• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.7
• /
• pp.741-753
• /
• 2008

This paper explores the throughput performance of CSMA/CA-based DCF protocol over both ideal channels and fading channels with payload size at the MAC layer in the 802.11a wireless LAN. In the ideal channel, there are no errors and at the transmission cycle there is one and only one active station which always has a packet to send and other stations can only accept packets and provide acknowledgements. In the fading channel, bit errors appear in the channel randomly and the number of stations is assumed to be fixed. And each station always has packets for transmission. In other words, we operate in saturation conditions. Up to now conventional research work about DCF throughput analysis of IEEE 802.11 a wireless LAN has been done over the ideal channel, but this paper is done over the Rayleigh/Ricean fading channel. So, the ratio of received average energy per bit-to-noise power spectral density $E_b/N_o$ is set to 25 dB and the ratio of direct-to-diffuse signal power in each sub-channel $\xi$ is set to 6 for combined Rayleigh/Ricean fading channel. In conclusion, it is shown that the saturation throughput is always less than the maximum throughput at all the payload size and the higher the transmission rate be, the higher the decreasing rate of saturation throughput compared to the maximum throughput be.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.8
• /
• pp.1631-1636
• /
• 2015

With the advance of wireless communication technology in terrestrial area, underwater communication is also evolving very fast from a simple point-to-point transmission to an elaborate networked communications. Underwater acoustic channel has quite different features comparing with the terrestrial radio channel in terms of propagation delay, Doppler shift, multipath, and path loss. Thus, existing technologies developed for terrestrial communication might not work properly in underwater channel. Especially medium access control (MAC) protocols which highly depend on propagation phenomenon should be newly designed for underwater network. CSMA/CA has drawn lots of attention as a candidate of underwater MAC protocol, since it is able to resolve a packet collision and the hidden node problem. However, a received signal could be degraded by the interferences from the nodes locating outside the receiver's propagation radius. In this paper, we study the effects of interference on the CSMA/CA based underwater network. We derived the SNR with the interference using the sonar equation and analyzed the degradation of the RTS/CTS effects. These results are compared with the terrestrial results to understand the differences. Finally we summarized the design considerations in CSMA/CA based underwater network.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.10
• /
• pp.1873-1878
• /
• 2017

Recently, many researches have been conducted on the aviation industry to replace the wire harness cable between the avionics of the aircraft with the wireless network. In this paper, we present an Event-Based Simulator for Wireless Avionics Intra-Communications (ES-WAIC) that can verify core technologies of wireless networks and efficiently integrate different layers of the network. ES-WAIC is developed to enhance the readability between the real time control application developers of the higher layer and the network layer developers. Specifically, the practical implement relies on an event-based programming concept to increase portability and compatibility that can be applied to the realistic low-power wireless embedded networks. ES-WAIC implements the overall system layers including the wireless channel modeling of the 4.4GHz band, the physical layer, the medium access control, the network, and the application layer of wireless avionics intra-communications.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.5
• /
• pp.3-9
• /
• 2015

The wireless communication system adopts an appropriate retransmission scheme on each system protocol layer to improve reliability of data transmission. In each system protocol layer, the retransmission scheme operates in independently other layers and operates based on the parameters without reference to end-to-end performance of wireless communication system. For this reason, it is difficult to design the optimal system parameters that satisfy the QoS requirements for each service class. Thus, the performance analysis of wireless communication system is needed to design the optimal system parameters according to the end-to-end QoS requirements for each service class. In this paper, we derive the mathematical model to formulate the end-to-end performance of wireless communication system. We also evaluate the performance at the MAC and transport layers in terms of average spectral efficiency and average transmission delay. Based on the results of performance evaluations, we design the optimal system parameters according to the QoS requirements of service classes. From the results, the HARQ combined with AMC is appropriate for the delay-sensitive service and the ARQ combined with AMC is appropriate for a service that is insensitive to transmission delay. Also, the TCP can be applied for the delay-insensitive service only.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.4
• /
• pp.106-114
• /
• 2015

Despite a series of various developments in underwater acoustic sensor networks, there are still occasions of loss of connection over the network. Because sufficient amounts of drawbacks causing disconnections posed particularly in the middle of connection over the network emerge in the ocean environment, there is a need of new testing mechanism for underwater acoustic networks. In this paper, we proposed to investigate the most vital parts of the network deployment whether they function well in order, without any failure so as to identify where exactly communication process problems and failures are. We introduce step-wised out-test mechanism for UWASNS and accomplished the mechanism by implementing experiments and rigorously checked all the underwater devices utilizing out-test function. Experimental results and out-test function are evinced by implementing, in order to explain our system and conclude with possible future improvements.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.5
• /
• pp.7-15
• /
• 2007

In wireless communication networks, single-radio single-channel architecture degrades throughput and end-to-end delay due to half-duplex transmission of wireless node and route intra interference. Also, In contention-based MAC (Medium Access Control) architecture, channel contention reduces throughput and packet collision enlarges end-to-end delay. In this paper, we use multi-radio multi-channel architecture which will make wireless node to operate in full duplex mode, and exclude route intra interference. Based on this architecture, we propose a new link metric, ccf which reflects the characteristics of a contention-based wireless link, and propose a routing path metric MCCR considering channel switching delay and route intra interference. MCCR is compared with MCR by simulation, the performance of a route established by MCCR outperforms the performance of a route by MCR in terms of throughput and end-to-end delay.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.777-781
• /
• 2004

