• Journal of Electrical Engineering and Technology
• /
• v.3 no.3
• /
• pp.408-421
• /
• 2008

In this paper, the parallel operation for a FC generation system is introduced and designed in order to increase the capacity for the distributed generation of a proton exchange membrane fuel cell (PEMFC) system. The equipment is the type that is used by parallel operated PEMFC generation systems which have two PEMFC systems, two dc/dc boost converters with shared dc link, and a grid-connected dc/ac inverter for embedded generation. The system requirement for the purpose of parallel operated generation using PEMFC system is also described. Aspects related to the mechanical (MBOP) and electrical (EBOP) component, size, and system complexity of the distributed generation system, it is explained in order to design an optimal distributed generation system using PEMFC. The optimal controller design for the parallel operation of the converter is suggested and informative simulations and experimental results are provided.

• The KIPS Transactions:PartC
• /
• v.10C no.3
• /
• pp.367-376
• /
• 2003

This study deals with the DCMST (Delay constrained Capacitated Minimum Spanning Tree) problem applied in the topological design of local networks or finding several communication paths from root node. While the traditional CMST problem has only the traffic capacity constraint served by a port of root node, the DCMST problem has the additional mean delay constraint of network. The DCMST problem consists of finding a set of spanning trees to link end-nodes to the root node satisfying the traffic requirements at end-nodes and the required mean delay of network. The objective function of problem is to minimize the total link cost. This paper presents two-phased heuristic algorithm, which consists of node exchange, and node shift algorithm based on the trade-off criterions, and mean delay algorithm. Actual computational experience and performance analysis show that the proposed algorithm can produce better solution than the existing algorithm for the CMST problem to consider the mean delay constraint in terms of cost.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.1
• /
• pp.413-435
• /
• 2018

Although the accuracy of handwritten character recognition based on deep networks has been shown to be superior to that of the traditional method, the use of an overly deep network significantly increases time consumption during parameter training. For this reason, this paper took the training time and recognition accuracy into consideration and proposed a novel handwritten character recognition algorithm with newly designed network structure, which is based on an extended nonlinear kernel residual network. This network is a non-extremely deep network, and its main design is as follows:(1) Design of an unsupervised apriori algorithm for intra-class clustering, making the subsequent network training more pertinent; (2) presentation of an intermediate convolution model with a pre-processed width level of 2;(3) presentation of a composite residual structure that designs a multi-level quick link; and (4) addition of a Dropout layer after the parameter optimization. The algorithm shows superior results on MNIST and SVHN dataset, which are two character benchmark recognition datasets, and achieves better recognition accuracy and higher recognition efficiency than other deep structures with the same number of layers.

• Journal of Korean Institute of Industrial Engineers
• /
• v.22 no.2
• /
• pp.303-311
• /
• 1996

The Self Healing Ring (SHR) is one of the most Intriguing schemes which provide survivability for telecommunication networks. To design a cost effective SONET ring it is necessary to consider load balancing problems by which the link capacity is determined. The load balancing problem in SONET ring when demand splitting is not allowed is considered in this paper. An efficient algorithm is presented which provides the best solution starting from various Initial solutions. The initial solution is obtained by routing ell demands such that no demands pass through an are In the ring. The proposed algorithm iteratively improves the Initial solution by examining each demand and selecting the maximum load are in its path. The demand whose maximum arc load is biggest is selected to be routed in opposite direction. Computational results show that the proposed algorithm is excellent both in the solution quality and in the computational time requirement. The average error bound of the algorithm is 0.11% of the optimum and compared to dual-ascent approach which has good computational results than other heuristics.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1285-1289
• /
• 2008

Increasing the flood control capacity's link that is enforcing to existing dam by unusual change of weather, While build planing construction by exiting spillway of tunnel type to dam, could know that part bed rock is formed as is different with design. Grasped topography of research area and geology state to definite distribution aspect of different bed rock, Place that achieved Surface geological Survey and correct Survey is difficult in some section enforced Electrical resistivity dipole-dipole investigation. Grasped stratigraphy distribution confirmation and fracture or weathering zone making out siding 2D-Resistivity Electrical resistivity diagram and Reverse analysis diagram, examining closely soil weathered rock rock's distribution state, established stability countermeasure plan

