• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.04a
• /
• pp.103-106
• /
• 1997

The electrical properties and the sensing properties of ZnO-TiO$_2$ composites were investigated by using the complex impedance measurement and voltage-current source and measurement unit. In air, the electrical conductivity of TiO$_2$ added ZnO increase with increasing the content of TiO$_2$ and the relative dielectric constants for 3, 5 and 7mol% TiO$_2$ added ZnO are 7, 13 and 120, respectively. In 3000ppm CO gas, the relative dielectric constants for 3, 5mol% TiO$_2$ added ZnO are 25, 28, respectively.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.1
• /
• pp.53-56
• /
• 2008

The commercial parallel plate electrodes system with guard-ring electrode have been widely used for measurement of dielectric constants of solid materials. And the specification of the electrodes system is about 1 % of measurement uncertainty. This measurement uncertainty is only estimated the error come from mechanical measurements such as the area of the electrodes and the gap between the electrodes except the error come from the air gap between the electrodes and dielectric specimen. Because it is impossible to measure the air gap. This study analyze the total measurement uncertainties of the commercial dielectric constant test cell using 3 kinds of Standard Reference Materials. As a results, the total measurement uncertainty is much bigger than 1 % and the most of the uncertainty can be reduced by compensation of the error values evaluated in this study.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.10
• /
• pp.902-908
• /
• 2002

Homogeneously aligned nematic liquid crystal displays (LCDs) driven by in-plane or fringe field were known to exhibit wide viewing angle and appeared to be black in the off state. However, the existence of spacers inside the cell causes the deformation of the liquid crystal molecules. Such a deformation of the liquid crystal causes light-leakage in the dark state, which lowers contrast ratio of the display. We found that the light-leakage due to deformation of the LC director near the spacer mainly depends on the dielectric anisotropy and the ratio of elastic constants of the LC. In this paper, the mechanism on deformation of the LC near spacer is investigated by optical polarizing microscopy.

• Journal of the Korean Ceramic Society
• /
• v.29 no.3
• /
• pp.177-182
• /
• 1992

The effect of heat-treatment temperature on the microwave absorbing properties was investigated in Ni0.8Zn0.2Fe2O4 specimens. The composite specimens were prepared by modling and curing the mixture of prereacted ferrite powder and silicone rubber. The measurement of complex permeability and permittivity was made by the reflection/transmission method. The most sensitive material constants with heat-treatment temperature is the imaginary (loss) component of permeability. The higher the heat-treatment temperature, the greater the magnetic loss. The composite specimens with high magnetic loss exhibited superior microwave absorbing properties. The quantitative estimation of microwave absorbing properties were made by plotting the observed material constants on the calculated solution map of impedance-matching.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.3
• /
• pp.257-262
• /
• 2001

Single crystalline films of La doped YIG(yttrium iron garnet) were grown by the liquid phase epitaxy. The lattice constants of films obtained by DCD(double crystalline diffractometer) measurement increased with increasing La contents in films. In particular, lattice constants of films grown wiht Y/La=20 solution were nearly same as those of GGG (gadolinium gallium garnet) substrate. The saturation magnetization measured with VSM (vibrating sample magnetometer) was about 1750Gauss which is the same as that of pure YIG irrespective of La contents in films. FMR(ferromagnetic resonance) linewidth of La doped YIG was smaller than that of pure YIG. Since appropriate La doping decreases the lattice mismatch between film and substrate, the FMR linewidth was Y/La=20 in this experiment.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.05a
• /
• pp.1.1-5
• /
• 1996

Structural characteristics in Se thin film fabricated by EBE method had been studied. Se thin film was deposited with noncrystalline until substrate temperature of 100$^{\circ}C$. But Se film was grown with monoclinic at substrate temperature of over 150$^{\circ}C$. Lattice constants of it were as follow: a=12.76[${\AA}$], b=9.15[${\AA}$], c=10.4[${\AA}$]. Finally, after heat-treatment at 150$^{\circ}C$ for 15 min with substrate temperature of 100$^{\circ}C$, noncrystalline Se was proved to be hexagonal. Lattice constants of it were as follow: a=4.27[${\AA}$], c=4.83[${\AA}$].

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1355-1357
• /
• 1997

In this study, the ferrite/rubber composite microwave absorbers mixed Ni-Zn ferrite and $Ni_2Y$ ferroxplana were prepared in order to control matching condion. The variation of the material constants($\dot{\varepsilon}$, $\dot{\mu}$) and microwave absorbing characteristics were investigated with various ferrite mixing ratio. The material constants of ferrite/rubber composite microwave absorber could be controlled by variation ferrite mixing radio. The matching frequency and thickness could be controlled with various ferrite mixing ratio.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.3
• /
• pp.238-246
• /
• 2003

We have performed the simulation of ferromagnetic resonance spectra on the exchange coupled bilayer thin films at perpendicular configuration. Variables considered in spectrum calculation were the interfacial exchange constants per unit area, the layer thickness, and the surface anisotropy constants. In case of antiferromagnetic coupling, variation of exchange constant gave a great effect to the absorption spectra of the low and the high magnetization layer. Variation of thickness in low magnetization layer did nt nearly influenced the resonated field of the high magnetization layer. Also, the increase of negative surface anisotropy increased the resonance field of the low and the high magnetization layer.

• Transactions on Electrical and Electronic Materials
• /
• v.10 no.6
• /
• pp.196-199
• /
• 2009

The practical applications of piezoelectric ceramics are applied not only under low electric field environment. Therefore, an examination for characteristics of PZT ceramics under the high electric field condition can contribute to reducing the susceptibility of multifarious applications and to facilitating production of control circuits. These contributions can lead to the expansion of industrial applications. In this research, we fabricated disk-type PZT ceramic samples using conventional methods, measured the resonance characteristics of these samples under from low to high voltage conditions and calculated the PZT constants.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.10 no.1
• /
• pp.103-118
• /
• 2018

When collision accident between ships or between ship and offshore platform occurs, a common phenomenon that occurs in structures is the plastic deformation accompanied by a large strain such as fracture. In this study, for the rational design against accidental limit state, the plastic material constants of steel plate which is heated by line heating and steel plate formed by cold bending procedure have been defined through the numerical simulation for the high speed tension test. The usefulness of the material constants included in Cowper-Symonds model and Johnson-Cook model and the assumption that strain rate can be neglected when strain rate is less than the intermediate speed are verified through free drop test as well as comparing with numerical results in several references. This paper ends with describing the future study.