• ETRI Journal
• /
• v.29 no.4
• /
• pp.445-451
• /
• 2007

An adaptive modulation scheme is presented for multiuser orthogonal frequency-division multiplexing systems. The aim of the scheme is to minimize the total transmit power with a constraint on the transmission rate for users, assuming knowledge of the instantaneous channel gains for all users using a combined bit-loading and subcarrier allocation algorithm. The subcarrier allocation algorithm identifies the appropriate assignment of subcarriers to the users, while the bit-loading algorithm determines the number of bits given to each subcarrier. The proposed bit-loading algorithm is derived from the geometric progression of the additional transmission power required by the subcarriers and the arithmetic-geometric means inequality. This algorithm has a simple procedure and low computational complexity. A heuristic approach is also used for the subcarrier allocation algorithm, providing a trade-off between complexity and performance. Numerical results demonstrate that the proposed algorithms provide comparable performance with existing algorithms with low computational cost.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2002.09a
• /
• pp.155-162
• /
• 2002

A technique for the seismic reliability evaluation of electric power transmission systems(EPTS) adapted to ground motion characteristics of Korea has been developed to evaluate reliability indices corresponding to the whole system and to each node within. A network model with nodes and links for EPTS has been established, and a seismic substation-fragility curve obtained from seismic fragilities of power system facilities has been derived. A point source model, the doubly truncated Gutenberg-Richter relationship, and earthquake intensity attenuation formula have been applied to simulate seismic events. Using Monte-Carlo simulation method, the seismic reliability of EPTS is evaluated and, it appeared that seismic effect on EPTS in low and moderate seismicity regions has to be considered.

• Journal of Power Electronics
• /
• v.13 no.4
• /
• pp.528-535
• /
• 2013

Most eco-friendly cars can adopt the concept of an integrated battery charger (IBC), which uses currently available motor drive systems. The IBC has a lot of strong points such as low cost and minimum space for the high voltage battery charger. On the other hand, it also has some defects caused by its structure. In this paper, the shortcomings of the conventional IBC for PHEVs with interior permanent magnet motors are discussed, and two advanced IBCs with improved performance are presented. Compared with the conventional IBC, the two advanced IBCs have plenty of strengths such as low common noise, high efficiency, simple sensing methods, etc. Then, the digital control algorithm is modified and a power loss calculation is carried out with simulation software. Finally, experimental results are provided to show the performance of the IBC systems.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.6
• /
• pp.37-43
• /
• 1997

In this paper, an analog-domain powr-reduction technique for a low-voltage CMOS operational amplifier and its application to clock-based VLSI systems are proposed. The proposed technique cuts off the bias current of the op amp during a half cycle of the clock in the sleeping mode and resumes the curent supply sequentially during the remaining cycle of the clock in the normal operating mode. The proposed sequential sbiasing technique reduces about 50% of the op amp power and improves the circuit performance through high phase margin and stable settling behavior of the output voltage. The power-reduction technique is applied to a sample-and-hold amplifier which is one of the critical circuit blocks used in the front-end stage of analog and/or digital integrated systems. The SHA was simulated and analyzed in a 0.8.mu.m n-well double-poly double-metal CMOS technology.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2004.05a
• /
• pp.100-103
• /
• 2004

This paper presents the aspect and distribution of voltage and current harmonics being made at low voltage power systems. The voltage and current harmonics in power systems supplying various loads were monitored and analyzed. We have examined the results compared to advanced countries' harmonics control standards. As a result, the current harmonics were significantly greater than the voltage harmonics. In particular, the harmonics of currents flowing through loads with power switching electronics was pronounced. Also, the contents of current harmonics of street lamp circuits was about 30%, and it was decreased to 12.3% with the installation of series reactor. On the whole, The measured results of voltage and current harmonics exceeds the regulation limits recommended by IEEE 519-1992.