• ETRI Journal
• /
• v.24 no.2
• /
• pp.81-96
• /
• 2002

This paper describes our design of a hybrid amplifier composed of a distributed Raman amplifier and erbium-doped fiber amplifiers for C- and L-bands. We characterize the distributed Raman amplifier by numerical simulation based on the experimentally measured Raman gain coefficient of an ordinary single mode fiber transmission line. In single channel amplification, the crosstalk caused by double Rayleigh scattering was independent of signal input power and simply given as a function of the Raman gain. The double Rayleigh scattering induced power penalty was less than 0.1 dB after 1000 km if the on-off Raman gain was below 21 dB. For multiple channel amplification, using commercially available pump laser diodes and fiber components, we determined and optimized the conditions of three-wavelength Raman pumping for an amplification bandwidth of 32 nm for C-band and 34 nm for L-band. After analyzing the conventional erbium-doped fiber amplifier analysis in C-band, we estimated the performance of the hybrid amplifier for long haul optical transmission. Compared with erbium-doped fiber amplifiers, the optical signal-to-noise ratio was calculated to be higher by more than 3 dB in the optical link using the designed hybrid amplifier.

• Journal of the Korea Society for Simulation
• /
• v.22 no.1
• /
• pp.41-51
• /
• 2013

This tutorial paper presents the design methodology of system-level simulators targeted for code division multiple access (CDMA) cellular standards such as EV-DO (Evolution-Data Only) and broadcast multicast service (BCMCS). The basic structure and simulation flow of system-level simulators are delineated, following the procedure of cell layout, mobile drops, channel modeling, received power calculation, scheduling, packet error prediction, and traffic generation. Packet data transmissions on the forward link of CDMA systems and EV-DO BCMCS systems are considered for modeling simulators. System-level simulators for cellular standards are modeled and developed with high-level languages and utilized to evaluate and predict air interface performance metrics including capacity and coverage.

• Smart Media Journal
• /
• v.12 no.9
• /
• pp.72-80
• /
• 2023

This paper presents a design and analyzes the performance of a hospital assignment and reassignment scheme for emergency rescue services based on minimum cost maximum flow algorithm. It consists of flow graph building, link capacity updating, and allocation discovering steps. The efficiency of the algorithm makes it possible to reallocate hospitals even in case of dynamic changes in the number of patients or hospitals. The performance measurement result obtained from a prototype implementation shows that the proposed scheme can reduce the transport time requirement miss by up to 24%.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.10
• /
• pp.2171-2180
• /
• 1997

In this paper, we proposed a MAC protocol called P/S-DCA that using dynamci channel allocation scheme for supports the multimedia traffic in wireless ATM, and analysis theoretically the throughput and delay of up/down link according to varying the down traffic load. To evaluate and the dynamic channel allocation scheme, simulations are executed with varying down traffic load. The results are proved that system capacity is improved better than PRMA and C-PRAM. The system capacity, denoting by $M_{0.01}$, is defined as the maximum number of conversations which can be supported under constraint of packet dropping probability no more than 1%. It is shown that the values of $M_{0.01}$ for ${\lambda}_{d}=0.5,\;{\lambda}_{d}=0.2\;{\lambda}_{d}=0.1\;{\lambda}_{d}=0.001$ are about 43, 69, 77 and 83, respectively. This indicates that P/S-DCA protocol achieves a significant improvement in system capacity relative to PRMA and C-PRMA protocol.

• Journal of Korean Society of Transportation
• /
• v.25 no.2 s.95
• /
• pp.83-93
• /
• 2007

Pedestrians and vehicle users should be treated with equal importance in urban street design. However, current street design suggests that the design criteria for sidewalks is based on the functional hierarchy of the vehicles, therefore it is necessary to develop sidewalk design standards that give more weight to pedestrians rather than vehicles. For this, this study suggests that the level of service of pedestrians should be considered in the process of designing sidewalks. Currently, level of service (LOS) criteria for pedestrians in the Korean Highway Capacity Manual are based on pedestrian volume, but the volume of pedestrians is seldomly estimated in practice. So, the current LOS criteria has limitations in terms of practical use. Also, the study assumes that the pedestrian flow rate is hardly the dominant factor that could affect the LOS of pedestrians at most urban sidewalks. In this context, the study considers a new LOS for sidewalk design based on the comfort of pedestrians while passing pedestrians coming from the opposite direction. Then the study attempts to link the new LOS criteria to the land use patterns using data of pedestrian traffic characteristics acquired from the field. In addition to this, the scope in which the suggested criteria can be applied is suggested.