• Journal of Trauma and Injury
• /
• v.26 no.1
• /
• pp.30-33
• /
• 2013

A 55-year-old woman was seen in the emergency department with posterior neck pain and a headache after a traffic accident. Physical examination revealed tenderness on palpation over the posterior skull and a midline spinous process of the cervical spine without neurologic deficit. A plain radiograph of the cervical spine demonstrated the absence of the lateral portion of the posterior arch of the atlas and very lucent shadowing of the anterior midline of the atlas, suggesting a fracture of the anterior arch. On three-dimensional computed tomography (CT) of the cervical spine, anterior and posterior bony defects of the atlas were noted. Well-corticated defects were noted with sclerotic change and with no evidence of soft tissue swelling adjacent to the bony discontinuities, consistent with a congenital abnormality. With conservative therapy, the patient gradually showed a lessening of the midline tenderness. Careful investigation with radiography or CT is needed for these patients to avoid confusion with a fracture, because these patients seldom need surgical treatment.

• Journal of Korean Neurosurgical Society
• /
• v.38 no.2
• /
• pp.111-115
• /
• 2005

Objective : Upper lumbar disc herniation is rare disease, compared with lower. The lamina of this high level lumbar vertebra is narrower than that of low level, and this have taken surgeon into important consideration for surgical methods because partial removal of lamina for discectomy weakens the base of the articular process and may result in fracture. The authors an accurate preoperative diagnosis that enables the surgeon to operative approach for preserving the facet joint. Methods : Thirteen patients with upper lumbar disc herniation have underone surgical procedure by midline approach for removal of ruptured disc fragment and paraspinal approach for removal of residual disc materials simultaneously without instrumentation. All patients who underwent surgery were analyzed and long-term follow-up was conducted. Results : At a mean follow-up of 24months, there were complete resolution of presenting radiating leg pain in 85% of the patients, 7.5% were left with minimal residual discomfort, and 7.5% derived little or no benefit from surgery. The follow-up radiologic findings of all patients shows that lamina and facet joint have preserved safely and no instability. Conclusion : Simultaneously, paraspinal with midline approach provides highly satisfactory operating methods by simplifying exposure and greatly limiting the risk of complications. This provides the basis for a planned surgical approach in which destruction of the facet joint can be avoided.

• The Journal of Advanced Prosthodontics
• /
• v.5 no.4
• /
• pp.409-415
• /
• 2013

PURPOSE. The midline fracture of maxillary complete dentures is a frequently encountered complication. The purpose of this study was to assess the effect of frenulum height on midline strains of maxillary complete dentures. MATERIALS AND METHODS. A removable maxillary complete denture was fabricated and duplicated seven times. Four different labial frenulum heights were tested for stresses occurring on the palatal cameo surface. The strains were measured with strain gauges placed on 5 different locations and the stresses were calculated. To mimic occlusal forces bilaterally 100 N of load was applied from the premolar and molar region. RESULTS. A statistically significant association between the height of the labial frenulum and the calculated stresses and strains was shown (P<.05) predominantly on the midline and especially on the incisive papilla. The results showed that stress on the anterior midline of the maxillary complete denture increases with a higher labial frenulum. CONCLUSION. Within the limitations of this in vitro study, it can be concluded that the stress on the anterior midline of the maxillary complete denture increases with a higher labial frenulum. Surgical or mechanical precautions should be taken to prevent short-term failure of maxillary complete dentures due to stress concentration and low cycle fatigue tendency at the labial frenulum region.

• Journal of Korean Neurosurgical Society
• /
• v.38 no.5
• /
• pp.393-395
• /
• 2005

Cerebral infarction rarely occur following head injury. The authors present the case of a 39-year-old man with complete infarction in the middle cerebral artery[MCA] and anterior cerebral artery[ACA] territories ccurred immediately after head injury. He had compound depressed fracture in right frontal bone with no neurological deficit. After the depressed bone elevation, postoperative computed tomography scan showed the right MCA and ACA territory infarction with midline shift. Cerebral angiography obtained on the day after emergent decompressive craneictomy showed the complete occlusion of the internal carotid artery[ICA] at the level of lacerum ICA segment. There was no evidence of neck vessel dissection and basal skull fracture. Cerebral infarction can occur in an ultraearly period after head injury without neck vessel dissection or basal skull fracture. We stress the need for attention to the cerebral infarction as the cause of a rare neurological deterioration of the head trauma.

• Clinics in Shoulder and Elbow
• /
• v.22 no.2
• /
• pp.113-117
• /
• 2019

Treating distal humerus fractures, especially those involving intra-articular lesions, is complex and often technically demanding. Although there still exist many controversial issues, the goal of treatment is to establish anatomical stable fixation by restoring the two columns and the articular surface. Universally, a posterior midline incision is applied, and the approach varies according to the further management of the triceps or olecranon. Evidence supports dual plate fixation as the optimal fixation method, and debates regarding appropriate plating configuration are still ongoing. As multiple clinical studies comparing results of parallel and perpendicular plate fixation have shown no actual difference, it is important to place the plates according to the fracture configuration.

