• Archives of Craniofacial Surgery
• /
• v.19 no.1
• /
• pp.48-50
• /
• 2018

Bony anomaly caused by lip tie is not many reported yet. There was a case of upper lip tie wrapping into the anterior premaxilla. We represent a case of severe upper lip tie of limited lip motion, upper lips curling inside, and alveolar hypoplasia. Male patient was born on June 3, 2016. He had a deep philtral sulcus, low vermilion border and deep cupid's bow of upper lip due to tension of short, stout and very tight frenulum. His upper lip motion was severely restricted in particular lip eversion. There was anterior alveolar hypoplasia with deep sulcus in anterior maxilla. Resection of frenulum cord with Z-plasty was performed at anterior premaxilla and upper lip sulcus. Frenulum was tightly attached to gingiva through gum and into hard palate. Width of frenulum cord was about 1 cm, and length was about 3 cm. He gained upper lip contour including cupid's bow and normal vermilion border after the surgery. This case is severe upper lip tie showing the premaxillary hypoplasia, abnormal lip motion and contour for child. Although there is mild limitation of feeding with upper lip tie child, early detection and treatment are needed to correct bony growth.

• KIPS Transactions on Software and Data Engineering
• /
• v.9 no.12
• /
• pp.431-438
• /
• 2020

In this paper, the method to extract lip contour by multiple threshold is proposed. Spyridonos et. el. proposed a method to extract lip contour. First step is get Q image from transform of RGB into YIQ. Second step is to find lip corner points by change point detection and split Q image into upper and lower part by corner points. The candidate lip contour can be obtained by apply threshold to Q image. From the candidate contour, feature variance is calculated and the contour with maximum variance is adopted as final contour. The feature variance 'D' is based on the absolute difference near the contour points. The conventional method has 3 problems. The first one is related to lip corner point. Calculation of variance depends on much skin pixels and therefore the accuracy decreases and have effect on the split for Q image. Second, there is no analysis for color systems except YIQ. YIQ is a good however, other color systems such as HVS, CIELUV, YCrCb would be considered. Final problem is related to selection of optimal contour. In selection process, they used maximum of average feature variance for the pixels near the contour points. The maximum of variance causes reduction of extracted contour compared to ground contours. To solve the first problem, the proposed method excludes some of skin pixels and got 30% performance increase. For the second problem, HSV, CIELUV, YCrCb coordinate systems are tested and found there is no relation between the conventional method and dependency to color systems. For the final problem, maximum of total sum for the feature variance is adopted rather than the maximum of average feature variance and got 46% performance increase. By combine all the solutions, the proposed method gives 2 times in accuracy and stability than conventional method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.10
• /
• pp.1891-1896
• /
• 2006

In this paper, we propose an improved Active Shape Model for extracting lip contour. Lip deformation is modeled by a statistically deformable model based Active Shape Model. Because each point is moved independently using local profile information in Active Shape Model, many error may happen. To use a global information, we define an energy function similar to an energy function in Active Contour Model, and points are moved to positions at which the total energy is minimized. The experiments have been performed for many lip images of Tulip 1 database, and show that our method extracts lip shape than a traditional ASM more exactly.

