• 설비공학논문집
• /
• 제14권7호
• /
• pp.599-606
• /
• 2002

uniform temperature. The surfaces of the block are taken at a constant higher temperature. The channel walls are assumed to be adiabatic. Results on the time-dependent temperature field are obtained and averaged over a cycle of pulsation. The effect of the important governing parameters, such as the Strouhal number on the flow and the heat transfer is investigated in detail. The results indicate that the recirculating flow behind the block are substantially affected by the pulsation frequency. These, in turn, have a strong influence on the thermal transport from the heated element to the pulsating flow. The frequency at which the enhancement is maximum is determined.

• 한국항공우주학회지
• /
• 제36권12호
• /
• pp.1171-1179
• /
• 2008

난류고리와 스플래쉬 판에 의한 난류 혼합과 난류 생성에 관한 연구를 위하여 LES 해석이 가능한 CFD 코드를 개발하였으며 이를 사용하여 LES 해석을 수행하였다. 계산 결과에 의하면 난류고리는 유동장에 매우 강한 난류를 생성하여 후류에서 난류 혼합을 촉진하는 역할을 담당하는 것으로 밝혀졌다. 한편 난류고리 후류 방향으로 스플래쉬 판을 설치하면 난류고리만을 설치한 경우와 매우 다른 형태의 난류 에너지와 엔스트로피 생성을 관찰할 수 있었다. 이 경우의 난류혼합은 판 뒤에 생성되는 매우 강하며 집중적인 난류의 생성에 의하여 이루어지며 압력강하는 초기 압력의 1% 수준으로 매우 낮았다. 또한 계산결과에 의하면 난류고리의 형상이나 돌출 길이 변화는 생성되는 난류의 특성에 매우 커다란 영향을 미치지 못하였다. 난류 혼합을 가장 효과적으로 이룰 수 있는 판의 위치에 관한 연구 는 진행하지 못하였으나 지금까지 계산결과에 의하면 스플래쉬 판이 설치되었을 때 압력 강하도 낮은 수준이며 난류 혼합이 가장 효과적임을 알 수 있었다.

• 한국연소학회지
• /
• 제14권1호
• /
• pp.31-38
• /
• 2009

The effects of acoustic excitation of coaxial air on mixing enhancement and reduction of nitrogen oxides (NOx) emission were investigated. A compression driver was attached to the coaxial air supply tube to impose excitation. Measurements of NOx emission with frequency sweeping were performed to observe the trend of NOx emission according to the fuel and air flow conditions and to inquire about the effective excitation frequency for reducing NOx. Then, Schlieren photographs were taken to visualize the flow field and to study the effect of excitation. In addition, phase-locked particle image velocimetry (PIV) was performed to acquire velocity field for each case and to investigate the effect of vortices more clearly. Direct photographs and OH chemiluminescence photographs were taken to study the variation of flame length and reaction zone. It was found that acoustic forcing frequencies close to the resonance frequencies of coaxial air supply tube could reduce NOx emission. This NOx reduction was influenced by mixing enhancement due to large-scale vortices formed by fluctuation of coaxial air jet velocity.

• 한국가시화정보학회지
• /
• 제3권2호
• /
• pp.51-56
• /
• 2005

Acoustic excitations were imposed to coaxial air jet of non-premixed jet flame with hydrogen gaseous injected axially in the center of the flow. The frequencies of excitation were three dominant resonant frequencies at 1L, 2L, 3L. modes including specially 514 Hz (2L-mode) which was estimated theoretically as longitudinal mode of combustor characteristics. The mixing enhancement by acoustic forcing has been investigated quantitatively using PLIF and PIV. The effect of acoustic excitation on combustion process was significant to enhance mixing rate that coincides with specific resonant frequencies. And the behavior of vortex-interaction on flame structure was a good evidence to investigate the phenomenon of shear/mixing layer of fuel-air jet structure. The results obtained in this study concludes that generated streamwise vortex by acoustic excitation has a potential to enhance the mixing rate and abating NOx emissions.

