCH₂) and pyridine led to the formation of a 1-dimensional coordination polymer with the empirical formula of [Zn₄(1,3-BDC)₃(Py)₂(O/sup 2-/)] (1). On the other hand, the hydrothermal reaction of Tb(NO₃)₃5H₂O with benzene-1,3-dicarboxylic acid (or isophthalic acid, 1,3-BDCH₂) and pyridine gave a 3-D compound [Tb₃(1,3-BDC)₂(H₂O₃] (2). The structures of both compounds have been determined by X-ray diffraction. 1 crystallizes in the monoclinlc space group P2₁/n, a = 10.344(3) Å, b = 18.030(3) Å, c = 18.033(3) Å, = 90.46(2)°, V = 3363.1(13) ,ų, Z = 4. 2 crystallizes in the monoclinic space group C2/n, a = 22.253(5) Å, b = 18.672(4) Å, c = 11.5812 Å, = 101.40(2)°, V = 4717.3(21) ų, Z = 8.

• Korean Journal of Crystallography
• /
• v.10 no.2
• /
• pp.119-124
• /
• 1999

X-선 회절법을 이용하여 3,6-bis(6'-methyl-2'pyridyl)pyridazine을 리간드로 한 Zn(Ⅱ) 착물인 [3,6-bis(6'-methyl-2'pyridyl)pyridazine]ZnCl2 (C16H16N4·ZnCl2)의 결정구조를 규명하였다. 이 결정의 결정계는 Monoclinic이며 공간군은 P21/a이다. 단위포 상수는 a=15.053(7) Å, b=14.594(7) Å, c=7.628(3) Å이며, β=93.92(4)°, V=1671.9(13) Å3, T=293(2)K, Z=4, Dc=1.594 Mgm-3이다. 회절반점들의 세기는 Enraf-Nonius CAD-4 diffractometer로 얻었으며 Mo Kα선(λ=0.71073 Å)을 사용하였다. 분자구조는 직접법으로 풀었으며, Fo>4σ (Fo)인 1750개의 독립 회절 데이터에 대하여 최소승자법으로 정밀화하여 최종 신뢰도 값 R=8.31%을 얻었다.