• Journal of the Korean Society of Food Science and Nutrition
• /
• v.46 no.10
• /
• pp.1178-1185
• /
• 2017

Two types of kimchi with a different total acidity (TA, 0.75% or 1.19%) were heated at $100^{\circ}C$ for up to 60 min to develop a gratin added with heated-kimchi. Their browning index and color intensity increased with increasing heating time, which was more apparent for the kimchi with the higher TA. This was attributed to the Maillard reaction facilitated at a higher heat intensity and by the smaller fermentation products. The same tendency was also observed for the antioxidant activities determined by the total reducing capacity, metal-chelating activity, and 2,2-diphenyl-1-picrylhydrazyl (DPPH) radical scavenging activity. In particular, heating kimchi at $100^{\circ}C$ only for 10 min increased the activities significantly. Therefore, the heated-kimchi was added to gratin at 20%. With the addition, the dietary fiber, ${\gamma}-aminobutyric$ acid (GABA) and ornithine contents in the gratin were increased appreciably (P<0.01). Nevertheless, there was little change in its salinity. The antioxidant activities of the gratin were significantly (P<0.001) higher than the control gratin without kimchi, with DPPH radical scavenging activity being 3.6 times higher. The results suggest that the functionality of kimchi could be effectually added to gratin even after heat treatment.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.6
• /
• pp.803-810
• /
• 2013

The purpose of this research is to analyze the effect of shape of the inductive textile electrode on the non-contact heart activity sensing, based on the magnetic-induced conductivity principle. Four types of the inductive textile electrodes were determined according to the combinations of the two shape features. A fiber-metal hybrid-typed conductive thread was developed and applied to materialization of the textile electrodes by embroidery method. The heart activity was extracted through the textile electrode sewn on a T-shirt. The experiments were implemented to constantly measure the heart activity for 20 seconds, in each case of 5 healthy male subjects. The heart activity signals acquired in each type of the inductive textile electrode were analyzed, 1)by drawing a comparison of morphology with those of ECG signal (LeadII), and 2)by calculation of the normalized mean and standard deviation of magnitude of the heart activity signals. The analysis resulted that the relatively better quality of signals were acquired in the 'square' types in the matter of whole shape, while the better results were obtained in 'donut' types in the matter of center hole. Accordingly, the relatively best quality of signals was obtained in the case of 'Square-Donut' type of the inductive textile electrode.

• Composites Research
• /
• v.29 no.1
• /
• pp.40-44
• /
• 2016

Nuclear fuel cladding used in a nuclear power plant must possess superior oxidation resistance in the coolant atmosphere of high temperature/high pressure. However, as was the case for the critical LOCA (loss-of-coolant accident) accident that took place in the Fukushima disaster, there is a risk of hydrogen explosion when the nuclear fuel cladding and steam reacts dramatically to cause a rapid high-temperature oxidation accompanied by generation of a huge amount of hydrogen. Hence, an active search is ongoing for an alternative material to be used for manufacturing of nuclear fuel cladding. Studies are currently aimed at improving the safety of this cladding. In particular, ceramic-based nuclear fuel cladding, such as SiC, is receiving much attention due to the excellent radiation resistance, high strength, chemical durability against oxidation and corrosion, and excellent thermal conduction of ceramics. In the present study, cladding with $SiC_f/SiC$ protective films was fabricated using a process that forms a matrix phase by polymer impregnation of polycarbosilane (PCS) after filament-winding the SiC fiber onto an existing Zry-4 cladding tube. It is analyzed the oxidation and microstructure of the metal cladding with $SiC_f/SiC$ composite protective films using a drop tube furnace for thermal shock test.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.21 no.2
• /
• pp.201-206
• /
• 1992

