• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2016년도 추계학술대회 논문집
• /
• pp.33-34
• /
• 2016

This paper presents a load sharing method based on the low bandwidth communication (LBC) applied to a DC microgrid in order to balance the state of charge (SOC) of the battery units connected in parallel to the common bus. In this method, SOC of each battery unit is transferred to each other through LBC to calculate average SOC value. After that, droop coefficients of battery units are adjusted according to the difference between SOC of each unit and average SOC value of all batteries in the system. The proposed method can effectively balance the SOC of battery units in charging and discharging duration with a simple low bandwidth communication system.

• Journal of information and communication convergence engineering
• /
• 제3권1호
• /
• pp.18-22
• /
• 2005

This paper presents the analog adaptive phase-locked loop (PLL) architecture with a new adaptive bandwidth controller to reduce locking time and minimize jitter in PLL output for wireless communication. It adaptively controls the loop bandwidth according to the locking status. When the phase error is large, the PLL increases the loop bandwidth and reduces locking time. When the phase error is small, the PLL decreases the loop bandwidth and minimizes output jitters. The adaptive bandwidth control is implemented by controlling charge pump current depending on the locking status. A 1.28-GHz CMOS phase-locked loop with adaptive bandwidth control is designed with 0.35 $mu$m CMOS technology. It is simulated by HSPICE and achieves the primary reference sidebands at the output of the VCO are approximately -80dBc.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.305-308
• /
• 1999

In this paper, a transimpedance optical receiver based on PIN/P-HEMT with cascoded input stage and inductor peaking technique was designed for several giga bits optical communication. Analysis of the receiver shows that cascoded input stage with inductor peaking increase bandwidth without sacrificing low frequence gain. The receiver achieved a low noise characteristic and maximally flat frequence response. It is shown that the 3-dB bandwidth of the designed receiver is 8.3 ㎓ and input equivalent noise current is as low as 16pA/√Hz to 10㎓.

• 한국정보통신학회논문지
• /
• 제10권5호
• /
• pp.851-856
• /
• 2006

본 논문에서는 단일 PLL을 사용하여 400MHz 대역의 트랜시버를 구현하였다. 일반적인 트랜시버의 경우, 송수신부에 각각 한 개의 PLL과 수신부에 2단의 믹서를 사용하여 구현되어진다. 이러한 구성 은 트랜시버의 가격과, 부피에 상당히 큰 영향을 미친다. 본 논문에서는 기존의 방식을 탈피하여 단일 PLL방식의 데이터 전송용 특정 소출력 무선기기의 송, 수신단의 회로설계, 제작 및 특성측정 연구를 하였다. 설계된 트랜시버의 주파수 대역은 424.7-424.95MHz이고, Low Side Injection방식을 사용하여 450KHz의 IF 주파수로 변환(Conversion)하였고, 반이중 (Semi duplex Communication) 통신방식, PLL Synthesized, 21 Channel, 12.5KHz Channel Bandwidth, FSK Modulation/Demodulation방식을 사용하였다.

• Journal of electromagnetic engineering and science
• /
• 제4권2호
• /
• pp.63-67
• /
• 2004

DAM(Delay-And-Multiplier) intercept receiver usually detects the symbol rate of the transmitted DS spread spectrum signal for the feature extraction. It is important for secure communication to reduce the normalized output signal-to-noise ratio that is generated at the DAM intercept receiver as a measure of detectability. In this paper, several kinds of chip waveforms are novelly analyzed for LPI(Low-Probability of Intercept) communication against DAM intercept receiver. Consequently, it is shown that the rectangular chip waveform shows the best LPI performance in the bandwidth of 2/$T_c$TEX>, 4/$T_c$TEX>, and 6/$T_c$TEX>/. Except the rectangular waveform, kaiser chip waveform show better LPI performance than the other waveforms in the bandwidth of 4/$T_c$TEX> and 6/$T_c$TEX>.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권2호
• /
• pp.159-167
• /
• 1999