• Archives of Plastic Surgery
• /
• v.38 no.4
• /
• pp.383-390
• /
• 2011

Purpose: To correct the upper lip depression after the correction of unilateral cleft lip, autologous grafts such as bone, dermal, fascial grafts and fat injections or alloplastic implants are used. Transplanted bones, dermis and fascia have a tendency to be absorbed and have donor morbidity. Fat injections are absorbed inconsistently and alloplastic implants have problems such as foreign body reactions, protrusions and infections. Authors corrected the upper lip depression using conchal cartilage graft in unilateral cleft lip deformity and the results was analysed with photos. Methods: 26-unilateral cleft lip and 2-microform cleft lip cases, totally 28 cases were performed. Their mean age was 21.89 years. The male and female cases were 12 and 16, respectively. Under anesthesia (general: 18 cases and local: 10 cases), cavum conchae (n=8), cymba conchae (n=16) and whole conchae (n=4) were harvested. Transversely cut the margin of the obtained cartilage, we cut out the most bent portion and put a partial-thickness incision on concave surface in cases of excessive convexity. Then, we performed the onlay graft of the conchal cartilage via scar revision site in unilateral cleft lip and via the reconstruction site of the cupid bow in microform cleft lip. The augmentation of the upper lip was evaluated with photos. Adapting the baseline connecting between the both cheilions as a horizontal standard line, we measured the highest point among the tangents between the upper lip and nose (point a), the lowest point (point c), the middle point between a and c (point b) and the vertical line from the alare (point d) to the horizontal standard line. To assess the postoperative symmetry, we compared cleft side upper lip contour index (%) A,B,C,D=(a,b,c,d)-ch ${\times}$ 100/(ch-ch) and non-cleft side upper lip contour index (%) A',B',C',D'= (a',b',c',d')-ch ${\times}$ 100 / (ch-ch).h) Results: After the surgery, no complication was found except in one case which double layers graft performed in the cleft lip deformity, the lateral portion was protruded. The upper lip contour index, the difference of A and A' were-0.83%, and thus the mild depression was persisted. Difference of B and B', C and C', D and D' were 0.83%, 1.07%, 0.90%. There were statistically significant difference, and thus the depression of upper lip were improved generally. Conclusion: Authors performed the onlay graft of the conchal cartilage in unilateral cleft lip deformity and found that the depression of the upper lip was well corrected except the uppermost part when photogrammetrically analyzed.

• Journal of Intelligence and Information Systems
• /
• v.8 no.1
• /
• pp.75-85
• /
• 2002

In this paper, we propose an efficient method for recognizing lip. Lip is localized by using the shape of lip and the pixel values around lip contour. The shape of lip is represented by a statistically based active shape model which learns typical lip shape from a training set. Because this model is affected by the initial position, we use a boundary between upper and lower lip as initial position for searching lip. The boundary is localized by using a weighted vector based on lip's shape. The experiments have been performed for many images, and show very encouraging result.

• The korean journal of orthodontics
• /
• v.27 no.5 s.64
• /
• pp.723-732
• /
• 1997

The purpose of this study was to investigate the variations of the soft tissue profile contour in relation to the skeletal patterns and to confirm the correlation of soft tissue angles to the sagittal or vertical skeletal elements. Lateral cephalograms of 79 cases which were older than 17 years in age, were traced and statistically analyzed. The obtained results were as follows : 1. Nasolabial, interlabial, lower lip, mentolabial, and symphyseal angles showed the significant differences between skeletal Class II and skeletal. Class III group, but nasofrontal, upper lip, mentolabial, and symphyseal angles showed the significant differences between high angle and low angle group. 2. ANB value showed the significant positive correlation to nasolabial, symphyseal, and interlabial angles and the significant negative relation to lower lip angle. 3. SN-GoMe value showed the significant positive correlation to mentolabial, symphyseal, nasofrontal, and upper lip angles. 4. Soft tissue profile contour in SK. Class II group showed greater accordance to SN-GoMe value than those in SK. Class III group.

• Archives of Plastic Surgery
• /
• v.35 no.4
• /
• pp.431-438
• /
• 2008

Purpose: The common deformity after the correction of unilateral cleft lip nasal deformity is nasal asymmetry, and it is caused by the hypoplasia of the pyriform aperture. To correct this, many procedures have been applied, but still many problems are present. Authors performed the inlay and onlay insertion of porous high density polyethylene sheet(1 mm thickness $Medpor{(R)}$ sheet) in the hypoplastic pyriform margin of cleft side and obtained satisfactory results. Methods: 11 cases were performed and the mean follow up period was 15.1 months. Their mean age was 23.6 years. Under general anesthesia, bilateral pyriform margin was exposed. $Medpor{(R)}$ sheets in "match stick" like shaped were inlay inserted, and kidney shaped were onlay inserted fixating with two 6 mm titanium screws. After the surgery, the results was evaluated by photogrammetric analysis. On the basal view, the distance from the subalare and labiale superius' to the transverse baseline connecting the both cheilions was measured from the cleft side and the non-cleft side. Then, the postoperative symmetry was assessed by obtaining the cleft side against the non-cleft side as proportion index, defined as lateral and medial upper lip contour index. Results: There were 2 infections. The cause was because the inserted implant was too long and thus protruded to the base of nasal cavity. The lateral upper lip contour index was from 95.49 to 103.27, and medial upper lip contour index was from 90.92 to 100.49, it was statistically increased, and thus the symmetry was improved. However clinically mild depression remained at nostril floor. Conclusion: Authors performed porous high density polyethylene sheet inlay and onlay insertion for the hypoplasia of the pyriform margin in unilateral cleft lip nasal deformity. It was found that depressed pyriform margin and upper lip were corrected effectively except for the nostril floor, for which an additional soft tissue augmentation would be necessary. The inlay insertion has risk of protrusion, thus the guideline of the use of artificial prosthesis should be observed strictly.

