• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.2
• /
• pp.733-750
• /
• 2019

Software Defined Networking (SDN) is a new network paradigm, allowing administrators to manage networks through central controllers by separating control plane from data plane. So, one or more controllers must locate outside switches. However, this separation may cause delay problems between controllers and switches. In this paper, we therefore propose a Priority-based Scheduling policy for OpenFlow (PSO) to reduce the delay of some significant traffic. Our PSO is based on packet prioritization mechanisms in both OpenFlow switches and controllers. In addition, we have prototyped and experimented on PSO using a network simulator (ns-3). From the experimental results, PSO has demonstrated low delay for targeted traffic in the out-of-brand control network. The targeted traffic can acquire forwarding rules with lower delay under network congestion in control links (with normalized load > 0.8), comparing to traditional OpenFlow. Furthermore, PSO is helpful in the in-band control network to prioritize OpenFlow messages over data packets.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.12
• /
• pp.1121-1126
• /
• 2010

This study is to investigate the effects of aromatics and T90 for low cetane number (CN) fuels on combustion and exhaust emissions in low-temperature diesel combustion. We use a 1.9-L common rail direct injection diesel engine at 1500 rpm and 2.6 bar BMEP. Low temperature diesel combustion was achieved via a high external EGR rate and strategic injection control. The tested fuels four sets: the aromatic content was 20% (A20) or 45% (A45) and the T90 temperature was $270^{\circ}C$ (T270) or $340^{\circ}C$ (T340) with CN 30. Given the engine operating conditions, the T90 was the stronger factor on the ignition delay time, resulting in a longer ignition delay time for higher T90 fuels. All the fuels produced nearly zero PM because of the extension of the ignition delay time induced by the low cetane number. The aromatic content was the main factor that affected the NOx and the NOx increased with the aromatic content.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.415-419
• /
• 1999

Many bipolar logic circuit of conventional occurred problem of speed delay according to deep saturation state of vertical NPN Transistor. In order to remove minority carries of the base region at changing signal in conventional bipolar logic circuit, we made transistor which is composed of NPN transistor shortened buried layer under the Base region, PNP transistor which is merged in base, epi layer and substrate. Also the Ring-Oscillator for measuring transmission time-delay per gate was designed as well. The structure of Gate consists of the vertical NPN Transistor, substrate and Merged PNP Transistor. In the result, we fount that tarriers which are coming into intrinsic Base from Emitter and the portion of edge are relatively a lot, so those make Base currents a lot and Gain is low with a few of collector currents because of cutting the buried layer of collector of conventional junction area. Merged PNP Transistor's currents are low because Base width is wide and the difference of Emitter's density and Base's density is small. we get amplitude of logic voltage of 200mv, the minimum of transmission delay-time of 211nS, and the minimum of transmission delay-time per gate of 7.26nS in AC characteristic output of Ring-Oscillator connected Gate.

• Journal of Communications and Networks
• /
• v.15 no.5
• /
• pp.496-503
• /
• 2013

In an orthogonal frequency division multiplexing system, conventional interpolation techniques cannot correctly balance performance and overhead when estimating dynamic long-delay channels in single frequency networks (SFNs). In this study, classical filter analysis and design methods are employed to derive a complex interpolator for maximizing the resistible echo delay in a channel estimator on the basis of the correlation between frequency domain interpolating and time domain windowing. The coefficient computation of the complex interpolator requires a key parameter, i.e., channel length, which is obtained in the frequency domain with a tentative estimation scheme having low implementation complexity. The proposed complex adaptive interpolator is verified in a simulated digital video broadcasting for terrestrial/handheld receiver. The simulation results indicate that the designed channel estimator can not only handle SFN echoes with more than $200{\mu}s$ delay but also achieve a bit-error rate performance close to the optimum minimum mean square error method, which significantly outperforms conventional channel estimation methods, while preserving a low implementation cost in a short-delay channel.

• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.200-203
• /
• 2003

By minimizing the burst error of data and correcting the error, we can define the convolution coding and interleaving in IEEE 802.11a wireless tan system. Two step block interleaver was decided by coded bits per OFDM symbol and due to this it comes to the delay time in IEEE 802.11a. This is the point of the question which we must consider. We try to decrease the delay time by all 48-clock from interleavings, and we have proposed a way carried out the interleaving outputs per symbol. So in comparison with the existing interleaver, we can decrease the delay time in reading and writing data, as well as reduce the delay time of bit re-ordering per symbol. Also this scheme is apply in all x-QAM cases.

• Journal of IKEEE
• /
• v.24 no.1
• /
• pp.326-332
• /
• 2020

This paper presents the design of a routing metric for energy-efficient and low-delay path selection and a new routing protocol utilizing the metric in duty-cycyled wireless sensor networks. The new routing metric based on duty cycle, EDW, can reduce the energy and delay of transmission paths, which represents total waiting time from source to destination due to duty cycle. Therefore, in this paper, we propose a new multipath routing protocol based on cross-layer information utilizing the new routing metric, and simulation results show that the proposed protocol shows better performance of end-to-end delay and energy consumption.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.5
• /
• pp.582-589
• /
• 2016

Multi-mode monopulse system is widely used for satellite terminal like UAV because of high tracking accuracy and low size/weight profile. In order to calculate tracking error, Multi-mode monopulse system utilizes high-order mode signal, and it should have enough C/N(carrier to noise) level therefore tracking system needs narrow band filtering of received satellite beacon signal as much as possible. However, UAV suffers for beacon frequency drift derived from Doppler effect due to satellite figure 8 movement and UAV maneuvering. Therefore wideband signal processing needs to be considered in advance for exact doppler compensation and consequent time delay. In this paper, we propose the multi-stage Digital Signal processing system for beacon signal, which could minimize the signal delay under high Doppler and low C/N condition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.5
• /
• pp.842-856
• /
• 1994

The various services that a broadband integrated services digital network (B-ISDN) carries, have a wide range of delay, delay jitter and cell loss probability requirements. Design of appropriate control schemes for B-ISDN is an extremely important and challenging problem. In this paper, we proposed multiplexing algorithm with both delay and loss priorities in order to satisfy the diverse requirements. For the implementation of cell lose priority, we assumed that voice cells are generated as non-discardable(i.e., high priority) and discardable (i.e., low priotity)cells. The low priority voice cell may be discarded inside the network if congestion occurs. The cell dropping scheme is shown to reduce cell losses as well as delays for both voice and data. Such a load shedding scheme is expected to improve significantly utilization of B-ISDN.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.2
• /
• pp.452-458
• /
• 2014

In Wireless Sensor Networks the Medium access control (MAC) protocol has many challenges to solve such as reducing energy consumption, supporting QoS(quality of service) fairness, and reducing delivery delay. This paper proposed a low-delay supporting MAC protocol in multi-hop Wireless Sensor Networks. The proposed protocol uses the RB(rapid beacon) frame for reducing delivery delay. The RB frame is a modified IEEE 802.15.4 beacon frame. For sender adaptive-wakeup, the RB frame includes a seed number for determining of a receiver wakeup time. And for next hop receiver adaptive-wakeup, the RB frame includes the length of remaining data packet information. Results showed that our LD-MAC protocol outperformed other protocol in terms of data packet delivery delay.

• Journal of Navigation and Port Research
• /
• v.36 no.8
• /
• pp.637-641
• /
• 2012

In this paper, the method that reduce a computation time by optimizing computation process is proposed to realize low-power underwater acoustic communication system. At first, dependency of decision delay on tap length of linear equalizer was investigated. Variance is calculated based on this result, and the optimal decision delay bound is estimated. In addition to decide optimal tap length with decision delay, we extracted the MSE(Mean Square Error) graph. From the graph, we obtained variance value of the MSE-decision delay, and estimated the optimum decision delay range from the variance value. Also, using the extracted optimal parameters, we performed a simulation. According to the result, the simulation employing optimal tap length, which is only 40% of maximum tap length, showed a satisfactory performance comparable to simulation employing maximum tap length. We verified that the proposed method has 33% lower tap length than maximal tap length via sea trial.