• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.4
• /
• pp.374-383
• /
• 2013

This paper presents a design for improvement of isolation characteristics by the inserted stub structure on ground plane of a handy terminal which is composed of a main antenna and a sub antenna covered LTE bandwidth. In order to compensate for a resonance length of proposed antenna and to realize a high isolation characteristic, a pair of stub was inserted and located on ground plane that currents from two antennas were converged. A simulated isolation characteristic of antenna without stub at the LTE class 13 band was about -5 dB, but its characteristics of proposed antenna with two stubs at uplink(777~787 MHz) and downlink(746~756 MHz) of the LTE class 13 band were about -12 dB and -15 dB, respectively. An average gain of a fabricated antenna with two stubs was observed about -2 dBi above and it showed good results with comparison of business condition that the average gain of commercial handy terminal has to appear -4 dBi above. The measured S-parameter characteristics and radiation patterns showed a reasonable agreement with the simulation results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.5
• /
• pp.493-500
• /
• 2008

This paper describes a design of internal frequency modulation(FM) radio antenna fur mobile terminal. In order to control of impedance at an operating frequency of the designed antenna, the lumped constant elements of R and L chip components are used. Patch and stubs located at antenna backside are added to control an exact resonance frequency and miniaturization. A fabricated antenna sire, the measured return loss, impedance, bandwidth, and gain are $40{\times}70{\times}1$ mm, -23 dB at 99 MHz, $55-j7{\Omega}$, 22 MHz($88{\sim}110$ MHz) below -10 dB, and -15 dBi, respectively. These measured results show a good agreement with simulated results. Especially, the measured gain of fabricated antenna is similar with value of a conventional ear-phone antenna in the designed frequency band. The measured radiation pattern agrees well with the calculated omni-directional pattern.

• Journal of Navigation and Port Research
• /
• v.31 no.1 s.117
• /
• pp.89-97
• /
• 2007

This paper presented a approach to the measurement of efficiency in container terminals in Korea. To perform this objective, it used Data envelopment analysis(DEA) which has particular applicability in the service sector. DEA as mathematical programming techniques enables relative efficiency ratings to be derived within a set of analysed units. So this paper investigated the efficiency employing DEA-CCR and DEA-BCC Model on data for 15 container terminals from 1998 through 2005. Results of this paper, suggested to some plan for operation strategy in Container terminals.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2005.10a
• /
• pp.303-309
• /
• 2005

This paper will suggest how can we guarantee terminal QoS like ship waiting time ratio and ship residing time applying RFID(Radio Frequence Identification) technology, raising up rapidly as a fundamental solution of new growing industry, to port information system. Also, lead time of whole port logistics can be decreased for reduction of loading & discharging time resulted from productivity improvement of Twinlift G/C(Gantry Crane) and Y/T(Yard Tract) etc as applying RFID technology to terminal operation. The purpose of this paper is suggesting of new business model of u-Port that port QoS can be guaranteed from mutual agreement of each terminals RFID technology applied and focusing on the implementation plan.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.1
• /
• pp.27-33
• /
• 2019

Several studies have been completed on the topic of container terminals in Northern Vietnam. Few of them, however, deal with competition in terms of costs related to vessel waiting time or cargo handling. This paper estimates the average waiting cost per TEU for all the container terminals in Northern Vietnam. After average waiting time was first estimated by applying queuing theory, uncertainty theory was applied to estimated vessel daily cost. A simulation was performed to create a series of data representing waiting cost per TEU in relation to the rate of volume handled/capacity of each terminal. Non-linear regression based on this series was used to present a function for the relationship between the average waiting cost of each terminal and the rate of volume handled /capacity.