• Journal of Power Electronics
• /
• v.8 no.2
• /
• pp.156-162
• /
• 2008

This paper proposes a low-cost power converter for micro wind turbine systems using permanent magnet synchronous generators (PMSG). The proposed converter consists of a two-leg three-phase PWM inverter for the generator control and a single-phase half-bridge PWM converter which is connected to the utility grid. For the two separate DC-link voltages, a balancing control is added and the adverse effect of the DC-link voltage ripples on the inverter output voltage is compensated. The control performance of the proposed converter topology for the micro wind turbine system is shown by the simulation results using PSIM software.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.311.2-311.2
• /
• 2013

Transmutation characteristics of minor actinides in a transmutation reactor based on a Low Aspect Ratio (LAR) tokamak are investigated. One-dimensional neutron transport and burn-up calculation coupled with the tokamak systems analysis were performed to find the optimal system parameters. The dependence of the transmutation characteristics such as neutron multiplication factor, produced power and transmutation rate on an aspect ratio A in the range of 1.5 to 2.0 was investigated. By adding Pu239 in the transmutation blanket as a neutron multiplication material, it was shown that the one unit of the transmutation reactor based on the LAR tokamak producing fusion power of 150 MWth can destroy the minor actinides contained in the spent fuels produced from more than 19 units of l GWe PWRs with production of the power being in the range of 0.9 - 3.4 GWth.

• Nuclear Engineering and Technology
• /
• v.56 no.2
• /
• pp.520-525
• /
• 2024

The optimization design problem of nuclear reactor radiation shield is a typical multi-objective optimization problem with almost 10 sub-objectives and the sub-objectives are always demanded to be under tolerable limits. In this paper, a design method combining multi-objective optimization algorithms with paralleling discrete ordinate transportation code is developed and applied to shield design of the Savannah nuclear reactor. Three approaches are studied for light-weighted and compact design of radiation shield. Comparing with directly optimization with 10 objectives and the single-objective optimization, the approach by setting sub-objectives representing weight and volume as optimization objectives while treating other sub-objectives as constraints has the best performance, which is more suitable to reactor shield design.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.8
• /
• pp.2647-2662
• /
• 2014

This paper proposes an efficient and low complexity power-loading algorithm for MIMO-OFDM downlink based cognitive radio system that maximizes the sum rate of single secondary user (SU) under constraints on the tolerable interference thresholds between secondary user and primary user's frequency bands and the total transmission power. Our suboptimal algorithm is based on the $2^{nd}$ order interference tracking and nulling mechanism to allocate transmission power of the subcarriers among SU's scheme. The performance of our proposed suboptimal scheme is compared with the performance of the classical power loading algorithms, e.g., water filling, $1^{st}$ order interference tracking, nulling, and other suboptimal schemes. Numerical results show that our algorithm has low complexity but obtains a higher channel capacity than that of some previous suboptimal algorithms in some scenarios. We dedicate also that for a given interference threshold, the $2^{nd}$ order interference tracking mechanism has dynamic number of nulling position instead fixed number of nulling position.

• ETRI Journal
• /
• v.30 no.3
• /
• pp.412-420
• /
• 2008

A new scan partition architecture to reduce both the average and peak power dissipation during scan testing is proposed for low-power embedded systems. In scan-based testing, due to the extremely high switching activity during the scan shift operation, the power consumption increases considerably. In addition, the reduced correlation between consecutive test patterns may increase the power consumed during the capture cycle. In the proposed architecture, only a subset of scan cells is loaded with test stimulus and captured with test responses by freezing the remaining scan cells according to the spectrum of unspecified bits in the test cubes. To optimize the proposed process, a novel graph-based heuristic to partition the scan chain into several segments and a technique to increase the number of don't cares in the given test set have been developed. Experimental results on large ISCAS89 benchmark circuits show that the proposed technique, compared to the traditional full scan scheme, can reduce both the average switching activities and the average peak switching activities by 92.37% and 41.21%, respectively.