• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.38 no.1
• /
• pp.43-48
• /
• 2020

Open pit mines for limestone mining require rapid development of technologies and efforts to prevent safety accidents due to rapid deterioration of the slope due to deforestation and rapid changes in the topography. Accurate three-dimensional spatial information on the terrain should be the basis for reducing environmental degradation and safe development of open pit mines. Therefore, this study constructed spatial information about open pit mine using UAV(Unmanned Aerial Vehicle) and analyzed its utility. images and 3D laser scan data were acquired using UAV, and digital surface model, digital elevation model and ortho image were generated through data processing. DSM(Digital Surface Model) and ortho image were constructed using image obtained from UAV. Trees were removed using 3D laser scan data and numerical elevation models were produced. As a result of the accuracy analysis compared with the check points, the accuracy of the digital surface model and the digital elevation model was about 11cm and 8cm, respectively. The use of three-dimensional geospatial information in the mineral resource development field will greatly contribute to effective mine management and prevention of safety accidents.

• The Korean Journal of Food And Nutrition
• /
• v.29 no.2
• /
• pp.283-289
• /
• 2016

The nutritional compositions and physicochemical properties of two aronia varieties (Viking and Nero) cultivated in Chungbuk were investigated. The proximate compositions of Nero and Viking powder were:13% moisture, 0.58% and 0.6% ash, 0.73% and 0.33% crude lipid, 5.47% and 6.51% crude protein, 15.65% and 16.15% crude dietary fiber, and 64.36 and 64.43% crude carbohydrate, respectively. The proximate contents of the aronia samples were not significantly different. Among the physicochemical properties, there was also no significant change in total anthocyanin and antioxidant activity. However, Viking had higher total polyphenol contents and ${\alpha}$-glucosidase inhibition activity than Nero. The mineral contents of Al, Fe, Mn, Mg, Ca, Na, K, Cu and Zn in the two aronias were determined. Cu and Zn were not detected in both varieties. With regard to Al, Na and K, Nero was higher than Viking, while Ca was higher in Viking than Nero. From the results, Viking could be suggested to be beneficial for food processing.

• Korean Journal of Food Science and Technology
• /
• v.29 no.5
• /
• pp.869-875
• /
• 1997

The chemical components of Korean pollens and pollen extracts were analysed to provide fundamental data for pollen processing and products development. The contents of crude protein, crude lipid, crude ash, crude fiber and carbohydrate of pollens were $14.0{\sim}22.3%,\;3.0{\sim}8.8%,\;2.2{\sim}3.3%,\;0{\sim}37.5%,\;and\;31.9{\sim}64.4%$ respectively, showing the specially high crude fiber content (37.5%) in Pine pollen. Almost all the carbohydrate, lipid, protein and ash components except fiber were extracted by water and n-hexane. Free sugars identified in water extracts $(10\;^{\circ}Bx)$ of pollens were fructose and glucose as major component and maltose as minor component. The proportions of three free sugars to total soluble solid content of Mixed, Acorn, and Pine water extracts were 73.6%, 85.4% and 47.7% respectively. Potassium and phosphorus content in pollens and pollen water extracts were high, but Ca, Na, Mg, Fe and Zn were not major mineral components. The essential amino acids such as leucine, phenylalanine, methionine, lysine, valine, isoleucine and threonine were contained richly in pollens and those were almost completely extracted by water. Vitamin $B_1$ and C were not detected, but only small amount of vitamin $B_2$ was detected in the pollens and pollen extracts tested. The essential fatty acids such as linoleic acid and linolenic acid were contained richly in pollens. The proportion of unsaturated fatty acids to total fatty acid content in Mixed, Acorn and Darae pollen except Pine was higher than 50%.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.34 no.6
• /
• pp.685-690
• /
• 2001

