• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.5
• /
• pp.842-849
• /
• 2011

The transponder simulator designed to simulate the transponder of military satellite communication systems in the geostationary orbit is required to have time delay function, because of 250 ms delay time, when a radio wave transmits the distance of 36,000 km in free space. But, it is very difficult to develop 250 ms time delay device in the transponder simulator of 100 MHz bandwidth, due to unstable operation of FPGA, loss of memory data for the high speed rate signal processing. Up to date, bandwidth of the time delay device is limited to 45 MHz bandwidth. To solve this problem, we propose the new time delay techniques up to 100 MHz bandwidth without data loss. Proposed techniques are the low speed down scaling and high speed up scaling methods to read and write the external memory, and the matrix structure design of FPGA memory to treat data as high speed rate. We developed the satellite link simulator in 100 MHz bandwidth using the proposed new time delay techniques, implemented to the transponder simulator and verified the function of 265 ms time delay device in 100 MHz bandwidth.

• Journal of IKEEE
• /
• v.19 no.3
• /
• pp.371-377
• /
• 2015

This paper is about the RF transceiver designed and implementation for common data link. The trasmitter is configured as a frequency up-converter, a power amplifier and a duplexer. The receiver is configured as a duplxer, a frequency down-converter and a low noise amplifier. The maximum transmission distance, the reception sensitivity is designed to meet the electrical and temperature characteristics and the like. Using a modeling and simulation in order to meet the requirements of the RF transceiver has been designed and implemented. Transmitting output power and Noise Figure has been measured with 38.58dBm and 5.5dB, respectively. All of the electrical and temperature specifications was meet. Was confirmed all of the requirement specification by electrical characteristics test and temperature characteristics test.

• Journal of Aerospace System Engineering
• /
• v.9 no.4
• /
• pp.37-42
• /
• 2015

The CubeSats is classified as a pico-class satellite which requires a ground station to track the satellite, transmit commands, and receive an on-orbit data such as SOH (State-of-Health) and mission data according to the operation plan. In order to this, the ground station system has to be properly designed to perform a communication to with the satellite with enough up- and down-link budgets. In this study, a conceptual design of the ground station has been performed for the CubeSat named as STEP Cube Lab. (Cube Laboratory for Space Technology Experimental Project). The paper includes a ground station hardware interface design, a link budget analysis and a ground station software realization. In addition, the operation plan of the ground station has been established considering the STEP Cube Lab. mission requirements.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.590-593
• /
• 2005

In this paper, it is analyzed a transmission time of ACL Packet in bluetooth wireless link. In order for segment to improve the transfer capability in bluetooth system, it is fragmented in TCP total messages that are coming down from upper layer and then the packets are sent one at time in baseband. And it is studied that transmission time for bluetooth wireless link according to DM1, DM3 or DM5 packet type in bluetooth piconet environment. From the results, we were able to obtain ACL packet transmission time, optimal TCP packet size and DM packet size.

• Journal of information and communication convergence engineering
• /
• v.21 no.2
• /
• pp.103-109
• /
• 2023

We investigated the antipodal-symmetric dispersion maps of a dispersion-managed link with a midway optical phase conjugator to compensate for the distorted 960 Gb/s wavelength division multiplexed (WDM) signal caused by these effects. The proposed antipodal-symmetric dispersion map has various shapes depending on the detailed design scheme. We confirmed that the dispersion-managed link designed with the dispersion map of the antipodal-symmetric structure is more advantageous than the conventional uniform dispersion map for compensating WDM channels. It was also confirmed that among the antipodal-symmetric structures, the dispersion map configured with the S-1-profile, in which S is inverted up and down, was more effective for distortion compensation than the dispersion map configured with the S-profile. In particular, we confirmed that the S-1-profile can broaden the optical pulse width intensively at a short transmission distance, more effectively compensating for the distorted WDM channel. Because this structure makes the intensity of the optical pulse relatively weak, it can decrease the nonlinear Kerr effect.

• Journal of Institute of Control, Robotics and Systems
• /
• v.8 no.6
• /
• pp.484-491
• /
• 2002

We developed a new type of human-sized BWR (biped walking robot) driven by a new actuator based on the ball screw which has high strength and high gear ratio. Each leg of the robot is composed of three pitch joints and one roll joint. In all, a 10 degree-of-freedom robot with two balancing joints was developed. A new type of actuator for the robot is proposed, which is composed of four bar link mechanism driven by the ball screw. The robot overcomes the limit of the driving torque of conventional BWRs. The BWR was designed to walk autonomously by adapting small DC motors for the robot actuators and has a space to board DC battery and controllers. In the performance test, the BWR performed sitting-up and down motion, and walking motion. Through the test, we found the possibility of a high performance biped-walking.

• Proceedings of the KIPE Conference
• /
• 2004.11a
• /
• pp.128-132
• /
• 2004

This paper proposed a control strategy for flywheel energy/recovery system with induction machine. The system is based on a vector controlled induction machine driving a flywheel and address the problem of regulating the DC-Link system voltage against input power shut-down. And we proposed the method to damp the oscillation of DC-Link. Experimental results are presented which verify the performance of the strategy.

• Bulletin of the Korean Space Science Society
• /
• 2004.10b
• /
• pp.344-346
• /
• 2004

KOMPSAT-2 (Korea Multi Purpose Satellite 2) which is scheduled to launch in 2005 year will communicate with KARI TTC (Tracking, Telemetry, and Command) station flying along sun synchronous orbits (685 km). The command from KARI TTC passes S-band omni-antenna, RF assembly, and transponder and finally reachs OBC (On Board Computer). The telemetry from KOMPSAT-2 arrives at KARI TTC through inverse procedure. In this paper, RF compatibility test between KOMPSAT-2 and KARI TTC station is demonstrated. RF interface for this test was established through real space and uplink signal test and downlink signal test and uplink & downlink signal test were performed.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.7
• /
• pp.43-50
• /
• 1995

In this paper, the variational method are used for the filter analysis methods and a CAD program for the design of the waveguide low-loss bandpass filters using inductive window structures for the VSAT(Very Small Aperture Terminal) system has been developed based on the passband correction method combined with fiter synthesis procedures. Using the developed CAD program, 0.01dB equi-ripple chebyshev type 6-section bandpass filters which are sued in the VSAT system operating nationally are designed for the purpose of the Down-link of 12.75~13.25GHz and the Up-link of 14.0~14.5GHz, fabricated and mesured. The measured results are good agreement woth the theoretical resuls.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1960-1963
• /
• 2002

Transmit diversity schemes we an effective capacity improvement method for down link of wideband code division multiple access (W-CDMA) systems. In this paper, we propose to use transmit antenna subset selection scheme in conjunction with closed loop transmit adaptive array (TxAA). The proposed scheme selects N$\_$s/ optimum antennas among N$\_$${\gamma}$/(>N$\_$s/) transmit antennas in order to maximize diversity gain from selected antennas, and also reduces the cost of RE chains by employing two different types of RF modules fur the selected and the unselected antenna group, respectively. Computer simulation results show performance improvement by the proposed scheme over the conventional TxAA when considering up link control information feedback.