• Journal of the Korea Institute of Military Science and Technology
• /
• v.10 no.3
• /
• pp.114-119
• /
• 2007

Dielectric properties of quartz glass and $Si_3N_4$ are investigated using the waveguide method from room temperature to $800^{\circ}C$. For the case of dielectric constant, $Si_3N_4$ showed similar increase with quartz glass up to $300^{\circ}C$, but less increase from $300^{\circ}C$ to $800^{\circ}C$. For the case of loss tangent, those showed gradual increase with temperature except of some temperature points. The loss tangent of $Si_3N_4$ and quartz glass increased up to 18.2% and 12.5% respectively. Through these researches, high temperature dielectric properties of silicon nitride materials are characterized.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.34 no.8
• /
• pp.323-330
• /
• 1985

Dielectric loss tangent and ac dielectric strength of GFRP (Glass Fiber Reinforced Plastics, G-10)was investigated as parameters of mechanical and thermal stresses, in order to study the basic dielectrical characteristics of composite insulating materials. The dielectric loss tangent was increased and the ac dielectric strength was decreased with increase in the mechanical stresses beyond the mechanical yield point on account of fiber-matrix debonding, but the dielectric constant was not varied sigificantly. the dielectric strength of G-10 was about 2 MV/cm and the dielectric constant was about 4.8.

• Journal of electromagnetic engineering and science
• /
• v.4 no.3
• /
• pp.113-118
• /
• 2004

As an application of ring filters, a new and simple method to determine an inherent-ring-resonance frequency is introduced. The ring filter consists of a ring and two short stubs. They are connected at 90$^{\circ}$ and 270$^{\circ}$ points of the ring and the ring filter may be seen in such way that two filters are connected in parallel. Therefore, if the two powers of the two filters are out-of-phase at the output, the power excited at the input can not be delivered. That can be done by making difference in length of the two short stubs, and when a certain condition is satisfied, a frequency exists where all the excited power is reflected. That is the very inherent-ring-resonance frequency. In the lossless case, the return loss with the condition reaches 0 dB at the inherent-ring-resonance frequency but does not with conductor, dielectric losses and so on. Therefore, the effective loss tangent at a frequency of interest may be obtained correctly. To verify the method, two ring filters have been fabricated in microstrip lines and the measured results show good agreement with the predicted ones.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.309-310
• /
• 2005

Generally, the dielectric constant and loss tangent are gotten by resonators. This paper presents analysis of the comparing the dielectric constant and loss tangent from the Ring, T and series gap structures. The T structure can be analyzed easily at wideband characteristic with simple design. the Ring can ignore the radiation loss from the open-ended effect. the Series gap can get more accurate permittivity than a Ring structure. The Used materials were dupont9599 LTCC ceramic and daeju0086 Ag.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.6
• /
• pp.445-451
• /
• 2019

This paper presents the design of a water-cooled radio-frequency(RF) load with simple structure, for use in the ultrahigh-frequency (UHF) band. After establishing a formula to obtain the physical properties that affect RF matching, we measure the permittivity and $tan{\delta}$(Loss tangent) of tap water. Because the temperature of tap water increases upon applying high power, we measure the permittivity and $tan{\delta}$ for all changes in the temperature of tap water. In order to reduce the length of the water-load, molybdate with high $tan{\delta}$ is mixed with tap water. The loss tangent of the mixture is found to be approximately 26 times higher than that of tap water. Finally, we manufacture a water-cooled RF load and measure its characteristics. A reflection coefficient of -19 dB and bandwidth of 15 % is obtained at 460 MHz.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.11a
• /
• pp.187-190
• /
• 1998

In this paper a probe for the' measurement of dielectric properties of dielectric sheet materials is designed and implemented as a coaxial air line type. Using the broadband impedance method with this measurement probe the dielectric constant and loss tangent of the glass-epoxy and teflon are determined in the frequency range of 0.1 - l.O[GHz] with the temperature variation from $25[^{\circ}C]$ up to $65[^{\circ}C]$. A measured relative dielectric constant of the glass-epoxy is 4.42 and a loss tangents is 0.019 relatively, and the relative dielectric constants of teflon is 2.17 and a loss tangents is 0.002 relatively

• Korea-Australia Rheology Journal
• /
• v.21 no.2
• /
• pp.91-102
• /
• 2009

This paper describes an extension of viscoelastic Group Interaction Modelling (GIM) to predict the relaxation response of linear, branched and cross-linked structures. This model is incorporated into a Monte Carlo percolation grid simulation used to generate the topological structure during the isothermal cure of a gel, so enabling the chemorheological response to be predicted at any point during the cure. The model results are compared to experimental data for an epoxy-amine systems and good agreement is observed. The viscoelastic model predicts the same exponent power-law behaviour of the loss and storage moduli as a function of frequency and predicts the cross-over in the loss tangent at the percolation condition for gelation. The model also predicts the peak in the loss tangent which occurs when the glass transition temperature surpasses the isothermal cure temperature and the system vitrifies.