This study was conducted to evaluate the quality of the commercial boiled-dried anchovies processed in Japan by determining chemical components and sensory evaluation. The moisture, salinity and acid-insoluble ash contents of the imported boiled-dried anchovies ranged $22.2\sim24.7\%,\;5.7\sim6.6\%\;and\;0.42\sim0.50\%$, respectively. By sensory evaluation, the imported boiled-dried anchovy was less than $5\%$ in breakage, whitish of yellowish in color and no foul smell in odor. Judging from the above results by Korean standard, the imported boiled-dried anchovy was classified into special grade. No difference in total amino acid and a major mineral contents were found between commercial boiled-dried anchovies processed in Korea and Japan. On the other hand, the lipid oxidation of the imported boiled-dried anchovy was inferior to the domestic boiled-dried anchovy sampled immediately after processing.

• Spatial Information Research
• /
• v.7 no.2
• /
• pp.159-173
• /
• 1999

GIS has been regarded as one of important tools or methodologies for various geoscience applications. Recently, spatial data integration schemes for site-specific or field-specific thematic mapping are newly developed and utilized. However, these kinds of approaches are somewhat insufficient quantitative assessment of integrated layers towards known targets in-detailed . Moreover, GIS analysis scheme is rarely extended to scientific approaches. In this study, simple approach of Multi-Buffer Zone Analysis , related to GIS analystical aspect, is addressed and an actual application for predicting or favorable mapping of mineral occurrences, one of GIS-based geoscientific approaches, is performed, As for geo-processing in GIS itself, this scheme can be regarded as extension or adaptiation of cell-based buffering or proximity analysis to geoscientific data interpretation. This study is based on rationale that surface geological pattern around primitives such as a point, a line, or a polygon in GIS, representing significant geological features, can be efficiently utilized to delineate complex geological behaviors or events, especially handling multiple dta sets originated from multiple sources such as airborne geophysical/radiometric exploration, field survey, and even a classified image of remote sensing. Conclusively, this methodology associated wit GIS is though to be helpful to analyze the spatial pattern of multiple data, pointing given sources, and is expected to effectively utilize for exploratory analysis of cell-based resultant layer integrated with complex or different data sources.

• Journal of Life Science
• /
• v.22 no.9
• /
• pp.1207-1213
• /
• 2012

Onion peels is a natural source of high-value functional ingredients produced in the onion industry without suitable processing. The objective of this study was to evaluate characteristics of onion peel extract (OPE), including its biological activities, obtained from solvent extraction in 3 times pilot scales (Lot A, B, and C). Mineral analysis showed that K was present in the largest amount (13,767.56-15,506.78 ppm), followed by Na and Ca at 8,602.44-9,796.00 ppm and 4,255.78-4,903.33 ppm, respectively. The amounts of total phenol, total flavonoid, and quercetin in the OPE were in the ranges of 598.57~626.73, 211.73~233.64, and 93.78~107.29 mg/g, respectively. The biological activities such as antioxidant and effects of fibrinolysis increased in parallel with the concentration of OPE. The $IC_{50}$ value of DPPH radical scavenging activity was in the range of 517.58~557.32 ppm in the OPE. The $IC_{50}$ value for superoxide dismutase (SOD)-like activity was in the range of 11,900.91~12,690.35 ppm. A clear zone of OPE (20,000 ppm) in fibrinolysis test was three times higher than the plasmin as a reference. In conclusion, OPE could be used as a good source of antioxidants and fibrinolytic activities.

• Restorative Dentistry and Endodontics
• /
• v.34 no.2
• /
• pp.120-129
• /
• 2009

