• Economic and Environmental Geology
• /
• v.35 no.6
• /
• pp.545-552
• /
• 2002

In order to investigate the influence of nuclear power plant operation on its nearby environment, soil, stream and marine sediment samples were collected in the vicinity of the Youngkwang Nuclear Power Plant in Korea, and analyzed for artificial and natural radionuclide radioactivity. From the analytical result, Cs-137 was detected in most soil samples. but it may have been derived fiom past nuclear weapon tests because Cs-134 having short half-live was not detected. The radioactivities of Cs-137 in the sediment samples were also detected which are within the normal range in the sediments based upon the published literature between 1997 and 1999. For the quality control of radioactivity analysis of environmental samples, sets of marine sediments in the Gamami area were analyzed using two HPGe Gamma-ray Spectroscopes (30% and 45%) according to the geostatistical sampling strategy, and Cs-137 and K-40 results were interpreted by analysis of variance (ANOVA). In the two-way ANOVA, variances derived from the geochemical variation were significant, but errors from sampling and analytical procedures are negligible. In conclusion. all the radioanalytical procedures of this study including sampling are validated to be acceptable.

• Korean Journal of Environmental Biology
• /
• v.24 no.4
• /
• pp.307-313
• /
• 2006

Seasonal variation of marine bacterial community was analyzed in the surface sea water collected from one of the stations locating at Tongyeoung coastal area, Korea. The results obtained by the culture method through identification with the VITEK Microbe ID system after pure culture in the selective medium were compared with those obtained by the DGGE based 16S rRNA PCR method. The composition of the marine bacterial community in the sea water samples harvested in September, 2004, November, 2004, January, 2005, May, 2005 and August, 2005 determined by the culture method showed 5, 5, 4, 6, and 10 strains respectively. Pseudomonas fluorescens and Acinetobacter lwoffii were detected in all seasons. The other strains were identified to be Pseudomonas stutzeri, Sphingomonas paucimobilis, Burkholderia mallei and Chryseobacterium indologenes. In contrast, the 16S rRNA PCR-DGGE method detected 10, 11, 6, 9 and 13 populations respectively in the same sea water samples and the strains were identified to be Acinetobacter lwoffii, Burkholderia mallei, Pseudomonas fluoresence, Actinobacillus ureae, Burkholderia sp., Pseudomonas stutzeri, Roseobacter sp., Vibrio parahaemolyticue, Sphingomonas paucimobilis and Rugeria algocolus. This results indicated that the DGGE based 16S rRNA PCR method was more efficient than the culture method for the grasp of the characteristics of the marine bacterial community.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.12
• /
• pp.1076-1086
• /
• 2010

Soil remediation technologies were experimented to evaluate whether the technologies could be used to apply remediation of contaminated marine sediment. In this research, marine sediments were sampled at "Ulsan" and "Jinhae" where remediation projects are considered, and then the possibility of heavy metal removal was evaluated throughout the technologies. Heavy metal concentration of silt and clay fraction was higher than that of sand fraction at "Ulsan". Heavy metal removal of the silt and clay fraction was arsenic (As) 81.5%, mercury (Hg) 93.8% by particle separation, cadmium (Cd) 72.2%, mercury (Hg) 93.8% by soil washing technology, cadmium (Cd) 70.8%, lead (Pb) 65.6% by another soil washing technology. Based on experimental results, tested particle separation and soil washing technologies could be used to remove heavy metals of sand fraction and silt and clay fraction. Heavy metal removal by soil washing technology which was composed of separation, washing and physical or chemical reaction by additives such as acid, organic solvents was more effective comparing to that of particle separation. Since heavy metal concentration of all treated samples was suitable for national soil standards, all the tested technologies were could be used not only to remove heavy metals of marine contaminated sediment but also to reuse treated samples in land.