Pinus pollen is used as the chief ingredient for Song-wha-dashik (Korea's traditional pattern-pressed candy). It has been the food stuff indispensable especially on the occasion of performing ancestral rites and holding a banquet since Shilla and Koryo Dynasty. In this paper, therefore, a new examination is made of the nutritive ingredients of the very Pinus pollen. Analysis has been made of the proximate composition, minerals, heavy metals, vitamins and free sugars of the Pollen of both Pinus densinora Siebol et Zuccarini and Pinus rigida Miller. In the proximate composition, Pinus rigida Miller is high except in free sugar ; crude ash (4.0%), crude protein (15.0%), crude fat (2.5%), crude fiber (17.5%). A lot of minerals have been found in both the samples. They contain Mg, Cl, Ca, Fe, Mn, Na, Zn, etc. In heavy metals, both the samples contain the same quantity of Cd(0.3 ppm) and the contents of Pb, Cu, and As are lower than the maximal limit permitted for food stuff. The contents of vitamin B$_1$, B$_2$, vitamin C are a little higher in Pinus rigida Miller : in vitamin E, on the contrary, Pinus densiflora Siebol et Zucarini (1.6 mg) doubles Pinus rigida Miller (0.8 mg). In free sugars, the results is as follows : 6.6%/6.9% in sucrose : 0.2% in fructose : 2.1% /2.9% in glucose respectively.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.17 no.2
• /
• pp.104-115
• /
• 2014

Abundance and composition of marine debris on 13 beaches of Tongyeong City, South Korea were surveyed in 2013 Autumn. The average quantity of macro debris (>25 mm) was about 30 particle/$m^2$ and that of micro debris (1 mm-25 mm) was about 26,971 particle/$m^2$. This is a very high level compared with other areas of South Korea and the other countries. Among the 7 material types of debris (styrofoam, hard plastic, fiber, metal, glass, wood and others), styrofoam composed a large portion: 75% of macro debris and 98% of micro debris. And among the 'whole' styrofoam debris items whose original volume is remained more than 50%, styrofoam buoy debris composed 93%. This result suggests that the beaches surveyed are seriously contaminated by marine debris, and most of its sources are aquaculture styrofoam buoys. Management of styrofoam buoy debris used for oyster aquaculture in Tongyeong City is important not only for Tongyeong city, but also for other areas, because Tongyeong city hosts the biggest number of oyster aquaculture areas in South Korea.

• Polymer(Korea)
• /
• v.28 no.5
• /
• pp.397-403
• /
• 2004

The sulfonated PET-g-GMA ion-exchange fine fibers were synthesized by UV radiation-induced graft copolymerization using a photoinitiator, and their chemical structure and adsorption properties were investigated. The optimum values for synthetic conditions - UV intensity, reaction time, and reaction temperature were 450 W, 60 min, and $40^{\circ}C$, respectively. Maximum values of the degree of sulfonation and ion exchange capacity were 8.12 mmol/g and 3.25 meq/g, respectively. Tensile strength of sulfonated PET-g-GMA fine ion exchange fibers was lower than that of PET trunk polymer as the grafting reaction rates increased. It was shown that as for the adsorption rate of $Ca^{2+}$ and $Mg^{2+}$ by the sulfonated PET-g-GMA fine ion exchange fibers, magnesium ion is slower than calcium ion in the solution. However, in the mixture of the calcium and magnesium ions, the adsorption rate of calcium ion was much slower than that of magnesium ion.

• Bulletin of the Korean Chemical Society
• /
• v.21 no.11
• /
• pp.1125-1132
• /
• 2000

The pH effect of the precursor solution on the preparation of $LiCoO_2$ by a solution phase reaction containing malonic acid was carried out. Layered $LiCoO_2$ powders were obtained with the precursors prepared at the different pHs (4, 7, and 9) and heat-treated at $700^{\circ}C(LiCoO_2-700)$ or $850^{\circ}C(LiCoO_2-850)$ in air. pHs of the media for precursor synthesis affects the charge/discharge and electrochemical properties of the $LiCoO_2electrodes.$ Upon irrespective of pH of the precursor media, X-ray diffraction spectra recorded for $LiCoO_2-850$ powder showed higher peak intensity ratio of I(003)/I(104) than that of $LiCoO_2-700$, since the better crystallization of the former crystallized better. However, $LiCoO_2$ synthesized at pH 4 displayed an abnormal higher intensity ratio of I(003)/I(104) than those synthesized at pH 7 and 9. The surface morphology of the $LiCoO_2-850$ powders was rougher and more irregular than that of $LiCoO_2-700$ made from the precursor synthesized at pH 7 and 9. The $LiCoO_2electrodes$ prepared with the precursors synthesized at pH 7 and 9 showed a better electrochemical and charge/discharge characteristics. From the AC impedance spectroscopic experiments for the electrode made from the precursor prepared in pH 7, the chemical diffusivity of Li ions (DLi+) in $Li0.58CoO_2determined$ was 2.7 ${\times}$10-8 $cm^2s-1$. A cell composed of the $LiCoO_2-700$ cathode prepared in pH 7 with Lithium metal anode reveals an initial discharge specific capacity of 119.8 mAhg-1 at a current density of 10.0 mAg-1 between 3.5 V and 4.3 V. The full-cell composed with $LiCoO_2-700$ cathode prepared in pH 7 and the Mesocarbon Pitch-based Carbon Fiber (MPCF) anode separated by a Cellgard 2400 membrane showed a good cycleability. In addition, it was operated over 100 charge/discharge cycles and displayed an average reversible capacity of nearly 130 mAhg-1.