• The korean journal of orthodontics
• /
• v.6 no.1
• /
• pp.17-24
• /
• 1976

The primary objective of this study was to define the differences that exist. between different sexes on the dentoskeletal framework and the soft tissue profile around the mouth. For the purpose of this study, cephalometric radiographs were obtained from the centric occlusion with closed lip position, through the research on each 42 males and females aged from 17 to 22 years with normal occlusion and acceptable facial appearence. The results were as follows: 1. Maxillary to mandibular relationships. Among the angles formed by the long axis of the maxillary and mandibular anterior teeth, the maxillary and mandibular anterior alveolar bone, and the lower and upper lips (Fig.2), only the angle formed by the lips was more acute in males than in females. The males have a more rounded profile, and the females have a flatter profile in the lower third of the face. The differences is statistically significant for the angle formed by the lips. The fact that the lips have a difference greater than that of teeth or the alveolar bone indicates that the lip position is not entirely due to tooth and bony support. Possibly the thickness of the lips has an influence. 2. Occlusal plane. The occlusal plane was related to the anterior tooth inclination, anterior alveolar bone profile, and the lip contour, both maxillary and mandibular (Fig.3). Only the angle related to lower lip was statistically significant. The females again had the more obtuse angle, indicating a flatter profile than that of the males. 3.Skeletal planes. The angles formed by the anterior maxillary lips, teeth, and alveolar bone with the Frankfort plane and the angles of the mandibular lips, teeth, and, alveolar bone and the mandibular plane were investigated (Fig.4). Results were similar to those from maxillary to mandibular relationships. The results were statistically significant for the upper lip and the lower lip, only. 4. Esthetics. The facial line and the mandibular plane were compared with the esthetic line. These angles were different for the different sexes, but only the latter was statistically significant. This difference may be due to the profile contour of the nose.

• Korean Journal of Bronchoesophagology
• /
• v.6 no.2
• /
• pp.185-188
• /
• 2000

The goals of lip reconstruction are to provide oral competence, adequate support for the lower lip, contour restoration, adequate lip sulcus, and adequate oral aperture. The composite radial forearm palmaris longus free flap is thin enough that it can be folded onto itself without a significant increase in bulk. The flap is easy to dissect, the pedicle contains long vessels of large diameter, and the skin is a good color and texture match for the perioral region. Moreover, the vascularized tendon can be used for lower lip reconstruction. This makes the flap ideally suited for total lower lip reconstruction. We experienced the case of total lower lip excision and reconstruction with the radial forearm free flap including palmaris longus tendon, so we reported that case with literature. The patient has a lower lip squamous carcinoma(T3NIM0), and performed a total lower lip excision with right modified radical neck dissection and left extended supraomohyoid neck dissection, and a reconstruction with radial forearm free flap includng palmaris longus tendon. The oral competence and masticatory function were nearly normalized and cosmetical result was very acceptable.

• Journal of KIISE:Software and Applications
• /
• v.30 no.5_6
• /
• pp.454-460
• /
• 2003

In this paper, we propose an efficient method for recognizing human lips. Based on Point Distribution Model, a lip shape is represented as a set of points. We calculate a lip model and the distribution of shape parameters using Principle Component Analysis and Gaussian mixture, respectively. The Expectation Maximization algorithm is used to determine the maximum likelihood parameter of Gaussian mixture. The lip contour model is derived by using the gray value changes at each point and in regions around the point and used to search the lip shape in a image. The experiments have been performed for many images, and show very encouraging result.