• 한국군사과학기술학회지
• /
• 제13권6호
• /
• pp.1034-1042
• /
• 2010

This study investigates effects of three different parameterizations of vertical mixing scheme on upper ocean simulation of the East Sea, focusing on the seasonal variations of the sea surface temperature(SST) and the mixed layer depth(MLD) using an ocean general circulation model(GFDL MOM1.1). The considered vertical mixing schemes are the Laplacian scheme(L scheme) that use a constant eddy coefficient, the Mellor-Yamada scheme(MY scheme), and a new scheme(Noh scheme). The Noh scheme, a second-order turbulence closure, was developed considering recent observational evidences such as the enhancement of turbulent kinetic energy near the sea surface. During summer L scheme underestimates the SST, while MY scheme overestimates the SST, compared to climatological SST. Noh scheme produces the SST in better agreement with climatological one. During winter all schemes overestimate the SST up to $4^{\circ}C$ compared to climatological SST. Vertical profiles of the basin-mean temperature show that L scheme produces higher temperature below the thermocline than those of other schemes. The winter MLD simulated from L scheme is rather large compared to that from other schemes, but the differences in MLD during summer are not significant.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2012년도 제38회 춘계학술대회논문집
• /
• pp.378-385
• /
• 2012

벤트 혼합기는 혼합기 후류에 존재하는 재순환 영역으로 공기를 유입시켜 연료-공기 혼합을 증대시키는 혼합기이다. Stereoscopic PIV기법을 통해 얻은 3차원 속도, 와류, 난류운동에너지를 토대로 계단형 혼합기를 기본 모델로 하여 벤트 혼합기의 성능을 분석하였다. 벤트 혼합기는 두터운 전단층으로 인해 높은 침투거리를 보였으며, 난류운동에너지는 주로 주유동과 제트유동의 경계면을 따라 분포하였다. 이 난류 영역은 혼합영역 내에서 활발히 물질전달을 일으키며, 혼합 증대를 가져온다.

• 한국태양에너지학회 논문집
• /
• 제39권1호
• /
• pp.33-40
• /
• 2019

Al-doped ZnO (AZO) thin films were synthesized on Si(100) wafers via plasma enhanced metal organic chemical vapor deposition (PE-MOCVD) method using diethyl zinc (DEZ) and N-methylpyrrolidine alane (MPA) as precursors. Effects of Al/Zn mixing ratio, plasma power on the surface morphology, crystal structure, and electrical property were investigated with SEM, XRD and 4-point probe measurement respectively. Growth rate of the film decreased slightly with increasing the Al/Zn mixing ratio, however electrical property was enhanced and resistivity of the film decreased greatly about 2 orders from $9.5{\times}10^{-1}$ to $8.0{\times}10^{-3}{\Omega}cm$ when the Al/Zn mixing ratio varied from 0 to 9 mol%. XRD analysis showed that the grain size increased with increasing the Al/Zn mixing ratio. Growth rate and electrical property were enhanced in a mild plasma condition. Resistivity of AZO film decreased down to $7.0{\times}10^{-4}{\Omega}cm$ at an indirect plasma of 100 W condition which was enough value to use for the transparent conducting oxide (TCO) material.

• Journal of Microbiology and Biotechnology
• /
• 제21권8호
• /
• pp.802-807
• /
• 2011