This paper presents an algorithm for multichannel slotted-ring topology medium access protocol (MAC) using in wavelength division multiplexing (WDM) networks. In multichannel ring, there are two main previously proposed architectures: Tunable Transmitter - Fixed Receiver (TTFR) and Fixed Transmitter - Tunable Receivers (FTTR). With TTFR, nodes can only receive packets on a fixed wavelength and can send packets on any wavelengths related to destination of packets. Disadvantage of this architecture is required as many wavelengths as there are nodes in the network. This is clearly a scalability limitation. In contrast, FTTR architecture has advantage that the number of nodes can be much larger than the number of wavelength. Source nodes send packet on a fixed channel (or wavelength) and destination nodes can received packets on any wavelength. If there are fewer wavelengths than there are nodes in the network, the nodes will also have to share all the wavelengths available for transmission. However the fixed wavelength approach of TTFR and FTTR bring low network utilization. Because source node with waiting data have to wait for an incoming empty slot on corresponding wavelength. Therefore this paper presents Tunable Transmitter - Tunable Receiver (TTTR) approach, in which the transmitting node can send a packet over any wavelengths and the receiving node can receive a packet from any wavelengths. Moreover, the self-similar distributed input traffic is used for evaluation of the performance of the proposed algorithm. The self-similar traffic performs better performance over long duration than short duration of the Poison distribution. In order to increase bandwidth efficiency, the Destination Stripping approach is used to mark the slot which has already reached the desired destination as an empty slot immediately at the destination node, so the slot does not need to go back to the source node to be marked as an empty slot as in the Source Stripping approach. MATLAB simulator is used to evaluate performance of FTTR, TTFR, and TTTR over 4 and 16 nodes ring network. From the simulation result, it is clear that the proposed algorithm overcomes higher network utilization and average throughput per node, and reduces the average queuing delay. With future works, mathematical analysis of those algorithms will be the main research topic.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.1
• /
• pp.12-22
• /
• 2000

This paper presents the window-based permit distribution scheme for efficient medium access control to support multiclass traffic in APON(ATM over passive optical network). The proposed MAC protocol considers the characteristics of QoS(Quality of Service) for various traffic classes. A periodic RAU(request access unit) in upstream direction, includes dedicative request fields for each traffic category within the request slot. The transmission of upstream cell is permitted by the proposed window-based spacing scheme which distributes the requested traffic into several segments in the unit of one spacing window. The delay sensitive traffic source such as CBR or VBR with the stringent requirements on CDV and delay, is allocated prior to any other class. In order to reduce the CDV, so that the permit arrival rate close to the cell arrival rate, Running-Window algorithm is applied to permit distribution processing for these classes. The ABR traffic, which has not-strict CDV or delay criteria, is allocated flexibly to the residual bandwidth in FIFO manner. UBR traffic is allocated with the lowest priority for the remaining capacity. The performance of proposed protocol is evaluated in terms of transfer delay and 1-point CDV according to various offered load. The simulation results show that our protocol has the prominent improvement on CDV and delay performance with compared to the previous protocol.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.1
• /
• pp.185-191
• /
• 2015

This paper suggest the safety class communication board in order to design the safety network of the nuclear safety class controller. The reactor protection system use the digitized networks because from analog system to digital system. The communication board shall be provided to pass the required performance and test of the safety class in the digital network used in the nuclear safety class. Communication protocol is composed of physical layer(PHY), data link layer(MAC: Medium Access Control), the application layer in the OSI 7 layer only. The data link layer data package for the cyber security has changed. CRC32 were used for data quality and the using one way communication, not requests and not responses for receiving data, does not affect the nuclear safety system. It has been designed in accordance with requirements, design, verification and procedure for the approving the nuclear safety class. For hardware verification such as electromagnetic test, aging test, inspection, burn-in test, seismic test and environmental test in was performed. FPGA firmware to verify compliance with the life-cycle of IEEE 1074 was performed by the component testing and integration testing.

• Journal of KIISE:Information Networking
• /
• v.35 no.5
• /
• pp.409-414
• /
• 2008

In mobile ad hoc networks, most of on demand routing protocols such as DSR and AODV do not deal with traffic load during the route discovery procedure. To solve the congestion and achieve load balancing, many protocols have been proposed. However, the existing load balancing schemes has only considered avoiding the congested route in the route discovery procedure or finding an alternative route path during a communication session. To mitigate this problem, we have proposed a new scheme which considers the packet bursting mechanism in congested nodes. The proposed packet bursting scheme, which is originally introduced in IEEE 802.11e QoS specification, is to transmit multiple packets right after channel acquisition. Thus, congested nodes can forward buffered packets promptly and minimize bottleneck situation. Each node begins to transmit packets in normal mode whenever its congested status is dissolved. We also propose two threshold values to define exact overloaded status adaptively; one is interface queue length and the other is buffer occupancy time. Through an experimental simulation study, we have compared and contrasted our protocol with normal on demand routing protocols and showed that the proposed scheme is more efficient and effective especially when network traffic is heavily loaded.