• Journal of Conservation Science
• /
• v.37 no.5
• /
• pp.525-535
• /
• 2021

This study identified material properties through scientific analysis on Jikgeumdan(satin with gold threads) from Donggungbi-Wonsam and the gold threads used in the embroidery. The Donggungbi-Wonsam's base of gold threads were estimated to have used mulberry fiber's Korean paper(Hanji) because non-wood-based fibers were observed. The X-ray spectrometer showed that the Tongsuseulan of Donggungbi-Wonsam was a flat gold thread of pure gold and Jikgeumdan of flat silver thread of its Saekdong and Hansam. High sulfur levels were detected in the flat silver thread, which appeared to have formed silver sulfide by either manufacturing process using sulfur or conservation environment. he dragon insignia's embroidery is also described as two types twisted gold threads; pure gold and alloying-gold and silver. while dragon insignia's border line is decorated with a twisted gold thread of pure gold. In particular, it was investigated that adhesives such as an animal glue, a protein-based compound by gas chromatography mass spectrometry. Additionally, XRF and Raman spectroscopy analysis on the mixture substances between the metal surface and the base paper of gold threads identified talc and quartz in the gold threads and Seokganju(hematite) in the flat silver threads.

• Journal of the Korean Electrochemical Society
• /
• v.22 no.3
• /
• pp.87-103
• /
• 2019

Nonaqueous organic electrolyte solution in commercially available lithium-ion batteries, due to its flammability, corrosiveness, high volatility, and thermal instability, is demanding to be substituted by safer solid electrolyte with higher cycle stability, which will be utilized effectively in large-scale power sources such as electric vehicles and energy storage system. Of various types of solid electrolytes, composite solid electrolytes with polymer matrix and active inorganic fillers are now most promising in achieving higher ionic conductivity and excellent interface contact. In this review, some kinds and brief history of solid electrolyte are at first introduced and consequent explanations of polymer solid electrolytes and inorganic solid electrolytes (including active and inactive fillers) are comprehensively carried out. Composite solid electrolytes including these polymer and inorganic materials are also described with their electrochemical properties in terms of filler shapes, such as particle (0D), fiber (1D), plane (2D), and solid body (3D). In particular, in all-solid-state lithium batteries using lithium metal anode, the interface characteristics are discussed in terms of cathode-electrolyte interface, anode-electrolyte interface, and interparticle interface. Finally, current requisites and future perspectives for the composite solid electrolytes are suggested by help of some decent reviews recently reported.

• Composites Research
• /
• v.32 no.5
• /
• pp.284-289
• /
• 2019

In the present paper, the dynamic force-moment equilibrium equations, driving power and energy equations are analyzed to formulate the equation for fuel economy(km/liter) equivalent to the driving distance (km) divided by the fuel volume (liter) of the vehicle, a selected model of gasoline powered KIA K3 (1.6v). In addition, the effects of the dynamic parameters such as speed of vehicle (V), vehicle total weight(M), rolling resistance ($C_r$) between tires and road surface, inclined angle of road (${\theta}$), as well as the aerodynamic parameters such as drag coefficient ($C_d$) of vehicle, air density(${\rho}$), cross-sectional area (A) of vehicle, wind speed ($V_w$) have been analyzed. And the possibility of alternative materials such as lightweight metal alloys, fiber reinforced plastic composite materials to replace the conventional steel and casting iron materials and to reduce the weight of the vehicle has been investigated by Ashby's material index method. Through studies, the following results were obtained. The most influencing parameters on the fuel economy at high speed zone (100 km/h) were V, the aerodynamic parameters such as $C_d$, A, ${\rho}$, and $C_r$ and M. While at low speed zone (60 km/h), they are, in magnitude order, dynamic parameters such as V, M, $C_r$ and aerodynamic ones such as $C_d$, A, and ${\rho}$, respectively.