The purpose of this study was to investigate the pulpal response to direct pulp capping with dentin sialoprotein (DSP) -derived synthetic peptide in teeth of dogs, and to compare its efficacy to capping substances $Ca(OH)_2$ and white mineral trioxide aggregate (WMTA). A total of 72 teeth of 6 healthy male beagle dogs were used. The mechanically exposed pulps were capped with one of the following: (1) DSP-derived synthetic peptide (PEP group): (2) $Ca(OH)_2$ (CH group): (3) a mixture paste of peptide and $Ca(OH)_2$ (PEP+CH group): or (4) white MTA (WMTA group). The access cavity was restored with a reinforced glass ionomer cement. Two dogs were sacrificed at each pre-determined intervals (2 weeks, 1 month, and 3 months). After the specimens were prepared for standard histological processing, sections were stained with hematoxylin and eosin. Under a light microscope, inflammatory response and hard tissue formation were evaluated in a blind manner by 2 observers. In the PEP group, only 3 of 17 specimens showed hard tissue formation, indication that the DSP-derived synthetic peptide did not induce proper healing of the pulp. Compared with the CH group, the PEP group demonstrated an increased inflammatory response and poor hard tissue formation. The CH and WMTA groups showed similar results for direct pulp capping in mechanically exposed teeth of dogs.

• Restorative Dentistry and Endodontics
• /
• v.36 no.2
• /
• pp.98-107
• /
• 2011

Caries remains prevalent throughout modern society and is the main disease in the field of dentistry. Although studies of this disease have used diverse methodology, recently, X-ray microtomography has gained popularity as a non-destructive, 3-dimensional (3D) analytical technique, and has several advantages over the conventional methods. According to X-ray source, it is classified as monochromatic or polychromatic with the latter being more widely used due to the high cost of the monochromatic source despite some advantages. The determination of mineral density profiles based on changes in X-ray attenuation is the principle of this method and calibration and image processing procedures are needed for the better image and reproducible measurements. Using this tool, 3D reconstruction is also possible and it enables to visualize the internal structures of dental caries. With the advances in the computer technology, more diverse applications are being studied, such automated caries assessment algorithms.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.4
• /
• pp.438-445
• /
• 2017

Tanzania has abundant copper deposits, but copper-metal extraction remains low there, owing to the lack of suitable copper recovery processes and insufficient funds for developing mining technologies. Accordingly, leaching and solvent extraction methods for the extraction of copper from copper ore were studied with a particular emphasis on developing a simple processing method for small-scale copper mining. Chrysocolla ore was used as the copper-bearing mineral and sulfuric acid was used as the leaching reagent. A maximum copper recovery of 95.1% was obtained when the particles in the sample were smaller than $53{\mu}m$, the concentration of 98%(w/w) sulfuric acid in the leaching solution was 5.0 g/L and the stirring rate was between 60 and 80 rpm. The highest selectivity of $Cu^2+$ in the solvent extraction was obtained using 15% LIX-70 in kerosene. In the pH range from 0.5 to 3.0, the efficiency of $Cu^2+$ extraction increased with increasing pH. However, at pH values higher than 3.0, other metal ions were extracted into the organic phase more readily than $Cu^2+$. The highest solvent extraction rate obtained was 96.5% at pH values of 2.0 and 3.0 using 15% LIX-70.

• Geophysics and Geophysical Exploration
• /
• v.19 no.4
• /
• pp.220-227
• /
• 2016

Marine seismic data have not only primary signals from subsurface but also ghost signals reflected from the sea surface. The ghost decreases temporal resolution of seismic data because it attenuates specific frequency components. For eliminating the ghost signals effectively, the exact ghost delaytimes and reflection coefficients are required. Because of undulation of the sea surface and vertical movements of airguns and streamers, the ghost delaytime varies spatially and randomly while acquiring seismic data. The reflection coefficient is a function of frequency, incidence angle of plane-wave and the sea state. In order to estimate the proper ghost delaytimes considering these characteristics, we compared the ghost delaytimes estimated with L-1 norm, L-2 norm and kurtosis of the deghosted trace and its autocorrelation on synthetic data. L-1 norm of autocorrelation showed a minimal error and the reflection coefficient was calculated using Kirchhoff approximation equation which can handle the effect of wave height. We applied the estimated ghost delaytimes and the calculated reflection coefficients to remove the source and receiver ghost effects. By removing ghost signals, we reconstructed the frequency components attenuated near the notch frequency and produced the migrated stack section with enhanced temporal resolution.