• Journal of Navigation and Port Research
• /
• v.48 no.3
• /
• pp.171-180
• /
• 2024

Recently, there has been a global emphasis on decarbonization in order to address climate change and achieve carbon neutrality by 2050. In line with government regulations, domestic port authorities have also started participating in this global agenda. Since 2010, when decarbonization became an important task in ports, there have been studies analyzing the environmental efficiency of container terminals, taking into account undesirable outputs. However, most of these previous studies only measured carbon dioxide emissions based on Tier 1, whereas this study is the first to analyze the environmental efficiency of South Korea's container terminals based on Tier 3, as presented in the IPCC guidelines. The study considered 17 container terminal operators in South Korea as decision-making units and used the DEA-SBM Model. Subsequently, an Undesirable Outputs Model was conducted to calculate the environmental efficiency.

• Journal of Satellite, Information and Communications
• /
• v.8 no.4
• /
• pp.75-80
• /
• 2013

In this paper, the Ka-band maritime satellite communication systems for mobile terminals are proposed. The design includes the link budget analysis, determination of modulation and coding schemes and the overall structure of a transmitter. To avoid the harmful effects on the existing DVB-S2 services, the proposed maritime satellite system using the same spectrum with DVB-S2 at the same time employs the very wideband spreading transmission. Additionally, omni-directional low-gain antennas should be equipped in a mobile terminal to reduce the system cost. These two considerations limit the maximum transmission rate of the proposed system. Due to the limitations, the proposed system includes 36 dB or 39 dB spreading gain depending on the modulation scheme and a link-adaptive repetition method depending on the level of rain attenuation. To support short packets with minimal performance loss, the turbo code used in 3GPP instead of LDPC(low density parity check code) is adopted. By combining them, the overall structure of low-rate maritime satellite communication system is designed.

• Journal of Navigation and Port Research
• /
• v.28 no.5
• /
• pp.385-393
• /
• 2004

This paper describes not only the complexities of LNG business including shipping sector but also its own current environmental changes. Furthermore, system dynamics (VENSIM analysis) as a methodology is introduced to analyze the potential LNG shipping market in the future. As a result of the VENSIM analysis, potentiality of the spot LNG shipping market is systematically established in connection with embodiment of the spot LNG market. This paper suggests three methods, which are centered on newbuildings of ships, for the shippers to prepare for the spot LNG shipping market on the basis that maritime economics can make a direct contribution to the shippers' business decision-making.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2011.06a
• /
• pp.408-409
• /
• 2011

Transshipment cargo volume in 2010 compared to 1st quarter 2011 increased 8.43 percent of busan port for transshipment of cargo. thus transshipment of cargo is growing among, south east container terminals and Horando area of new port is planing to develop using small dock for the operations in order to enable. therefore, this study is to deduce implications for operating activation about 6 berths of feeder port in pusan new port that is planing to develop with dock that could be docked very large container ships and feeder dock that could be handled transshipment of cargo.

• Proceedings of the KIEE Conference
• /
• 1998.07g
• /
• pp.2373-2376
• /
• 1998

This paper describes the development of the SCADA(Supervisory Control and Data Acquisition) system which can be controlled via the Internet. In this paper, the SCADA system is composed of a number of microprocessor-based RTU(Remote Terminal Unit)s, a MMI(Man Machine Interface) host, a SCADA server, and SCADA clients. There are two protocols used in the system. Each RTU and the MMI host are connected by a RS-485 line and CSMA/CD(Carrier Sense Multiple Access / Collision Detection) protocol is used to communicate with each other. TCP/IP(Transmission Control Protocol/Internet Protocol) is used among the MMI host, the SCADA server, and SCADA clients. The equipments installed in the field are controlled by a number of RTUs. The function of the MMI host is to acquire real-time data from RTUs and control them. The SCADA server supports data transfer between the networked MMI host and the SCADA client on the web-server through TCP/lP. Data transfer is possible regardless of the type of network only if there are TCP/lP Winsock-compatible stack driver. The SCADA client is implemented as the shape of web-page by means of JAVA language. Therefore, it runs on a web-browser such as Netscape and Explorer, and allows a number of users to access this SCADA system.