This paper presents a new transient voltage blocking device(TOBD)which low power and high frequency bandwidth to protect info-communication facilities from transient voltages. Conventional protection devices have some problems such as low frequency bandwidth low ener-gy capacity and high remnant voltage. in order to improve these limitations a hybrid type TOBD which consists of a gas tube avalanche diodes and junction type field effect transistor (JFETs) is developed. The TOBD differs from the conventional protection devices in configuration and JFETs are used as an active non-linear element and a high speed switching diode with low capacitance limited high current. Therefore the avalanche diode with low energy capacity are protected from the high current and the TOBD has a very small input capacitance. From the performance test using combination surge generator which can produce $1.2/50{\mu}m$ 4.2 kV/max, $8/20{\mu}m$ 2.1 kAmax it is confirmed that the proposed TOBD has an excellent protection per-formance in tight clamping voltage and limiting current characteristics.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2000년도 종합학술발표회 논문집 Vol.10 No.1
• /
• pp.350-353
• /
• 2000

In this paper, we designed the microstrip patch antenna with L-shaped aperture, which greatly enhances its bandwidth. We optimized to get a maximum bandwidth. The microstrip patch antenna with L-shaped aperture has the widest bandwidth of the conventional aperture coupled microstrip patch antenna. This antenna also has the low-cross polarization level. The effects of changing several key design parameters of the antenna are investigated. We calculated the VSWR, input impedance, and radiation pattern.

• Journal of Information Processing Systems
• /
• 제19권6호
• /
• pp.817-829
• /
• 2023

Variable wireless channel is a big challenge for real-time video applications, and the rate adaptation of realtime video streaming becomes a hot topic. Intra-video coding is important for high-quality video communication and industrial video applications. In this paper, we proposed a novel adaptive scheme for real-time video transmission with intra-only coding over a wireless network. The key idea of this scheme is to estimate the instantaneous remaining capacity of the network to adjust the quality of the next several video frames, which not only can keep low queuing delay and ensure video quality, but also can respond to bandwidth changes quickly. We compare our scheme with three different schemes in the video transmission system. The experimental results show that our scheme has higher bandwidth utilization and faster bandwidth change response, while maintaining low queuing delay.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제54권4호
• /
• pp.178-184
• /
• 2005

In this paper, using diplexer structure and varactor diode controlled by reverse bias voltage for diplexer switch gives possibilities to improve isolation and current characteristics. 1 have newly designed switch with high isolation by application varactor diode corresponding to capacitor of diplexer. The low-pass filter for proposed tunable diplexer passes the microwave signal in the bandwidth for wireless cellular network systems and high-pass filter passes it in the bandwidth for wireless personal communication services (PCS) network systems. As the capacitance of the low-pass filter increases, the cut-off frequency can be moved to low frequency, so that the switch is on state in cellular bandwidth and off state in the PCS bandwidth, in contrast to, as the capacitance for attenuation characteristic of high-pass filter increases, it can be moved to high frequency, so that the switch is off state and on state in the cellular bandwidth. it is possible to improve isolation and current consumption characteristics by application diplexer design methods and varactor diode. 1 expect that the tunable diplexer circuit and design methods should be able to find applications on MMIC and low temperature copired ceramic (LTCC).

• 한국군사과학기술학회지
• /
• 제14권5호
• /
• pp.842-849
• /
• 2011

The transponder simulator designed to simulate the transponder of military satellite communication systems in the geostationary orbit is required to have time delay function, because of 250 ms delay time, when a radio wave transmits the distance of 36,000 km in free space. But, it is very difficult to develop 250 ms time delay device in the transponder simulator of 100 MHz bandwidth, due to unstable operation of FPGA, loss of memory data for the high speed rate signal processing. Up to date, bandwidth of the time delay device is limited to 45 MHz bandwidth. To solve this problem, we propose the new time delay techniques up to 100 MHz bandwidth without data loss. Proposed techniques are the low speed down scaling and high speed up scaling methods to read and write the external memory, and the matrix structure design of FPGA memory to treat data as high speed rate. We developed the satellite link simulator in 100 MHz bandwidth using the proposed new time delay techniques, implemented to the transponder simulator and verified the function of 265 ms time delay device in 100 MHz bandwidth.