• Journal of Korean Society of Water and Wastewater
• /
• v.26 no.3
• /
• pp.471-478
• /
• 2012

Where an activated sludge system needs to be converted to biological nutrient removal(BNR) system, the secondary clarifier must handle higher MLSS from bioreactor since nitrification in BNR system that requires higher SRTs than activated sludge system. Either increase the clarifier size or modification of clarifier physical structure is required to cope with MLSS surge. One of recommended structural modification is the insertion of Lamellar within clarifier. In this study, two clarifiers - one has Lamellar structure inserted and the other does not - were used to compare the effect of Lamellar in solid/liquid separation. Same MLSS was fed to both clarifiers and concentrations of MLSS were varied. With all MLSS concentrations, attachment of MLSS on Lamellar was observed and it was found that detached MLSS caused the higher effluent SS concentrations than that of non-Lamellar clarifier effluent. From these results, Lamellar should not be inserted in clarifier to handle MLSS from BNR processes and the recommendation must be withdrawn.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.14 no.1
• /
• pp.151-159
• /
• 2006

In these days, the importance of sludge treatment is emerging due to the London Convention, so this study was conducted to propose the alternatives for the improved sludge treatment on the organic wastewater and sewage sludge with JAR test and settling column equipped with stirrer. The minimum coagulant dosage to earn the optimum sludge settling efficiency resulted from 200mg/l and each critical sludge settling interface showed no distinct difference when PAC was dosed over 200mg/l. Accordingly, Clarification Rate(CR) with 200mg/l dosage was calculated to CR=(Ho-Ht) / Ho=1-0.4=0.6 because the critical sludge settling height stopped at 0.4. The settling velocity of sludge interface was decreased with the increase of MLSS concentration but rather increased with MLSS concentration over 1,000mg/l. This resulted from positive effect of interacted coagulation for floc formation by transfer to the zone of compressed settling when MLSS concentration increased over 1,000mg/l. The settling velocity of sludge interface showed $28.66{\times}10^{-3}/min$ for average settling velocity of sewage sludge which is 6.7 times higher than $4.25{\times}10^{-3}/min$ for average settling velocity of organic wastewater sludge. The increasing rate of CR for organic wastewater activated sludge was higher than that of settling velocity under 200mg/l of PAC dosage but settling velocity was higher than CR over 200mg/l of PAC dosage. However, in case of sewage sludge, the differential rate of CR was low when PAC dosage was increased but the settling velocity was suddenly increased with over 200mg/l dosage. Therefore coagulation effect was more efficient to MLSS settling velocity rather than SS removal effect in the supernatant.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.3
• /
• pp.152-158
• /
• 2015

This paper investigated the membrane fouling potential at the state of passive adsorption which is no permeation with the test modules on COD (Chemical oxygen demand) loading rates, examined the recovery rate and resistance on membrane fouling by three cleaning manners of hydrophobic membrane in a bioreactor. The results showed that high COD loading led to the increase of extra-cellular polymeric substances and filtration resistance. The permeability resistance from 1st day to 63rd day was getting increased, however, the value of permeability resistance after 63th day during the operation period was almost same level at three COD loading rates, it was due that the biomass adhesion on membrane surface at the state of passive adsorption reached to the critical state. Also, the final recovery rates after three cleaning manners were 78%, 72% and 69% at the COD loading concentrations of 250 mg/L, 500 mg/L and 750 mg/L respectively, and then recovery rate by physical cleaning at Run 2 and Run 3 was decreased after 40th day, it proved that biomass cake, which is not easily removed, was formed on the membrane surface because of high COD loading rate and EPS concentration.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.3
• /
• pp.271-277
• /
• 2008

The biofilm of white-rot fungi fully exposed in atmosphere are that operation is easy, management cost and energy waste is low. To develop biofilm of white-rot fungi fully exposed in atmosphere, basic test are as follows. To select most effective microoganism species, investigated treatment characteristics of wastewater containing non-biodegradable material for three species of white-rot fungi(Phanerochaete chrysosporium PSBL-1, Phanerochaete chrysosporium KCTC 6147, Trametes sp. KFCC 10941) and activated sludge. And then investigated attached and detached biomass of selected white-rot fungi species on HBC ring surface. Among the three strains tested, P. chrysosporium PSBL-1 and P. chrysosporium KCTC 6147 showed higher efficiency for organics removal than Trametes sp. KFCC 10941, and P. chrysosporium PSBL-1 showed higher efficiency for nitrogen removal than P. chrysosporium KCTC 6147 and Trametes sp. KFCC 10941. Respectively, 51$\sim$59.8%, 57.5$\sim$60.3% of NBDCOD was removed for P. chrysosporium PSBL-1 and P. chrysosporium 6147 in pH 3.5$\sim$5.5. TN removal efficiency showed 39.3$\sim$85.3%, 3.4$\sim$7.6% for P. chrysosporium PSBL-1 and P. chrysosporium 6147 in pH 4.5$\sim$11.5 respectively. Considered that white-rot fungi remove organism and nitrogen simultaneously, the microorganism selected white-rot fungi P. chrysosporium PSBL-1. White-rot fungi P. chrysosporium PSBL-1 attached on HBC ring surface 4,538 mg/L, 4,546 mg/L, 4,531 mg/L after 5 minutes, 4,575 mg/L, 4,573 mg/L, 4,568 mg/L after 10 minutes from initial MLSS 4,600 mg/L in pH 4, 7 and 10 respectively. Also detached biomass is negligible from right after attachment to 10 day in pH 4, 7 and 10.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.5
• /
• pp.959-970
• /
• 2000

A laboratory-scale experiment was conducted to investigate the effect of soluble microbial products(SMP) on permeate flux in the submerged membrane separation activated sludge process. Continuous and batch filtration test were operated to understand mechanism of relationship between membrane fouling and SMP. Synthetic wastewater(phenol) was used as a carbon source. Hydraulic retention time(HRT) and mixed-liquor volatile suspended solids(MLVSS) of the reactor were kept at 12 hours and 9.000mg VSS/L, respectively. Batch filtration tests ($J_{60}/J_o$) using the mixed liquor from reactor showed that the increase of accumulated SMP concentration in the reactor caused to the decreasing permeate flux and the increasing of the adhesion matters which form cake and gel layer. The resistance value of cake layer was measured $2.9{\times}10^{10}{\sim}4.0{\times}10^{10}(1/m)$, this value showed more significant effect on flux drop than that of among other resistance layers. Batch phenol-degradation experiment was conducted to observe SMP type expected $SMP_{nd}$ and $SMP_{e}$ (SMP resulted from endogenous cell decomposition), these are non-biodegradable high molecular weight organic matter and playa significant role in permeate flux drop. Also, SMP concentration was accumulated as increased of HRT against flux drop.