• Journal of Food Hygiene and Safety
• /
• v.35 no.5
• /
• pp.411-418
• /
• 2020

In this study, we reviewed a group of marine biotoxins, namely yessotoxins (YTXs), focusing on their causative organisms, contaminated shellfish, domestic and foreign management status, and analytical methods. Although YTXs have not yet been reported in any cases of seafood contamination in South Korea, it is necessary to implement preemptive measures through continuous monitoring because there is a potential risk, due to the introduction of toxic microalgae associated with climate changes and the introduction of contaminated seafood from various countries. YTXs are produced by dinoflagellates, such as Protecratium reticulatum, Gonyaulax polygramma, Gonyaulax spinifera, and Lingulodinium polyedrum, all of which are species found along Korea's coastal areas. Analysis of YTXs in shellfish samples is mainly performed by use of LC-MS/MS after methanol extraction and SPE cartridge clean-up (HLB or strata-X). In the case of lipophilic marine biotoxins, including YTXs, pectenotoxins, and azaspiracids, the extraction and purification procedures are similar. Thus, it seems that the simultaneous analysis of several lipophilic marine biotoxins in shellfish samples is possible, and optimization is necessary. In addition, continuous monitoring studies on causative marine microalgae for YTXs in Korean coastal waters and contaminations in domestic and imported seafood are needed.

• Journal of the Korean Geotechnical Society
• /
• v.25 no.6
• /
• pp.17-29
• /
• 2009

There has been an increase in the investigation of deep sea sediments with a consequent increase in the amount of energy required to undertake these investigations. The geotechnical characteristics of Ulleung Basin sediment are explored by using depressurized specimens following methane production tests carried out on pressured core samples obtained at 2,100 m water depth and 110 m below sea floor. Geotechnical index tests, X-ray diffraction, and scanning electron microscope are conducted to identify the geotechnical index parameters, clay mineralogy, chemical composition, and microstructure of the sediments. Compressibility, and elastic and electromagnetic wave parameters are investigated for two samples by using a multi sensing instrumented oedometer cell. The strength chatracteristics are obtained by the direct shear tests. The dominant clay minerals are mostly kaolinite, illite, chlorite, and calcite. The SEM shows a well-developed flocculated structure of the microfossil. Void ratio, electrical resistivity, real permittivity, conductivity, and shear wave velocity show bi-linear behavior with the effective vertical stress: as the vertical effective stress increases. The friction angle obtained by the direct shear test is about $21^{\circ}$, which is similar to the value observed in the Ulleung Basin sediments. This study shows that the understanding of the behavior acting on the diatomaceous marine sediment is important because it often maintains the useful energy resources such as gas hydrate and so will be the new engineering field in the next generation.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.12 no.3
• /
• pp.244-250
• /
• 2007

Membrane inlet mass spectrometer (MIMS) has been used to accurately quantify dissolved gases in liquid samples. In this study, the MIMS system was applied to measure dissolved methane in seawater and sediment porewater. To evaluate the accuracy of the measurement, liquid samples saturated with different methane partial pressure were prepared and the methane concentrations were quantified with the MIMS system. The measured values correspond well with the expected values calculated from solubility constants. The standard error of the measurements were $0.13{\sim}0.9%$ of the mean values. The distribution of dissolved methane concentration in seawater of the South Sea of Korea revealed that the physical parameters primarily control the methane concentration in sea water. The MIMS system was effective to resolve the small dissolved methane difference among water masses. The probe type inlet in MIMS system was proven to be effective to measure porewater methane concentration.

• Journal of the Korean institute of surface engineering
• /
• v.50 no.5
• /
• pp.373-379
• /
• 2017

Dry processes like evaporation and sputtering in vacuum chamber are difficult to make a uniform, large area and high quality film on thin PET substrate because of PET degradation and bad adhesion. On the other hand, wet processes like electro or electroless plating have complex processes and require high environmental cost. In this study, we successfully prepared $2{\mu}m$ Zn/Cu/Ni multilayers coated on $12{\mu}m$ polyethylene terephthalate (PET) substrate by using dry-wet mixing processes. Their surface electric resistances were evaluated around $0.2{\Omega}$ by using 4 probe measurements. Furthermore, their corrosion resistance also evaluated by natural potential test and compared with other wet, dry and mixing process samples.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.37 no.2
• /
• pp.98-104
• /
• 2004