• The Journal of Korean Academy of Prosthodontics
• /
• v.34 no.2
• /
• pp.363-372
• /
• 1996

A common site of fracture in maxillary complete denture is on the anteroposterior midline that coincides with the notch for relief of the labial frenum. Various approaches to reduce the incidence of this type of fracture have been suggested. The most widely used technique is the reinforcement of acrylic resin denture base with several solid metal forms. But few comparative studies on the efficacy of metal reinforcements have been reported. This study was conducted to compare reinforcing effects of commonly available metal reinforcements, which include wire, metal mesh embedded in the denture base and metal plate affixed to the impression surface of denture base by silicoating technique. This was load on the posterior. The strain gauges were oriented perpendicular to the anteroposterior midline of maxillary polished denture surface at one labial and the four palatal sites Non-renforced denture was used as control. The results were as follows : 1. In the non-reinforced denture group, only tensile strains on the palatal polished surface were observed. The tensile strains decreased in the order of incisive papilla, posterior denture border area, mid palatal area and rugae area. Compressive strain was observed on the labial polished surface. 2. As compared with the non-reinforced denture group, the metal plate or the metal mesh reinforced denture groups showed reduced palatal tensile strains,and the metal mesh reinforcement had a better reinforcing effect than the metal plate. But both reinforced denture groups showed no difference in the amount of compressive strain on the labial polished surface when compared to the non-reinforced denture group. 3. The metal wire positioned just above the labial notch decreased the compressive strain on the labial polished surface. But the presence of metal wires in the palatal polished surface caused increase in tensile strains in the area.

• Archives of Plastic Surgery
• /
• v.36 no.1
• /
• pp.61-65
• /
• 2009

Purpose: Most nasal bone fractures involve the septum; either or both of the ethmoidal perpendicular plate(EPP) and quadrangular cartilage(QC). Unlocked tension from the underlying quadrangular cartilage and poorly reducted bony septum are obstacles to the successful reduction of nasal bone. So we compared the preliminary outcome of septoplasty as a primary treatment with the untreated septum in nasal bone fractures. Methods: We performed a retrospective study of 215 patients underwent reduction of nasal fracture between January 2002 and February 2008. We graded patients into four groups according to the amount of deviation and direction of force by CT. Our indication for septoplasty and combined procedures was the deviation of EPP or QC over 50% from the midline. We interviewed part of the patients by telephone regarding the subjective esthetic and functional outcomes. Results: Forty five of 215 patients (21 percent) underwent septoplasty and combined procedures (cartilage graft, etc) after the informed consent. Patients who underwent septoplasty significantly satisfied with the outcome of esthetic appearance and nasal patency compared with patients who underwent simple closed reduction despite of having septal deviation over 50 percent from the midline. (p < 0.05) Conclusion: Septal surgery and esthetic consideration shoud be made even in simple nasal reductions. And if CT scans reveal severe deviation of septum, septoplasty should be considered as a primary treatment.

• Journal of Korean Neurosurgical Society
• /
• v.37 no.4
• /
• pp.253-257
• /
• 2005

Objective: We analyze pain relief, deformity correction and complication rate after percutaneous kyphoplasty for osteoporotic vertebral compression fractures. Methods: The authors retrospectively reviewed medical records and radiological findings of 32 patients who underwent percutaneous kyphoplasty for osteoporotic vertebral compression fractures. Results: The patients had significant pain improvement with the procedure. The visual analogue scale score reduced from 8.6 to 3.4 significantly after the procedure. The midline vertebral body height significantly increased postoperatively, but mean kyphotic angle did not. There was no serious complication except one case of epidural cement leakage without neurological impairment. Conclusion: Balloon kyphoplasty safely can reduce severe back pain and returned geriatric patients to higher activity levels. The midline vertebral height is restored significantly. However kyphotic deformity correction is not significant as contrary to what we expected from the present study before it was carried out.

• Archives of Plastic Surgery
• /
• v.32 no.6
• /
• pp.739-743
• /
• 2005

Subcondylar fractures have generally been treated by intermaxillary fixation except in cases where there is an absolute indication for open reduction. The reason behind a less aggressive surgical approach lies on the inherent difficulties in manipulating fragments in such a small area at the risk of damaging facial nerves or vessels such as the internal maxillary artery. However, long-term follow-up studies showed that conservative treatment of subcondylar fractures results in disturbances of occlusal function, deviation of the mandible, internal derangement of the temporomandibular joint, and ankylosis of the joint. We carried out open reduction of dislocated subcondylar fractures in 14 patients from 2000 to 2004 by a retromandibular approach. After the reduction of fractured bone, two H-shaped miniplates with 6 holes were fixed with screws at the anterior and posterior surfaces of the subcondyle. The retromandibular approach allowed good access and easy manipulation of the subcondyle. Immediate relief from malocclusion and correction of mandibular midline shifting were observed in all patients. Late temporomandibular dysfunction and ankylosis were not observed. Open reduction with plate osteosynthesis made it possible to avoid IMF in 7 of the 14 patients. The present study shows that open reduction through this retromandibular approach can produce good outcome in adult patients with subcondylar fracture.

• Archives of Plastic Surgery
• /
• v.37 no.2
• /
• pp.195-198
• /
• 2010

Purpose: The zygoma is a key element which composes the facial contour. Zygomatic fracture induces facial asymmetry. We use radiologic evaluation or inspections mainly for identification of symmetry after reduction depressed zygomatic fracture. But the disadvantages of such methods are time-consuming and complicated process. So we tried to develop a new testing method with a ruler and a level. Methods: In unilateral depressed zygomatic fracture patient, parallel to the patient's head to make sure lay horizontaly. Put the leg of a ruler on the malar eminence so that it is at the same distance from the facial midline. Then take the level of malar eminence as put the level above the ruler. This process was performed before and after the reduction. Results: We were able to fix with plate and screw after checking the results of reduction fast and easily. Good results were obtained at post-operative radiologic evaluation. Conclusion: We can easily get the ruler and level around life. This method is not only simple but also shorttime process compared with other method-radiologic evaluation or inspection. And the operator can explain the results to the patients easily and objectively. Authors obtained the good results with this new method, and would introduce it for another method of identifying the result of reduction in depressed zygomatic fractures.