Cationic liposomes have been actively used as gene delivery vehicle because of their minimal toxicity, but their relatively low efficiency of gene delivery is the major disadvantage of these vectors. Recently, cysteine residue incorporation to HIV-1 Tat peptide increased liposomemediated transfection compared with unmodified Tat peptide. Therefore, we designed a novel modified Tat peptide having a homodimeric (Tat-CTHD, Tat-NTHD) and closed structure (cyclic Tat) simply by using the disulfide bond between cysteines to develop a more efficient and safe nonviral gene delivery system. The mixing of Tat-CTHD and Tat-NTHD with DNA before mixing with lipofectamine increased the transfection efficiency compared with unmodified Tat peptide and lipofectamine only in MCF-7 breast cancer cells and rat vascular smooth muscle cells. However, cyclic Tat did not show any improvement in the transfection efficiency. In the gel retardation assay, Tat-CTHD and Tat-NTHD showed more strong binding with DNA than unmodified Tat and cyclic Tat peptide. This enhancement was only shown when Tat-CTHD and Tat-NTHD were mixed with DNA before mixing with lipofectamine. The effects of Tat- CTHD and Tat-NTHD were also valid in the experiment using DOTAP and DMRIE instead of lipofectamine. We could not find any significant cytotoxicity in the working concentration and more usage of these peptides. In conclusion, we have designed a novel transfection-enhancing peptide by easy homodimerization of Tat peptide, and the simple mix of these novel peptides with DNA increased the gene transfer of cationic lipids more efficiently with no additional cytotoxicity.

• 한국항공우주학회지
• /
• 제33권1호
• /
• pp.48-53
• /
• 2005

본 연구의 목적은 기계적인 전단층 자극방법을 이용 스월제트 혼합향상의 가능성을 고찰함에 있다. 이를 위해 기계적 자극장치가 설계, 제작되었다. 주요 구성품으로는 두개의 아음속 노즐, 스월 발생기, 그리고 유동 자극기 등이다. 실험은 다음과 같은 다양한 헬리컬 모드들에서 수행되었다; m=+0, m=$\pm$1, m=$\pm$2, m=$\pm$3, m=$\pm$4. 열선유속계를 이용한 plane 파동과 헬리컬 파동 자극에 따른 제트속도 측정이 이루어 졌다. 다양한 헬리컬 모드에서의 결과 값들이 기준 값(plane-wave)과 비교되었다. 획득된 결과는 3-D mesh plot 과 2-D contour plot으로 표현되었다. 이로써 새로 고안된 장치는 헬리컬 불안정파 자극에 대한 효과를 입증하였고 또한 결과적으로 스월제트의 혼합을 증진시켰다.

• 분석과학
• /
• 제30권2호
• /
• pp.75-81
• /
• 2017

5-methylthioninhydrin (5-MTN) is an amino acid sensitive reagent used for the development of latent fingermarks deposited on porous surfaces such as paper and wood. The present study demonstrates that the 5-MTN can be used as a latent footwear impression enhancement reagent, by reacting with trace multivalent metal ions, which are the main components of the latent footwear impression. 5-MTN and L-alanine complex (MTN-ALA) used for the latent footwear impression development was prepared, by mixing $4.5{\times}10^{-3}M$ 5-MTN (in methanol) and $4.5{\times}10^{-3}M$ L-alanine (in methanol) in 1:1 ratio, and keeping undisturbed at room temperature for 24 h. The latent footwear impressions were deposited on white and black non-porous surfaces (glass plate, polyethylene panel, polypropylene panel, acryl panel, polyvinyl chloride (PVC) panel, poly(methyl methacrylate) (PMMA) panel, acrylonitrile-butadiene-styrene (ABS) panel, tile), and a semi-porous surfaces (painted wood). The latent footwear impressions on these surfaces were treated with MTN-ALA complex by spraying. The fluorescence of footwear impressions (occurred due to the reaction between MTN-ALA and metal complexes) was observed under a 505 nm forensic light source and an orange barrier filter. The enhancement of latent footwear impression was achieved from black surfaces without any blurring. However, the fluorescence (enhancement) of footwear impression was not observed on the white PVC, PMMA, and ABS surfaces, because the incident light interfered and reflected on the surface. The sensitivity of MTN-ALA was superior to 2,2'-dipyridil, which is a representative non-fluorescing footwear impression enhancement reagent, and similar to 8-hydroxyquinoline, which is a representative fluorescing footwear impression enhancement reagent.