Early development and metamorphosis of the ascidian (Halocynthia hilgendorfi ritteri) were investigated from fertilized egg. The samples were collected in the coastal waters of Yongdam, northwest of Jeju Island in November 2002. H. hilgendorfi ritteri was solitary ascidian and produced spheral eggs with egg size ranging from $0.33\pm0.01\;mm.$ On the outer surface of the vitelline coat are attached many follicle cells. At $21.0\pm0.5^{\circ}C$ of water temperature, first cleavage took place in about 1.5 hrs after fertilization, and gastrulation followed in about 12.5 hrs. The formation of tailbud embryos and free swimming larvae were observed 13.3 hrs and 20.5 hrs after fertilization, respectively. The size of newly hatched tadpole larva was 1.30-1.45 mm, the larva swam for 2 hrs to 14 hrs. At 4 hrs after hatching, the palpi were lost and tail absorption began with an abrupt rupture of the anterior end of the notochord. At 17-18 hrs after hatching, tail completely absorption and remained trunk. The coniform adhesive papilla began protrusion at 30 hrs after hatching. The oral and atrial siphon formed at 6-7 days after settlement. At 17-18 days after settlement, metamorphosed the larvae developed into protoascidian of which the external morphology was similar to their adult.

• Advances in concrete construction
• /
• v.6 no.1
• /
• pp.47-68
• /
• 2018

This article reports the utilization of fly ash (FA) waste product from industry and silpozz which is an agro-waste from agriculture as an environmental friendly material in construction industry. The evaluation of strength and durability study was observed using FA and silpozz as a partial replacement of Ordinary Portland Cement (OPC). The studied parameters are compressive strength, flexural strength, split tensile strength and bond strength as well as the durability study involves the acid soluble chloride (ASC), water soluble chloride (WSC), water absorption and sorptivity. Scanning electron microscopy (SEM) and XRD of selected samples are also done. It reveals from the test results that the deterioration factor (DF) in compressive strength is 4% at 365 days. The DF of split tensile strength and flexural strength is 0.96% and 0.6% at 90 days respectively. The minimum slip is 1mm and 1.1mm after 28 days of testing bond strength for NWC and SWC sample respectively. The percentage decrease in bond strength is 10.35% for 28 days SWC samples. The pre-cast blended concrete samples performed better to chloride diffusion. Modulus of elasticity of SWC samples are also studied.The water absorption and sorptivity tests are conducted after 28 days of curing.

• Ocean and Polar Research
• /
• v.33 no.1
• /
• pp.35-43
• /
• 2011

Blubber plays different biological roles in cetaceans, including structural support, physiological demands (thermoregulation, streamlining, buoyancy, etc.), and energy storage. As such, biochemical composition, especially lipid, in the blubber may be vertically stratified in order to effectively assist with these functions. We analysed lipid content, class and fatty acid composition in the blubber of by-catch minke whale (Balaenoptera acutorostrata; n = 11), long-beaked common dolphin (Delphinus capensis; n = 3) and Pacific white-sided dolphin (Lagenorhynchus obiquidens; n = 2) from Korean waters. Lipid content for all three species ranged from 55 to 96% of wet weight, with a dominance of triacylglycerols. Vertical stratification of blubber lipid content was different between species. For minke whale and longbeaked common dolphin, it increased from inner (near the muscle) to outer (near the skin) layer, whereas it decreased for Pacific white-sided dolphin. Thirty-one fatty acids were found in all blubber samples and vertical stratification of fatty acid composition was similar among all three species. Among grouped fatty acids, monounsaturates were the most abundant, gradually increasing from inner to outer blubber layer, whereas polyunsaturates and saturates decreased. Such vertical stratification of lipid content and composition suggests that the modification and accumulation of lipid occur in the blubber itself in order to help cetaceans with their specific physiological needs.