• Journal of Advanced Navigation Technology
• /
• v.13 no.1
• /
• pp.41-47
• /
• 2009

In this paper, a band pass filter with a rejection band is proposed for UWB(Ultra Wide Band) communication system. First, low pass filter accessed cut off frequency of 10.2 GHz was designed using structure stepped impedance. And high pass filter accessed cut of frequency of 3.2 GHz was designed using parallel short-stub. There was implemented composite connection of designed low pass filter and high pass filter. The relative dielectric constant, the height, the loss tangent of the PCB substrate were ${\varepsilon}_r$=2.2, h=0.508 mm and loss tangent = 0.0009 respectively. The fabricated band pass filter shows a compact size of 3 cm. The fabricated band pass filter was characterized using 37169A VNA(Vector Network Analyzer). And measured result were obtained 7.5 GHz of bandwidth and -10 dB of return loss and -3 dB of insertion loss from pass band. The result of the research can be used for the UWB communications and MIC/MMIC, RFIC system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.222-222
• /
• 2007

RF circuit을 구현하는데 있어서 기판의 전기적 특성을 정확하게 아는 것은 원하는 결과를 추출하기 위해 매우 중요하다. 본 연구에서는 현재 사용되고 있는 PI 기판의 전기적인 특성인 유효 유전율과 loss tangent 값을 T-resonator률 이용해 정확하게 측정하고자 했다. T-resonator는 microstrip 구조로 구현 되었으며 conductor material은 Cu를 사용하였다. PI 기판의 두께는 25um, Cu의 두께는 PI 기판의 종류에 따라 12um 와 18um, T-resonator line width는 50um로 구현하였다. 또한 공진 주파수에 따라 stub 길이가 다른 10개의 T-resonator를 제작하였다. PI 기판의 유효 유전율을 구하기 위해 stub 길이의 open-end effect와 T-junction effect를 고려하였으며 수식을 통해 정확한 유효 유전률을 추출하였다. 또한 PI 기판의 loss tangent 추출에 필요한 dielectric loss를 추출하기 위해 unload quality factor를 분석하였다. Unload quality factor는 dielectric loss, conductor loss, radiation loss를 구성되며 conductor loss와 radiation loss를 수식에 의해 구하고 dielectric loss를 추출 하였다. 추출 된 dielectric loss를 통해 각각의 T-resonator의 loss tangent 값을 구하였다. T-resonator를 이용한 PI 기판의 측정은 비교적 복잡한 수식에 의해 이루어지지만 정확한 data를 얻을 수 있고 다른 재료의 전기적 특성을 추출하는데 응용이 가능하다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.210-210
• /
• 2007

RF circuit을 구현하는데 있어서 기판의 전기적 특성을 정확하게 아는 것은 매우 중요하다. 왜냐하면 초고주파로 갈수록 기판의 전기적인 특성이 circuit에 많은 영향을 미치고 이러한 영향을 고려한 circuit를 설계해야 원하는 결과를 얻을 수 있기 때문이다. 본 연구에서는 현재 사용되고 있는 PI 기판의 전기적인 특성인 유효 유전율과 loss tangent 값을 캐패시터를 이용해 정확하게 측정하고자 했다. 캐패시터의 conductor material은 Cu를 사용하였고 PI 기판의 투께는 25um 를 이용하였다. PI 기판의 유효 유전율은 캐패시터 측정에 의한 data률 EM simulation tool 을 통해 분석한 후 간단한 수식에 의해 구했다. 또한 PI 기판의 loss tangent 값을 구하기 위해 캐패시터의 dissipation factor를 분석하였다. 캐패시터의 dissipation factor는 dielectric loss, AC 저항에 의한 loss, DC 저항에 의한 loss를 포함한다, DC 저항에 의한 loss는 dissipation factor에 차지하는 비율이 낮기 때문에 생략이 가능하다. 하지만 AC 저항에 의한 loss는 주파수에 비례하여 값이 커지게 된다. 따라서 주파수가 올라 갈수록 dissipation factor도 상승하게 되는데 주파수의 전 대역에서 AC 저항에 의한 loss를 보정해주면 dielectric loss를 얻을 수 있다. 추출된 dielectric loss를 통해 PI 기판의 loss tangent 값을 구하였다. 캐패시터를 이용한 PI 기판의 전기적 특성 추출은 간단한 구조를 통해 얻을 수 있기 때문에 다른 재료의 기판의 전기적 특성을 추출하는데도 이용이 용이하다.